Design of optimization algorithm for WLAN AP selection during emergency situations

In wireless local area networks (WLANs) made up of Extended Service Sets, access point (AP) selection is a key issue to improve the network performance and balance the traffic load. WLANs operating in the shared Industrial, Scientific and Medical band can benefit from the use of cognitive radio (CR) techniques to enable dynamic access to spectrum holes that are free from interference. In this paper, we propose an optimal Green AP Selection (GAPS) scheme, in which AP selection is optimized to maximize the system throughput while minimizing the energy consumption, for multi-rate WLANs enhanced by CRs. Different from most existing AP selection schemes, GAPS takes into account of the state transition tendency of APs and the influence of Automatic Rate Fallback mechanism in the Distributed Coordination Function. The AP selection problem is formulated as a restless bandit problem and solved by the primal-dual index heuristic algorithm based on first order relaxation to yield the GAPS scheme with the "indexability" property and hence a low complexity. GAPS is further divided into offline computation, which accounts for the bulk of the computations, and online selection, with a low complexity to facilitate implementation. Extensive simulation results illustrate the significant performance improvements of GAPS compared with existing AP selection schemes in different scenarios.

It is usually possible to associate with more than one Access Point (AP) in IEEE 802.11 Wireless LANs. AP selection is a crucial issue because the performance achieved by a user heavily depends on the AP selected. A received signal strength (RSS)-based association mechanism is specified by the IEEE 802.11 standard. However, this does not consider the channel conditions and AP load, which leads to a low throughput and a low user transmission rate. An alternative to using the RSS is to exploit the airtime metric, which provides users with information on how busy the channel is, but the results of our simulations show that the airtime metric cannot indicate the exact status of the channel. In this paper, we present a new association framework using channel occupancy in order to provide users with exact channel status information of APs. Via the proposed scheme, users can compare the achievable throughput provided by each AP and select the best AP. We validate our proposed association method via simulation results, which show that the throughput improvement of the method is worthy of notice.

PurposeWireless local area networks (WLANs) are the predominant option for broadband wireless access network, and multiple access points (APs) will be much more available for wireless stations (WSTAs). Call admission control (CAC) on AP selection problem over 802.11 WLAN is a critical issue. In the existing architecture, strongest‐signal‐first is the default AP selection mechanism in 802.11 WLAN which uses the single criterion, received signal strength indicator, to select AP. However, this method suffers from bandwidth deficiency and unbalanced load among APs due to the uneven distribution of user load, thus degrading the system throughput. Instead, the purpose of this paper is to propose a multi‐criteria CAC on AP selection algorithms.Design/methodology/approachThe distributed multi‐criteria considered in order are RSSI, minimum required bandwidth of WSTA, estimated effective bandwidth (EEB) and AP‐WSTA distance. A semiMarkov model considering both packet retransmission limit, packet error rate and collision effect is proposed to predict the system throughput and validated through simulation results. Two multi‐criteria AP selection algorithms after EEB is evaluated are proposed and compared based on this analytical model.FindingsThe proposed algorithms outperform the traditional SSF algorithm in terms of the balance index for AP and the average system throughput.Originality/valveThe paper presents performance analysis for multi‐criteria CAC for distributed access point selection in WLANs.

This paper focuses on addressing the Access Point (AP) selection problem by relying on a centralized controller that provides a global view of the network. This approach follows the Software-Defined Networking (SDN) concept, which has long been considered in the literature as an innovative method to control management functionalities for wired networks and that is also now becoming a hot topic in the context of Wi-Fi networks. The proposed AP selection approach is based on a novel algorithm which relies on the Fittingness Factor (FF) concept, to maximize a function that reflects the suitability of the available spectrum resources to the application requirements. Specifically, this paper describes the development of a framework that implements the FF-based algorithm for smart AP selection in a centralized controller. The simulated performance comparison of this algorithm against a strategy that maximizes the achievable data rate considered in many papers in the literature, illustrates the important achievements that have been obtained in terms of saved bandwidth and users' satisfaction.

