Mathys (Germany)

This chapter reports the results of a cycle computer case study and a previously conducted industrial case study from the automation domain. The key result is a model-based testing process for highly configurable embedded systems. The initial version of the testing process was built upon parameterizeable systems. The cycle computer case study adds the configuration using the product line concept and a feature model to store the parameterizable data. Thus, parameters and their constraints can be managed in a very structured way. Escalating demand for flexibility has made modern embedded software systems highly adjustable. This configurability is often realized through parameters and a highly configurable system possesses a handful of those. Small changes in parameter values can often account for significant changes in the system's behavior, whereas in some other cases, changed parameters may not result in any perceivable reaction. The case studies address the challenge of applying model-based testing to configurable embedded software systems in order to reduce development effort. As a result of the case studies, a model-based testing process was developed. This process integrates existing model-based testing methods and tools such as combinatorial design and constraint processing as well as the product line engineering approach. The testing process was applied as part of the case studies and analyzed in terms of its actual saving potentials, which turned out to reduce the testing effort by more than a third.

Further development of ceramic materials for total hip replacement aim to increase fracture toughness and further reduce the incidence of bearing fracture. Edge loading due to translational mal positioning (microseparation) has replicated stripe wear, wear rates, and bimodal wear debris observed on retrievals. This method has replicated the fracture of early zirconia ceramic-on-ceramic bearings. This has shown the necessity of introducing microseparation conditions to the gait cycle when assessing the tribological performance of new hip replacement bearings. Two novel ceramic matrix composite materials, zirconia-toughened alumina (ZTA) and alumina-toughened zirconia (ATZ), were developed by Mathys Orthopädie GmbH. In this study, ATZ-on-ATZ and ZTA-on-ZTA bearing combinations were tested and compared with alumina-on-alumina (Al2O3-on-Al2O3) bearings under adverse microseparation and edge loading conditions using the Leeds II physiological anatomical hip joint simulator. The wear rate (±95% confidence limit) of ZTA-on-ZTA was 0.14 ± 0.10 mm(3)/million cycles and that of ATZ-on-ATZ was 0.06 ± 0.004 mm(3)/million cycles compared with a wear rate of 0.74 ± 1.73 mm(3)/million cycles for Al2O3-on-Al2O3 bearings. Stripe wear was evident on all bearing combinations; however, the stripe formed on the ATZ and ZTA femoral heads was thinner and shallower that that formed on the Al2O3 heads. Posttest phase composition measurements for both ATZ and ZTA materials showed no significant change in the monoclinic zirconia content. ATZ-on-ATZ and ZTA-on-ZTA showed superior wear resistance properties when compared with Al2O3-on-Al2O3 under adverse edge loading conditions.

Ceramic-on-ceramic articulations are a frequently used bearing for total hip replacements. This success mainly is due to their excellent tribological properties. Ceramics can withstand high pressure loads due to its brittleness but only low bending stresses. A ceramic ball head fracture is the result of subcritical crack growth. This kind of fracture in vivo can abet by damage or contamination of the stem cone. The main goal of this work is to provide a risk assessment of different possible damage mechanisms and contaminations that may result in lower fracture strength of a ceramic ball head. To simulate potential causes, different types and dimensions of metal wire, foils, hair, and lubricants were inserted between the ceramic ball head and the metal cone of the stem. The test results clearly show that fracture strength is negatively influenced by most of the inhomogeneities between the cone and the head because they increase the peak stresses acting on a part of the ceramic ball head. The results of this article clearly confirm the demand for an undamaged taper fit "free of contamination" between the ceramic head and the metal cone during implantation.