A Low-Complexity Universal Scheme for Rate-Constrained Distributed Regression Using a Wireless Sensor Network

Sensor nodes in Wireless Sensor Networks (WSNs) operate with limited power resources such as small batterieswhich are difficult to be either recharged or replaced in some environments when depleted. Power consumptionrepresents one of the most constraints impact the design of WSNs, leading to various protocols and algorithmsaimed at minimizing the power consumption and extending batteries' lifetime. Sensor nodes in WSNs transmittheir periodic packets continuously to central nodes (receivers) which are responsible for decoding packets andtransmitting them to other communication networks. In addition, sensors usually follow various MAC strategieswhich allow accessing to wireless communication channels. However, sensors may attempt to access thewireless channels at the same time, potentially, leading to collisions among multiple nodes. In fact, central nodesin WSNs most often consume a large amount of power due to the necessity to decode every received packetregardless of the fact that the transmission may suffer from packets collision which impede the networkperformance. Therefore, in the receiver side of WSNs current collision detection mechanisms have largely beenrevolving around direct demodulation and decoding of received packets and deciding on a collision based onsome form of parity bits in each packet for error control. From information theoretic prospective full decoding ofreceived packets with error control bits at central nodes can achieve an efficient usage of network capacity,however, such an approach represents a major burden on power-constrained sensors. This drawback comes fromthe need to expend a significant amount of energy and processing complexity at sink nodes in order tofully-decode a packet, only to discover the packet is illegible due to a collision. In this paper, we propose a morepractical power saving approaches which achieve a significant power saving with low-complexity at the expenseof low throughput losses. Based on studying the statistics of received packets, central nodes can make a fastdecision to detect a collision without the need for full-decoding of the whole received packets. Our novelapproaches not only reduces processing complexity and hence power consumption, but it also reduces the delayincurred to detect a collision since it operates on only a small number of IQ samples in the beginning of areceived packet. In such a paradigm, our approaches operate directly at the output of the receiver’sAnalog-to-Digital-Converter (ADC) and eliminate the need to pass the corrupted packets through the entiredemodulator/decoder line-up. The performance gain of our proposed approach is illustrated through thecomparison between the computational complexity of our Statistical Discrimination (SD) approaches and someexisting Full Decoding (FD) algorithms(note 1). Our results show that the SD approaches has significant powersavings and low computational complexities over existing FD algorithms with low False-Alarm and Missprobabilities, which qualify our SD approaches to be considered as reliable collision detection mechanisms inWSNs. We also show how to tune various design parameters in order to allow a system designer multipledegrees of freedom for design trade-offs and optimization.

In this paper, we study two problems of providing reliable data transmission and developing aggregation techniques for correlated data in wireless sensor networks. A system with forward error correction (FEC) can provide an objective reliability while using less transmission power than a system without FEC. Because of the additional parity bits and encoding/decoding energy consumptions, we study the effect of FEC on energy efficiency. We propose to use LDPC codes for FEC. We show that wireless sensor networks using LDPC codes are almost 45% more energy efficient than those that use BCH codes, which were shown to be 15% more energy efficient than the best performing convolutional codes. Then we study the problem of providing aggregation for two and three correlated nodes in wireless sensor networks. We propose to use LDPC codes in wireless sensor networks for source and channel coding to obtain a two-fold energy savings. For two correlated nodes, we study both distributed source coding and joint source-channel coding. While distributed source coding using LDPC codes was studied before, joint source-channel coding using LDPC codes is introduced for the first time. The difference between our work in distributed source coding using LDPC codes and the previous work lies in the LDPC code design procedure. The simulation results show that our proposed design criteria improves the performance of the source coding. The convergence of the non-uniform LDPC code of our design technique is almost 60% closer to the Slepian-Wolf limit. For three correlated nodes, we study distributed source coding using LDPC codes. We simplified the problem of design procedure to randomly punctured LDPC codes. This is a new approach for designing LDPC codes and the simulation results for code of length 1000 shows that the convergence of the LDPC code is achieved at compression rate 0.3174 which is only 0.08 away from the Slepian-Wolf limit.

