• Home
  • Search
  • ЧИСЛЕННОЕ МОДЕЛИРОВАНИЕ ТЕПЛОМАССОПЕРЕНОСА В ПАРОГЕНЕРАТОРЕ РЕАКТОРНОЙ УСТАНОВКИ ТИПА БРЕСТ ПРИ ВОЗНИКНОВЕНИИ КРИСТАЛЛИЗАЦИИ СВИНЦОВОГО ТЕПЛОНОСИТЕЛЯ
  • Cite Icon2
  • https://doi.org/10.32326/1814-9146-2018-80-2-267-280Copy DOI Icon

ЧИСЛЕННОЕ МОДЕЛИРОВАНИЕ ТЕПЛОМАССОПЕРЕНОСА В ПАРОГЕНЕРАТОРЕ РЕАКТОРНОЙ УСТАНОВКИ ТИПА БРЕСТ ПРИ ВОЗНИКНОВЕНИИ КРИСТАЛЛИЗАЦИИ СВИНЦОВОГО ТЕПЛОНОСИТЕЛЯ

Show More
  • Abstract
  • Literature Map
  • References
  • Citations
  • Similar Papers
Abstract

The method of numerical simulation has been developed describing non-stationary heat and mass transfer and thermal conductivity in a steam generator with liquid metal coolant when there is a crystallization process. The method takes into account the differences of the process depending on the condition of the contact surfaces. On its basis the dynamics of solid phase formation in a lead-coolant of reactor plant BREST type during the accident with the steam generator steam line depressurization has been studied. The calculations are carried out with using of the RASPLAV software complex, which allows modeling the interconnected dynamics of thermal-hydraulic processes in the first and second circuits in terms of the one-dimensional equilibrium approximation. It is shown that at failure of feed water lock-regulatory armature there is a full closure of flow section of the emergency steam generator first circuit by solid phase. Depending on the condition of the protective oxide layer of the heat exchange surface the solidification of lead coolant takes place either on the heat exchanger tubes or in the lower part of the steam generator reservoir. In both cases, there is a threat of cessation of circulation in the emergency loop. A brief description of the mathematical model of the steam generator and the reactor plant circuit as a whole is given. A one-dimensional description of heat and mass transfer is used. A thermodynamic equilibrium of the phases at the boundary of phase transfer is postulated. The test results of the programmed numerical model are given. The calculation of the high pressure pipeline rupture is tested by comparison with the experimental data. The calculation of the solid layer formation dynamics on the surface of heat exchange tubes is tested by comparing the numerical solution with the analytical solution of the Stefan problem. The results of this research can be used for design of reactors with a lead coolant.Keywords: Stefan problem, stop valve, mathematical model, steam generator, reactor plant, lead coolant, surface wettability, mixing feedwater heater, crystallization process, phase transfer.

Similar Papers
  • Conference Article
  • Citations1

Experimental Measurements of Eddy Current Signal From SG Tubes of Fast Breeder Reactor Covered by a Thin Sodium Layer Using a SG Mock-Up

  • Jan 01, 2009
  • Volume 1: Plant Operations, Maintenance, Engineering, Modifications and Life Cycle; Component Reliability and Materials Issues; Next Generation Systems
  • Toshihiko Yamaguchi +3
  • Research Article

ФУНДАМЕНТАЛЬНЫЕ ИССЛЕДОВАНИЯ В ОБЛАСТИ ТЕПЛОФИЗИКИ ЯЭУ: ДОСТИГНУТЫЕ РЕЗУЛЬТАТЫ И ПРОБЛЕМЫ ДАЛЬНЕЙШИХ ИССЛЕДОВАНИЙ

  • Mar 26, 2020
  • PROBLEMS OF ATOMIC SCIENCE AND TECHNOLOGY. SERIES: NUCLEAR AND REACTOR CONSTANTS
  • Yu Kuzina +1
  • Research Article

Vibrational wear of pipe-spacer pair in steam generator with lead coolant

  • Dec 01, 2009
  • Russian Engineering Research
  • Yu N Drozdov +4
  • Research Article
  • Citations3

Numerical simulation of gas volume motion during the gas injection into liquid metal coolant

  • Sep 01, 2017
  • Journal of Physics: Conference Series
  • E V Usov +5
  • Research Article

Procedure of calculation of the spatial distribution of temperatures and heat fluxes in the steam generator of a nuclear power installation with an RBEC fast-neutron reactor

  • Jul 14, 2016
  • Thermal Engineering
  • A A Frolov +1
  • Research Article

ICONE15-10146 DAMPING IN HEAT EXCHANGER TUBE BUNDLES : A REVIEW

  • Jan 01, 2007
  • The Proceedings of the International Conference on Nuclear Engineering (ICONE)
  • Qamar Iqbal +5
  • Research Article
  • Citations1

Development of Tritium Recovery by Flowing O2+Ar Gases at Steam Generator in Fast Breeder Reactor

  • Nov 01, 2011
  • Fusion Science and Technology
  • Yasuhisa Oya +3
  • Conference Article
  • Citations1

Experimental Studies of Thermal Hydraulics of a HLMC Flow Around Heat Exchange Surfaces

  • Jul 29, 2013
  • Mikhail Iarmonov +3
  • Book Chapter
  • Citations2

GAS-COOLED REACTOR TECHNOLOGY

  • Jan 01, 1968
  • H.B Stewart +2
  • Conference Article

Development of Atlas of Defects of Steam Generators Heat Exchanging Tubes of NPPs With WWER and Analysis of Testing Results

  • Jan 01, 2008
  • Volume 1: Plant Operations, Maintenance, Installations and Life Cycle; Component Reliability and Materials Issues; Advanced Applications of Nuclear Technology; Codes, Standards, Licensing and Regulatory Issues
  • Murat Bakirov +2
  • Research Article
  • Citations8

Studying the operation of a VVER steam generator in the condensing mode at different parameters of emergency processes

  • Apr 28, 2017
  • Thermal Engineering
  • A V Morozov +3
  • Conference Article
  • Citations2

Effect of Temperature on Damping in Shell and Tube Heat Exchangers

  • Jan 01, 2008
  • Volume 4: Structural Integrity; Next Generation Systems; Safety and Security; Low Level Waste Management and Decommissioning; Near Term Deployment: Plant Designs, Licensing, Construction, Workforce and Public Acceptance
  • Ali Roheim El-Ghalban +4
  • Research Article
  • Citations5

Modeling and analysis of selected organization for economic cooperation and development PKL-3 station blackout experiments using TRACE

  • Jan 09, 2018
  • Nuclear Engineering and Technology
  • Roman Mukin +3
  • Research Article
  • Citations18

Experimental mass and heat transfer at a serpentine tube heat exchanger located at the wall of a square stirred tank reactor

  • Jan 01, 2023
  • Applied Thermal Engineering
  • W.B Rasslan +6
  • Conference Article
  • Citations1

OXIPROBE: A Non Destructive Tool for Determining Steam Generator Oxide Characteristics

  • Jan 01, 2009
  • John P Krasznai
Cactus Communications logo

Copyright 2026 Cactus Communications. All rights reserved.