Asymptotic Analysis and Power Control Optimization for Wirelessly Powered Cell-free Lot

Cell-free Massive MIMO (mMIMO) is envisaged to be a next-generation technology beyond 5G with its high spectral efficiency and superior spatial diversity as compared to that of conventional MIMO technology. The main principle is that many distributed access points (APs) cooperate to simultaneously serve all the users within the network without creating cell boundaries. This paper considers the uplink of a cell-free mMIMO system utilizing the radio stripe network architecture. We propose a novel sequential processing algorithm with normalized linear minimum mean square error (N-LMMSE) combining at every AP. This algorithm enables interference suppression in cell-free mMIMO while keeping the cost and front-haul requirements low. The spectral efficiency of the proposed algorithm is computed and analyzed. We conclude that it provides an attractive trade-off between low front-haul requirements and high spectral efficiency.

We generalize the multiuser (CDMA spread spectrum) communication systems to the fading environments. We first extend Verdu's (1986) conventional optimum receiver to Rayleigh-fading environments and then evaluate its performance. Having no knowledge of the received power at the receiving end, we therefore need an estimator to efficiently estimate the received signal strength of each user in fading environments. A linear minimum mean square error (LMMSE) unbiased estimator is proposed to attain this goal. By using the minimum mean square error (MMSE) Bayesian estimation, we further propose the LMMSE bit estimator for efficient demodulation. Its performance is close to the optimum multiuser receiver but with a much simpler polynomial complexity. To further reduce the complexity, we extend the LMMSE estimator to the sequential LMMSE estimator. In sequential estimation, we do not need to implement the matched filter banks and to perform the matrix inversion when estimating. In addition, it converges after approximately 2k iterations, where k is the number of users. With this fast convergence property and the simple structure, the sequential LMMSE estimator provides an attractive alternative to the implementation of a multiuser system.

A decision-directed (DD) channel estimation based on iterative linear minimum mean square error (LMMSE) is proposed for orthogonal frequency division multiplexing systems. Existing DD channel estimation is well known to have the problem of error propagation because of symbol-by-symbol detection. The proposed algorithm can estimate the correction term of current channel state information (CSI) according to the error vector of previous CSI by applying the orthogonality principle, and corrects the current CSI with this correction term. Analysis and simulation results have shown that this method has no error propagation problem. The performance of the proposed algorithm is much better than the conventional DD channel estimation, and close to the optimal LMMSE estimator, but with much less computational complexity compared with the optimal LMMSE estimator.

Backscatter communication (BC) has emerged as a promising paradigm for enabling energy-efficient and low-cost Internet of Things (IoT) systems. However, one practical constraint that is often neglected in BC studies is the circuit sensitivity of the backscatter device (BD), which sets the minimum signal strength required to activate it for signal reflection. In this paper, we address the channel estimation (CE) problem in the BC system with a circuit sensitivity constraint. Specifically, we propose three channel estimators for the receiver in the BC system that is unaware of the activation states of the BD, namely the maximum likelihood (ML), linear minimum mean square error (LMMSE), and maximum a posteriori (MAP) estimators. We derive both the Cramér-Rao bound (CRB) and Bayesian Cramér-Rao bound (BCRB) to evaluate the performance of the proposed estimators. Finally, we provide simulations to validate our analysis. Our results demonstrate that the proposed LMMSE and MAP estimators outperform traditional estimators that neglect the circuit sensitivity constraint.

Channel estimation (CE) is a challenging problem and one of the key technologies in Orthogonal Frequency Division Multiplexing (OFDM) systems. The Linear Minimum Mean Square Error (LMMSE) proposed for OFDM systems has excellent Mean Square Error (MSE) performance. However, the conventional method requires the statistical knowledge of the channel information in advance and the complicated inverse operation of large dimension matrices. In this case, an enhanced fast LMMSE channel estimation using Fast Fourier Transform (FFT) operation and the most significant taps (MST) algorithm for OFDM systems is proposed. This method has the advantage of low computational complexity and no requirement on the detailed channel information. In addition, simulation results demonstrate that the proposed algorithm outperforms other LMMSE methods in terms of bit error rate (BER) without the loss of MSE performance.

