Dynamic cascade-model-based frequency-scanning interferometry for real-time and rapid absolute optical ranging.

The accurate estimation of battery state of charge (SOC) enables the reliable and safe operation of lithium‐ion batteries. Data‐driven SOC estimation is considered an emerging and effective solution. However, existing data‐driven SOC estimation methods typically involve direct estimation and lack effective feedback correction. Moreover, battery degradation poses additional challenges to accurate SOC estimation. Therefore, this study proposes an adaptive combined method for battery SOC estimation based on a long short‐term memory (LSTM) network and unscented Kalman filter (UKF) algorithm considering battery aging status. First, an LSTM model is constructed to characterize the battery's dynamic performance instead of traditional battery models. Then, the UKF algorithm is employed to perform SOC estimation through the feedback of terminal voltage prediction. To enhance estimation accuracy under different aging statuses, a proportional‐integral‐derivative controller is employed to correct the capacity fading during the SOC estimation process. Validation results indicate that the terminal voltage prediction model demonstrates exceptional robustness against interference from current and voltage noise. Compared to the traditional estimation method combining the deep learning model and Kalman filter algorithm, the proposed method demonstrates superior estimation accuracy under various complex operating conditions. Furthermore, the proposed method outperforms the traditional method in estimation performance during battery aging.

Wireless Sensor Network (WSN) is a new technology integrated with communications, embedded technology, and network functions; having capability of real-time collecting, communicating, and sensing, for which dynamic target locating and tracking is its critical task, as well as a basic element in its commercial and military application such as battlefield information accessing and traffic monitoring. Sensor target tracking is the technology of target location estimate based on measurements from corresponding sensors. An inaccurate estimated location may very easily lead to target tracking failure which reduces the reliability and stability of the target tracking [1]. Experts and scholars have done a lot of researches to solve problems exited in wireless sensor target tracking, and many new tracking algorithms have been proposed, among which tracking algorithms such as target contrail-fitting, linear prediction, Kalman filter, unscented Kalman filter(UKF) and particle filter[2] are most common applied. Sikdar, with his partners, has proposed target location tracking algorithm based on linear sensor which is proved better than conventional contrail fitting algorithm in its effects. Zhang Xiaoping , with his partners, has proposed WSN target tracking algorithm through modeling for quadratic polynomial motions which has improved target tracking accuracy[3]. However, there is a problem in common: all the algorithms above assume the tracking target contrail-fittings being in linear motion, while the actual contrail fitting is of uncertainty and variability, and the estimated accuracy can hardly be improved after being to a certain level. In this condition, the tracking error of the above algorithms can be greater [4]. Kalman filter algorithm can be applied for weakly nonlinear models, but for strongly nonlinear models, Unscented Kalman Filter algorithm can be better. Kalman filter work well in cases based on model-linear and Gaussian noise, thus its estimated accuracy is not that ideal [5, 6]. Particle filter algorithm is based on optimal regression Bayesian filtering algorithm in Monte Carlo simulation, which can accurately estimate the any distribution state with only a small amount of mobile anchor nodes. PF algorithm has distinguished advantages in processing non-linear, non-Gaussian cases [7]. However, in PF application process after several iterations, diversified degradation of the particles will occur, which is likely to lead a target tracking loss, thus further affect WSN target tracking accuracy [8]. In order to solve the diversified degradation of the particles in Particle Filter algorithm, this paper Research on the Target Tracking Algorithm for Wireless Sensor Network Based on Improved Particle Filter Liang Peng,Xinhan Huang, Li He

GPS disciplined crystal oscillator technology has been widely used to obtain high-precision and low-cost frequency standards. But there are two factors that would affect the accuracy of the frequency correction. The first is the random error and outliers contained in the one pulse per second (PPS) outputted by the GPS. The second factor is the frequency nonlinear drift of crystal oscillator because of the aging and the temperature. To solve these problems, a mathematical model of the frequency difference between IPPS signal and crystal oscillator signal is established in this paper. And then a novel high-precision method based on the sequence weighted adaptive Unscented Kalman filter (UKF) algorithm is proposed on the basis of the mathematical model. To be more specific, the UKF is used to address the problem of random error and frequency nonlinear drift. And the effect of outliers is eliminated by weighing sequence in the UKF algorithm. The adaptive filtering technology can reduce the impact of the variable and random system noise. Numerical simulation and verification are described. The results show that the proposed method can make frequency standards higher stability and precision.

