A Comparison of UVC Ray Tracing Models to Biofouling Field Immersion Tests

A proof-of-concept study was designed to investigate using an Ultraviolet C (UVC) lamp mounted on a hull-crawling remotely operated vehicle (ROV) to prevent biofouling on a ship hull. A wheeled cart with a UVC lamp was built to expose two large test panels to UVC. The test panels were coated with an ablative copper antifouling and a silicone fouling release coating, and these were immersed in seawater at Port Canaveral, Florida. Three exposure frequencies (once a week, twice a week, and three times a week) and two dosages (8 and 16 s of UVC exposure) were tested. UVC was effective at preventing biofilm growth during the first 2 weeks of UVC treatment but was unable to prevent increased fouling growth as time progressed. It appears that an increase in UVC intensity and duration of exposure would be needed to prevent fouling growth especially during high-fouling seasons or that UVC exposure would need to be combined with another fouling prevention practice, such as mechanical wiping, to be more effective.

Due to the COVID-19 virus being highly transmittable, frequently cleaning and disinfecting facilities is common guidance in public places. However, the more often the environment is cleaned, the higher the risk of cleaning staff getting infected. Therefore, strong demand for sanitizing areas in automatic modes is undoubtedly expected. In this paper, an autonomous disinfection vehicle with an Ultraviolet-C (UVC) lamp is designed and implemented using an ultra-wideband (UWB) positioning sensor. The UVC dose for 90% inactivation of the reproductive ability of COVID-19 is 41.7 J/m2, which a 40 W UVC lamp can achieve within a 1.6 m distance for an exposure time of 30 s. With this UVC lamp, the disinfection vehicle can effectively sterilize in various scenarios. In addition, the high-accuracy UWB positioning system, with the time difference of arrival (TDOA) algorithm, is also studied for autonomous vehicle navigation in indoor environments. The number of UWB tags that use a synchronization protocol between UWB anchors can be unlimited. Moreover, this proposed Gradient Descent (GD), which uses Taylor method, is a high-efficient algorithm for finding the optimal position for real-time computation due to its low error and short calculating time. The generalized traversal path planning procedure, with the edge searching method, is presented to improve the efficiency of autonomous navigation. The average error of the practical navigation demonstrated in the meeting room is 0.10 m. The scalability of the designed system to different application scenarios is also discussed and experimentally demonstrated. Hence, the usefulness of the proposed UWB sensor applied to UVC disinfection vehicles to prevent COVID-19 infection is verified by employing it to sterilize indoor environments without human operation.

Postharvest hot air and UV-C treatments enhance aroma-related volatiles by simulating the lipoxygenase pathway in peaches during cold storage

Effective ultraviolet C light disinfection of respirators demonstrated in challenges with Geobacillus stearothermophilus spores and SARS-CoV-2 virus

AimThe study of minimal ter operon as a determinant of tellurium resistance (TeR) is important for the purpose of confirming the relationship of these genes to the pathogenicity of microorganisms. The ter operon is widespread among bacterial species and pathogens, implicated also in phage inhibition, oxidative stress and colicin resistance. So far, there is no experimental evidence for the role of the Escherichia coli (E. coli) minimal ter operon in ultraviolet C (UVC) resistance, biofilm formation and auto-aggregation. To identify connection with UVC resistance of the minimal ter operon, matched pairs of Ter-positive and -negative E. coli cells were stressed and differences in survival and whole genome sequence analysis were performed. This study was aimed also to identify differences in phenotype of cells induced by environmental stress.MethodsIn the current study, a minimal ter operon(terBCDEΔF) originating from the uropathogenic strain E. coli KL53 was used. Clonogenic assay was the method of choice to determine cell reproductive death after treatment with UVC irradiation at certain time intervals. Bacterial suspensions were irradiated with 254 nm UVC-light (germicidal lamp in biological safety cabinet) in vitro. UVC irradiance output was 2.5 mW/cm2 (calculated at the UVC device aperture) and plate-lamp distance of 60 cm. DNA damage analysis was performed using shotgun sequencing on Illumina MiSeq platform. Biofilm formation was measured by a crystal violet retention assay. Auto-aggregation assay was performed according to the Ghane, Babaeekhou & Ketabi (2020).ResultsA large fraction of Ter-positive E. coli cells survived treatment with 120-s UVC light (300 mJ/cm2) compared to matched Ter-negative cells; ∼5-fold higher resistance of Ter-positive cells to UVC dose (p = 0.0007). Moreover, UVC surviving Ter-positive cells showed smaller mutation rate as Ter-negative cells. The study demonstrated that a 1200-s exposure to UVC (3,000 mJ/cm2) was sufficient for 100% inhibition of growth for all the Ter-positive and -negative E. coli cells. The Ter-positive strain exhibited of 26% higher auto-aggregation activities and was able to inhibit biofilm formation over than Ter- negative strain (**** P < 0.0001).ConclusionOur study shows that Ter-positive cells display lower sensitivity to UVC radiation, corresponding to a presence in minimal ter operon. In addition, our study suggests that also auto-aggregation ability is related to minimal ter operon. The role of the minimal ter operon (terBCDEΔF) in resistance behavior of E. coli under environmental stress is evident.