The bandwidth shortage has motivated the exploration of the millimeter wave (mmWave) frequency spectrum for future communication networks. To compensate for the severe propagation attenuation in the mmWave band, massive antenna arrays can be adopted at both the transmitter and receiver to provide large array gains via directional beamforming. To achieve such array gains, channel estimation (CE) with high resolution and low latency is of great importance for mmWave communications. However, classic super-resolution subspace CE methods such as multiple signal classification (MUSIC) and estimation of signal parameters via rotation invariant technique (ESPRIT) cannot be applied here due to RF chain constraints. In this paper, an enhanced CE algorithm is developed for the off-grid problem when quantizing the angles of mmWave channel in the spatial domain where off-grid problem refers to the scenario that angles do not lie on the quantization grids with high probability, and it results in power leakage and severe reduction of the CE performance. A new model is first proposed to formulate the off-grid problem. The new model divides the continuously-distributed angle into a quantized discrete grid part, referred to as the integral grid angle, and an offset part, termed fractional off-grid angle. Accordingly, an iterative off-grid turbo CE (IOTCE) algorithm is proposed to renew and upgrade the CE between the integral grid part and the fractional off-grid part under the Turbo principle. By fully exploiting the sparse structure of mmWave channels, the integral grid part is estimated by a soft-decoding based compressed sensing (CS) method called improved turbo compressed channel sensing (ITCCS). It iteratively updates the soft information between the linear minimum mean square error (LMMSE) estimator and the sparsity combiner. Monte Carlo simulations are presented to evaluate the performance of the proposed method, and the results show that it enhances the angle detection resolution greatly.

Channel estimation is a critical component in orthogonal frequency division multiplexing (OFDM) systems for ensuring reliable wireless communication. In this study, we propose a fast super-resolution convolutional neural network (FSRCNN) model for channel estimation, designed to reduce computational complexity while maintaining high estimation accuracy. The proposed FSRCNN model incorporates modifications such as replacing linear interpolation with zero padding and leveraging a new fast CNN architecture to estimate channel coefficients. Our numerical experiments and simulations demonstrate that the FSRCNN model significantly outperforms traditional methods, such as least square (LS) and linear minimum mean square error (LMMSE), in terms of mean square error (MSE) across various signal-to-noise ratios (SNRs). Specifically, the FSRCNN model achieves MSE values comparable to MMSE estimation, particularly at higher SNRs, while maintaining lower computational complexity. At an SNR of 20 dB, the FSRCNN model shows a notable improvement in MSE performance compared to the ChannelNet and LS methods. The proposed model also demonstrates robust performance across different SNR levels, with optimal results observed when the training SNR is close to the operating SNR. These findings validate the effectiveness of the FSRCNN model in providing a low-complexity, high-accuracy alternative for channel estimation, making it suitable for real-time applications and devices with limited computational resources. This advancement holds significant promise for enhancing the reliability and efficiency of current and future wireless communication networks.

In orthogonal frequency division multiplexing (OFDM) systems, the least square (LS) in addition to the technique of linear minimum mean square error (LMMSE) channel estimation are compared using frequency as well as time domain in this paper. A constant LMMSE channel estimation has been proposed in time domain where the channel is not intimated before. It is presented by the Simulation outcomes that the channel estimation execution can be improved by the techniques of time domain but not using the techniques of frequency domain. Additionally, using the technique of LMMSE, higher accuracy is achieved by the proposed method which is presented in the outputs of the simulation.

Generalized frequency division multiplexing (GFDM) is a promising candidate waveform for next-generation wireless communication systems. However, GFDM channel estimation is still challenging due to the inherent interference. In this paper, we formulate a pilot design framework with linear minimum mean square error (LMMSE) channel estimation for GFDM, and propose a novel pilot design to achieve interference precancellation during pilot generation with the fixed transmit sample values at selected frequency bins. Numerical results demonstrate that the proposed method reduces the channel estimation mean square error and the symbol error rate (SER) in high signal-to-noise ratio (SNR) regions, compared with the conventional methods.

This paper proposes a cognitive radio approach for WiMAX (CogMAX). The proposed system has all the capabilities of cognitive radio from monitoring to action, decision and learning. We use fuzzy logic (FL) reasoning as the core of the reasoning engine. The reasoning engine is used to determine different parameters that will be used by the WiMAX system. This work will focus on one of the main functions of the reasoning engine i.e. determination of the channel type and the number of pilots used for channel estimation. The number of pilots will depend on the type of channel which is determined by the cognitive engine. We examine two channel estimators, the Least Square (LS) and the Linear Minimum Mean Square Error (LMMSE) along with 2D-Linear, averaging and constant coefficients interpolators. Evaluation is done using the minimum square error with the SNR of the channel. Numerical results reveal that changing the number of pilots can lead to better channel estimation.

