Publications from 2021 to 2026
Filter Showing 10 of 150 papers
Joining PIP-SiCf/SiC composite to Co-base superalloy using a compositionally tuned Cu-Ni-Ti filler for balanced reactivity and high-temperature reliability
Study on tribochemical reaction behavior induced by abrasives scratching in SiC wafer backside thinning
Recession behavior of plasma-sprayed ytterbium monosilicate environmental barrier coating against silicate deposits
Research on surface quality and subsurface damage of sapphire microgroove etched by femtosecond laser-induced plasma-assisted ablation
1Flame inclination instability under lateral fuel mass fraction differences: An experimental study in anthracite/alumina hybrid filtration combustion
1Research on single-crystal diamond surface polishing process and material removal mechanism based on inductively coupled plasma etching reactions
Influences of Polishing Slurry Components on Material Removal and Surface Morphology of 4H-SiC C-Face Based on Fenton Reaction CMP
This study systematically investigates the effects of polishing slurry components on the material removal rate (MRR) and surface morphology of the C-face of 4H-SiC substrates during chemical mechanical polishing (CMP) based on the Fenton reaction. By regulating the particle size and concentration of colloidal silica abrasives, H2O2 concentration, and Fe3O4 catalyst content, the mechanisms of each component on MRR and surface roughness (Sa) were systematically analyzed. The results indicate that in an alkaline polishing slurry at pH = 9, Fe3O4 effectively catalyzes the decomposition of H2O2 to generate hydroxyl radicals (·OH), thereby significantly enhancing the material removal efficiency. When using colloidal silica with a particle size of 110 nm at a concentration of 8 wt%, H2O2 at 5 wt%, and Fe3O4 at 0.03 wt%, a maximum MRR of 701 nm/h was achieved along with a good surface quality of Sa = 0.79 nm. The study also found that the abrasive particle size and concentration, as well as the ratio of oxidant to catalyst, significantly influence the chemo-mechanical synergy. Excessively high H2O2 or Fe3O4 concentrations can trigger ·OH quenching reactions, thereby reducing polishing efficiency. This research provides a theoretical basis and process optimization direction for the application of heterogeneous Fenton reactions in SiC CMP under alkaline conditions.
Read moreResearch on the causes of deviation between analytical and numerical solutions of flexure hinge compliance and a correction model
Atomic-scale regulation of interfacial reactions in low-temperature brazing of TA1 titanium alloy using in situ formed Ag–Al filler
Fabrication, Microstructure, and Properties of CuSn12Ni2 Coating on 45 Steel by High-Speed Laser Cladding
Copyright 2026 Cactus Communications. All rights reserved.
