- Book Chapter
- 10.1002/9781119088042.refs
References
- Aug 26, 2016
References
The emerging applications for mobile internet in different areas such as education, health care, smart grids, and security are growing very fast. Due to the integration of these applications with people's lives it is inevitable that over then the next ten years there will be huge increases in the required user data rate per area and the spectral efficiency. On the other hand, delivering a higher data rate per area requires more transmission power, which is constrained not only by safety limits but also by the importance of the global warming issues and need for green communications. Therefore, high-speed transmission would mean a diminishing coverage range, as otherwise, an enormous increase of transmission power is required by both mobile terminals and base stations to maintain the current cell size and achieve the ambitious targets of the beyond-IMT advanced technologies.
References
References
Special issue on energy‐efficient wireless communication networks with QoS
Special issue on energy‐efficient wireless communication networks with QoS
When the Smart Grid Meets Energy-Efficient Communications: Green Wireless Cellular Networks Powered by the Smart Grid
Recently, there is great interest in considering the energy efficiency aspect of cellular networks. On the other hand, the power grid infrastructure, which provides electricity to cellular networks, is experiencing a significant shift from the traditional electricity grid to the smart grid. When a cellular network is powered by the smart grid, only considering energy efficiency in the cellular network may not be enough. In this paper, we consider not only energy-efficient communications but also the dynamics of the smart grid in designing green wireless cellular networks. Specifically, the dynamic operation of cellular base stations depends on the traffic, real-time electricity price, and the pollutant level associated with electricity generation. Coordinated multipoint (CoMP) is used to ensure acceptable service quality in the cells whose base stations have been shut down. The active base stations decide on which retailers to procure electricity from and how much electricity to procure. We formulate the system as a Stackelberg game, which has two levels: a cellular network level and a smart grid level. Simulation results show that the smart grid has significant impacts on green wireless cellular networks, and our proposed scheme can significantly reduce operational expenditure and CO_2 emissions in green wireless cellular networks.
Read moreEnergy efficient cellular networks with CoMP communications and smart grid
There is great interest in considering the energy efficiency aspect of wireless cellular networks. Coordinated multipoint (CoMP) communication is a new method that helps with the implementation of dynamic base station coordination for energy efficient communications. On the other hand, the power grid infrastructure is experiencing a significant shift from the traditional electricity grid to the smart grid. In this paper, we consider not only energy efficient communications but also the dynamics of the smart grid in designing green wireless cellular networks. We formulate the system as a Stackelberg game, which has two levels: a cellular network level and a smart grid level. Simulation results show that the smart grid has significant impacts on green wireless cellular networks, and our proposed scheme can significantly reduce operational expenditure and CO <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">2</sub> emissions in green wireless cellular networks.
Read moreDynamic operation of BSs in green wireless cellular networks powered by the smart grid
There is great interest in considering the energy efficiency aspect of wireless cellular networks. When a wireless cellular network is powered by the smart grid, only considering energy efficiency in the cellular network is not enough. In this paper, we consider not only energy-efficient communications but also the dynamics of the smart grid in operating green wireless cellular networks. We formulate the system as a two-level Stackelberg game. A backward induction method is used to analyze the proposed scheme. we prove that the Stackelberg equilibrium (SE) of the proposed game exists and is unique. An iteration algorithm is proposed to obtain the SE. Simulation results show that the smart grid has a significant impact on green wireless cellular networks, and our proposed scheme can significantly reduce operational expenditure and CO2 emissions in green wireless cellular networks.
Read moreRelax, but Do Not Sleep: A new perspective on Green Wireless Networking
Saving power on base stations (BS) becomes a critical issue in wireless cellular networks. Many existing work has proposed to schedule BS into sleep to save energy. However, in reality, it is very difficult to shut down and reboot BSs frequently due to numerous technical issues and performance requirements. In this work, we propose a much more practical solution and offer a new perspective on implementing Green Wireless Networking by embracing the hot-trended small cell network idea. Instead of putting BSs into sleep, we tactically reduce the coverage (and the power usage) of each BS, and strategically place microcells (relay stations) to offload the traffic transmitted to/from BSs in order to save total power consumption. We propose approximation algorithms for various network design scenarios, with different wireless network setups and different power saving optimization objectives. Extensive numerical results are presented to confirm our theoretical analysis.
Read moreEnergy-efficient subcarrier optimization scheme based on particle swarm for green radio wireless networks
The growing awareness towards energy efficient cellular networks has paved way for new technologies to enable design towards green cellular networks. According to technical analysts, the base stations are the most energy intensive element in a typical cellular network. Saving power in base stations is therefore the primary focus in green cellular networks. The main goal of designing green base stations is for saving energy and reducing power consumption while guaranteeing service and coverage for users and ensuring the capability of base station for evolution. One cannot ignore the amount of energy that is wasted due to the lack of efficient utilization of resources. This was the main motivation behind this study. This paper aims to exploit the dynamic traffic load conditions to improve the downlink energy consumption by achieving optimal balancing between the number of subcarriers and dynamic traffic load conditions. Particle Swarm Optimization (PSO) has been adopted to optimize the subcarriers under the condition of maximum traffic load while guaranteeing the QOS under the constraint of minimal power per subcarrier. Simulation results show that the annual energy savings that achieved by this approach only for one base station up to 130 kWh. Hence, in a large area with thousands of base stations or even more, the aggregate energy savings could be substantial as well as the annual OPEX saving.
