Common Clock for GNSS Receivers: Characterization of Parameters Estimated with GNSS Receivers Connected to the Same External High-Precision Clock
Global Navigation Satellite Systems (GNSS) rely on one-way signal travel time measurements from satellites to receivers. To ensure accurate ranging, GNSS must estimate and compensate for clock offsets on at least one end of the transmitter-receiver system. Consequently, clock offsets are highly correlated with GNSS-derived parameters such as station coordinates, tropospheric delay estimates, satellite radial orbit parameters, and apparent geocenter coordinates. Improper handling of clock offsets can lead to their absorption into these parameters, degrading geodetic product accuracy. Traditionally, clocks have been handled within individual techniques without being specially addressed. However, some research efforts and experimental trials have explored using VLBI to synchronize clocks for GNSS and refining clock models to reduce correlations with other estimated parameters in GNSS, thereby improving overall precision.With recent advancements, high-precision optical clocks and fiber-optic time transfer technologies provide new possibilities for enhancing clock synchronization in GNSS. Optical fiber offers a stable, interference-free medium for time and frequency transfer, eliminating atmospheric effects such as ionospheric and tropospheric delays that impact GNSS-based synchronization. Moreover, fiber-optic time transfer is inherently two-way, removing the need for external clock offset estimation. Thus, fiber-optic clock synchronization represents the most precise timing technique currently available. Establishing a common clock by connecting multiple GNSS receivers via optical fiber could significantly reduce the number of estimated clock parameters in GNSS solutions, leading to improved geodetic measurement precision and a more accurate geodetic reference frame.Despite its potential, the approach of implementing a common clock with optical fiber for GNSS receivers remains largely untested. Although optical fiber links have been successfully used in clock synchronization, their integration into GNSS receiver clocking is still in an experimental stage. Notable existing efforts include: (1) the Geodetic Observatory Wettzell, where multiple receivers are connected to a single clock via optical fiber, representing a local baseline setup, and (2) the GFZ experiment, where a receiver is linked to the ultra-stable clock of PTB, representing a regional baseline approach.This study characterizes existing fiber-optic connections among GNSS receivers to identify practical challenges and evaluate their impact on GNSS parameter estimation. We process data from receivers sharing a common clock using Bernese GNSS Software. Initially, PPP will be performed to compare GNSS-derived clock parameters across receivers sharing a common clock, verifying the effectiveness of fiber-optic clock synchronization. Following this validation, we will leverage GNSS-derived clock parameters to evaluate inter-receiver clock differences measured via optical fiber. Subsequently, we will implement a strategy in which only one receiver’s clock parameters are estimated, using fiber-measured clock differences as a priori constraints for other receivers in the PPP solution. This approach reduces the number of estimated clock parameters and serves as a preliminary test of the feasibility of a GNSS common clock framework.Future developments will focus on refining our analysis framework to enable simultaneous estimation of GNSS receivers operating under a common clock. This research contributes to the broader goal of integrating ultra-stable clocks into global GNSS networks, ultimately enhancing the stability of geodetic reference frames and improving GNSS-derived geodetic products.
Read more
10
