Application and improvement of soil spatial distribution mapping using advanced modelling techniques

An artificial neural network (ANN) model was developed to monitor the density of rigid foam PVC on-line during the extrusion process using an ultrasound sensor mounted on the extruder die. Acoustic properties of the polymer melt, measured by multiple ultrasound echoes propagating through the polymer melt, were used to train a multilayer perceptron (MLP) artificial neural network to estimate the density of the extruded foam. The foam density was varied by varying the processing conditions, i.e. heating zones and screw speed, during the extrusion process. A high correlation was found to exist between the acoustic properties of the polymer melt and the foam density using a three-layer multilayer perceptron artificial neural network.

The relationships between physico-chemical and rheological properties are considered complex nonlinear systems. Thus, the artificial neural network (ANN) and regression models were used for the rheological characterization of Brazilian honeys, based on low-cost measurements of water content and temperature. The steady shear viscosity (η) performed well when measured in the test phase in a 2-12-1 neuron multilayer perceptron (MLP) ANN (model 1) with a root mean square error (RMSE) and correlation coefficient (r) equal to 0.0430 and 0.9681, respectively. The parameter loss modulus (G″), storage modulus (G′) and complex viscosity (η*) were predicted in the temperature sweep test by small amplitude oscillatory shear (SAOS) measurements during heating and cooling, and the MLP ANNs with architectures of 2-9-3 (model 2) and 2-3-3 (model 3) showed RMSE values equal to 0.0261 and 0.0387 in the test phase, respectively. For all the determined parameters, non-linear exponential models showed similar results to models 1, 2 and 3. An ANN with 3-9-3 architecture (model 4) showed RMSE and r for G′ equal to 0.0158 and 0.7301, for G″ equal to 0.0176 and 0.9581, and for η* equal to 0.0407 and 0.9647, respectively, in the test phase for date of the frequency sweep test obtained by SAOS. These results were far superior to those obtained by second-order multiple linear models. The acquisition of all models is an important application for the processing of honey and honey-based products, since these properties are essential in engineering calculations and quality control of products.

State estimation is used currently in wide area electrical systems for real time analysis. Studies have shown that in HV transmission networks, where system-wide synchronized phasor measurement units are installed, voltage angle measurements can be included in the input measurements data set, with the result of improving the estimation precision. The authors developed in previous papers a SE algorithm based on Multilayer Perceptron Artificial Neural Networks. This paper extends this research by using PMU voltage magnitude and angle measurements in the input data for the ANN estimator, and shows in a case study that the estimation precision is improved. The development of advanced electricity markets in Europe and North America changed the operation and dispatch rules of power systems. In the United States and Canada, the ISO/RTO model is used to manage grid operation for approximately a half of North American Continent (1), while in Europe continuous efforts are made for coupling the national and regional electricity markets into a common market, markets supplying 75% of the demand using now a common day-ahead price mechanism and cross-border capacity management (2). High-performance tools are required for real time monitoring and control of such large systems. Enhanced state estimation (SE) algorithms are robust tools used today by system operators. Phasor measurement units (PMU) are used for synchronizing measurements used in state estimation analyses for systems covering wide geographical territories (3), and the trend is to generalize their deployment also at distribution level (4,5). Other approaches use distributed estimation, by splitting one large system in several areas estimated locally (6). The two approaches can be also combined (7). Recent research also use artificial neural networks (ANN) for state estimation (8,9). The authors proposed in (10) a SE approach which uses Multilayer Perceptron (MLP) artificial neural networks. A case study performed on a section of the Romanian HV distribution system was carried out, and the estimation results have shown a good precision. This paper extends the study by including PMU measurements into the measurement input set to improve the previous estimation results. The expected results are the improvement of estimation, a behaviour similar to classic algorithms.

This study aimed to predict some soil water contents and soil erodibility indices with a multilayer perceptron (MLP) artificial neural network (ANN) using remote sensing data (Landsat 8 OLI TIRS) and topographic variables from a digital elevation model (DEM) in a semi-arid ecosystem. In models, the input variables were derived from remote sensing imaging and DEM. The output variables were field capacity, wilting point, aggregate stability index, structural stability index, dispersion ratio, and clay flocculation index. This study was realized in the watersheds of the Koruluk dam, the Kızlarkalesi, and the Telme ponds built for agricultural irrigation in Gümüşhane-Şiran. The soil samples were obtained from two depths (0-10cm and 10-20cm) from 59 soilprofiles. Besides field capacity, wilting point, and aggregate stability analysis, undispersed/dispersed sand, silt, clay contents, and organic matter analysis were performed due to their strong effect on soil moisture, soil water content, and erodibility indices. The correlation analysis results showed significant relationships between soil characteristics and soil water contents/soil erodibility indices. The remote sensing variables were derived from three Landsat images of 2015 (June, July, and September). The performance results of MLP ANN models predicted for soil water contents and erodibility indices ranged from 0.75 to 0.90 for R2, 0.046-4.115 for root mean square error (RMSE), 4.46-6.54 for normalized root mean square error (NRMSE), and 0.042-0.186 for mean absolute error (MAE). Topography was a more significant group of variables that affected soil water contents and soil erodibility indices and the feature importance of topography in the prediction was over 55%. The results showed that the use of topographic variables together with remote sensing variables in MLP ANN modeling increased the performance of the models.

