- https://doi.org/10.31274/rtd-20200723-9
CMOS interface circuits for spin tunneling junction based magnetic random access memories
- Jan 1, 2002
- Ganesh Saripalli
Magneto resistive memories (MRAM) are non-volatile memories which use magnetic instead of electrical structures to store data.These memories , apart from being nonvolatile, offer a possibility to achieve densities better than DRAMs and speeds faster than SRAMs.MRAMs could potentially replace all computer memory RAM technologies in use today, leading to future applications like instant-on computers and longer battery life for pervasive devices.Such rapid development was made possible due to the recent discovery of large magnetoresistance in Spin tunneling junction devices.Spin tunneling junctions (ST J) are composite structures consisting of a thin insulating layer sandwiched between two magnetic layers.This thesis research is targeted towards these spin tunneling junction based Magnetic memories.In any memory, some kind of an interface circuit is needed to read the logic states.In this thesis, four such circuits are proposed and designed for Magnetic memories (MRAM).These circuits interface to the Spin tunneling junctions and act as sense amplifiers to read their magnetic states.The physical structure and functional characteristics of these circuits are discussed in this thesis.Mismatch effects on the circuits and proper design techniques are also presented.To demonstrate the functionality of these interface structures, test circuits were designed and fabricated in TSMC 0.35µ CMOS process.Also circuits to characterize the process mismatches were fabricated and tested.These results were then used in Matlab programs to aid in design process and to predict interface circuit's yields. 1 INTRODUCTION MotivationThe field of Magneto-resistive random access memories (MRAM) has experienced significant development ever since they were introduced two decades ago [2).Continued research efforts in this field have helped them compete with the faster and denser semiconductor random access memories , making them a potentially attractive solution for future memory applications.These memories were initially targeted to replace early non-volatile memory technologies like Ferrite cores and Plated wire, because these have infinite read/write endurance and need less energy to write, making them a favorable solution for even high-speed re-programmable systems.Successful working models of magneto-resistive memories have been demonstrated in the past [3,4,5,6,7,8) using either Anisotropic Magneto-resistance effect (AMR) or Giant Magneto-resistance effect (GMR).These memories, even though successful, could not compete with the semiconductor RAMs due to slower read speeds.The amount of magneto-resistance available was not high enough for successful application (typically 6% in GMR, 2% in AMR); resulting in small input signal levels for the sense circuits.This resulted in large access times and also degradation in the signal-to-noise ratio.But ever since the discovery of Spin tunneling junctions in 1995 [9), application of these devices in MRAMs is a great opportunity to compete with contemporary semiconductor memories.Spin tunneling junctions are inherently high impedance devices and demonstrated a large magneto-resistance effect of nearly 40% in certain cases [10 , 11] .Due to these characteristics, MRAMs based on spin tunneling junctions may have comparable input signal levels (20m V) on par with semiconductor memory elements; and thus should
- # Spin Tunneling Junction
- # Magneto-resistive Memories
- # Magneto-resistive Random Access Memories
- # Random Access Memories
- # Interface Circuit
- # Magneto-resistance Effect
- # Anisotropic Magneto-resistance Effect
- # Tunneling Junctions
- # Contemporary Semiconductor
- # Giant Magneto-resistance