Adaptive Fuzzy Optimal Control for Interconnected Switched Nonlinear Systems With Dwell Time

Approaching the problem of optimal adaptive control as ldquooptimal control made adaptive,rdquo namely, as a certainty equivalence combination of linear quadratic optimal control and standard parameter estimation, fails on two counts: numerical (as it requires a solution to a Riccati equation at each time step) and conceptual (as the combination actually does not possess any optimality property). In this note, we present a particular form of optimality achievable in Lyapunov-based adaptive control. State and control are subject to positive definite penalties, whereas the parameter estimation error is penalized through an exponential of its square, which means that no attempt is made to enforce the parameter convergence, but the estimation transients are penalized simultaneously with the state and control transients. The form of optimality we reveal here is different from our work in [Z. H. Li and M. Krstic, ldquoOptimal design of adaptive tracking controllers for nonlinear systems,rdquo <i xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">Automatica</i> , vol. 33, pp. 1459-1473, 1997] where only the terminal value of the parameter error was penalized. We present our optimality concept on a partial differential equation (PDE) example-boundary control of a particular parabolic PDE with an unknown reaction coefficient. Two technical ideas are central to the developments in the note: a nonquadratic Lyapunov function and a normalization in the Lyapunov-based update law. The optimal adaptive control problem is fundamentally nonlinear and we explore this aspect through several examples that highlight the interplay between the non-quadratic cost and value functions.

Adaptive tracking control for a class of switched uncertain nonlinear systems under a new state-dependent switching law

1 A Survey on Computational Optimal Control.- Issues in the Direct Transcription of Optimal Control Problems to Sparse Nonlinear Programs.- Optimization in Control of Robots.- Large-scale SQP Methods and their Application in Trajectory Optimization.- Solving Optimal Control and Pursuit-Evasion Game Problems of High Complexity.- 2 Theoretical Aspects of Optimal Control and Nonlinear Programming.- Continuation Methods In Boundary Value Problems.- Second Order Optimality Conditions for Singular Extremals.- Synthesis of Adaptive Optimal Controls for Linear Dynamic Systems.- Control Applications of Reduced SQP Methods.- Time Optimal Control of Mechanical Systems.- 3 Algorithms for Optimal Control Calculations.- Second Order Algorithm for Time Optimal Control of a Linear System.- An SQP-type Solution Method for Constrained Discrete-Time Optimal Control Problems.- Numerical Methods for Solving Differential Games, Prospective Applications to Technical Problems.- Construction of the Optimal Feedback Controller for Constrained Optimal Control Problems with Unknown Disturbances.- Repetitive Optimization for Predictive Control of Dynamic Systems under Uncertainty.- Optimal Control of Multistage Systems Described by High-Index Differential-Algebraic Equations.- A New Class of a High Order Interior Point Method for the Solution of Convex Semiinfinite Optimization Problems.- A Structured Interior Point SQP Method for Nonlinear Optimal Control Problems.- 4 Software for Optimal Control Calculations.- Automated Approach for Optimizing Dynamic Systems.- ANDECS: A Computation Environment for Control Applications of Optimization.- Application of Automatic Differentiation to Optimal Control Problems.- OCCAL: A mixed symbolic-numeric Optimal Control CALculator.- 5 Applications of Optimal Control.- A Robotic Satellite with Simplified Design.- Nonlinear Control under Constraints of a Biological System.- An Object-Oriented Approach to Optimally Describe and Specify a SCADA System Applied to a Power Network.- Near-Optimal Flight Trajectories Generated by Neural Networks.- Performance of a Feedback Method with Respect to Changes in the Air-Density during the Ascent of a Two-Stage-To-Orbit Vehicle.- Linear Optimal Control for Reentry Flight.- Steady-State Modelling of Turbine Engine with Controllers.- Shortest Paths for Satellite Mounted Robot Manipulators.- Optimal Control of the Industrial Robot Manutec r3.

In this paper, a novel NN-based optimal adaptive consensus-based formation control scheme over finite horizon is presented for networked mobile robots or agents in the presence of uncertain robot/agent dynamics. The uncertain robot formation dynamics are approximated online by using an NN-based identifier and a suitable weight tuning law. In addition, a novel time-varying value function is derived by using the augmented error vector, which consists of the regulation and consensus-based formation errors of each robot. By using the value function approximation and the identified dynamics, the near optimal control input over finite horizon is derived. This finite horizon optimal control leads to a time-varying value function, which becomes the solution of the Hamilton–Jacobi–Bellman equation, and control input is approximated by a second NN with time-varying activation function. A novel weight update law for the NN value function is developed to tune the value function, satisfy the terminal constraint, and relax an initial admissible controller requirement. The Lyapunov stability method is utilized to demonstrate the consensus of the overall formation. Finally, simulation results are given to verify theoretical claims. Copyright © 2015 John Wiley & Sons, Ltd.

