Capillary atmospheric pressure chemical ionization using liquid point electrodes.

The fragmentation behavior of taxoids was studied using electrospray (ESI) and atmospheric pressure chemical ionization (APCI) sources with multi-stage tandem mass spectrometry. In the positive ion mode taxoids gave prominent [M+Na]+ and [M+K]+ ions with the ESI source, and [M+NH4]+ or [M+H]+ ions with the APCI source. The MS/MS fragmentations of ions produced by APCI and ESI sources were very similar. For both sources, the presence of cinnamoyl or benzoyl groups could be characterized by initial losses of 148 or 122 u, respectively, from molecular adduct ions. However, the elimination of cinnamic acid was relatively difficult for the molecular adduct ions formed by APCI, and was comparable in importance to the loss of acetic acid. The other fragments involved losses of CH2CO, CO, and H2O. The 5/7/6 type taxoids underwent characteristic losses of 58 or 118 u from ions produced by both APCI and ESI sources. The fragmentation behavior was remarkably influenced by substitution locations. The elimination of the C-10 benzoyl group was usually the first fragmentation step, while that of the C-2 benzoyl group was relatively difficult. The acetoxyl group at C-7 was more active than those at C-2, C-9, and C-10, which in turn were more active than that at C-4. These fragmentation rules could facilitate the rapid screening and structural characterization of taxoids in plant extracts by high-performance liquid chromatography/mass spectrometry (HPLC/MS).

Direct coupling of supercritical fluid extraction to a gas phase atmospheric pressure chemical ionisation source ion trap mass spectrometer for fast extraction and analysis of food components

The capabilities of a recently launched atmospheric pressure chemical ionization (APCI) source for mass spectrometry (MS) coupled to gas chromatography (GC) have been tested in order to evaluate its potential in pesticide residue analysis in fruits and vegetables. Twenty-five pesticides were selected due to their high fragmentation under electron ionization (EI), making that the molecular ion (M+) is practically absent in their spectra. The fragmentation of these pesticides under APCI conditions was studied, with the result that M+ was not only present but also highly abundant for most compounds, with noticeable differences in the fragmentation patterns in comparison with EI. Moreover, the addition of water as modifier was tested to promote the formation of protonated molecules ([M+H]+). Under these conditions, [M+H]+ became the base peak of the spectrum for the majority of compounds, thus leading to an increase of sensitivity in the subsequent GC–MS/MS method developed using triple quadrupole analyzer (QqQ). Highly satisfactory sensitivity and precision, in terms of repeatability, were reached and linearity was satisfactory in the range 0.01–100ng/mL. The developed methodology was applied to apple, orange, tomato and carrot QuEChERS fortified extracts in order to evaluate the matrix effects. In summary, the soft and reproducible ionization in the APCI source has greatly favored the formation of [M+H]+ oppositely to EI where abundant fragmentation occurs and where the molecular ions have low abundance or are even absent in the mass spectrum. In this way, the use of APCI has facilitated the development of tandem MS methods based on the selection of abundant [M+H]+ as precursor ion.

Recent evidence has shown that the atmospheric pressure chemical ionization (APCI) mechanism can be more complex than generally assumed. In order to better understand the processes in the APCI source, for the first time, an ionization efficiency scale for an APCI source has been created. The scale spans over 5 logIE (were IE is ionization efficiency) units and includes 40 compounds with a wide range of chemical and physical properties. The results of the experiments show that for most of the compounds the ionization efficiency order in the APCI source is surprisingly similar to that in the ESI source. Most of the compounds that are best ionized in the APCI source are not small volatile molecules. Large tetraalkylammonium cations are a prominent example. At the same time, low-polarity hydrocarbons pyrene and anthracene are ionized in the APCI source but not in the ESI source. These results strongly imply that in APCI several ionization mechanisms operate in parallel and a mechanism not relying on evaporation of neutral molecules from droplets has significantly higher influence than commonly assumed.

