Analysis and Code Design for the Binary CEO Problem Under Logarithmic Loss

We propose a novel concatenated coding scheme combined Low Density Parity Check(LDPC) code and vertical Bell Labs layered space-time (VBLAST) code to improve the bit error rate (BER) performance for Free-space optical (FSO) communication links with On Off Keying(OOK) modulation. In the scheme, π-rotation encoding and belief-propagation (BP) decoding algorithm are employed in LDPC code, and minimum mean-square error (MMSE) soft-decision decoding algorithm is used for VBLAST code. Moreover, a joint iterative detection and decoding algorithm of VBLAST code and LDPC code is used to improve the overall link performance. At last, the BER of the proposed scheme over lognormal atmospheric turbulent fading channels is analyzed by using Monte Carlo method. The result shows that the BER of the proposed concatenated coding scheme is much improved than that only use VBLAST code scheme.

Turbo codes are attractive compared with Low Density Parity Check (LDPC) codes for Forward Error Correction (FEC) applications mainly due to their superior performance, especially at low Signal-to-Noise Ratio (SNR) such as are common in Powerline channels. For example, IEEE 1901-FFT PHY used the Turbo coding scheme defined in the HomePlug AV standards. However, patent fees are usually required for each turbo-code enabled manufactured device. The objective of this paper is to examine whether unlicensed LDPC codes, with optimized choices of block lengths, could be a viable alternative for future Powerline Communications (PLC) applications. The paper shows that the performance of the LDPC codes can approximate that of the Turbo codes with higher block lengths, on channels with typical and realistic PLC characteristics. The paper also shows that the additional complexity associated with this increase in block length can be mitigated by the use of Quasi-Cyclic LDPC (QC-LDPC) codes.

Low Density Parity Check (LDPC) codes have capacity-approaching performance over several channels of interest. In practice, for good block-error rate performance, the girth of the Tanner graph of an LDPC code needs to be as high as possible. In theory, to show that block-error rate approaches zero for increasing block-lengths, the girth of the Tanner graph sequence needs to tend to infinity with block-length. To meet these requirements, we construct sequences of large-girth irregular LDPC codes for a given degree-distribution pair (DDP) by applying a general node splitting algorithm on large girth graphs. The obtained Tanner graph meets the required DDP up to a suitable approximation. By optimizing the node-splitting method and using suitable large-girth graphs, we show code constructions with smaller block length for the same girth, when compared to previous constructions. Similar gains in block length are observed in the construction of sequences of large-girth protograph LDPC codes. Simulations, over a binary erasure channel, confirm the gains in block-error rate obtained by the large girth construction.

Big data storage demands larger cluster. The increasing size of the cluster may lead to failures of larger number of nodes. To provide reliable big data storage, replications are not cost-effective and does not provide a robust solution to prevent data loss. Traditional erasure codes applied in the RAID system such as Reed-Solomon (R-S) based solutions have limitations in providing high reliability. This is because higher reliability requires erasure codes with larger size. The computational cost of the R-S codes increase quadratically with the number of failures the R-S codes can tolerate for the same redundancy rate. It has been shown that Low Density Parity Check (LDPC) codes have lower computational cost and repair network traffic compared with R-S based solutions. Unfortunately, there does not exist a construction method for LDPC codes with larger size to control the computational cost and repair traffic. In this paper, a novel method is proposed to construct a family of LDPC codes - expanCodes with expandable sizes. The proposed expanCodes allows the encoding and decoding complexity remain unchanged with the increase of the size of the LDPC codes. As a result, increased reliability can be achieved without additional computation and repair traffic. The proposed expanCodes is integrated with the Hadoop system. Simulations show that more than 29% decrease in terms of encoding and decoding latency compared with R-S based solutions.

This letter gives a random construction for Low Density Parity Check (LDPC) codes, which uses an iterative algorithm to avoid short cycles in the Tanner graph. The construction method has great flexible choice in LDPC code’s parameters including codelength, code rate, the least girth of the graph, the weight of column and row in the parity check matrix. The method can be applied to the irregular LDPC codes and strict regular LDPC codes. Systemic codes have many applications in digital communication, so this letter proposes a construction of the generator matrix of systemic LDPC codes from the parity check matrix. Simulations show that the method performs well with iterative decoding.

