DGA-Based Fault Diagnosis Using Self-Organizing Neural Networks with Incremental Learning

Accurate faults diagnosis in power transformers is important for utilities to schedule maintenance and minimises the operation cost. Dissolved gas analysis (DGA) is one of the proven and widely accepted tools for incipient fault diagnosis in power transformers. To improve the accuracy and solve the cases that cannot be classified using Rogers’ Ratios, IEC ratios and Duval triangles methods, a novel DGA technique based on Parzen window estimation have been presented in this study. The model uses the concentrations of five combustible hydrocarbon gases: methane, ethane, ethylene, acetylene and hydrogen to compute the probability of transformers fault categories. Performance of the proposed method has been evaluated against different conventional techniques and artificial intelligence‐based approaches such as support vector machines, artificial neural networks, rough sets analysis and extreme learning machines for the same set of transformers. A comparison with other soft computing approaches shows that the proposed method is reliable and effective for incipient fault diagnosis in power transformers.

Dissolved gas analysis (DGA) approach is extensively applied to detect incipient faults of power transformers. This paper presents a novel DGA method for power transformer incipient fault diagnosis based on integrated adaptive neuro fuzzy inference system (ANFIS) and Dempster-Shafer Theory (DST). Four out of seven common conventional methods which are studied and compared for better consistency and accuracy, are used to develop new ANFIS based fault diagnosis models. To promote fault diagnostic performance further and make fault decision process more reliable and reasonable, an improved DST is introduced to integrate outputs of each ANFIS based model, and to provide comprehensive and convincing fault diagnosis results. The fault diagnosis capability of the proposed method is validated by a reported fault dataset and 10-fold cross validation experiment. The performance of the proposed method is compared with conventional approaches and ANFIS based models which demonstrate that the proposed method is superior to other methods and is more effective and stable for power transformer fault diagnosis with high accuracy and consistency.

PurposePower transformers are vital components of an electrical network. A defective transformer can cause instability and blackouts in parts of the network. An accurate classification of different transformer faults results in a relatively accurate fault diagnosis and timely corrective actions. It is possible to increase productivity and reduce costs by using fault detection of power transformers through the analysis of gases dissolved in oil. The proposed technique is a suitable tool to help the utilities and engineers in charge of preventive maintenance by reducing the costs of different fault diagnosis tests for power transformers.Design/methodology/approachIn this paper, the IEC 60599 standard along with clustering and classification methods are used to classify power transformer’s fault types. K-means and Fuzzy C-means clustering methods are used for clustering, and the support vector machine (SVM) method is used for classification of different types of faults in ‎power ‎transformers. The performance of K-means and SVM methods is improved by using the Grasshopper Optimization Algorithm (GOA). The efficiency of the proposed methods is evaluated using real field data of power transformers. The purpose of this study is to propose hybrid methods including K-means-GOA clustering and SVM-GOA classification for accurate fault diagnosis. These methods have been used for the first time in fault diagnosis determination of power transformers through gas analysis. The Silhouette criteria is used in this paper to compare the efficiency of different clustering methods.FindingsSimulation results of the paper are based on the gas chromatography data related to 266 different real power transformers. They show the high accuracy and high-performance speed of intelligent clustering and classification methods compared to conventional ones. This analysis would be helpful in performing the required maintenance check and plan for repairs.Originality/valueThe applicability and efficiency of the proposed hybrid K-means-GOA and SVM-GOA models are verified for transformer fault detection using the experimental diverse data set including 266 set of real field test parameters of power transformers.

The power transformer is a valuable asset of the electrical system. A damage causes the interruption of electrical service and high repair costs for companies. Therefore, the detection of faults in incipient conditions is essential. In the recent literature Dissolved Gas Analysis (DGA) is the best accepted technique to the diagnosis of incipient faults in power transformers. This paper presents an approach to diagnosis fault by DGA using deep neural network, the drawbacks of the number of training patterns (amount of data) is satisfactory solved with using the Mean Shift algorithm. Likewise, the input and output parameters are conveniently selected, the input parameters being the gas relations established in the IEC 60599 standard acting in parallel with a new ratio of proposed gas (Rnew=C2H2 / C2H6) and a binary output. The proposed approach achieved an accuracy of 100%, both in the training and validation process as well.