In this article, an observer-based fuzzy adaptive inverse optimal output feedback control problem is studied for a class of nonlinear systems in strict-feedback form. The considered nonlinear systems contain unknown nonlinear dynamics and their states are not measured directly. Fuzzy logic systems are applied to identify the unknown nonlinear dynamics and an auxiliary nonlinear system is constructed. Based on this auxiliary system, a fuzzy state observer is first designed to estimate the immeasurable states. By using the inverse optimal principle and adaptive backstepping design theory, an observer-based fuzzy adaptive inverse optimal output feedback control scheme is then developed. The proposed inverse optimal control scheme need not assume that the states are measurable. It also guarantees that the closed-loop system is semiglobally uniformly ultimately bounded, and achieves the optimal control objective as well. Finally, two simulation examples are provided to check the validity of the presented control method.

In this article, we propose an adaptive robust nonlinear optimal sliding mode control (SMC) using the optimal homotopy asymptotic method (RNOSC‐OHAM) for maximizing wind power capture. Because of the unstable nature of the wind and the presence of uncertainties and disturbances in the structure of the wind turbine, the optimal controller cannot provide robustness against uncertainties. Hence, we integrated this approach with a proportional–integral–derivative SMC (PID‐SMC) scheme to ensure the robustness of the system. The presented hybrid control input signal involves two components: a nonlinear optimal control law that provides the optimal performance of the nominal system and an adaptive PID‐SMC law. The adaptive PID‐SMC law employs a PID sliding surface along with adaptive mechanisms to create the robustness of the nonlinear wind turbine system. The nonlinear optimal control policy is designed by addressing the partial differential Hamilton–Jacobi–Bellman (HJB) equation. This equation is approximated using the OHAM. This combination strategy reduces the final time of the optimal control problems, provides desired responses and improves performance. Additionally, the RNOSC‐OHAM controller facilitates the safe performance of the wind turbine under uncertainties and maximizes the wind power captured. To evaluate the performance of RNOSC‐OHAM, the results of the presented algorithm are compared with some existing control schemes. The results indicate that the designed RNOSC‐OHAM controller is very rapid and needs few iterations and computational costs. Indeed, the present control scheme exhibits the best characteristics and has the fastest transient response. The RNOSC‐OHAM controller offers a proper balance between enhancing aerodynamic power capture and minimizing low‐speed shaft fluctuations using a small control input.

An observer-based adaptive inverse optimal control (AIOC) scheme is developed for unknown nonlinear systems. First, a dynamic neural network (DNN) observer is designed to estimate system states. Then, based on the observed states, a neuro-controller is constructed based on control Lyapunov function (CLF) via inverse optimal method to obtain the optimal feedback control. In this framework, a two-layer DNN is used to construct the observer which can be implemented to systems with higher degrees of nonlinearity and without a priori knowledge of system dynamics. The optimal control scheme is implemented to online control the unknown nonlinear systems and the DNN observer simultaneously. An asymptotic stability of the closed-loop system is guaranteed using Lyapunov-based analysis. Simulation results are presented to demonstrate the effectiveness of the proposed control scheme.

The use of an adaptive optimal control algorithm for two real-time control applications, an optimal excitation control of a synchronous generator (OEC) and a power system stabilizer (PSS), is described. Experimental studies on a physical model of a power system showed that the proposed OEC and PSS can track the controlled system by parameter identification at different operating conditions. The proposed algorithm is based on linear optimal control theory. A special fifth-order discrete Riccati equation is solved in each sampling period. The proposed OEC and PSS can always guarantee that in a closed loop the controlled system will be stable based on the identified parameters. As the actual output of the controlled system and control are directly used in the controller, no observer is required. The proposed OEC and PSS can track the controlled system very rapidly. A number of tests have been performed, and all show satisfactory results.< <ETX xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">&gt;</ETX>

