Cooperative MAC protocol with distributed relay selection using group-based probabilistic contention

Cooperative communication takes advantage of the broadcast nature of the wireless medium and spatial diversity, and has been applied to design the medium access control (MAC) protocol based on IEEE 802.11. However, the state-of-the-art cooperative MAC protocols do not exploit the advantage of cooperative gain fully. In order to solve the problem and improve the packet delivery ratio and end-to-end throughput, this paper proposes an improved cooperative MAC (IC-MAC) protocol, which is backward compatible to the legacy IEEE $802.~11\mathrm {b}$. The numerical analysis demonstrates that the IC-MAC protocol outperforms the IEEE $802.~11\mathrm {b}$ and the typical cooperative MAC protocol on the packet delivery ratio and end-to-end throughput when the packet error rate of the direct transmission channel exceeds a certain threshold.

In this work, we propose an instantaneous rate based cooperative medium access control (MAC) protocol (termed as IrcMAC) and compare its performance gain over the existing cooperative MAC protocols under heavy load and fast fading conditions. CoopMAC I protocol, proposed in [5] which selects either direct path or relay path based on rate comparison to enhance average throughput and delay, performs worse under fading conditions due to lower direct path or relay path reliability. UtdMAC protocol, proposed in [8], performs better than CoopMAC I due to improved transmission reliability provided by the back up relay path, however, it uses relay path only as a secondary backup path. Our proposed IrcMAC protocol makes use of channel coherence time and estimates instantaneous signal-to-noise ratio (snr(t)) of source-to-relay, relay-to-destination and source-to-destination links; to reliably select between relay path or direct path for enhanced throughput and delay performances. Simulation results clearly show that IrcMAC significantly outperforms the existing CoopMAC I and the UtdMAC protocols in wireless ad hoc network.

Relay-based cooperative communications have been emerging as a novel paradigm in many wireless protocols. The IEEE 802.11 medium access control (MAC) protocols have attracted many cooperative techniques. The relay selection algorithms have a remarkable influence on the design and the performance of the cooperative MAC (CMAC) protocols. Most of the existing algorithms have been designed based on a single objective such as spectrum efficiency and energy efficiency. In this paper, two multi-objective CMAC protocols are proposed: FCGMAC and EECMAC. The FCGMAC employs a multiple relay selection algorithm providing the spectrum efficiency and fairness. The EECMAC exploits a single relay selection improving the energy efficiency and the spectrum efficiency. The proposed protocols have been simulated in the ns-3 network simulator and the simulation results indicate the improvement of network performance according to the design objectives.

Medium access control (MAC) protocols have been studied under different contexts for several years now. In all these MAC protocols, nodes make independent decisions on when to transmit a packet and when to back-off from transmission. In this paper, we introduce the notion of node cooperation into MAC protocols. Cooperation adds a new degree of freedom which has not been explored before. Specifically we study the design of cooperative MAC protocols in an environment where each node is equipped with a single transceiver and has multiple channels to choose from. Nodes cooperate by helping each other select a free channel to use. We show that this simple idea of cooperation has several qualitative and quantitative advantages. Our cooperative asynchronous multi-channel MAC protocol (CAM-MAC) is extremely simple to implement and, unlike other multi-channel MAC protocols, is naturally asynchronous. We conduct extensive simulation experiments. We first compare CAM-MAC with IEEE 802.11b and a version of CAM-MAC with the cooperation element removed. We use this to show the value of cooperation. Our results show significant improvement in terms of number of collisions and throughput for CAM-MAC. We also compare our protocol with MMAC and SSCH and show that CAM-MAC significantly outperforms both of them.

In wireless sensor networks, in order to satisfy the requirement of long working time of energy-limited nodes, we need to design an energy-efficient and lifetime-extended medium access control (MAC) protocol. In this paper, a node cooperation mechanism that one or multiple nodes with higher channel gain and sufficient residual energy help a sender relay its data packets to its recipient is employed to achieve this objective. We first propose a transmission power optimization algorithm to prolong network lifetime by optimizing the transmission powers of the sender and its cooperative nodes to maximize their minimum residual energy after their data packet transmissions. Based on it, we propose a corresponding power-optimized cooperative MAC protocol. A cooperative node contention mechanism is designed to ensure that the sender can effectively select a group of cooperative nodes with the lowest energy consumption and the best channel quality for cooperative transmissions, thus further improving the energy efficiency. Simulation results show that compared to typical MAC protocol with direct transmissions and energy-efficient cooperative MAC protocol, the proposed cooperative MAC protocol can efficiently improve the energy efficiency and extend the network lifetime.