• The hourly wind speed prediction is an important problem. • A feed-forward (FF) multi-layer perceptron (MLP) artificial neural network (ANN) is used for prediction. • The FF MLP ANN is optimized by 9 state-of-art metaheuristic algorithms. • In the experiments, 38 years of hourly wind data belonging to 5 cities were used. • Grey Wolf Optimizer produced best results in terms of mean square error (MSE). The growing population has tremendously increased the daily energy demand all around the world. India is the second-most crowded nation in the world with approximately 1.4 billion people. New and renewable energy is on the agenda of India and in 2021 India possesses the fourth-largest installed capacity of wind power. Accurate prediction of wind speed is vital in wind farm design and operation. In this work, an hourly wind speed prediction with an artificial neural network optimized by a metaheuristics approach is conducted. A feed-forward (FF) multi-layer perceptron (MLP) artificial neural network (ANN) is used for the prediction of the hourly wind speed. In this study, 38 years of hourly wind data belonging to 5 cities (Ambur, Hosur, Kumbakonam, Nagapattinam, and Pudukottai) were used. These cities have different specific properties such as latitude, longitude, and altitude. The FF MLP ANN is optimized by 9 state-of-art metaheuristic algorithms. In this work, Artificial Bee Colony (ABC), Ant Colony Optimization (ACO), Biogeography Based Optimization (BBO), Evolutionary Strategy (ES), Genetic Algorithm (GA), Grey-Wolf-Optimizer (GWO), Population-Based Incremental Learning (PBIL), Particle Swarm Optimization (PSO), Tree-Seed Algorithm (TSA) have been used to optimize the weights of the ANN. GWO outperforms other metaheuristic algorithms in the prediction of wind speed with a FF MLP ANN model, with a success percentage rate of approximately 3% to 10,000%.

An approach towards building robust neural networks models using multilayer perceptron through experimentation on different photovoltaic thermal systems

Regional modeling of the ionosphere using adaptive neuro-fuzzy inference system in Iran

Super-resolution reconstruction of noisy gas-mixture absorption spectra using deep learning

In recent years, artificial intelligence has been widely used in the field of meteorology. However, it is perhaps less known that AI-based tools have been used for over 30 years in the modeling of pollutant dispersion in the atmosphere.In the early 1990s, Slovenia and other parts of Europe faced significant air pollution problems caused by SO₂ emissions from coal-fired power plants without desulfurization systems. Due to the highly complex terrain, simple physical Gaussian dispersion models were not suitable for reconstructing the dispersion of SO₂ in the atmosphere, while complex numerical Lagrangian particle dispersion models were still in development.Therefore, as early as 1992, we modeled air pollution using a Multilayer Perceptron Artificial Neural Network (MLPANN). We developed the world's first comprehensive method for selecting training samples, features, and the topology of the neural network, enabling the model to learn from measured meteorological variables and pollutant concentrations around the power plant to predict SO₂ concentrations at a selected location in advance.This type of artificial neural network remains the foundation for various derived structures used for machine learning from data even today.In the following decades, we expanded the use of MLPANN to ozone prediction. Researchers from other Slovenian research groups also worked on this topic. Meanwhile, the use of these and similar tools in pollutant dispersion modelling began to grow on a global scale.Together with Brazilian researchers, we successfully applied MLPANN for predicting diffuse solar radiation. In this field, we also managed to develop a spatially transferable model, which is not a common capability for artificial neural network-based models.For the classification of wind fields based on measurements from ground-based meteorological stations, we used a Kohonen neural network.Later, we added another tool called "Gaussian processes" (which, like MLPANN, is a universal approximator) and the tool "decision trees." We expanded the use to point-based forecasting of basic meteorological variables. In recent years, with high computational capabilities available even without supercomputers, we have been using these tools for surrogate models that can represent or predict pollutant concentration fields in the atmosphere, not only for individual points but for entire areas around pollution sources.Other Slovenian groups from Slovenian Meteorological Agency, the Department of Meteorology, and the Faculty of Computer Science have, in recent years, used machine learning for global medium-range forecasts of daily averages of meteorological variables and for post-processing weather forecasts from physical models.In the presentation, we will explain the basic principles of building models based on artificial neural networks in a way that is understandable to laypeople. For experts in the field, we will showcase numerous examples of their application. For the latter group, we hope these examples will inspire others to expand the use of these modern tools even further.

