- Research Article
24
- 10.1016/0010-4655(89)90157-4
Applications of the Lanczos method
- May 01, 1989
- Computer Physics Communications
- B Nour-Omid
Applications of the Lanczos method
A self-consistent one-dimensional two-fluid model of the magnetized plasma-wall transition is presented. The model includes magnetic field, elastic collisions between ions and electrons, and creation/annihilation of charged particles. Two systems of differential equations are derived. The first system describes the whole magnetized plasma-wall transition region, which consists of the pre-sheath, the magnetized pre-sheath (Chodura layer), and the sheath, which is not neutral, but contains a positive space charge. The second system of equations describes only the neutral part of the plasma-wall transition region—this means only the pre-sheath and the Chodura layer, but not also the sheath. Both systems are solved numerically. The first system of equations has two singularities. The first occurs when ion velocity in the direction perpendicularly to the wall drops below the ion thermal velocity. The second occurs when the electron velocity in the direction perpendicularly to the wall exceeds the electron thermal velocity. The second system of differential equations only has one singularity, which has also been derived analytically. For finite electron to ion mass ratio, the integration of the second system always breaks down before the Bohm criterion is fulfilled. Some properties of the first system of equations are examined. It is shown that the increased collision frequency demagnetizes the plasma. On the other hand, if the magnetic field is so strong that the ion Larmor radius and the Debye length are comparable, the electron velocity in the direction perpendicularly to the wall reaches the electron thermal velocity before the ion velocity in the direction perpendicularly to the wall reaches the ion sound velocity. In this case, the integration of the model equations breaks down before the Bohm criterion is fulfilled and the sheath is formed.
Applications of the Lanczos method
Applications of the Lanczos method
CHAPTER 9 - SYSTEMS OF DIFFERENTIAL EQUATIONS
CHAPTER 9 - SYSTEMS OF DIFFERENTIAL EQUATIONS
Scaling of a System of Linear Differential Equations
The purpose of this paper is to derive a means of scaling the dependent variables of a system of linear differential equations so that the normalized system accurately reflects the dependence of the system on initial data. The theory is developed for the special case of a system of first order hyperbolic partial differential equations in two independent variables. Several other systems of differential equations, to which the same normalization could be applied, are also indicated. The scaling is equivalent to row and column scaling commonly used in linear algebra. For the case of positive matrices (that is, for the case where the diagonalizing matrix and its inverse have no zero elements), the theory for the “1” and “$\infty $ ” norms has been thoroughly developed by Bauer [1]. The assumption of positive matrices is too stringent for some applications. Thus, the theory is generalized to show that for irreducible matrices a best scaling exists (for both the “1” and “ $\infty $” norms), while for simply reducible matrices a best scaling exists for at least one of these two norms. Several examples are given.
Read moreEnergy loss and multiple scattering of light ions in dense and strongly magnetized plasma
Energy loss and multiple scattering of light ions in dense and strongly magnetized plasma
ДОСЛІДЖЕННЯ НЕСТАЦІОНАРНИХ СИСТЕМ АВТОМАТИЧНОГО КЕРУВАННЯ ІЗ ЗАПІЗНЕННЯМ
We considered a non-stationary optimal control system with delay. Non-stationary optimal control systems are described by systems of differential or differential-algebraic equations. Variable coefficients do not allow, in general, to construct a solution to such systems in quadratures. Numerical or asymptotic methods are used to solve such systems. In this paper, asymptotic methods are used, in particular, the Feshchenko-Shkil' method for integrating of singularly perturbed systems and the Wasow’s method for systems with an unstable spectrum. In this paper, we construct a transformation that reduces the optimal delay control system to a system that does not contain terms without delay. This transformation makes it possible to integrate the system by the method of steps without solving systems of differential equations at each step. The system of equations obtained as a result of the transformation of the original system is somewhat easier to study in terms of building a solution. However, the problem of optimizing the control of both systems requires both a separate mathematical study and clarification of the practical reality of spectrum instability in such systems. If the instability of the spectrum is caused by the degeneracy of the main matrix, this leads to the unboundedness of the system solution as the small parameter approaches zero. The aforementioned growth of the solution can create emergency situations in real systems. Future research concerns solving the problem of optimal control of systems with an unstable spectrum and studying the question of the reality and physical meaning of turning points in specific systems. In future studies, it is also planned to construct an asymptotic representation of the solution of a control system with delays and degeneracies. Keywords: optimal control system, systems of differential equations with delay, asymptotic solution, turning point.