In this paper we propose a simple relay enabled medium access (SRMAC) protocol that enables cooperative relay transmissions. Due to the wireless signal power attenuation with distance, using a relay in a wireless network can make wireless networking more bandwidth efficient at the expense of requiring multiple transmissions for a single packet. Standard MAC protocols such as the IEEE 802.11 MAC protocol, while useable with relaying, however are not designed explicitly for relay communication. When IEEE 802.11 MAC protocol is used for cooperative communication such a relaying, each packet transmission would need to separately contend for the channel via a channel access procedure which can use significant resources (both energy and bandwidth). Because using a single relay requires two transmissions, an efficient medium access control (MAC) protocol that supports two hop transmission is needed. We introduce a protocol, SRMAC, which is a simple cooperative MAC protocol that utilizes information from the physical layer for the MAC operation of relay networks. We consider the bandwidth efficiency of SRMAC protocol considering both the physical layer and MAC layer. The SRMAC protocol includes the possibility of both cooperative transmission and direct transmission. With SRMAC, cooperative transmission (relaying) can be dynamically chosen when it is more beneficial than direct transmission. The SRMAC protocol can improve the throughput by up to 20% compared to conventional MAC protocols.

Power efficient ultra-wideband based wireless communication for wireless body area network applications

Since cognitive wireless network (CRN) has the characteristic of secondary use, it can enable the device to dynamically access available spectrum without interference to primary users (PUs), which can effectively alleviate contradiction between the lack of spectrum resources and the growing demand for wireless access. However, Medium Access Control (MAC) protocol as CRN core components, can achieve competition access of the licensed spectrum and coordination control, which will maximize spectrum utilization efficiency and network throughput. The contribution of this survey is threefold. First, we analyze the characteristics of the existed multi- channel MAC protocol in CRN; Second, according to the different ways of spectrum access in CRNs, the multi-channel MAC protocols are classified into time-slotted based MAC protocol, control channel based MAC protocol and hybrid MAC protocol, and the paper emphatically analyzed the advantages and disadvantages of these multi-channel MAC protocols; Finally, the paper explores the difficulties and the challenges of multi-channel MAC protocols design in cognitive wireless network.

Cognitive Radio (CR) exploits underutilized licensed spectrums to improve its bandwidth availability. Using CR technology, a node is able to adapt its transmission and reception radio parameters including channel frequency dynamically according to local spectrum availability. For channel access between wireless nodes, a cognitive Medium Access Control (MAC) protocol is necessary to coordinate the CRs. Multi-channel MAC protocol extensions have been proposed in IEEE802.11 to enable a node to operate in multiple channels in order to improve network-wide throughput. These multi-channel MAC protocols have several functions that can be leveraged by cognitive MAC protocols due to their similarities in certain aspects, though the CR has an additional requirement to cope with the existence of licensed users that have higher authority over the channels. Current research in cognitive MAC protocols assumes the availability of a common control channel at all times, which is an approach in the multi-channel MAC protocols. This approach has certain hardware requirements that may not be readily available at CR nodes. Hence, other approached may be necessary. In this paper, various types of multi-channel MAC protocols are reviewed, followed by discussion of their merits and demerits in multi-channel environments. The purpose is to show the additional functionalities and challenges that each multi-channel MAC protocol has to offer and address in order to operate in multihop CR networks. By providing discussion on possible technology leverage from multi-channel to cognitive MAC protocols, we aim to establish a foundation for further research and discussion.

Two important criteria of wireless body area networks (WBANs) are low power consumption and delay. These criteria can be met by designing efficient medium access control (MAC) protocols. In this paper, two TDMA-based MAC protocols are proposed. The first protocol, TM–MAC makes use of only a main radio. The second proposed protocol, TWM–MAC makes use of a WUR alongside the main radio. The two proposed protocols are compared with different categories of standard MAC protocols and it is shown that they outperform the standard ones by improving the power consumption and delay. The TWM–MAC consumes 55% less power consumption than the Scheduled Channel Polling MAC (SCP–MAC) protocol for a high traffic scenario on the high-rate platform while the TM-MAC consumes 85% less power consumption than the SCP–MAC. For a low traffic scenario, the TWM–MAC performs 53.5% better than the SCP–MAC protocol and 77.5% better than the very low power MAC (VLPM) protocol on the high and low-rate platforms respectively. An improvement in delay was observed with the TWM–MAC protocol for high traffic situations. The TWM–MAC protocol surpasses the VLPM protocol by 81.1% in terms of latency for a high traffic scenario and 3.2% for a low traffic scenario.