In order to effectively solve the problems such as fault with single features, carrying the lack of information resulting in poor effect of fault judgment in traditional transformer fault diagnosis method. In view of this, this paper will consider the insulation resistance of the core 12 fault symptoms and fault characteristic gases as the combination of fault characteristics, effectively solve the problem of the existence of the feature quantity; At the same time, the principal component analysis and self-organizing neural network combination is introduced to this paper, this paper puts forward a new method of transformer fault diagnosis based on principal component analysis and self-organizing neural network. Firstly, using the principal component analysis for the main components of 17 kinds of feature extraction, extracted features can effectively present the characteristics of 10 kinds of fault classification, on this basis, the 10 methods of feature extraction was obtained as input vector of self-organizing neural network and identification of fault types. The example analysis shows that this method has a good diagnostic effect, which can effectively improve the accuracy of fault diagnosis and verify the validity and feasibility of this method.

The bidirectional gated recurrent unit (BiGRU) method based on dissolved gas analysis (DGA) has been studied in the field of power transformer fault diagnosis. However, there are still some shortcomings such as the fuzzy boundaries of DGA data, and the BiGRU parameters are difficult to determine. Therefore, this paper proposes a power transformer fault diagnosis method based on landmark isometric mapping (L-Isomap) and Improved Sand Cat Swarm Optimization (ISCSO) to optimize the BiGRU (ISCSO-BiGRU). Firstly, L-Isomap is used to extract features from DGA feature quantities. In addition, ISCSO is further proposed to optimize the BiGRU parameters to build an optimal diagnosis model based on BiGRU. For the ISCSO, four improvement methods are proposed. The traditional sand cat swarm algorithm is improved using logistic chaotic mapping, the water wave dynamic factor, adaptive weighting, and the golden sine strategy. Then, benchmarking functions are used to test the optimization performance of ISCSO and the four algorithms, and the results show that ISCSO has the best optimization accuracy and convergence speed. Finally, the fault diagnosis method based on L-Isomap and ISCSO-BiGRU is obtained. Using the model for fault diagnosis, the example simulation results show that using L-ISOMP to filter and downscale the model inputs can better improve model performance. The results are compared with the SCSO-BiGRU, WOA-BiGRU, GWO-BiGRU, and PSO-BiGRU fault diagnosis models. The results show that the fault diagnosis rate of ISCSO-BiGRU is 94.8%, which is 11.69%, 10.39%, 7.14%, and 5.9% higher than that of PSO-BiGRU, GWO-BiGRU, WOA-BiGRU, and SCSO-BiGRU, respectively, and validate that the proposed method can effectively improve the fault diagnosis performance of transformers.

Fault diagnosis can insure the power transformer safety and economic operation, and the data mining is the key technology of fault diagnosis for power transformer. In order to achieve the fast parallel fault diagnosis for power transformer, we need to put cloud computing technology into the smart grid. We give a parallel method of K-means based on MapReduce framework on the Hadoop distributed systems cluster to diagnose operation state of power transformer. Finally, through transformer fault diagnosis experimentations of massive DGA data, the results indicate closely linear speedup with an increasing number of node computers.