Controlling sprouting in potato tubers using ultraviolet-C irradiance

Disinfection of surfaces by ultraviolet-C (UV-C) radiation is gaining importance in diverse applications. However, there is generally no accepted computational procedure to determine the minimum irradiation times and UV-C doses required for reliable and secure disinfection of surfaces. UV-C dose distributions must be comparable for devices presently on the market and future ones, as well as for the diverse surfaces of objects to be disinfected. A mathematical model is presented to estimate irradiance distributions. To this end, the relevant parameters are defined. These parameters are the optical properties of the UV-C light sources, such as wavelength and emitted optical power, as well as electrical features, like radiant efficiency and consumed power. Furthermore, the characteristics and geometry of the irradiated surfaces as well as the positions of the irradiated surfaces in relation to the UV-C light sources are considered. Because mercury (Hg) lamps are competitive with UV-C light-emitting diodes, a comparative analysis between these two light sources based on the simulation results is also discussed.

Star Ruby grapefruit [Citrus paradisi (Macf.)] were harvested in November, February, and May, treated with ultraviolet C (UV-C) light at 0.5, 1.5, or 3.0 kJ.m(-)(2), and then stored at 7 degrees C and 90-95% relative humidity (RH) for 4 weeks with 1 additional week at 20 degrees C and approximately 80% RH. Untreated fruits were used as control. UV-C irradiation at 0.5 kJ.m(-)(2) effectively reduced decay development as compared to nontreated fruit without causing damage. Irradiation at dosages >0.5 kJ.m(-)(2) did not further improve decay control and caused rind browning and necrotic peel, the extent of damage depending on treatment dosage and harvest date. The percentage of damaged fruit after irradiation at the higher UV-C dosages was significantly higher in fruit harvested in November; differences between fruits harvested in February and May were negligible. After UV-C irradiation, the phytoalexins scoparone and scopoletin accumulated in flavedo tissue, their amounts depending on harvest date and UV-C dosage. Both phytoalexins showed similar accumulation patterns, although the concentrations of scoparone were much lower than those of scopoletin. Phytoalexin levels increased in most samples as the treatment dosage increased. No detectable levels of scoparone and scopoletin could be found in nonirradiated fruit. The influence of UV-C treatments on soluble solids concentration and titratable acidity of juice was negligible.

The far ultraviolet C (UVC) light sources based on carbon nanotube (CNT) field emitters as excitation sources have become promising light sources for sterilization, disinfection, and water purification. However, the low light extraction efficiency of UVC–CNT light sources still hinders the practical application of these structures. Herein, we report an optimized aluminum (Al) reflector to enhance the light extraction efficiency of UVC–CNT light sources. Optical analysis of UVC-CNT light sources covered by the Al reflectors with various thicknesses ranging from 30 to 150 nm was performed to realize the optimized reflector. The UVC-CNT light sources exhibit the highest light extraction efficiency when the Al reflector layer has an optimized thickness of 100 nm. For comparison, the cathodoluminescence (CL) spectra were recorded for UVC–CNT light sources with and without the optimized Al reflector. The measured light output power and the estimated power efficiency of the UVC–CNT light-source-tube with Al reflector were enhanced by about 27 times over the reference. This enhancement is mainly attributed to the outstanding reflection effect of the Al reflector.