Read moreEXPLICIT FIFTH-ORDER HYBRID METHODS FOR DYNAMICAL SYSTEMS WITH DELAY
In the paper we consider the systems of delay differential equations, which are mathematical models of many technical processes with delay in time. An explicit fifth-order hybrid method for systems of delay differential equations for the variable step of numerical integration is constructed. This algorithm is based on the most commonly used explicit fifth-order Runge-Kutta methods for ordinary systems of differential equations and the construction of Newton polynomials for the prehistory of the model and Taylor formula. The basic principles of construction of such explicit hybrid methods of higher orders of convergence are given. An accurate estimate of the local error of numerical integration by this method is obtained. This algorithm allows the use of numerical integration steps greater than the magnitude of the delay or procedures for adjusting the magnitude of the step depending on the calculation error. Such a problem of numerical integration of time-delay dynamical systems occurs when the time interval is large enough compared to the delay. Implicit continuous Runge-Kutta methods were previously used for numerical integration such problems, which complicated the numerical algorithm, because nonlinear systems of equations have to be solved at each step of numerical integration. The explicit hybrid method constructed by us for systems of delay differential equations is convenient for programming, has a high speed of calculation of numerical solution, in comparison with implicit methods for such models of problems. Also, this method has no restrictions on the magnitude of the delay, in contrast to the hybrid methods with decomposition in Taylor series for delay. The method obtained by us can be used to construct maps of dynamic modes in the study of regular and chaotic behavior of time-delay dynamical systems.
Read moreNumerical use of {[formula omitted]}-approximation method thermoelastic anisotropic thin shell theory equations represented in a special form
Numerical use of {[formula omitted]}-approximation method thermoelastic anisotropic thin shell theory equations represented in a special form
Read moreAn approach to solutions of systems of linear partial differential equations with applications
An approach to solutions of systems of linear partial differential equations with applications
SYSTEM CONTROL IN CONDITIONS OF FUZZY DYNAMIC PROCESSES
In this article, a mathematical model of controlling the system in conditions of fuzzy processes is presented. Such a system can also be a power supply system. Analytical approaches that can be used to describe the mutual impact of output and stocks (additional capacities) on hierarchically distributed occurrence/usage/variation or demand already exist. We add dynamics to the system with the use of continuous and discrete dynamic processes, which are of a random (stochastic) form. The dynamic discrete model of control for this system is built with a system of difference equations, and the dynamic continuous model is built with a system of differential equations. These systems of equations can be solved with a one-part z-transform in discrete situations in with Laplace transform in the continuous systems. Fuzzy system control follows a continuous and discrete stochastic mathematical closed-loop model of control of stocks (additional capacities) in production systems. The fuzzy model is demonstrated with a numerical example.
Read moreA variable gravity model of the otolith membrane
A variable gravity model of the otolith membrane
A fast implicit iterative numerical method for solving multidimensional partial differential equations
A new technique for solving the large system of linear algebraic equations associated with implicit differencing of multidimensio nal partial differential equations is presented. The coefficient matrix of the equations is factored, and then approximations to certain terms in the matrix are obtained from series expansions. The resulting system of equations is solved easily. The method is developed and demonstrated using a simple representative two-dimensional equation. Very good results are obtained when one direction is dominant. MPLICIT finite-difference schemes for the solution of multidimensional partial differential equations are usually stable and therefore applicable to a large class of problems. However, they are difficult to implement and may require an excessive amount of computer storage and time. The long computing time arises from the need to solve the large system of linear algebraic equations that result from the differencing. The computing time can be reduced significantly by approximating the coefficient matrix of the linear equations with a matrix that produces a system of equations that are relatively easy to solve. Among such methods are the alternating direction method (ADI)l used by Beam and Warming2 and Stone's strongly implicit method,3 which has been tested by Linetal.4 In this paper, a new technique for solving the large system of linear algebraic equations associated with implict differencing of multidimensional partial differential equations is presented. This method, called the pseudo-elimination method (PE), is shown to be faster than Stone's method for certain problems. The method is directly applicable to linear and linearized nonlinear systems of parabolic or elliptic partial differential equations. In order to discuss the method, a simple linear partial differential equation will be used; however, it should be kept in mind that the PE method is applicable to much more complicated problems. The question of whether the method will work when applied to difficult problems is not addressed. The scope of this paper is limited to presenting the method and illustrating, via a simple problem, that the method has some merit and deserves further study.