A slightly modified atmospheric pressure chemical ionization source is employed for direct quantitative analysis of volatile or semivolatile organic compounds in air. The method described here is based on the direct introduction of an analyte in the gas or particle phase, or both, into the ion source of a commercial ion trap mass spectrometer. For quantitation, a standard solution is directly transferred into the vaporizer unit of the ion source via a deactivated fused-silica capillary by using the sheath liquid syringe pump, which is part of the mass spectrometer. The standard addition procedure is conducted by varying the pump rate of a diluted solution of the standard compound in methanol/water. A N2 sheath gas flow is applied for optimal vaporization and mixing with the analyte gas stream. By performing detailed reagent ion monitoring experiments, it is shown that the relative signal intensity of [M + H]+ ions is dependent on the relative humidity of the analyte gas stream as well as the composition and concentration of CI reagent ions. The method is validated by a comparison of the standard addition results with a calibration test gas of known concentration. To demonstrate the potential of atmospheric pressure chemical ionization mass spectrometry as a quantitative analytical technique for on-line investigations, a tropospherically relevant reaction is carried out in a 493-L reaction chamber at atmospheric pressure and 296 K in synthetic air at 50% relative humidity. Finally, the applicability of the technique to rapidly differentiate between analytes in the gas and particle phase is demonstrated.

Indoles are common building blocks of new pharmacologically active chemical entities in drug discovery and development. Due to their poor ionization in electrospray ionization mass spectrometry, atmospheric pressure chemical ionization (APCI) is the method of choice for LC-MS analysis of simple indoles. Three types of ions, including [M − 1]+, , and [M + H]+, can be observed in APCI but the relative intensities of these ions may vary depending upon the structural properties of the indoles and the mass spectral source conditions. We report in this paper the observation of [M − 1]+ions for methylindoles in an Agilent multimode ion source and the investigation into their formation. By means of tandem mass spectrometric experiments performed on a Thermo Fisher Scientific LTQ ion trap mass spectrometer equipped with an APCI source, it was found that [M − 1]+ions can be generated from ions upon-collision induced dissociation. This suggests that the [M − 1]+ions might be the in-source fragmentation product of ions. It was proposed that both [M − 1]+and ions are probably generated through a charge transfer mechanism while [M + H]+ions are the product of proton transfer. The basicity of the analytes might play an important role in dictating which ionization mechanism is operative. For 3-methylindole, the charge transfer process appears to be more dominant than for 2-methylindole since the former is less basic. As expected, substituting electron withdrawing groups on 3-methylindole, such as fluorine, promotes charge transfer and vice versa. Therefore, it is expected that formation of the [M − 1]+ions is more pronounced for less basic methylindoles.

A fast, simple and sensitive liquid chromatography/tandem mass spectrometry (LC/MS/MS) method was developed for the determination of acetylcholine in rat brain microdialysis samples. The chromatographic separation was achieved in 3 min on a reversed-phase column with isocratic conditions using a mobile phase containing 2% (v/v) of acetonitrile and 0.05% (v/v) of trifluoroacetic acid (TFA). A stable isotope-labeled internal standard was included in the analysis and detection was carried out with a linear ion trap mass spectrometer using selected reaction monitoring (SRM). Analyte ionization was performed with an atmospheric pressure chemical ionization (APCI) source without applying discharge current (atmospheric pressure spray ionization). This special ionization technique offered significant advantages over electrospray ionization for the analysis of acetylcholine with reversed-phase ion-pairing chromatography. The lower limit of quantification was 0.15 nM (1.5 fmol on-column) and linearity was maintained over the range of 0.15-73 nM, providing a concentration range that is significantly wider than that of the existing LC/MS methods. Good accuracy and precision were obtained for concentrations within the standard curve range. The method was validated and has been used extensively for the determination of acetylcholine in rat brain microdialysis samples.

Atmospheric pressure chemical ionization is employed for direct air analysis, without ion source modification, by using the sheath gas as the sample transport agent. A simple modification of the sheath gas inlet line allows introduction of gaseous samples into a commercial atmospheric pressure chemical ionization source. Optimization and testing of this novel air sampling method are described and detection of semivolatile compounds is shown. The analytical performance of the technique is established with methyl salicylate, including a limit of quantification of 100 pptr, a limit of detection of 50 pptr, a linear response from 100 pptr to 20 ppb, and rise and fall times of 12 and 20 s, respectively. Using reagent ion monitoring, it is shown that the protonated methanol dimer is the principal CI reagent ion leading to protonated dimethyl methylphosphonate, while the monomer is mainly responsible for protonating methyl salicylate. Since the formation of the CI reagent (methanol clusters) can be controlled by simple variation of experimental parameters, the selectivity of the method can be easily adjusted to suit the targeted analyte. Performance is found to be independent of the choice of air or nitrogen as the sheath gas (and thus as the sample matrix) and this, together with the sensitivity and speed of the technique, make it promising for field studies.