Numerical simulation of a new early gas kick detection method using UKF estimation and GLRT

Accurate remaining useful life (RUL) prediction under the noisy environment is a big challenge for the health management of modern industrial systems since the extraction of the accurate data structure from heavily corrupted data is difficult. In recent years, the kernel adaptive filter (KAF) has been widely adopted to solve the robust regression problem due to its low-complexity and high-approximation capability and robustness while the applications in battery RUL prediction are still few and far between. Thus, this paper is concerned with long-term RUL prediction using the KAF method. At first, concretely speaking, a robust KAF algorithm is derived based on the double-Gaussian-mixture (DGM) cost function, which is used to learn the capacity degradation mechanism from contaminated capacity data and so as to build the long-term prediction model. Second, a robust unscented Kalman filter (UKF) algorithm employing the DGM-based cost function is developed, which is then combined with the KAF-based prediction model to realize a more accurate and reliable prediction. Under the hybrid prognostic framework, the proposed UKF algorithm is applied to filter the noisy observations. When the observation data are inaccessible, the predicted data from the off-line trained KAF-based prediction model are adopted as the approximated value of the real observations for the UKF algorithm to optimize the prediction results and to provide the uncertainty representation. The experimental results reveal that the proposed method has great robustness when the measurements contain noise and large outliers, which makes it possible to get satisfactory prediction performance without preprocessing the data manually.

Optical coherence tomography (OCT) is a widely used three-dimensional (3D) optical imaging method with many biomedical and non-medical applications. Miniaturization, cost reduction, and increased functionality of OCT systems will be critical for future emerging clinical applications. We present a silicon photonic integrated circuit swept-source OCT (SS-OCT) coherent receiver with dual polarization, dual balanced, in-phase and quadrature (IQ) detection. We demonstrate multiple functional capabilities of IQ polarization resolved detection including: complex-conjugate suppressed full-range OCT, polarization diversity detection, and polarization-sensitive OCT. To our knowledge, this is the first demonstration of a silicon photonic integrated receiver for OCT. The integrated coherent receiver provides a miniaturized, low-cost solution for SS-OCT, and is also a key step towards a fully integrated high speed SS-OCT system with good performance and multi-functional capabilities. With further performance improvement and cost reduction, photonic integrated technology promises to greatly increase penetration of OCT systems in existing applications and enable new applications.

This paper studies the relay selection in wireless cooperative communication systems. Since the high mobility of Unmanned Aerial Vehicles (UAVs) will lead to the change of link state, a relay selection algorithm based on position prediction is proposed in this paper to better study this problem. First, the Unscented Kalman Filter (UKF) algorithm is used to predict the real-time location information of each UAV, and based on the location information, it is determined whether the current UAV relay node needs to be replaced. The real-time location information of each UAV is predicted by UKF algorithm, which is the basis for determining whether the current UAV relay node needs to be replaced. Then, the outage probability of each standby UAV relay node is calculated, and the standby UAV relay node is sorted according to the link outage probability. Finally, the greedy algorithm is used to find the node with the smallest interruption probability among the backup UAV relay nodes as the next UAV relay node. The simulation results show that in terms of position prediction, the UKF algorithm is more accurate than the Kalman Filtering (KF) algorithm, and the error is smaller. In terms of interruption probability, the relay selection algorithm proposed in this paper reduces the interruption probability of the link, and the interruption probability of the link is more stable.

Estimating dynamic positioning ship motion states is complex if the measured nonlinear motion data have outlying data caused by faulty sensors or ocean environmental noises. To overcome the adverse effects of sensor outliers, we developed a modified unscented Kalman filter (MUKF) algorithm. An outlier detection function was first established to spot the outliers in the measurement and then embedded into the regular unscented Kalman filter (UKF) algorithm to modify the covariance of measurement noise for obtaining smooth changes of the filter gain. To verify the developed MUKF algorithm, two dynamic positioning ship motions were simulated for estimating ship motion states in the presence of measurement outliers. Four outlier scenarios with different extents of sensor faults, different points at which the outlier occurred, and outlier duration during the ship motion course were simulated. The estimated values were compared with the theoretical ones. Additional parameter sensitivity was then performed to verify the stability and convergence performance of the developed MUKF algorithm. The results estimated by the robust MUKF were accurate and reliable, regardless of the outlier scenario, indicating the robustness of the MUKF algorithm to reduce the influence of outliers on the estimation of dynamic positioning ship motion states. The implications of this study are also discussed and presented.