Assessment of microbiological status of liquid pasteurized egg products produced in Romania

Ultraviolet-C inactivation of Escherichia coli O157:H7, Listeria monocytogenes, Pseudomonas aeruginosa, and Salmonella enterica in liquid egg white

Effective ultraviolet-C (UV-C) decontamination protocols of N95 respirators require validation that the entire N95 surface receives sufficient dose. Photochromic indicators (PCIs) can accurately measure UV-C dose on nonplanar surfaces, but often saturate below doses required to decontaminate porous, multilayered textiles like N95s. Here, we investigate the use of optical attenuators to extend PCI dynamic range while maintaining a near-ideal angular response-critical for accurate measurements of uncollimated UV-C. We show analytically that tuning attenuator refractive index, attenuation coefficient, and thickness can extend dynamic range, but compromises angular response unless the attenuator is an ideal diffuser. To investigate this tradeoff empirically, we stack PCIs behind model specular (floated borosilicate) and diffuse (polytetrafluoroethylene) attenuators, characterize the angular response, and evaluate on-N95 UV-C measurement accuracy within a decontamination system. Both attenuators increase PCI dynamic range >4×, but simultaneously introduce angle-dependent transmittance, which causes location-dependent underestimation of UV-C dose. PCI-borosilicate and PCI-polytetrafluoroethylene stacks underreport true on-N95 dose by (1) 14.7% and 3.6%, respectively, when near-normal to the source lamp array, and (2) 40.8% and 19.8%, respectively, in a steeply sloped location. Overall, we demonstrate that while planar attenuators can increase PCI dynamic range, verifying near-ideal angular response is critical for accurate UV-C measurements.

In this paper, the pain point that cold chain transportation urgently needs for an efficient disinfection method is pointed out. Thus, this work aims at solving the problems and improving the disinfection efficiency in cold chain transportation. While Ultraviolet-C (UVC) irradiation is an effective method by which to kill viruses, it is difficult to apply the commonly used UVC-LED disinfection light source to ice-covered cold chain transportation due to its uneven light field distribution. Thus, the light field regulation of UVC-LED disinfection for cold chain transportation is studied. A UVC-LED chip with a wavelength of 275 nm was used as a light source, and parallel light was obtained by collimating lenses. Then, microlens array homogenization technology was used to shape the UVC light into a uniform light spot, with an energy space uniformity rate of 96.4%. Moreover, a simulation was conducted to compare the effects of the ice layer on the absorption of UVC light. Finally, an experiment was carried out to verify that the disinfection efficiency can be increased nearly by 30% with the proposed system by disinfecting E. coli (Escherichia coli), and the results indicate that the proposed system is an effective disinfection solution during cold chain transportation.

The global coronavirus disease (COVID-19) pandemic of 2020 caused by SARS-CoV-2 resulted in a shortage of filtering facepiece respirators (FFRs), such as N95 and KN95 masks. Ultraviolet-C (UV-C) irradiation has been proposed as a potential decontamination method to enable FFR reuse and mitigate the shortage. This study aims to evaluate the impact of UV-C irradiation on the filtration efficiency (FE) of various FFR types and SARS-CoV-2 RNA degradation. We evaluated the effect of UV-C irradiation (60-900 mJ/cm2) on the FE using various particle sizes (PSs, 0.3-5 μm) representing seven common FFR types (3M-8210, 3M-1860, Gerson 1730, Medline, Benehal, KN95 "duck shape," and KN95 "molded shape") and the stability of the SARS-CoV-2 RNA genes (E, RdRp2, RdRp4, and N) using reverse transcription quantitative real-time polymerase chain reaction (RT-qPCR). Following UV-C exposure, the FE of the FFRs at all PSs was >98%, with no significant differences among them (p > 0.05). UV-C irradiation significantly increased the RT-qPCR cycle threshold values (ΔCt) for the E, RdRp2, and RdRp4 SARS-CoV-2 genes (p ≤ 0.001) compared with the control, indicating marked RNA degradation; however, it did not significantly affect N gene stability (p = 0.612). These results support the use of UV-C as an effective decontamination technique for FFRs, particularly during periods of shortage.

Combined ultraviolet-C and modified atmosphere packaging treatments for reducing microbial growth of fresh processed lettuce