This paper studies the secrecy performance of light-fidelity (LiFi) networks under the consideration of random device orientation and partial knowledge of the eavesdroppers’ channel state information. Particularly, the secrecy capacity and secrecy outage probability are analysed for the case of a single eavesdropper as well as for the case of multiple eavesdroppers. Moreover, a machine learning based access point (AP) selection algorithm is presented with the objective of maximising the secrecy capacity of legitimate users. Our results show that optimising the AP selection while taking into account the random behaviour of the optical channel results in a significant enhancement in the achievable secrecy performance. In fact, using the derived realistic secrecy expressions as the basis for AP selection results in up to 30% secrecy capacity enhancement compared to the limited assumption of fixed orientation.

This paper proposes a cell-free massive multiple-input multiple-output (CF-mMIMO) architecture with joint list-based detection with soft interference cancellation (soft-IC) and access points (APs) selection. In particular, we derive a new closed-form expression for the minimum mean-square error receive filter while taking the uplink transmit powers and APs selection into account. This is achieved by optimizing the receive combining vector by minimizing the mean square error between the detected symbol estimate and transmitted symbol, after canceling the multi-user interference (MUI). By using low-density parity check (LDPC) codes, an iterative detection and decoding (IDD) scheme based on a message passing is devised. In order to perform joint detection at the central processing unit (CPU), the access points locally estimate the channel and send their received sample data to the CPU via the front haul links. In order to enhance the system's bit error rate performance, the detected symbols are iteratively exchanged between the joint detector and the LDPC decoder in log likelihood ratio form. Furthermore, we draw insights into the derived detector as the number of IDD iterations increase. Finally, the proposed list detector is compared with existing detection techniques.

Background: Cell Free massive MIMO, containing a very large number of distributed access points (APs), which is a promising technology to provide high data rate, spectral efficiency (SE), and energy efficiency (EE). The system performance of cell-free M-MIMO is maximum when selecting optimal access points (AP) from the large number of APs. The linear precoding methods of zeroforcing (ZF) and minimum mean square error (MMSE) are utilized in this study because they are devoid of self-interference and so improve the system capacity. Objective: The objective of this study is to maximize the system data rate in a cell-free M-MIMO network. Method: To maximize the system data rate, the maximum channel gain-based Access Point Selection (MCGAPS), Distance based Access Point Selection (DAPS), and Random-Access Point Selection (RAPS) algorithms are used to pick access points (APs) in a cell-free M-MIMO network. Because the MCGAPS algorithm selects those APs with the highest channel gain, the system’s rate is improved. Result & Discussion: The DAPS algorithm is used to choose the closest APs to the user. The APs were randomly chosen using RAPS. Random user selection (RUS) algorithm schedules the same number of users. Conclusion: It is observed that the DAPS and RUS algorithms jointly improve the system rate significantly in cell-free massive MIMO system compared to the other proposed algorithms.

Light Fidelity (LiFi) is an emerging technology for future high-speed indoor wireless communications. Co-channel interference (CCI) caused by the dense deployment of LiFi access points (APs) can be effectively mitigated by using angle diversity receivers (ADRs). ADRs require signal combining where the combining weights depend on the selection of serving APs. In this paper, the AP selection (APS) strategy considering handover is studied. A novel APS scheme based on evolutionary game theory (EGT) is proposed for the LiFi network using ADRs. The performance of the proposed scheme is comprehensively analysed and compared with the APS scheme based on signal strength strategy (SSS). The result shows that, in terms of ADRs with SBC/MRC, the EGT-based APS scheme achieves more than 5% improvement in quality of service (QoS) compared with the SSS-based APS scheme. With the sub-optimum weights of maximum ratio combining (MRC) for ADRs, the EGT-MRC scheme can achieve more than 20 Mbps data rate improvement compared with LiFi systems using single photodiode (PD) receiver.

A novel Access Point (AP) selection algorithm to maximise the system throughput while considering user fairness is proposed for multi-rate WLANs. When a new-coming user enters an overlapping area of multiple APs, it chooses the one to achieve the highest system throughput. For existing users that locate in the overlapping area, they may also need to change their AP associations due to the dynamic nature of traffic load. To enable the fairness among users, each user is guaranteed a minimum transmission opportunity. In-depth theoretical analysis and extensive simulations are performed to verify the throughput optimisation and user fairness.