DOI: 10.1049/cp:20061337 ISBN: 0 86341 644 6 Location: Hangzhou, China Conference date: 6-9 Nov. 2006 Format: PDF The BER performance of presented quasi-cyclic (QC) low-density parity-check (LDPC) codes is not good as that of randomly constructed LDPC codes, while the lack of structure of randomly constructed LDPC codes implies serious disadvantages in terms of storing and accessing a large parity-check matrix. To solve the problems, this paper proposes a design of good quasi-cyclic (QC) low-density parity-check (LDPC) codes, the obtained algebraically structured codes have large minimum distances and good BER performance. The proposed design is based on index matrices, which determines the shifts of the circulant matrices of the sparse parity-check matrices. Compared with the presented design of QC LDPC codes, the designed QC LDPC codes are free from girth 4, sometimes free from girth 6, and have much larger minimum distances. Based on the algebraic code structure, the conditions of the girth and minimum distance of the codes are found. The BER performance of the designed QC LDPC block codes compares with that of randomly constructed LDPC codes for any block lengths. Better BER performance is obtained by increasing the circulant size of the base QC code. Simulations verify the construction of the QC LDPC codes to be valid. (4 pages) Inspec keywords: AWGN channels; error statistics; channel coding; algebraic codes; parity check codes; sparse matrices Subjects: Algebra; Other topics in statistics; Codes

A new method for analyzing low density parity check (LDPC) codes and low density generator matrix (LDGM) codes under bit maximum a posteriori probability (MAP) decoding is introduced. The method is based on a rigorous approach to spin glasses developed by Francesco Guerra. It allows to construct lower bounds on the entropy of the transmitted message conditional to the received one. Based on heuristic statistical mechanics calculations, we conjecture such bounds to be tight. The result holds for standard irregular ensembles when used over binary input output symmetric channels. The method is first developed for Tanner graph ensembles with Poisson left degree distribution. It is then generalized to `multi-Poisson' graphs, and, by a completion procedure, to arbitrary degree distribution.

In this paper we propose an innovative channel coding scheme called 'Accumulate Repeat Accumulate codes' (ARA). This class of codes can be viewed as serial turbo-like codes, or as a subclass of Low Density Parity Check (LDPC) codes, thus belief propagation can be used for iterative decoding of ARA codes on a graph. The structure of encoder for this class can be viewed as precoded Repeat Accumulate (RA) code or as precoded Irregular Repeat Accumulate (IRA) code, where simply an accumulator is chosen as a precoder. Thus ARA codes have simple, and very fast encoder structure when they representing LDPC codes. Based on density evolution for LDPC codes through some examples for ARA codes, we show that for maximum variable node degree 5 a minimum bit SNR as low as 0.08 dB from channel capacity for rate 1/2 can be achieved as the block size goes to infinity. Thus based on fixed low maximum variable node degree, its threshold outperforms not only the RA and IRA codes but also the best known LDPC codes with the dame maximum node degree. Furthermore by puncturing the accumulators any desired high rate codes close to code rate 1 can be obtained with thresholds that stay close to the channel capacity thresholds uniformly. Iterative decoding simulation results are provided. The ARA codes also have projected graph or protograph representation that allows for high speed decoder implementation.

In this paper, we propose a concatenated code by combining a Recursive Systematic Convolutional (RSC) code with a Low-Density Parity-Check (LDPC) code. The proposed concatenated code is encoded in parallel by an RSC encoder and an LDPC encoder without interleavers between them. When decoding the proposed concatenated code, the information bits are decoded by two decoding algorithms, and soft information is exchanged between the RSC decoder and the LDPC decoder. This allows for the elimination of wrong codewords output by each decoder. The use of an LDPC code allows us to halt the decoding process when the valid codeword is obtained. We evaluate the error rate performance of the proposed concatenated code by computer simulations. We show that the proposed concatenated code does not have a high error floor, and achieves better BLock Error Rate (BLER) performance than either conventional LDPC codes or conventional turbo codes in the high Eb/No region. We also show that since the proposed concatenated code can correct wrong codewords output by each decoder, it achieves better BLER than the regular LDPC code at the same Bit Error Rate (BER).