The objective of this work is to study the interaction of methanol droplets with the heated surface for the improved detection of low-volatility and thermally labile compounds by the flash evaporation that occurs below the Leidenfrost temperature. 5 μL solutions of low-volatility compounds in methanol were introduced into the heated tube. Desorbed analytes were ionized in the sealed atmospheric pressure chemical ionization (APCI) source by direct current (DC) corona discharge using air as the reagent gas. The rapid desorption of low-volatility compounds accompanied by the flash evaporation of methanol solvent was observed in the temperature range of 60-100°C. Linear relationships between the signal intensities and the solute concentrations in the range of 0.01-5 ppm for morphine, cocaine, methamphetamine, and amphetamine were obtained at 95°C. The observed rapid desorption of low-volatility compounds below the Leidenfrost temperature would provide useful information in many fields, e.g., the interaction of liquid droplets with heated matter, liquid sample introduction into the injection port of a gas chromatograph, coupling of the flash evaporation with pulse valve operated miniaturized mass spectrometer, etc.

Ionization of esters of carboxylic acids RCOOR' (R = H, alkyl; R' = alkyl) within the air plasma of the Atmospheric Pressure Chemical Ionization (APCI) source occurs largely via H(+)-transfer and, to a minor extent, via NO(+) association. The protonated ester MH(+) is normally observed as M(2)H(+) and as higher aggregates (M(3)H(+), M(3)H(+)(H(2)O)) also at high source temperature. The behavior of M(2)H(+) upon collisional activation is consistent with the reported dissociation of proton-bound dimers to MH(+) species that, in turn, fragment according to the known paths of lowest energy. In addition, other important product ions form within the plasma, some in very high relative abundance, which are attributed to ion-molecule condensation reactions between neutral M and either MH(+) or M(2)H(+) resulting in the elimination of CO, R'OH, alkene from the alkoxy moiety of the ester and HCOOH. A general scheme is proposed to account for the experimental observations, which suggest that the encounter complex formed between MH(+) and M or between M(2)H(+) and M may either collisionally relax to the protonated dimer or trimer, respectively, or react via covalent bond forming and cleaving steps to eliminate stable neutral molecules. The proposed scheme is supported by both the observed concentration dependence and the temperature dependence of the products relative abundances within the plasma. Such reactions can be the dominant process, as in the case of formate esters. A second significant ionization route involves addition of NO(+) to form M(n)NO(+) (n = 1, 2, 3). An additional product corresponding to [M(2)NO(+) - CO(2)] is also observed with iso- and n-butyl formate esters.

Contribution of atmospheric pressure chemical ionization mass spectrometry for the characterization of bio-oils from lignocellulosic biomass: Comparison with electrospray ionization and atmospheric pressure photoionization

Atmospheric pressure chemical ionization source as an advantageous technique for gas chromatography-tandem mass spectrometry

Comparison of universal detectors for high-temperature micro liquid chromatography

Previous studies have shown that calcium stressed Saccharomyces cerevisiae, challenged with immunosuppressant drugs FK506 and Cyclosporin A, responds with comprehensive gene expression changes and attenuation of the generalized calcium stress response. Here, we describe a global metabolomics workflow for investigating the utility of tracking corresponding phenotypic changes. This was achieved by efficiently analyzing relative abundance differences between intracellular metabolite pools from wild-type and calcium stressed cultures, with and without prior immunosuppressant drugs exposure. We used pathway database content from WikiPathways and YeastCyc to facilitate the projection of our metabolomics profiling results onto biological pathways. A key challenge was to increase the coverage of the detected metabolites. This was achieved by applying both reverse phase (RP) and aqueous normal phase (ANP) chromatographic separations, as well as electrospray ionization (ESI) and atmospheric pressure chemical ionization (APCI) sources for detection in both ion polarities. Unsupervised principle component analysis (PCA) and ANOVA results revealed differentiation between wild-type controls, calcium stressed and immunosuppressant/calcium challenged cells. Untargeted data mining resulted in 247 differentially expressed, annotated metabolites, across at least one pair of conditions. A separate, targeted data mining strategy identified 187 differential, annotated metabolites. All annotated metabolites were subsequently mapped onto curated pathways from YeastCyc and WikiPathways for interactive pathway analysis and visualization. Dozens of pathways showed differential responses to stress conditions based on one or more matches to the list of annotated metabolites or to metabolites that had been identified further by MS/MS. The purine salvage, pantothenate and sulfur amino acid pathways were flagged as being enriched, which is consistent with previously published literature for transcriptomics analysis. Thus, broad discovery-based data mining combined with targeted pathway projections can be an important asset for rapidly distilling, testing and evaluating a large amount of information for further investigation.

An improved and fully validated LC–MS/MS method for the simultaneous quantification of simvastatin and simvastatin acid in human plasma