- Book Chapter
9
- 10.1533/9780857098757.179
6 - Maskless photolithography
- Jan 01, 2014
- Nanolithography
- M.e Walsh + 3 more +3
Publications from 2021 to 2026
Showing 4 of 4 papers
6 - Maskless photolithography
Confining Light to Deep Subwavelength Dimensions to Enable Optical Nanopatterning
In the past, the formation of microscale patterns in the far field by light has been diffractively limited in resolution to roughly half the wavelength of the radiation used. Here, we demonstrate lines with an average width of 36 nanometers (nm), about one-tenth the illuminating wavelength lambda1 = 325 nm, made by applying a film of thermally stable photochromic molecules above the photoresist. Simultaneous irradiation of a second wavelength, lambda2 = 633 nm, renders the film opaque to the writing beam except at nodal sites, which let through a spatially constrained segment of incident lambda1 light, allowing subdiffractional patterning. The same experiment also demonstrates a patterning of periodic lines whose widths are about one-tenth their period, which is far smaller than what has been thought to be lithographically possible.
Read moreMaskless Lithography using Diffractive-Optical Arrays
An optical maskless-lithography system is described that is capable of patterning complex geometries at very high resolution, and in a cost-effective manner with potential applications in the fabrication of nanostructures for photonic devices.
Read moreMaskless zone-plate-array lithography (ZPAL): for enhanced creativity in nanostructures fabrication and research
Summary form only given, as follows. We report on our development of a maskless lithography system that uses an array of Fresnel phase zone plates to bring CW laser radiation to an array of onaxis focal spots. A Grating Light Valve (GLVm') device from Silicon Light Machines modulates the intensity of the spots as the stage is moved, enabling the creation of patterns of arbitrary geometry, with excellent control of linewidth. Placement accuracy -1nm is ensured by fabricating the zone plates with spatialphase-locked e-beam lithography, We have demonstrated multilevel alignment, fully multiplexed writing, and lithographic performance near theoretical limits with zone plates of 0.85 numerical aperture. Although our ZPAL prototype employs 400 nm wavelength, 150nm dense lines and spaces (Le,, k, = 0.32) are achieved with little difficulty. Throughput is limited primarily by the speed of beam modulation. We are proceeding toward commercial manufacturing of ZPAL tools for research and development. Diffractive optics has significant advantages over refractive approaches since near-ideal performance is achieved on axis, costs are low, and the approach can be readily scaled to shorter wavelengths. Maskless lithography, such as we will describe, should enable circuit designers to more fully exploit their creativity, unencumbered by the constraints of mask-based lithography. Ths may revolutionize custom circuit design as well as research in electronics, NEMS, microphotonics, nanomagnetics and nanoscale science and engineering.
Read more