Read moreIntroduction to the theory and application of a unified Bohm criterion for arbitrary-ion-temperature collision-free plasmas with finite Debye lengths
At present, identifying and characterizing the common plasma–sheath edge (PSE) in the conventional fluid approach leads to intrinsic oversimplifications, while the kinetic one results in unusable over-generalizations. In addition, none of these approaches can be justified in realistic plasmas, i.e., those which are characterized by non-negligible Debye lengths and a well-defined non-negligible ion temperature. In an attempt to resolve this problem, we propose a new formulation of the Bohm criterion [D. Bohm, The Characteristics of Electrical Discharges in Magnetic Fields (McGraw-Hill, New York, 1949)], which is here expressed in terms of fluid, kinetic, and electrostatic-pressure contributions. This “unified” Bohm criterion consists of a set of two equations for calculating the ion directional energy (i.e., the mean directional velocity) and the plasma potential at the common PSE, and is valid for arbitrary ion-to-electron temperature ratios. It turns out to be exact at any point of the quasi-neutral plasma provided that the ion differential polytropic coefficient function (DPCF) of Kuhn et al. [Phys. Plasmas 13, 013503 (2006)] is employed, with the advantage that the DPCF is an easily measurable fluid quantity. Moreover, our unified Bohm criterion holds in plasmas with finite Debye lengths, for which the famous kinetic criterion formulated by Harrison and Thompson [Proc. Phys. Soc. 74, 145 (1959)] fails. Unlike the kinetic criterion in the case of negligible Debye length, the kinetic contribution to the unified Bohm criterion, arising due to the presence of negative and zero velocities in the ion velocity distribution function, can be calculated separately from the fluid term. This kinetic contribution disappears identically at the PSE, yielding strict equality of the ion directional velocity there and the ion sound speed, provided that the latter is formulated in terms of the present definition of DPCFs. The numerical values of these velocities are found for the Tonks–Langmuir collision-free, plane-parallel discharge model [Phys. Rev. 34, 876 (1929)], however, with the ion-source temperature extended here from the original (zero) value to arbitrary high ones. In addition, it turns out, that the charge-density derivative (in the potential “space”) with respect to the potential exhibits two characteristic points, i.e., potentials, namely the points of inflection and maximum of that derivative (in the potential space), which stay “fixed” at their respective potentials independent of the Debye length until it is kept fairly small. Plasma quasi-neutrality appears well satisfied up to the first characteristic point/potential, so we identify that one as the plasma edge (PE). Adopting the convention that the sheath is a region characterized by considerable electrostatic pressure (energy density), we identify the second characteristic point/potential as the sheath edge (SE). Between these points, the charge density increases from zero to a finite value. Thus, the interval between the PE and SE, with the “fixed” width (in the potential “space”) of about one third of the electron temperature, will be named the plasma–sheath transition (PST). Outside the PST, the electrostatic-pressure term and its derivatives turn out to be nearly identical with each other, independent of the particular values of the ion temperature and Debye length. In contrast, an increase in Debye lengths from zero to finite values causes the location of the sonic point/potential (laying inside the PST) to shift from the PE (for vanishing Debye length) towards the SE, while at the same time, the absolute value of the corresponding ion-sound velocity slightly decreases. These shifts turn out to be manageable with employing the mathematical concept of the plasma-to-sheath transition (different from, but related to our natural PST concept), resulting in approximate, but sufficiently reliable semi-analytic expressions, which are functions of the ion temperature and Debye length.
Read moreExact solutions of some nonlinear systems of partial differential equations by using the first integral method
Exact solutions of some nonlinear systems of partial differential equations by using the first integral method
Electrostatic Charging of Lunar Cavities Governed by the Flow‐to‐Thermal Speed Ratio: 3D PIC Simulations and a Free‐Fall Model
We use Particle‐In‐Cell (PIC) simulations to investigate the charging characteristics inside deep cavities on the lunar surface under the solar wind plasma conditions. Specifically, we systematically study the dependence of the cavity bottom potential on plasma flow velocity and cavity aspect ratio. In light of prior results indicating that the charging characteristics are predominantly determined by the cavity aspect ratio, the present analysis employs a rectangular shape for the cavity with a width smaller than the local Debye length. Three flow regimes are then defined according to the ordering among the bulk flow velocity () and the ion thermal velocity () and the electron thermal velocity (); low (), medium (), and high (). Accordingly, the charging characteristics differ across the regimes. In the low‐flow velocity regime, the influx of electrons dominates over the influx of ions, resulting in the development of a negative potential at the bottom. In the medium‐flow velocity regime, most electrons are lost to the side walls, while ions tend to reach the bottom. This results in the development of a positive potential at the cavity bottom. In the high‐flow velocity regime, the influx of ions saturates while the influx of electrons becomes comparable to that of ions, resulting in the bottom potential converging to zero. These results provide significant insight into the electrostatic environment related to the complex morphology of the lunar surface, formed as a result of interactions with the space plasma.
Read moreOn symmetries and exact solutions of the Einstein–Maxwell field equations via the symmetry approach
Using the Lie symmetry approach, we have examined herein the system of partial differential equations corresponding to the Einstein–Maxwell equations for a static axially symmetric spacetime. The method used reduces the system of partial differential equations to a system of ordinary differential equations according to the Lie symmetry admitted. In particular, we found the relevant system of ordinary differential equations is all optimal subgroups. The system of ordinary differential equations is further solved in general to obtain exact solutions. Several new physically important families of exact solutions are derived.
Read more