Dual-target CRISPR-Cas12 diagnostics based on asymmetrically chemical-modified DNA probe.

Diagnostic value of combined nucleic acid and antibody detection in suspected COVID-19 cases

Highly efficient loop cleavage for human papillomavirus detection with a novel thermophilic Argonaute from Thermus brockianus.

The development of a contamination-free and on-site nucleic acid detection platform with high sensitivity and specificity but low-cost for the detection of pathogenic nucleic acids is critical for infectious disease diagnosis and surveillance. In this study, we combined the recombinase-aided amplification (RAA) with the exonuclease III (Exo III)-assisted signal amplification into a platform for sensitive and specific detection of nucleic acids of African swine fever virus (ASFV). We found that this platform enabled a naked eye visual detection of ASFV at a detection limit as low as 2 copies/μL in 30 min. As expected, no cross-reactivity was observed with other porcine viruses. In addition, to avoid aerosol contamination, a one-tube RAA-Exo III colorimetric assay was also established for the accurate detection of ASFV in clinical samples. Taken together, we developed a rapid, instrument-free, and low-cost Exo III-assisted RAA colorimetric-assay-based nucleic acid detection platform.

Self-partitioning SlipChip for slip-induced droplet formation and human papillomavirus viral load quantification with digital LAMP

Nucleic acid detection and quantification using a labeled DNA probe is a very common molecular biology procedure. Here, we describe a new method, based on commonly used laboratory solutions, for nucleic acid hybridization and detection with digoxigenin-labeled DNA probes. The protocol described is faster, more sensitive and much cheaper than a standard protocol using commercial solutions. Comparison with a classical radioactive detection method shows that the latter exhibits less background and shows a greater linear response. Hence, the proposed protocol may be routinely performed for qualitative detection of nucleic acid, but when precise signal quantitation needs to be obtained, radioactive probe hybridization associated to phosphorimaging technology is more reliable.

Rapid, low-cost, and sensitive nucleic acid detection and quantification assays enabled by microfluidic paper-based analytical devices (μPADs) hold great promise for point-of-care disease diagnostics and field-based molecular tests. Through the capillary action in μPAD, flexible manipulation of nucleic acid samples can be achieved without the need for external pumps or power supplies, making it possible to fabricate highly integrated sample-to-answer devices that streamline the nucleic acid extraction, separation, concentration, amplification, and detection. To detect minute amounts of genetic materials from clinical and biological samples, it is also critical to develop sensitive signal readouts that generate physically detectable signals for in-device nucleic acid detection and/or quantification. In this review, we will focus on μPAD approaches for the facile manipulation of nucleic acids and emerging signal transduction strategies allowing sensitive and specific nucleic acid detection in μPAD. Graphical abstract ᅟ.

Nucleic acid amplification tests are the gold standard for many infectious disease diagnoses due to high sensitivity and specificity, rapid operation, and low limits of detection. Despite the advantages of nucleic acid amplification tests, they currently offer limited point-of-care (POC) utility due to the need for complex instruments and laborious sample preparation. We report the development of the Nucleic Acid Isotachophoresis LAMP (NAIL) diagnostic device. NAIL uses isotachophoresis (ITP) and loop-mediated isothermal amplification (LAMP) to extract and amplify nucleic acids from complex matrices in less than one hour inside of an integrated chip. ITP is an electrokinetic separation technique that uses an electric field and two buffers to extract and purify nucleic acids in a single step. LAMP amplifies nucleic acids at constant temperature and produces large amounts of DNA that can be easily detected. A mobile phone images the amplification results to eliminate the need for laser fluorescent detection. The device requires minimal user intervention because capillary valves and heated air chambers act as passive valves and pumps for automated fluid actuation. In this paper, we describe NAIL device design and operation, and demonstrate the extraction and detection of pathogenic E. coli O157:H7 cells from whole milk samples. We use the Clinical and Laboratory Standards Institute (CLSI) limit of detection (LoD) definitions that take into account the variance from both positive and negative samples to determine the diagnostic LoD. According to the CLSI definition, the NAIL device has a limit of detection (LoD) of 1000 CFU mL(-1) for E. coli cells artificially inoculated into whole milk, which is two orders of magnitude improvement to standard tube-LAMP reactions with diluted milk samples and comparable to lab-based methods. The NAIL device potentially offers significant reductions in the complexity and cost of traditional nucleic acid diagnostics for POC applications.

The use of lateral flow assays to detect nucleic acid targets has many applications including point-of-care diagnostics, environmental monitoring, and food safety. A sandwich format, similar to that in protein immunoassays, is often used to capture the target nucleic acid sequence with an immobilized complementary strand anchored to a substrate, and then to visualize this event using a complementary label nucleic acid bound to a nanoparticle label. A critical component of high-sensitivity nucleic acid detection is to utilize high-density capture surfaces for the effective capture of target nucleic acid. Multiple methods have been reported, including the use of streptavidin-based protein anchors that can be adsorbed to the lateral flow substrate and that can utilize the high-affinity streptavidin-biotin linkage to bind biotinylated nucleic acid capture sequences for subsequent target nucleic acid binding. However, these protein anchors have not been systematically characterized for use in the context of nucleic acid detection. In this work, we characterize several protein-based anchors on nitrocellulose for (i) capturing the robustness of the attachment of the protein anchor, (ii) capturing nucleic acid density, and (iii) targeting nucleic acid capture. Further, we demonstrate the signal gains in target nucleic acid hybridization made by increasing the density of capture nucleic acid on a nitrocellulose substrate using multiple applications of protein loading onto nitrocellulose. Finally, we use our high-density capture surfaces to demonstrate high-sensitivity nucleic acid detection in a lateral flow assay (in the context of a SARS-CoV-2 sequence), achieving a LOD of approximately 0.2 nM.