The application of Low Density Parity Check (LDPC) code in the anti-interference systems has drawn an increasing attention, due to its admiring performance which is very close to the theory limit. This paper focuses on a LDPC encoded slow frequency hopping (SFH) communication system with partial-band interference. Firstly, a modified soft- decision algorithm based on the utilization of interference information is proposed, and its performance is compared with some other soft-decision methods. Secondly, with numerical simulation, the influence of code rate, code length and the number of symbols per hops on the performance of the system with partial band noise interference is illustrated and examined in detail. Considering the great influence of hops per symbol on the performance, interleaver should be used and its influence on the performance is further examined by simulation. Finally, some constructive advises for the design of LDPC coded SFH system are given. Simulation results show that, with a reasonable design, the SFH system with LDPC code could achieve a desirable performance.

Low Density Parity Check (LDPC) codes have been widely used in communications systems due to their high error correction capabilities. Recently these codes are also investigated for being exploited in high performance storage systems, especially when Non-Volatile Memory (NVM) technologies are used. The main drawback of using LDPC codes in storage systems with a high number of parallel channels is the increased hardware complexity and cost, especially when variable rate codes are used. In this work, we present an architecture of a NVM-based storage system that dynamically adapts the LDPC's rate to the aging conditions of the storage device in order to maximize its lifetime capacity while keeping low its hardware complexity. In order to decrease the system's complexity we propose a PCIe-based architecture that uses a pool of LDPC decoders shared by all NVM channels and we study its effect on the system's lifetime capacity and the achievable I/O data rate.

In this paper, a random Low-Density Parity-Check (LDPC) code is proposed for Noncontiguous Orthogonal Frequency Division Multiplexing (NC-OFDM) Cognitive Radio (CR) systems. Unlike other encoding schemes which achieve a system code rate of only 1/4 when half of the subcarriers are active, the proposed scheme achieves a system code rate of 1/2. The LDPC code is used to enhance the data transmission rate. A new channel model comprised of a binary erasure channel concatenated with an uncorrelated fading channel and an AWGN channel is adopted for NC-OFDM CR systems. Moreover, the adopted channel model is employed with density evolution algorithm to obtain good degree distribution pairs for the LDPC code. Thereafter, a modified shortest-path algorithm is used to construct the parity-check matrix for the LDPC code. Simulation results show that the proposed LDPC code performs well in terms of both error rate and data transmission rate.

Summary form only given. The ultimate performance limit or threshold of low-density parity-check (LDPC) codes is close to capacity over various memoryless channels (S.-Y. Chung, IEEE Trans. Info. Theory, vol. 47, pp. 657-670, 2001). Since the capacity of binary-input partial response (PR) channels is unknown, we estimate the capacity by calculating the threshold of capacity-approaching LDPC codes over these channels. We assume a BCJR equalizer for the channel and a sum-product message-passing decoder for the LDPC code. We also assume that the log-likelihood ratios (LLRs) in the channel BCJR and the LDPC decoder are Gaussian. We use our results to guide the design of decoder schedules that minimize the number of computationally expensive BCJR steps. The threshold calculation method can be used to optimize the left and right degree sequences of the LDPC code factor graph, using fast linear programming methods, to provide better thresholds than regular codes.

Low-density parity-check (LDPC) codes have been widely considered as error-correcting codes for next generation communication systems. A good LDPC decoder design requires both implementation friendly LDPC codes and efficient decoder architectures. The quality of LDPC code is crucial in determining the coding gain and implementation complexity of LDPC hardware decoders. This paper presented a genetic algorithm (GA) based LDPC code search algorithm with hardware considerations. Regular quasi-cyclic LDPC codes are used due to its friendliness to hardware implementation. Our hardware architecture design schedules pipeline LDPC decoding operation to boost the hardware utilization efficiency (HUE) of LDPC decoder. A LDPC decoder with a block size of 12288 is implemented in FPGA to validate our code and architecture design.

RS (Reed - Solomon) code is used in DVB-H (digital video broadcasting - handheld) system as an addtional error correcting code to improve the performance during mobile reception. LDPC (low density parity check) code which is rediscovered recently shows the astonishing performance. Therefore LDPC code can be used to replace RS code in order to improve the performance further since both of them are block codes. So the performance of LDPC code in MPE-FEC (multi protocol encapsulation - forward error correction) frame of DVB-H system is analyzed in this paper.