InnerOptic Technology (United States)

A novel and efficient 3D calibration method for different types of autostereoscopic multi-view 3D displays is presented in this paper. In our method, a camera is placed at different locations within the viewing volume of a 3D display to capture a series of images that relate to the subset of light rays emitted by the 3D display and arriving at each of the camera positions. Gray code patterns modulate the images shown on the 3D display, helping to significantly reduce the number of images captured by the camera and thereby accelerate the process of calculating the correspondence relationship between the pixels on the 3D display and the locations of the capturing camera. The proposed calibration method has been successfully tested on two different types of multi-view 3D displays and can be easily generalized for calibrating other types of such displays. The experimental results show that this novel 3D calibration method can also be used to improve the image quality by reducing the frequently observed crosstalk that typically exists when multiple users are simultaneously viewing multi-view 3D displays from a range of viewing positions.

For generalized augmented reality to be feasible, the augmenting elements must be visible in varied environments and under rapidly changing, high dynamic range lighting, from bright sunlight to deep shadows. We present a high dynamic range, optical see-through, augmented reality display that dynamically adjusts the brightness of the virtual imagery to match the current brightness of the real scene. Critical components include the spatial brightness sensor array and the positional brightness image intensity matcher. The color, scene-adaptive HDR display system is based on a high-rate (15 kHz) DMD projector using a high-speed RGB LED illuminator, each color with independent 16 bit intensity control for each binary DMD frame. The critical input to the intensity matching algorithm is the output of an array of high sensitivity light sensors. This paper discusses the implementation of the system and reports performance via still and video demonstrations under a variety of lighting conditions.

This article describes Ethernet passive optical networks, an emerging local subscriber access architecture that combines low-cost point-to-multipoint fiber infrastructure with Ethernet. EPONs are designed to carry Ethernet frames at standard Ethernet rates. An EPON uses a single trunk fiber that extends from a central office to a passive optical splitter, which then fans out to multiple optical drop fibers connected to subscriber nodes. Other than the end terminating equipment, no component in the network requires electrical power, hence the term passive. Local carriers have long been interested in passive optical networks for the benefits they offer: minimal fiber infrastructure and no powering requirement in the outside plant. With Ethernet now emerging as the protocol of choice for carrying IP traffic in metro and access networks, EPON has emerged as a potential optimized architecture for fiber to the building and fiber to the home.

This paper explains why next generation local access networks will evolve to an all-optical IP Ethernet architecture that supports quality of service and management for a full range of voice, data and video services.