In December 2019, a novel coronavirus was identified in Wuhan City, Hubei Province, China and later the disease was named coronavirus disease 2019 (COVID-19). On March 11, 2020, the World Health Organization (WHO) officially announced that COVID-19 had reached global pandemic status. This article summarized the understanding of the etiology, pathogenesis, epidemiology, clinical characteristics, diagnosis, treatment, rehabilitation, and prevention and control measures of COVID-19 based on the available data and anti-epidemic experience in China.

Molecular beacons are dual-labelled probes that are typically used in real-time PCR assays, but have also been conjugated with solid matrices for use in microarrays or biosensors. We have developed a fluid array system using microsphere-conjugated molecular beacons and the flow cytometer for the specific, multiplexed detection of unlabelled nucleic acids in solution. For this array system, molecular beacons were conjugated with microspheres using a biotin-streptavidin linkage. A bridged conjugation method using streptavidin increased the signal-to-noise ratio, allowing for further discrimination of target quantitation. Using beads of different sizes and molecular beacons in two fluorophore colours, synthetic nucleic acid control sequences were specifically detected for three respiratory pathogens, including the SARS coronavirus in proof-of-concept experiments. Considering that routine flow cytometers are able to detect up to four fluorescent channels, this novel assay may allow for the specific multiplex detection of a nucleic acid panel in a single tube.

Specific, sensitive and rapid Curcuma longa turmeric powder authentication in commercial food using loop-mediated isothermal nucleic acid amplification.

Human papillomavirus (HPV) causes the prevalent sexually transmitted infection that accounts for the majority of cervical cancer incidences. Therefore, the development of a rapid, accurate, automatic and affordable nucleic acid detection strategy is urgently required for HPV tests, among which microfluidic chip is a promising diagnostic method. In this work, we developed a microfluidic detection system consisting of a microfluidic chip and the corresponding detection equipment to diagnose high-risk HPV. The proposed method integrates nucleic acid purification, isothermal amplification and real-time fluorescence detection into one device. Moreover, it demonstrates good detection performance such as high specificity of primer sets (100%) and exceptional stability (coefficient of variation <6%) among five HPV genotypes. Besides, the microfluidic loop-mediated isothermal amplification (LAMP) assay is accurate (specificity of 91.7% and sensitivity of 100%) and fast (average time threshold = 10.56 minutes) when considering the conventional qPCR assay as the gold standard. The integrated microfluidic detection system offers automated and rapid diagnosis within 40 minutes and shows broad potential to deliver point-of-care detection in resource-limited circumstances owing to its simplicity and affordability.

Nucleic acid testing (NAT) is widely considered the gold standard in analytical fields, with applications spanning environmental monitoring, forensic science and clinical diagnostics, among others. However, its widespread use is often constrained by complicated assay procedures, the need for specialized equipment, and the complexity of reagent handling. In this study, we demonstrate a fully integrated 3D-printed biosensensing device employing a CRISPR/Cas12a-based dual-enzymatic mechanism for highly sensitive and user-friendly nucleic acid detection. A plastic probe stick was designed to host small-sized gold nanoparticles, enhancing enzyme labeling density. Alkaline phosphatase (ALP) was then conjugated via single-stranded DNA, requiring only a single enzyme substrate addition to generate a simple visual signal change. This approach eliminates the need for amplification or centrifugation steps, achieving a limit of detection (LOD) as low as 10 pM - among the highest sensitivities reported for amplification-free colorimetric nucleic acid detection. Furthermore, we developed a device that incorporates this probe stick, integrates all necessary reagents, and features a smartphone-compatible accessory for quantitative analysis. This allows end-users to perform visual or quantitative DNA analysis with simple operations, achieving a visual detection limit of approximately 100 pM, comparable to other CRISPR-based non-amplified nucleic acid detection methods. Additionally, the system successfully distinguished perfectly matched from mismatched nucleic acid sequences, demonstrating its specificity and versatility. Although certain design limitations affected the sensitivity of the integrated device compared to the probe stick alone, the simplicity and portability of this device make it a promising tool for rapid nucleic acid screening in clinical diagnostics, environmental monitoring, and food safety control. This study paves the way for the development of practical biosensors for point-of-care testing (POCT) applications.

Preliminary establishment and validation of a loop-mediated isothermal amplification assay for convenient screening of 13 types of high-risk human papillomaviruses in cervical secretions

To study the epidemiological characteristics of respiratory syncytial virus (RSV) infection in hospitalized children with community-acquired pneumonia (CAP) in Hebei Province. Hospitalized children with CAP who tested positive for RSV and were admitted to Hebei Children's Hospital from various cities and counties across Hebei Province between January 2019 and December 2023 were included in the study. Clinical data were collected and analyzed to assess epidemiological characteristics. The clinical data of 43 978 children with CAP were collected, with an overall RSV detection rate of 25.98%. The detection rate was higher during the implementation of non-pharmaceutical interventions (NPIs) (30.60%) than in the non-NPIs period. Winter and spring were the primary epidemic seasons for RSV each year except in 2022. The detection rate in males (26.62%) was higher than in females (25.06%) (P<0.001). The highest detection rate (59.18%) was found in infants aged 29 days to <1 year. Single RSV infection was more common, with rhinovirus being the most frequent co-infection. The overall RSV detection rate in Hebei Province is influenced by NPIs, being higher during their implementation. RSV predominantly circulates in winter and spring. The detection rate of RSV is higher in males and infants. RSV infection is primarily single, most often co-occurring with rhinovirus.