- Research Article
- 10.37665/reucsra26946
Smart Product Handling Conveyance & Storage Management
- May 01, 2024
- Regional Events
- Stefan Petz
ABSTRACT *Presentation Slides (PDF) Only*
Publications from 2021 to 2026
Showing 3 of 3 papers
Smart Product Handling Conveyance & Storage Management
ABSTRACT *Presentation Slides (PDF) Only*
Paste-based silver reduction for iTOPCon rear side metallization
This work presents two approaches to reduce the silver (Ag) amount on the rear side of M2-sized industrial tunnel oxide passivated contact (iTOPCon) solar cells by (partially) substituting conventional Ag pastes with copper (Cu) and aluminum (Al) pastes. The first approach is Cu-based and works by screen printing an Ag layer with ca. 75% Ag paste reduction compared to a conventional Ag layer (functioning as a contact and Cu barrier layer) and screen printing a full-area Cu layer on top of the Ag layer (functioning as a conduction layer compensating the reduced Ag amount). This Cu-based approach yields similar power conversion efficiency (η) compared to the conventional approach, showing the Cu-based approach is promising for iTOPCon solar cells. The second approach is Al-based and works by laser contact opening of the dielectric layers and screen printing a full-area layer with an Al paste – adapted to properly contact an n+-poly-Si layer –, substituting Ag on the rear side entirely. This Al-based approach exhibits a 0.9%absη gap to the conventional approach, mainly stemming from the Al paste damaging the poly-Si layer, while – on a positive note – neither rear p+ layer formation nor tunnel oxide layer penetration by the Al paste is detected. Even though the abovementioned η gap must be eliminated in the future, it shows the principal functionality and potential of such type of contact for iTOPCon solar cells.
Read moreThe project »Rock-Star«: The evolution of rotary printing for solar cell metallization
Within this work, we provide a comprehensive overview about research activities and current status with respect to rotary printed metallization for silicon solar cells. We will present the major results of the research project »Rock-Star« and previous activities which focused on the metallization of Si solar cells using flexographic printing and rotary screen printing. We demonstrate that the rear side metallization of passivated emitter and rear cells (PERC) can be realized with rotary screen printing on the same quality level as state-of-the-art flatbed screen printing. Furthermore, it is shown that both rotary screen printing and flexographic printing are able to realize the fine line front side metallization. Fine line front side contacts down to approx. 40 µm for rotary screen printing and around 30 µm for flexographic printing are demonstrated. However, further optimization is required to reduce finger width, increase finger height and thus decrease the mean lateral finger resistance. A major result of project »Rock-Star« is the development of an innovative demonstrator platform to enable rotary printed solar cell metallization with high printing speed and low cycle time per wafer. Newly developed transport, alignment and printing concept enables a cycle time of down to 0.45 s/wafer. The concept and features of the demonstrator machine are presented within this paper.
Read more