The condition monitoring and fault diagnosis of power transformers plays a significant role in the safe, stable and reliable operation of the whole power system. Dissolved gas analysis (DGA) methods are widely used for fault diagnosis, however, their accuracy is limited by the selection of DGA features and the performance of fault diagnosis models, for example, the classical support vector machine (SVM), is easily affected by unbalanced training samples. This paper presents a transformer fault diagnosis model based on chemical reaction optimization and a twin support vector machine. Twin support vector machines (TWSVMs) are used as classifiers for solving problems involving unbalanced and insufficient samples. Restricted Boltzmann machines (RBMs) are used for data preprocessing to ensure the effective identification of feature parameters and improve the efficiency and accuracy of fault diagnosis. The chemical reaction optimization (CRO) algorithm is used to optimize TWSVM parameters to select the optimal training parameters. The cross-validation (CV) method is used to ensure the reliability and generalization ability of the diagnostic model. Finally, the validity of the model is verified using real fault samples and random testing.

BA-PNN-based methods for power transformer fault diagnosis

Multi-filter semi-supervised transformer model for fault diagnosis

To allow utilities to fulfill self-imposed and regulative performance targets the demand for new optimized tools and techniques to Estimate the performance of modern Transformers has increased. The modern power transformers has subjected to different types of faults, which affect the continuity of power supply which in turn causes serious economic losses. To avoid the interruption of power supply, various fault diagnosis approaches are adopted to detect faults in the power transformer and has to eliminate the impacts of the faults at the initial stage. Among the fault diagnosis methods, the hybrid technique of Particle Swarm Optimization (PSO) with Support Vector Machine (SVM) learning algorithm is simple conceptually derived and its implementation process is faster with better scaling properties for complex problems with non linearity and load variations but performance factor related to accuracy has a declined value in case of correlations implicit . In order to obtain better fault diagnosis to improve the service of the power transformer, SVM is optimized with Improved PSO technique to achieve high interpretation accuracy for Dissolved Gas Analysis (DGA) of power transformer through the extracting positive features from both the techniques. Primary SVM is applied to establish classification features for faults in the transformer through DGA. The features are applied as input data to Autonomous optimized Technique for faults analysis. The proposed methodology obtains the DGA data set from diagnostic gas in oil of 500 KV main transformers of Pingguo Substation in South China Electric Power Company. The simulations are carried out in MATLAB software with an Intel core 3 processor with speed of 3 GHZ and 4 GB RAM PC. The result obtained by Autonomous optimized Technique (IPSO-SVM) is compared against PSO-SVM to estimate the performance of the classifiers in terms of execution time and quality of classification for precision. The test results indicate that the Autonomous optimization of IPSO-SVM approach has significantly improved the classification accuracy and computational time for power transformer fault classification. Keywords: Transformer Fault Analysis, Improved Particle Swarm Optimization, Hybrid Optimization, Dissolved Gas Analysis, Support Vector Machine

Dissolved gas analysis (DGA) is one of the most useful techniques to detect incipient faults in power transformers. However, the identification of the faulted location by the traditional method is not always an easy task due to the variability of gas data and operational variables. A novel extension method, which is based on the matter-element model and extended relation functions, is presented for fault diagnosis of power transformers. Thus, incipient faults in power transformers can be identified directly by the degree of relation. The application of this new method to some transformers has given promising results.

A two-step image segmentation based on clone selection multi-object emperor penguin optimizer for fault diagnosis of power transformer

Bayesian network offers a powerful map framework that can process probabilities inference. It can be used in inference and express of uncertainty knowledge. This paper introduce a new electrical equipment fault diagnosis method based on Bayesian network (BN). For example, power transformer is very important in power system as a electrical equipment. But, it's very difficult to diagnose the fault exactly because power transformer's complexity configuration. Now, dissolved gas analysis (DGA) is the most effective and convenient method in transformer fault diagnosis. However, the codes of DGA is too absolute, so this paper advances a new transformer fault diagnosis method based on Bayesian network (BN). This method introduces BN method into transformer fault diagnosis and presents a new idea of finding out transformer faults rapidly and exactly. Then, the transformer fault diagnosis model based on Bayesian network and DGA is constructed. Finally, the application examples in the fault diagnosis of transformer are given which shows that this method is effective.

Fault diagnosis of power transformer based on multi-layer SVM classifier