Background and Objectives: Routing and data aggregation are two important techniques for reducing communication cost of wireless sensor networks (WSNs). To minimize communication cost, routing methods can be merged with data aggregation techniques. Compressive sensing (CS) is one of the effective techniques for aggregating network data, which can reduce the cost of communication by reducing the amount of routed data to the sink. Spatiotemporal CS (STCS), with the use of spatial and temporal correlation of sensor readings, can increase the compression rate in WSNs, thereby reducing the cost of communication. Methods: In this paper, a new method of STCS technique based on the geographic adaptive fidelity (GAF) protocol is proposed which can effectively reduce the communication cost and energy consumption in WSNs. In the proposed method, temporal data is obtained from random selection of temporal readings of cluster head (CH) sensors located in virtual cells in the clustered sensors' area and spatial data will be formed from the data readings of CHs located on the routes. Accordingly, a new structure of sensing matrix will be created. Results: The results of proposed method show that the proposed method as compared to the method proposed in ‎[29], which is the most similar method in the literature, reduces energy consumption in the range of 22% to 43% in various scenarios which were implemented based on the number of required measurements at the sink (M) and the number of measurements in the routes (mr). Conclusion: In the proposed method, based on spatio-temporal CS (STCS), a new structure of sensing matrix is created that can increase the compression rate, thereby reducing the communication cost in the WSNs.======================================================================================================Copyrights©2018 The author(s). This is an open access article distributed under the terms of the Creative Commons Attribution (CC BY 4.0), which permits unrestricted use, distribution, and reproduction in any medium, as long as the original authors and source are cited. No permission is required from the authors or the publishers.======================================================================================================

A scheme for WSNs (wireless sensor networks) security is given by dividing sensing tetrahedron into clusters and using the symmetric polynomials in this paper.The sensing tetrahedron is divided into a number of small grids.All those sensor nodes, both ordinary sensor nodes and heterogeneous sensor nodes are distributed in the sensing tetrahedron.In a grid, all ordinary sensor nodes and heterogeneous sensor nodes establish their shared keys through using the symmetric polynomials.All the heterogeneous sensor nodes establish their shared keys through using the symmetric polynomials.At last, all sensor nodes establish their keys directly or indirectly in the whole sensing tetrahedron.Analysis and comparison demonstrate this scheme enhances the WSN security, has good network connectivity, saves node storage, reduces network computing load, and extends the network lifetime.

Studies the asymptotic characteristics of uniform scalar quantizers that are optimal with respect to mean-squared error (MSE). When a symmetric source density with infinite support is sufficiently well behaved, the optimal step size /spl Delta//sub N/ for symmetric uniform scalar quantization decreases as 2/spl sigma/N/sup -1/V~/sup -1/(1/6N/sup 2/), where N is the number of quantization levels, /spl sigma//sup 2/ is the source variance and V~/sup -1/(/spl middot/) is the inverse of V~(y)=y/sup -1/ /spl int//sub y//sup /spl infin// P(/spl sigma//sup -1/X>x) dx. Equivalently, the optimal support length N/spl Delta//sub N/ increases as 2/spl sigma/V~/sup -1/(1/6N/sup 2/). Granular distortion is asymptotically well approximated by /spl Delta//sub N//sup 2//12, and the ratio of overload to granular distortion converges to a function of the limit /spl tau//spl equiv/lim/sub y/spl rarr//spl infin//y/sup -1/E[X|X>y], provided, as usually happens, that /spl tau/ exists. When it does, its value is related to the number of finite moments of the source density, an asymptotic formula for the overall distortion D/sub N/ is obtained, and /spl tau/=1 is both necessary and sufficient for the overall distortion to be asymptotically well approximated by /spl Delta//sub N//sup 2//12. Applying these results to the class of two-sided densities of the form b|x|/sup /spl beta//e(-/spl alpha/|x|/sup /spl alpha//), which includes Gaussian, Laplacian, Gamma, and generalized Gaussian, it is found that /spl tau/=1, that /spl Delta//sub N/ decreases as (ln N)/sup 1//spl alpha///N, that D/sub N/ is asymptotically well approximated by /spl Delta//sub N//sup 2//12 and decreases as (ln N)/sup 2//spl alpha///N/sup 2/, and that more accurate approximations to /spl Delta//sub N/ are possible. The results also apply to densities with one-sided infinite support, such as Rayleigh and Weibull, and to densities whose tails are asymptotically similar to those previously mentioned.

Connected dominated subsets (CDS) of nodes in wireless sensor network are always selected to form a virtual backbone. Construction of r-hop 2-connected dominating sets can reduce the size of CDS and the total amount of information to be transmitted. The 2-connected properties can provide higher fault tolerance and robustness as well. In this paper an approximation r-hop 2-connected dominating set algorithm for wireless sensor and ad-hoc networks is presented. The main strategy is partition to three phases: in the first phase, an r-hop independent dominating set is established; in the second phase, the r-hop dominating set is interconnected successively to form a connected subgraph; in the third phase, more vertices are selected and added into dominating set to make it 2-connected. Extensive simulations according to the algorithm steps have been conducted. Performance with detailed analysis has been shown at last.

A novel method for optimizing energy consumption in wireless sensor network using genetic algorithm

Trust and reputation systems have been regarded as a powerful tool to defend against insider attacks caused by the captured nodes in wireless sensor networks (WSNs). However, trust systems are vulnerable to on-off attacks, in which malicious nodes can opportunistically behave good or bad, compromising the network with the hope that bad behavior will be undetected. Thus, malicious nodes can remain trusted while behaving badly. In this paper, we propose O2Trust, On-Off attack mitigation for Trust systems in wireless sensor networks. O2Trust adopts the penalty policy against the misbehavior history of each node in the network as a reliable factor that should influence on the calculation of the trust value. This punishment future helps to perceive malicious node that aim to launch intelligent attacks against trust-establishment and consequently on-off attack is mitigated efficiently.

