A Study on Wind Power Prediction Based on Machine Learning Methods and Climate Character Analysis

The continuous increase in energy consumption has made the potential of wind-power generation tremendous. However, the obvious intermittency and randomness of wind speed results in the fluctuation of the output power in a wind farm, seriously affecting the power quality. Therefore, the accurate prediction of wind power in advance can improve the ability of wind-power integration and enhance the reliability of the power system. In this paper, a model of wavelet decomposition (WD) and weighted random forest (WRF) optimized by the niche immune lion algorithm (NILA-WRF) is presented for ultra-short-term wind power prediction. Firstly, the original serials of wind speed and power are decomposed into several sub-serials by WD because the original serials have no obvious day characteristics. Then, the model parameters are set and the model trained with the sub-serials of wind speed and wind power decomposed. Finally, the WD-NILA-WRF model is used to predict the wind power of the relative sub-serials and the result is reconstructed to obtain the final prediction result. The WD-NILA-WRF model combines the advantage of each single model, which uses WD for signal de-noising, and uses the niche immune lion algorithm (NILA) to improve the model’s optimization efficiency. In this paper, two empirical analyses are carried out to prove the accuracy of the model, and the experimental results verify the proposed model’s validity and superiority compared with the back propagation neural network (BP neural network), support vector machine (SVM), RF and NILA-RF, indicating that the proposed method is superior in cases influenced by noise and unstable factors, and possesses an excellent generalization ability and robustness.

Wind power prediction accuracy is closely related to the quality of wind power data. However, most of traditional prediction methods do not consider the cybersecurity of raw data. So, it would be important to study the prediction accuracy under false data injection attack (one type of cybersecurity attacks) and its influence on the economy and security of power system. In this paper, very short-term forecasting approach of wind power generation is studied for choosing the optimal prediction model. Different scenarios of false data injection attack are then simulated upon wind power data. Wind power prediction accuracy after being affected by false data injection is observed. The robustness of wind power prediction model is evaluated. Finally, wind power prediction information is applied to day-ahead unit commitment to evaluate the impact of cybersecurity of wind power forecasting on power system economy and security.

With the gradual warming of the global climate, wind energy, as one of the representatives of clean energy, has been rapidly developed in countries worldwide. However, wind power generation has strong intermittency and variability, constantly impacting the stability of the power grid. In order to improve the accuracy of wind power prediction, this paper proposes a BP neural network model optimized by genetic algorithm (GA) for wind power prediction. This model uses GA to optimize the initial weights and thresholds of the BP neural network to improve the computational accuracy and convergence speed of the model, effectively avoiding the problem of a single BP neural network model easily falling into local minima and the slow training speed of GA algorithm. By preprocessing and normalizing meteorological data such as weather, temperature, and wind direction, a wind power prediction model is constructed, and the prediction results show that the model effectively improves the computational accuracy and convergence speed compared to the traditional BP neural network model. This result proves the feasibility of using GA to optimize BP neural network for wind power prediction in this paper.

With the rapid development of wind energy, the imperative for precise wind power predictions has intensified, with the crux lying in forecasting wind speeds. The accurate short-term (1 to 3 days) forecast of wind speeds at the hub height in boundary layer poses a significant scientific challenge. Generating such forecasts for wind farms 1 to 3 days in lead time necessitates reliance on global weather forecast products and the WRF model. In pursuit of heightened accuracy, artificial intelligence (AI) algorithms are employed to refine WRF-predicted wind speeds based on observational data. This study draws upon observational data from five operational wind farms over three years, employing diverse deep time-series models, to examine the effectiveness and limitations of these models in post-processing corrections for WRF-predicted wind speeds. Based on our examination, we conclude that: 1) Transformer-based models have significant untapped potential, with the Pyraformer model emerging as a well-suited temporal model for post-processing corrections in wind speed and power predictions. 2) Traditional full-attention mechanisms are less effective, highlighting the importance of sparse attention as a vital approach for capturing temporal correlations in such problems. 3) The optimal model demonstrates a reduction of approximately 20% in RMSE for single-point post-processing corrections. In addition, wind speed prediction accuracy reaches around 86%, and power prediction accuracy is approximately 82%. 4) AI-based post-processing corrections may encounter challenges, including the underestimation for high-value and difficulties in reproducing forecasts below the average value.

Soft sensors have been extensively utilized to approximate real-time power prediction in wind power generation, which is challenging to measure instantaneously. The short-term forecast of wind power aims at providing a reference for the dispatch of the intraday power grid. This study proposes a soft sensor model based on the Long Short-Term Memory (LSTM) network by combining data preprocessing with Variational Modal Decomposition (VMD) to improve wind power prediction accuracy. It does so by adopting the isolation forest algorithm for anomaly detection of the original wind power series and processing the missing data by multiple imputation. Based on the process data samples, VMD technology is used to achieve power data decomposition and noise reduction. The LSTM network is introduced to predict each modal component separately, and further sum reconstructs the prediction results of each component to complete the wind power prediction. From the experimental results, it can be seen that the LSTM network which uses an Adam optimizing algorithm has better convergence accuracy. The VMD method exhibited superior decomposition outcomes due to its inherent Wiener filter capabilities, which effectively mitigate noise and forestall modal aliasing. The Mean Absolute Percentage Error (MAPE) was reduced by 9.3508%, which indicates that the LSTM network combined with the VMD method has better prediction accuracy.

