The acronym PID stands for Proportion-Integral-Differential control. Each of these, the P, the I and the D are terms in a control algorithm, and each has a special purpose. Conventional PID controller has a simple structure and can provide satisfactory performance for many control problems. For process control systems, in particular, more than 95% of the controllers used are of PID type (Ogata, 2002). This is because it is easily applicable to field use, and also easily adjustable. The process of stabilization or improving the performance of the system is achieved by attaching a controller or compensator to the closed loop system. There are different types and structures of controllers. However, the controller cannot deal fully with nonlinear and/or time varying systems. In the design of a PID controller, the main difficulty has been how the control gains should be selected for good control performance, especially where the process to be controlled is of high order with complex nonlinear dynamics. This problem is made more difficult by the need to keep these gains tuned, during operations, to ensure robust performance in the face of plant parameter variations, load or environment disturbances and measurement noise. Genetic algorithms (GAs) are one of the efficient tools that are employed in solving optimization problems (Rothlauf, 2006). Because of the simplicity and robustness, PID controllers are frequently the used controllers in industries (Almeida et al., 2005). Parameters adjustment of PID controllers is an old challenge in the field of control system design. Some of methods have been proposed to select the PID coefficients, but they are not completely systematic methods and result in a poorly tuned controller that needs some trail and error. So far, finding new methods to automatically select PID parameters was interest of researches (Ho, 2003), (Almeida et al., 2005), (Nasri et al., 2007), and (Mansour, 2011). However in this chapter, the selection of optimal PID controller coefficients are introduced and applied based on genetic algorithms technique. Therefore it is possible to find genetically the optimal controller coefficients, Kp, Ki, and Kd with the constraint of minimizing absolute or square error signal to achieve system stability and to enhance system performance. However in feedback control systems the most important requirement is the stability of the whole system (Bartoszewicz, 2011). Another requirement is the speed, i.e. in the case of a changing reference value or a disturbance; the control error should be eliminated as soon as possible. Finally, simulation results will be implemented using MATLAB/SIMULINK to test system performance and stability. Due to the fact that in the last two decades MATLAB became the standard computing environment for engineers from different fields of science, a
Read more