- Research Article
2
- 10.1016/j.segan.2025.101867
Analyzing the performance of aggregators under communication protocol constraints
- Sep 01, 2025
- Sustainable Energy, Grids and Networks
- Fabian Krug + 2 more +2
Publications from 2021 to 2026
Showing 9 of 9 papers
Analyzing the performance of aggregators under communication protocol constraints
A Compounder’s Vision of the Future: The Nonfossil Plastics Industry
Heart rate and blood lactate responses during the cross-country test of 2-star to 5-star eventing competitions
The objective of this retrospective study was to evaluate the physiological demands of cross-country competitions at different levels. Heart rates (HR) and post exercise blood lactate concentrations (LAC) measured between 2010 and 2019 in response to 1,463 cross-country competitions (437 at 2-star, 703 at 3-star, 313 at 4-star and 10 at 5-star level) in 294 horses were analysed. The effect of competition level, mean velocity, height profile, total distance, number of jumping efforts, climate, age, sex, percentage of Thoroughbred blood and performance level on HR, LAC, HR recovery and LAC disappearance rates was evaluated by Linear Mixed Effects Models. Mean HR and LAC significantly increased from 2-star to 4-star level (P<0.001). Each 30 m/min increase in mean velocity was associated with a 3 beats/min increase in HR (P<0.001) and a 41% increase in LAC (P<0.001) and each 30 m increase in cumulative elevation with a 2 beats/min increase in HR (P<0.001) and a 32% increase in LAC (P<0.001). Each 20 m increase in mean distance per jumping effort was associated with a 1 beat/min decrease in HR (P<0.01) and a 13% decrease in LAC (P<0.001). Compared to Warmbloods, horses with 75% Thoroughbred blood had 4 beats/min lower HRs (P<0.05) and 34% lower LAC values (P<0.001). Each 5 years increase in age was associated with a 4 beats/min decrease in HR (P<0.001, only in mares) and an 11% decrease in LAC (P<0.01). The HRs during the first 3 minutes of recovery were higher at warmer and more humid conditions (P<0.05). The rate of LAC disappearance was higher in horses with higher percentages of Thoroughbred blood (P<0.05).
Read moreAppliquer le TDABC aux parcours de soins, bien plus qu’une promenade de santé
Dans le cadre d’une attention accrue portée aux parcours de soins autour des personnes soignées, les démarches de valorisation de ces parcours sont cruciales, mais restent encore exploratoires dans les structures de santé. La méthode de calcul de coûts complets TDABC (time-driven activity based costing), préconisée, reste rare. Cet article vise à identifier les défis concrets de son application à des parcours de soins dans le cadre d’une structure innovante, un institut hospitalo-universitaire (IHU) lié à un centre hospitalo-universitaire (CHU). L’article précise les étapes de mise en œuvre et les difficultés associées, au niveau de la définition des parcours, de la collecte des données et de leur valorisation. L’étude permet aussi de pointer le potentiel d’amélioration des processus, met en évidence les compétences communicationnelles nécessaires au déploiement de la méthode, et montre l’importance de l’adapter pour ne pas rigidifier les processus, et favoriser l’innovation. Le TDABC, qui semble simple, présente des difficultés dans les phases précédant le calcul de coût final.
Read moreWeryfikacja jakości połączeń lutowanych z miedzi za pomocą badań rentgenowskich
W pracy przedstawiono zagadnienia związane z oceną jakości połączeń lutowanych stosowanych w instalacjach grzewczych. Porównano ocenę jakości na podstawie badań wizualnych oraz metalograficznych z wynikami badań radiologicznych. Badania wykazały, że zastosowanie dodatkowego topnika przy lutowaniu lutem Cu-P poprawia zwilżalność powierzchni lutowanej, tym niemniej samotopnikujące dzia- łanie lutu było wystarczające dla uzyskania wymaganego poziomu jakości złączy. Verification of the quality of brazed joints in copper by means of X-ray examinations Abstract The paper presents issues related to the assessment of the quality of brazed joints used in heating systems. The quality of joints assessed on the basis of visual and metallographic tests were compared with radiological examinations. Studies have shown that the use of chemical flux by soldering with Cu-P solder improves wettability soldered surface, however self-fluxing action of the solder was sufficient to obtain the required level of quality of joints.