Near-infrared (NIR) spectroscopy for motor oil classification: From discriminant analysis to support vector machines

Soil prediction using artificial neural networks and topographic attributes

In this paper, we present concepts in artificial neural networks (ANN) to help detect intrusion attacks against network computers, and introduce and compare a multi-layer perceptron ANN (MLPANN) with Snort, an open-source tool for intrusion detection systems (IDS). To conduct these comparison experiments, we inserted malicious traffic into the MLPANN to train our ANN, with results indicating that our ANN detected 99% of these input attacks.

The complexity of the statistical models used to estimate the productivity of many crops, including soybeans, restricts the use of this practice, but an alternative is the use of artificial neural networks (ANNs). This study aimed to estimate soybean productivity based on growth habit, sowing density and agronomic characteristics using an ANN multilayer perceptron (MLP). Agronomic data from experiments conducted during the 2013/2014 soybean harvest in Anapolis, Goias State, B razil, were used to conduct this study after being normalized to an ANN-compatible range. Then, several ANNs were trained to choose the best-performing one. After training the network, a performance analysis was conducted to select the ANN with a performance most appropriate for the problem, and the selected network had a 98% success rate with training data and a 72% data validation accuracy. The application of the MLP to the data used in the experiment shows that it is possible to estimate soybean productivity based on agronomic characteristics, growth habit and population density through AI.

Context. The problem of identification, formation and restoration of the boundaries of influencing factors, lost as a result of the implementation of multi-layer perceptron models into the models of subjective perception of the object of software complexes support, as well as the applied practical problem of primary monitoring of the frequency manifestation of a given influencing factor in the post-real-time mode, is considered. The object of research is the influencing factors of support of software complexes. Objective – the goal of the work is to develop a model of inverse chains of maximum weights for the analysis of influencing factors of the software complexes support. Method. A model of maximal weights inverse chains for the analysis of the influence factors of the software complexes support was developed for the analysis of the influencing factors of the software complexes support. The developed model provides possibility to identify and form feedback chains of maximum weights for the identification and further analysis of influencing factors that are reflected into the results of the object perception (the supported software complex or its support processes), by the relevant subjects of interaction which directly or indirectly interact with it. Results. Results of the resolved applied practical problem of primary monitoring of the frequency manifestation of a given influencing factor in the post-real-time mode have been provided as an example of the applied practical use of the developed model. The output results of the developed models functioning – are the reverse chains of maximum weights. In the future, the results obtained by the developed model are used to solve the applied-scientific problem of identification, formation and restoration of the boundaries of influencing factors, lost as a result of the implementation of the appropriate models of multilayer perceptron inside the models of subjective perception of the software complexes support. So the developed model of maximal weights inverse chains for the analysis of the influence factors of the software complexes support resolves this applied-scientific problem, initially caused by the implementation of the corresponding multilayer perceptron models inside the model of the subjective perception of the object of software complexessupport. The developed model provides the possibility of carrying out a qualitative analysis of the transformation of the input characteristics of the object of support into the output resulting characteristics of its subjective perception. Conclusions. Developed model allows to resolve the described problems. At the same time, the developed model improves the classical understanding of multilayer perceptron artificial neural networks, as it introduces an additional value to the neurons of hidden layers, which (starting from now) are able to perform a completely new role of influencing factors markers, while in the classical understanding of multilayer perceptron artificial neural networks they did not perform any functions other than arithmetic to ensure the possibility of correct learning and functioning of a multilayer perceptron artificial neural networks.

The paper presents an artificial neural network (ANN) and an adaptive neuro-fuzzy inference system (ANFIS), which could accurately estimate the maximum equilibrium depth of the contraction scour. The developed networks have been trained using the data set conducted by different investigators for long contractions under clear-water conditions. The designed multilayer perceptron (MLP) ANN includes one hidden layer and seven nodes within that layer. Its hidden neurons use a hyperbolic tangent sigmoidal transfer function. The ANN model was implemented using the MATLAB software package. The importance of the individual input parameters was tested with a sensitivity analysis. This revealed the contraction ratio to be by far the most sensitive parameter, followed by the effect of armor layer formation for nonuniform sediments. For the designed MLP–ANN network, the training was based on the Levenberg–Marquardt back-propagation algorithm in batch mode. The designed ANFIS was the zero-order Takagi–Sugeno model with four bell-shaped membership functions for each input and applied the Levenberg–Marquardt algorithm for network training. The ANFIS model was implemented using a FORTRAN-based computer code. The calculated results show that the selected networks estimate the equilibrium maximum scour depth under clear-water conditions within the range of the used data set significantly better than other conventional methods.