Metroprojekt Praha (Czechia)

Abstract An empirical and a numerical calculation model were developed to predict the surface settlements due to EPB tunnelling in hard rock with heterogeneous face conditions. For this purpose, surface settlement and TBM driving data from Boßler Tunnel were considered. The TBM launching area characterised by a low overburden (z/D < 2) and a nature conservation area at surface was examined. The developed models were calibrated against the measured surface settlements of the first eastbound tube and were used to predict the surface settlements of the subsequent westbound tube. The prediction was then compared to the actual measured settlements during the excavation of the westbound tube. From this, findings for future settlement predictions in similar ground conditions were derived. It could be shown that both models are suitable for the application in the investigated subsoil conditions and can be used successfully in practice in different phases of the project development.

The use of precast steel fibre reinforced concrete (SFRC) for tunnel segments is a relatively new application of this material. It was first applied in Italy in the 1980s. However, it did not begin to be widely applied until after 2000. The Czech Technical University in Prague (CTU), together with Metrostav, carried out a study to evaluate the use of this new technology for tunnels in the Czech Republic. The first tests were carried out on small samples (beams and cubes) produced from SFRC to find an appropriate type and an appropriate dosage of fibres. The tests were also used to verify other factors affecting the final product (e.g. production technology). Afterwards, SFRC segments were produced and then tested at the Klokner Institute of CTU. Successful test results confirmed that it was possible to use SFRC segments for Czech transport tunnels. Consequently a 15 m-long section of segmental lining generated from SFRC without steel rebars was constructed as part of line A of the Prague metro.