Read moreBasics of Adsorption Heat Pump Processes
A heat pump process is a thermodynamic process having the main target to pump heat from a heat reservoir at a low temperature (ambient heat source) to a heat sink at a higher temperature (heating net). According to the second law of thermodynamics, this target can only be realized if a driving energy is applied. Contrary to the vapor compression heat pump process, where mechanical work is applied as a driving energy to run the compressor, thermally driven heat pumps (TDHP) make use of heat at a higher temperature (driving heat source), compared to the heat sink temperature, as a driving energy.
Read moreMechanical Stability of Adsorbent Coatings
An adsorbent material consolidated in form of coating could present poor mechanical stability if a proper binder and/or an optimized binder content are not adopted in the coating formulation. Mechanical stability of the adsorbent coating may be affected by different typologies of mechanical stresses during its lifetime (vibrations, impacts, etc.). For this reason, a single mechanical test is not sufficient to prove completely the overall mechanical stability of the coated layer.
Read moreA Moderate Zinc Deficiency Does Not Impair Gene Expression of PPARα, PPARγ, and Mitochondrial Enoyl-CoA Delta Isomerase in the Liver of Growing Rats
The aim of the study was to investigate the impact of a moderate zinc deficiency and a high intake of polyunsaturated fat on the mRNA expression of peroxisome-proliferator-activated receptor alpha (PPARα), peroxisome-proliferator-activated receptor gamma (PPARγ), and mitochondrial Δ3Δ2-enoyl-CoA isomerase (ECI) in the liver. Weanling rats were assigned to five groups (eight animals each) and fed semi-synthetic, low-carbohydrate diets containing 7 or 50 mg Zn/kg (low-Zn (LZ) or high-Zn (HZ)) and 22% cocoa butter (CB) or 22% safflower (SF) oil for four weeks. One group each was fed the LZ-CB, LZ-SF, or HZ-SF diet free choice, and one group each was fed the HZ-CB and HZ-SF diets in restricted amounts according to intake of the respective LZ diets. The LZ diets markedly lowered growth and zinc concentrations in plasma and femur. Hepatic mRNA levels of PPARα, PPARγ, and ECI were not reduced by the moderate zinc deficiency. Overall, ECI-mRNA abundance was marginally higher in the SF-fed than in the CB-fed animals.
Read moreOn the Effect of Grain Size on the Kinetics of Water Vapor Adsorption and Desorption into/from Loose Pellets of FAM-Z02 under a Typical Operating Condition of Adsorption Heat Pumps
The kinetics of water vapor adsorption/desorption under quasi isobaric conditions have been studied on one layer of loose pellets of FAM-Z02 placed on a metal plate. Temperature of the sample holding plate has been changed as it takes place in real adsorption heat pumps (AHPs), while the vapor pressure over the adsorbent was maintained almost constant (saturation pressures corresponding to an evaporator temperature of 5°C and a condenser temperature of 35°C). Adsorption- and desorption-end temperatures have been adjusted to 35 and 90°C, respectively. Measurements have been carried out on grains having the following size distributions: 0.7 to 1.0 mm, 1.4 to 1.6 mm and 2.0 to 2.6 mm. An average equilibrium differential water loading of 19.2 g/100 g has been measured during desorption compared to 16.4 g/100 g during adsorption. The adsorption/desorption rates have been characterized by the times required to reach 50, 80 and 90% of the equilibrium loading. It has been found that the adsorption kinetics are mainly dominated by inter-crystalline diffusion, while the desorption kinetics are mostly influenced by surface resistance to the heat and mass transfer. Average specific evaporator cooling/condenser heating capacities in the order of 1 kW/kg have been estimated for the grain size 0.7 to 1.0 mm, putting in evidence the possibility of developing highly compacted AHPs with FAM-Z02 for heating and cooling applications. The influencing parameters on the combined heat and mass transfer process have been discussed.
Read more