This paper studies the problem of optimal parallel tracking control for continuous-time general nonlinear systems. Unlike existing optimal state feedback control, the control input of the optimal parallel control is introduced into the feedback system. However, due to the introduction of control input into the feedback system, the optimal state feedback control methods can not be applied directly. To address this problem, an augmented system and an augmented performance index function are proposed firstly. Thus, the general nonlinear system is transformed into an affine nonlinear system. The difference between the optimal parallel control and the optimal state feedback control is analyzed theoretically. It is proven that the optimal parallel control with the augmented performance index function can be seen as the suboptimal state feedback control with the traditional performance index function. Moreover, an adaptive dynamic programming ( ADP ) technique is utilized to implement the optimal parallel tracking control using a critic neural network ( NN ) to approximate the value function online. The stability analysis of the closed-loop system is performed using the Lyapunov theory, and the tracking error and NN weights errors are uniformly ultimately bounded ( UUB ) . Also, the optimal parallel controller guarantees the continuity of the control input under the circumstance that there are finite jump discontinuities in the reference signals. Finally, the effectiveness of the developed optimal parallel control method is verified in two cases.

This paper introduces an optimal tracking controller for robot manipulators with asymmetrically saturated torques and partially - unknown dynamics based on a reinforcement learning method using a neural network. Firstly, the feedforward control inputs are designed based on the backstepping technique to convert the tracking control problem into the optimal tracking control problem. Secondly, a cost function of the system with asymmetrically saturated input is defined, and the constrained Hamilton-Jacobi-Bellman equation is built, which is solved by the online reinforcement learning algorithm using only a single neural network. Then, the asymmetric saturation optimal control rule is determined. Additionally, the concurrent learning technique is used to relax the demand for the persistence of excitation conditions. The built algorithm ensures that the closed-loop system is asymptotically stable, the approximation error is uniformly ultimately bounded (UUB), and the cost function converges to the near-optimal value. Finally, the effectiveness of the proposed algorithm is shown through comparative simulations.

Adaptive neural inverse optimal tracking control for uncertain multi-agent systems

SummaryThe problem of adaptive optimal semiactive control of a structure subjected to a moving load is studied. The control is realised by a change of damping of the structure's supports. The results presented in the previous works of the authors demonstrate that switched optimal controls can be very efficient at reducing the vibration levels of the structure. On the other hand, these controls exhibit a high sensitivity to changes of the speed of the travelling load. The aim of this paper is to develop an algorithm that enables real‐time adaptation of the optimal controls according to both the measured speed of the travelling load and the estimated state of the structure. The control objective is to provide smooth passage for the vehicles and reduce the material stresses on the carrying structures. The designed adaptive algorithm uses reference optimal controls computed for constant speeds and a set of functions describing the sensitivity of the system dynamics to the measured parameters. The convergence of the algorithm, as well as aspects of its implementation, is studied. The performance of the proposed method is validated by means of numerical simulations conducted for different travelling speed scenarios. In the assumed objective functional, the proposed adaptive controller can outperform the reference optimal solutions by over 50%. The practicality of the proposed method should attract the attention of practising engineers.

Voronoi-based adaptive area optimal coverage control for multiple manipulator systems with uncertain kinematics and dynamics

In this paper, the nonlinear optimal control problem is investigated for spacecraft formation flying with collision avoidance. Based on a nonlinear model of formation flying, two optimal tracking control laws are proposed to ensure the formation pattern converges to the predetermined configuration. The first optimal control law which combines Lyapunov optimizing control with a trajectory-following optimization technique is developed to solve the finite-time nonlinear optimal control problem. For the second controller, an extended [Formula: see text]-[Formula: see text] method is applied to design a closed-form feedback control scheme for nonlinear control problem of spacecraft formation flying with non-standard cost functions. By taking into account the flying safety, a repulsive control scheme is incorporated in the optimal controller to ensure collision avoidance and minimize the performance index. Finally, a numerical example is performed to demonstrate the effectiveness of the proposed approaches.

This paper investigates the robust optimal formation control for the position subsystem of quadrotor unmanned aerial vehicles (UAVs) subject to external disturbances and collision constraints. To prevent collision with both members of the formation and external obstacles, a collision avoidance potential function is constructed using relative position and velocity information. The basic bounded control input can ensure the stable flight and collision avoidance of a quadrotor UAV system. Based on the approximate dynamic programming (ADP) framework and two‐player zero‐sum differential game theory, the optimal controller is designed to further enhance the control performance of the system. The optimal value function is approximated by a single layer neural network, which avoids solving complex nonlinear Hamilton‐JacobiIsaac (HJI) equation. The stability of the closed loop system is proved. The effectiveness of the robust optimal formation controller based on learning is validated through MATLAB simulation in two distinct scenarios.