Enhancing the availability of wireless visual sensor networks: Selecting redundant nodes in networks with occlusion

The sensor nodes are independent and work as sender, receiver and intermediate node in Wireless Sensor Network (WSN). The sensor nodes are forming the small network in which the one or more sender is sending data to one destination/s through intermediate nodes or sending information to Base Station (BS). The information collect by base station is further analyzed. The nodes are also static or mobile depends on the situation or conditions. The connection establishment and data sending is possible through routing protocols of WSN. The routing protocols of WSN are not same as traditional wireless routing protocols. One major issue on this network is security. The routing protocols are sending information to destination from particular source and the routing strategy is provides the better way of delivery in the network. The sensor nodes in network are performing through limited battery supply called node energy or power. The attacker are also affected the limited energy resource. In this paper the center of consideration is on the security issues related to WSN routing protocols. The routing in WSN remains a key issue because of that without accurately functioning of routing protocols, the network cleanly will not work the technique it's intended to. Unfortunately, routing also one of the most difficult to protect against attacks malicious activities because of the administration in WSN. The better protection scheme is provides the complete security from attacks and the secure routing is provides the better and trustful network performance.

A Resiliency-Connectivity metric in wireless sensor networks with key predistribution schemes and node compromise attacks

Wireless sensor network is an area in wireless computing research which has been receiving a lot of attention recently. This can be mainly attributed to the huge number of potential applications of a wireless sensor network. As wireless sensor networks are primarily employed for sensing tasks, the architecture of the node in the network is fairly simple making them more energy efficient. This is where the main shortcoming of a wireless sensor network is. Due to the simple architecture it is difficult to ensure security in a wireless sensor network, as security protocols need to be lightweight enough to meet the energy constraints of the nodes. This is where this paper comes up with a proposal to enhance an already existing protocol to improve both the security and efficiency of the wireless sensor network. Keywords: Wireless Sensor Networks; Authentication; Security; Sensor Network Architecture; Clustering

Profiling environmental parameter using a large number of spatially distributed wireless sensor network (WSN) NODEs is an extensive illustration of advanced modern technologies, but high power requirement for WSN NODEs limits the widespread deployment of these technologies. Currently, WSN NODEs are extensively powered up using batteries, but the battery has limitation of lifetime, power density, and environmental concerns. To overcome this issue, energy harvester (EH) is developed and presented in this paper. Solar-based EH has been identified as the most viable source of energy to be harvested for autonomous WSN NODEs. Besides, a novel chemical-based EH is reported as the potential secondary source for harvesting energy because of its uninterrupted availability. By integrating both solar-based EH and chemical-based EH, a hybrid energy harvester (HEH) is developed to power up WSN NODEs. Experimental results from the real-time deployment shows that, besides supporting the daily operation of WSN NODE and Router, the developed HEH is capable of producing a surplus of 971 mA·hr equivalent energy to be stored inside the storage for NODE and 528.24 mA·hr equivalent energy for Router, which is significantly enough for perpetual operation of autonomous WSN NODEs used in environmental parameter profiling.

Herein, an Internet of Things (IoT) system with remote reconfigurable wireless sensor network (WSN) nodes is presented and its application to measure group work activity in a classroom is discussed. This IoT system consists of wiki pages, bots, (defined as remotely controlled devices), gateways, and remotely reconfigurable WSN Nodes. The bots/gateways and WSN nodes of the IoT system are controlled by scripts written on wiki pages that are read by the bot/gateways, which then forward the commands contained in the scripts to the WSN nodes. Each WSN node then executes the commands, obtains the resulting sensor values, and then returns those values to the bot/gateways. The bot/gateways relay the values and write them onto the wiki page. Each WSN node is flexible and reconfigurable because its behavior can be changed by the script commands written onto the wiki page. Using this IoT system, we created a measurement system to evaluate activity levels of group work in a classroom. After developing the measurement system, we found it was possible to adjust the sampling rate for obtaining sensor values simply by rewriting the script on the wiki page without directly manipulating the WSN.

Wireless sensor networks (WSN) are large scale networks of sensors running on wireless environment. For an application running on a WSN, gathered data by the sensors are time critical in most of the cases. However, almost all the nodes suffer from a problem named clock drift. This problem causes clock difference among nodes as time goes because the processors do not run exactly at the same speed. There are many proposed solutions to remedy this problem. TPSN (timing-sync protocol for sensor networks) is one of the effective protocols proposed to synchronize sensor networks. In this paper, we propose enhancements over TPSN to synchronize nodes in a wireless sensor network more effectively with a lower message complexity and higher precision.