Read moreSpecial issue on green radio
International audience
Handoffs in Cellular Wireless Networks: The Daedalus Implementation and Experience
Network protocols in cellular wireless data networks must update routes as a mobile host moves between cells. These routing updates combined with some associated state changes are called handoffs. Most current handoff schemes in wireless networks result in data loss or large variations in packet delivery times. Unfortunately, many applications, such as real-time multimedia applications and reliable transport protocols, adapt to long term estimates of end-to-end delay and loss. Violations and rapid fluctuations of these estimates caused by handoff processing often result in degraded performance. For example, loss during handoff adversely affects TCP performance [4], and high packet loss and variable delays result in poor real-time multimedia performance. In this paper, we describe a multicast-based protocol that eliminates data loss and incurs negligible delays during a handoff. The basic technique of the algorithm is to anticipate a handoff using wireless network information in the form of received signal strengths and to multicast data destined for the mobile host to nearby base stations in advance. This routing, combined with intelligent buffering techniques at the base stations, enables very rapid routing updates and eliminates data loss without the use of explicit data forwarding. We have implemented this protocol using IP Multicast and Mobile IP-like routing. In our implementation, handoffs typically take between 8 and 15 ms to complete and result in no data loss.
Read moreNumerical Approach to Performance Analysis of Multi-Parametric CAC in Multi-Service Wireless Networks
Numerical Approach to Performance Analysis of Multi-Parametric CAC in Multi-Service Wireless Networks
Visible Light Communications for Energy Efficient Heterogeneous Wireless Networks
The necessity of having energy efficient wireless communication networks emerges because of the related environmental and economical benefits. Achieving energy efficient wireless communications using visible light communications (VLC) has been recently studied due to its transmission properties. Moreover, the integration of VLC and radio frequency (RF)-based wireless networks has shown improved data rate and reliability for the mobile users. In this chapter, we investigate the energy efficiency of the integration of VLC and RF wireless networks. We formulate and solve the energy efficiency maximization problem by allocating the power and bandwidth of a heterogenous RF/VLC wireless network. We study the impact of various system parameters on the network performance. Numerical results are presented to demonstrate the performance gains of the hybrid system and to quantify the impact of the system specifications on the achieved energy efficiency. Moreover, several challenging issues due to the RF/VLC integration are addressed.
Read moreIntegrating Wireless Cellular and Ad-Hoc Networks Using Fuzzy Logic Considering Node Mobility and Security
Several solutions have been proposed for improving the Quality of Service (QoS) in wireless cellular networks, such as Call Admission Control (CAC) and handover strategies. However, none of them considers the usage of different interfaces for different conditions. In this work, we propose a Fuzzy-Based Multi-Interface System (FBMIS), where each node is equipped with two interfaces: the traditional cellular network interface and Mobile Ad hoc Networks (MANET)interface. The proposed FBMIS system is able to switch from cellular to ad-hoc mode and vice versa. We consider four input parameters: Distance Between Nodes (DBN), Node Mobility (NM), Angle between Node and Base station (ANB), and User Request Security (URS). We evaluated the performance of the proposed system by computer simulations using MATLAB. The simulation results show that our system has a good performance.
Read moreAn Integrated System for Wireless Cellular and Ad-Hoc Networks Using Fuzzy Logic
Several solutions have been proposed for improving the Quality of Service (QoS) in wireless cellular networks, such as Call Admission Control (CAC) and handover strategies. However, none of them considers the usage of different interfaces for different conditions. In this work, we propose the Fuzzy-Based Multi-Interface System (FBMIS), where each node is equipped with two interfaces: the traditional cellular network interface and Mobile Ad hoc Networks (MANET) interface. The proposed FBMIS system is able to switch from cellular to Ad-Hoc mode and vice versa. We consider three input parameters: distance between nodes, node mobility and the angle between node and the base station. We evaluated the performance of the proposed system by computer simulations using MATLAB. The simulation results show that our system has a good performance.
Read moreSpatial–Temporal Energy Management of Base Stations in Cellular Networks
The operations of base stations (BSs) contribute most of the energy consumption in the cellular wireless networks. Powering BSs by distributed energy resources (DERs), such as photovoltaic (PV) and energy storage, is an effective way to reduce on-grid power consumption and build green wireless networks. Optimal energy management of BSs helps to reduce electricity bills for the wireless network and provides flexibility to the power networks. This article proposes the concept of spatial–temporal energy management (ST-EM) for the energy management of BSs. On the one hand, the BSs manage their power consumption according to the real-time prices; on the other hand, the BSs adjust the user associations and change their power consumption according to the price differences among different BSs. The ST-EM of BSs is formulated as a large-scale mixed-integer nonlinear programming (MINLP) problem, which is proven to be NP-hard. We propose a heuristic approach to search for one suboptimal solution by decomposing the original problem into an energy network optimization subproblem and a communication network optimization subproblem. The two subproblems are solved alternatively until convergence. Numerical experiments are conducted to verify the effectiveness of our proposed method.
Read moreA power control solution for multicast service in green wireless cellular railway network
The wireless cellular network deployed for railway can be characterized by specific chain structure, high speed mobility, high security requirement, frequent and continuous handover, predicable traffic aligned with train schedule. In this paper, to achieve an energy efficient solution for wireless cellular railway network, we proposed an optimal power control solution to adjust transmission power adaptively based on actual Signal to Interference plus Noise Ratio (SINR) for Multimedia Broadcast multicast service Single Frequency Network (MBSFN) at User Equipment (UE) side when provide Enhanced Multimedia Broadcast Multicast Service ( E-MBMS). The system model and optimization algorithms are introduced. Simulation results show that this solution can be a good way for high network energy efficiency and can dynamically adjust the output power for the multicast service.
Read more