Location estimation using received signal strength (RSS) in pervasively available Wi-Fi infrastructures has been considered as a popular indoor positioning solution. However, accuracy deterioration due to uncertainty of RSS and offline manual calibration cost limit the deployment of Wi-Fi positioning systems. This paper proposes a signal perturbation technique to enhance existing support vector regression (SVR) based Wi-Fi positioning. By signal perturbation, more RSS training samples are generated, thus enhancing the generalization ability of SVR. In addition, access point (AP) selection method is applied to reduce the input dimension by discarding the redundant APs. The proposed method is compared with previous classical methods in a real wireless indoor environment. Experimental results show that the proposed method improves accuracy while reducing calibration cost.

In recent years, indoor fingerprint-based localization algorithm has been widely used by applications on smart phone. In these localization algorithms, it’s very popular to use WiFi signal characteristics to represent the location fingerprint. With the fast popularization of WiFi, the WiFi access points (APs) could be seen everywhere. However, as the number of APs increases, the dimension of the fingerprint and the complexity of fingerprint-based localization algorithm subsequently increase. Responding to the above challenges, this paper proposes a novel indoor localization algorithm MAPS (indoor localization algorithm based on multiple access point selection). MAPS could effectively reduce the complexity of localization computation, and improve the performance of localization through AP selection method. With the first round AP selection, MAPS can obtain a stable subset of AP, thus reducing the dimension of fingerprint, and obtaining better discrimination. And with the second round of AP selection, AP subset could be further condensed to construct a decision tree in each location cluster. This step can further improve the localization performance. The experimental results shown, as compared with classical indoor localization algorithm, MAPS has better positioning accuracy, and could achieve the accuracy of over 90% within 2m location error.

Public areas, such as train stations and airports, providing wireless Local Area Network (WLAN) services are increasing and expanding because of the rapid development of WLANs based on IEEE 802.11 standard. Moreover, because of the advances in smartphone tethering technology, portable access points (APs) such as mobile Wi-Fi routers are being utilized more frequently. Consequently, there are increasing circumstances where a user needs to select and connect to one of the many APs. AP selection significantly determines the quality of service of the subsequent communication session. Existing AP selection algorithms consider user movement but not AP movement. We propose an AP selection method that handles both types of movement effectively. Moreover, we show that the proposed method improves the throughput significantly compared to the existing method.

Given the strong macro-diversity gain, cell-free massive multiple-input-multiple-output (MIMO) with many access points (APs) can provide a more uniform service level for randomly distributed users or user sensors (USs). There has, however, been little implemented in practical applications, due to the challenges of substantial backhaul overhead and high signal processing demands in cell-free massive MIMO systems. In this article, we propose a resource allocation scheme that incorporates the effective algorithms for AP selection, pilot assignment, and power allocation, to improve the performance of user-centric cell-free massive MIMO systems. In particular, a grouping-based AP selection algorithm is investigated to select APs with significant gain contributions to USs. Based on this, we propose an improved K-means clustering (I-KMC)-based pilot assignment algorithm to reduce pilot contamination caused by pilot reuse. To improve the reliability of data transmission, we present two power allocation algorithms to maximize the achievable sum-rate, namely sequential convex approximation in combination with geometric programming (SCA-GP) approach, and nonmonotone accelerated proximal gradient (NAPG) approach with line search. Results demonstrate that the proposed scheme achieves similar sum-rate performance to the scenario where all USs are served by all APs, but with significantly lower power consumption.

We propose an optimal access-point (AP) selection algorithm for maximizing system throughput while preserving newly arrived-user throughput. In our algorithm, newly arrived users cooperate with a wireless area network system they are trying to use, i.e., they are willing to move toward an appropriate AP. We use our algorithm to determine the optimal AP. Moreover, we discuss the effectiveness of our proposed algorithm by using numerical analysis.

Wireless stations (WSs) in an IEEE 802.11 access network compete with each other for collective bandwidth offered by access points (APs). The competition involves selecting an AP with the consideration of potential link rate and workload status. From the perspective of system, a good AP selection policy should be stable, increase overall system throughput, and maintain bandwidth fairness among WSs. This paper models AP selections under the framework of game theory, where each WS's sole goal is to maximize its achievable throughput. The achievable throughput depends on not only the number of WSs that associate with the same AP but the set of link rates these WSs use as well. It is not a monotonically decreasing function of WS population when considering the effect of performance anomaly. We have proven the stability of this game (Nash equilibrium) and shown that selfish behavior of individual WSs in fact improves overall bandwidth fairness among WSs. Thorough simulations were conducted to demonstrate the validity of the analytical results and compare the performance of the proposed game with that of counterparts.