The key contributions of this paper are the proposed Pure Collective Aloha (PCA) medium access control (MAC) protocol with multilevel powers and its closed-form theoretical analysis. The PCA MAC protocol collects a batch of packets before transmitting these packets sequentially in the channel. The key idea in the design of this PCA MAC protocol with multilevel powers is to spread out the arrivals of each batch of packets in a channel and the multilevel powers of the packets received at the receiver allow capture for the case of the strongest signal power packet among the overlapping lower signal power packets to be successfully received at the receiver. If it is the only received packet, it is successfully received, regardless of its received power level. The PCA MAC protocol with multilevel powers is analyzed theoretically. The explicit closed-form expressions for the optimal offered loads and the maximum throughputs of the Pure Aloha, the Slotted Aloha and the PCA MAC protocols with multilevel powers are presented. The numerical results show that the throughput of the asynchronous PCA MAC protocol with multilevel powers is about 90.5% better than that of the asynchronous Pure Aloha MAC protocol with multilevel powers and can approach the maximum throughput bound of the synchronous Slotted Aloha MAC protocol with multilevel powers, without the need of any synchronization mechanism to slot boundaries.

High throughput and fair resource sharing are two of the most important objectives in designing a medium access control (MAC) protocol. Currently, most MAC protocols including IEEE 802.11 DCF adopt a random access based approach in a distributed manner in order to coordinate the wireless channel accesses among competing stations. In this paper, we first identify that a random access–based MAC protocol may suffer from MAC protocol overhead such as a random backoff for data transmission and a collision among simultaneously transmitting stations. Then, we propose a new MAC protocol, called sequential coordination function (SCF), which coordinates every station to send a data frame sequentially one after another in a distributed manner. By defining a service period and a joining period, the SCF eliminates unnecessary contentions during the service period, and by explicitly determining the sequence of frame transmission for each stations, it reduces collision occurrences and ensures fairness among stations in the service period. The performance of SCF is investigated through intensive simulations, which show that the SCF achieves higher throughput and fairness performances than other existing MAC protocols in a wide range of the traffic load and the number of stations.

A joint MIMO-OFDM transceiver and MAC design for mobile ad hoc networking

IEEE 802.11 Distributed Coordination Function (DCF) guarantees fair transmission opportunity to stations. Channel occupation of low rate stations in IEEE 802.11 Wireless Local Area Network (WLAN) causes the performance anomaly resulting in the degradation of overall network throughput. Using cooperative communications between a high rate station and a low rate station, performance anomaly can be mitigated in IEEE 802.11 WLAN. In this paper, we propose a new cooperative Medium Access Control (MAC) protocol to remedy the performance anomaly and to improve transmission opportunities for low rate stations. We show that the proposed cooperative MAC protocol can enhance overall performance (e.g., throughput and MAC delay).

Radio Frequency Identification (RFID) has become widespread thanks to its important advantages over traditional identification technologies, like barcodes. Compared to this technology, RFID is, in fact, able to cover larger distance and does not require line-of-sight, that represent important improvements in the considered field of application. An RFID system is formed by a set of n tags, that represent clients in the identification process, and a tag reader, that is the identification server. Each tag is associated with an identifier (ID), that must be transmitted to the reader upon receipt of a suitable identification query. Tags can be active, i.e. provided with an independent power supply (like a battery), or passive. In the latter case, tags depend on energy provided by the tag reader through its queries (Want, 2006). For this reason, active tags can have some data processing ability, while passive tags are limited to doing only elementary operations and replying to the reader’s queries. An important issue in Radio Frequency Identification systems concerns the reading of colocated tags, that must be managed through suitable Medium Access Control (MAC) protocols, specifically designed for low power devices. Efficiency of MAC protocols for RFID systems directly influences the time needed by the tag reader for completely identifying a set of co-located tags, so it has great impact on the whole system performance. A deep analysis of the MAC technologies adopted in RFID is the aim of this chapter. We denote by Ttot(n) the time needed by the tag reader for completely identifying a set of n tags. Under ideal conditions, it should be Ttot(n) = nTpkt, where Tpkt is the time needed to transmit one identification packet. However, in order to ensure collision-free transmission to each tag, a MAC protocol is needed that, inevitably, produces a time waste with respect to the ideal condition. The time actually needed for identification depends on several factors, like the technology adopted, the working frequency, etc. So, RFID systems can exhibit very different reading rates, typically ranging between 100 Tag/s and 1000 Tag/s. The most common MAC protocols used in RFID systems can be grouped into two classes: deterministic protocols and stochastic protocols. Deterministic protocols basically coincide with tree traversal algorithms: all RFID tags form a binary tree on the basis of their identifiers, and the reader explores the tree in a systematic way, by repeating queries based on bit masks. Randomness is only in the tree structure (due to the choice of the co-located tag set), while the algorithm execution is pre-determined. Stochastic MAC protocols are instead based on the framed slotted Aloha (FSA) algorithm, that requires each tag to make a constrained pseudo-random choice of an integer number in order to reduce the probability of collisions.