SummaryThis paper introduces the concept of spatial and media‐based modulated (SMBM) orthogonal frequency division multiplexing (OFDM) as a potential candidate for highly mobile next generation beyond 5G (B5G) wireless communications. The proposed SMBM‐OFDM technique utilizes not only the transmit antenna and channel state indices but also OFDM subcarriers to improve the system performance under high mobility. In addition, this study sheds light on challenging fast time‐varying channel estimation problem of MBM‐based systems by using the linear minimum mean square error (LMMSE) approach due to its optimality to investigate the achievable system performance with the aid of basis expansion modeling. The minimum lower bound on the channel estimation error (Bayesian Cramer–Rao bound) is derived theoretically and shown to be attainable by the considered LMMSE estimator. Moreover, symbol detection performance is provided for different modulation types and higher mobile velocities. Simulation results demonstrate that SMBM‐OFDM system under high mobility is able to provide around 12‐dB performance gains in terms of both channel estimation and symbol detection error compared to conventional spatial modulation (SM)‐OFDM systems without MBM. The presented framework is important due to addressing the high mobility support of SMBM‐OFDM systems for B5G wireless communications in terms of achievable channel estimation and data detection performance.

We study support for unmanned aerial vehicle (UAV) communications through a cell-freemassive MIMO architecture, wherein a large number of access points (APs) is deployed in place of largeco-located massive MIMO arrays. We consider also a variation of the pure cell-free architecture by applyinga user-centric association approach, where each user is served only from a subset of APs in the network.Under the general assumption that the propagation channel between the mobile stations, either UAVs orground users (GUEs), and the APs follows a Ricean distribution, we derive closed form spectral efficiencylower bounds for uplink and downlink with linear minimum mean square error channel estimation. Weconsider several power allocation and user scheduling strategies for such a system, and, among these,also minimum-rate maximizing power allocation strategies to improve the system fairness. Our numericalresults reveal that cell-free massive MIMO architecture and its low-complexity user-centric alternativemay provide better performance than a traditional multi-cell massive MIMO network deployment.

With the increasing rate of wireless devices and high bandwidth operations, wireless networking and communications are becoming over crowded. To cope with such crowded and messy situation, massive MIMO is designed to work with hundreds of low-cost serving antennas at a time as well as improve the spectral efficiency at the same time. Time Division Duplexing (TDD) has been used for gaining beamforming which is a major part of massive MIMO, to gain its best improvement to transmit and receive pilot sequences. All the benefits are only possible if the channel state information or channel estimation is gained properly. Least Square (LS), Minimum Mean Square Error (MMSE) and Linear Minimum Mean Square Error (LMMSE) are the estimators commonly used for estimating channel matrices. We have optimized these methods using genetic algorithm to minimize the mean squared error and finding the best channel matrix from existing algorithms with less computational complexity. Our simulation result has shown that the use of Genetic Algorithm (GA) worked well on existing algorithms in a Rayleigh slow fading channel and existence of Additive White Gaussian Noise. We found that the GA optimized LS is better than existing algorithms. GA provides optimal result in some few iterations in terms of Mean Square Error (MSE) with respect to SNRand computational complexity.

Photon-counting detectors are greatly improving the resolution and image quality in computed tomography (CT) technology. The drawback is, however, that the reconstruction becomes more challenging. This is because there is a considerable increment of the processing data due to the multiple energy bins and materials in the reconstruction analysis, as well as improved resolution. Yet efficient material decomposition and reconstruction methods tend to generate noisy images that do not completely satisfy the expected image quality. Therefore, there is a need for efficient denoising of the resulting material images. We present a new and fast denoiser that is based on a linear minimum mean square error (LMMSE) estimator. The LMMSE is very fast to compute, but not commonly used for CT image denoising, probably due to its inability to adapt the amount of denoising to different parts of the image and the difficulty to derive accurate statistical properties from the CT data. To overcome these problems we propose a model-based deep learning strategy, that is, a deep neural network that preserves an LMMSE structure (model-based), providing more robustness unseen data, as well as good interpretability to the result. In this way, the solution adapts to the anatomy in every point of the image and noise properties at that particular location. In order to asses the performance of the new method, we compare it to both to a conventional LMMSE estimator and to a “black-box” CNN in a simulation study with anthropomorphic phantoms.

LMMSE and MAP estimators for reduction of multiplicative noise in the nonsubsampled contourlet domain