Wind power potential assessment of 12 locations in western Himalayan region of India

Analysis and application of forecasting models in wind power integration: A review of multi-step-ahead wind speed forecasting models

Accurate wind power prediction can reduce the negative impact of wind power on power grid and reduce the operation cost of power system. Wind power forecasting is of great significance in spot trading, but the instability of wind power series brings difficulties to forecasting. With the rapid development of deep learning technology, prediction algorithm based on deep learning has been widely used in wind power prediction. The long short-term memory (LSTM) network performs well in a variety of prediction scenarios, but there is still room for improvement. In order to improve the prediction accuracy of LSTM in wind power prediction, this paper adopts a new gating mechanism in LSTM network, which can improve the context information modeling ability of LSTM network. The experimental results based on real data show that the proposed improved LSTM prediction model can improve the prediction accuracy of LSTM prediction model in ultra-short term wind power prediction scenarios.

Wind power generated by wind has non-schedule nature due to stochastic nature of meteorological variable. Hence energy business and control of wind power generation requires prediction of wind speed (WS) from few seconds to different time steps in advance. To deal with prediction shortcomings, various WS prediction methods have been used. Predictive data mining offers variety of methods for WS predictions where artificial neural network (ANN) is one of the reliable and accurate methods. It is observed from the result of this study that ANN gives better accuracy in comparison conventional model. The accuracy of WS prediction models is found to be dependent on input parameters and architecture type algorithms utilized. So the selection of most relevant input parameters is important research area in WS predicton field. The objective of the paper is twofold: first extensive review of ANN for wind power and WS prediction is carried out. Discussion and analysis of feature selection using Relief Algorithm (RA) in WS prediction are considered for different Indian sites. RA identify atmospheric pressure, solar radiation and relative humidity are relevant input variables. Based on relevant input variables Cascade ANN model is developed and prediction accuracy is evaluated. It is found that root mean square error (RMSE) for comparison between predicted and measured WS for training and testing wind speed are found to be 1.44 m/s and 1.49 m/s respectively. The developed cascade ANN model can be used to predict wind speed for sites where there are not WS measuring instruments are installed in India.

Wind power has been valued by countries for its renewability and cleanness and has become most of the focus of energy development in all countries. However, due to the uncertainty and volatility of wind power generation, making the grid-connected wind power system presents some serious challenges. Improving the accuracy of wind power prediction has become the focus of current research. Therefore, this paper proposes a combined short-term wind power prediction model based on T-LSTNet_markov to improve prediction accuracy. First, perform data cleaning and data preprocessing operations on the original data. Second, forecast using T-LSTNet model in original wind power data. Finally, calculate the error between the forecast value and the actual value. The k-means++ method and Weighted Markov process are used to correct errors and to get the result of the final prediction. The data that are collected from a wind farm in Inner Mongolia Autonomous Region, China, are selected as a case study to demonstrate the effectiveness of the proposed combined models. The empirical results show that the prediction accuracy is further improved after correcting errors.

The electrical energy demand is growing every day. Fossil fuel-based electrical power generation pollutes the environment. So, to fulfil the electrical energy demand, clean renewable energy sources like solar and wind are emerging as viable alternatives. But the amount of power generated from solar and wind energy sources is varying in magnitude and is intermittent in nature. So, predicting solar and wind power generation is indispensable for efficient planning and controlling of a renewable energy system. This paper aims to identify a machine learning model suitable for time-series prediction of wind power and also surveys the predominantly existing machine learning followed by the deep learning approaches. The main objective of this study is to solve a real-life problem in the renewable energy sector by accurately estimating the amount of power generation production per hour by applying machine learning techniques using historical wind power energy production data. Hence, historical wind data set with input parameters like wind speed, wind direction air temperature, pressure, and output parameters of wind power generation is considered for training and testing using mean absolute error for evaluating the prediction accuracy. Layers from simple to complex deep layers are trained and tested for prediction accuracy, i.e. baseline, linear, dense, multidense, convolution neural networks, and long short-term memory. Investigating further, LSTM and Residual LSTM prove to have higher mean absolute prediction accuracy of 0.0987 and 0.0958. This eventually enlightens the wind power forecasting models and new paths for further research applications.

A novel clustering algorithm based on mathematical morphology for wind power generation prediction

Wind power predictions from nowcasts to 4-hour forecasts: A learning approach with variable selection

A new short-term wind power prediction methodology based on linear and nonlinear hybrid models

An integrated development environment based situational awareness for operational reliability evaluation in wind energy systems incorporating uncertainties