Dynamic frequency scanning interferometry measurement based on optical frequency synchronous motion measurement and error compensation

<div class="section abstract"><div class="htmlview paragraph">The application of millimeter-wave radar technology in autonomous driving has become increasingly widespread with the rapid development of intelligent transportation systems. However, millimeter-wave radar is easily affected by environmental noise, multipath reflections, and electromagnetic interference, resulting in a large number of invalid target signals that reduce the system’s detection accuracy and safety. We proposes a method for filtering invalid targets based on interference signal characteristics and an Adaptive Interactive Multiple Model Kalman Filter (IMM-KF) target tracking algorithm. First, we effectively filter out empty targets, ghost targets, and false targets through a threshold method and lifecycle assessment, achieving a filtering rate exceeding 99.8%. Second, the improved Adaptive IMM-KF algorithm, combined with the Hungarian algorithm, associates and tracks multiple targets. The root mean square error (RMSE) of our methods is reduced by 7.07% and 8.05% compared to the traditional IMM and Unscented Kalman Filter (UKF) algorithms in scenarios with a single pedestrian moving in a straight line. And in scenarios involving both pedestrians and motor vehicles, the RMSE is reduced by 4.29% and 7.61% compared to the traditional IMM and UKF algorithms, respectively. Real-vehicle experiments have validated the robustness and accuracy of the proposed method across various scenarios.</div></div>

HVDC transmission is an integral part of various power system networks. This article presents an Unscented Kalman Filter dynamic state estimator algorithm that considers the presence of HVDC links. The AC - DC power flow analysis, which is implemented as power flow solver for Dynamic State Estimation (DSE), creates an updated admittance matrix. First, a hybrid AC/DC network model is developed to combine the AC network and DC links. Then a non-linear state estimator can solve for hybrid AC/DC states by applying the unscented Kalman filter (UKF) algorithm. It is demonstrated that UKF is easy to implement and accurate in estimation. The dynamic state variables of multi-machine power systems, which are generator rotor speed and rotor angle, are estimated to study transient behavior of the power system network. Finally, a dynamic state estimation model is built for a 14 bus power system network to evaluate the proposed algorithm for hybrid AC/DC networks.

In view of abnormal situations, such as multimodal noise, bad measurement data, and sudden load changes in a ship integrated electric propulsion system, this article proposes an unscented Kalman filter with enhanced mixture minimum error entropy (EnMMEE-UKF) to estimate the dynamic state of a ship integrated electric propulsion system. The new algorithm mixture includes two Gaussian functions, defines them as kernel functions, and uses quantization operators to lighten the weight of the mixture minimum error entropy (MMEE). This not only reduces the calculation burden of the MMEE but also effectively improves the system’s ability to handle strongly nonlinear models. In addition, in the lightweight MMEE (LMMEE)-unscented Kalman filter (UKF) algorithm, a fading factor is introduced, based on the strong tracking filter (STF) theory, to modify the error covariance matrix. The enhanced MMEE replaces the mean square error loss of the traditional UKF algorithm. This enhances the robustness of the algorithm estimation, in which a statistical linearization method is adopted to merge the state and measurement errors into the cost function of the enhanced MMEE. Finally, a fixed-point iteration method is applied to recursively update the posterior estimate and covariance matrix. To verify the effectiveness of the proposed method, numerical simulation experiments of various scenarios are conducted on the simulation system and the prototype system. The results demonstrate that the proposed algorithm not only has high estimation accuracy under various abnormal conditions but also effectively reduces the computational complexity of the algorithm, making its application in engineering possible.

X-ray pulsars navigation is a newly developed celestial navigation method, but the filter cycle time is long, and it cannot provide continuous navigation information. COMPASS can provide all-weather and continuous navigation information, but it has poor dynamic performance, and is susceptible to electromagnetic interference and the satellite signal is easy to be blocked. A X-ray pulsars/COMPASS integrated navigation method was proposed in order to improve the autonomous navigation capability of spacecraft. In this case, an autonomous orbit determination method of spacecraft is proposed through federal filtering that combines COMPASS navigation with X-ray pulsar navigation system. The extended Kalman filter (EKF), unscented Kalman filter (UKF) and the square root unscented Kalman filter (SR_UKF) algorithm are applied as the sub-filter. Simulation shows that the integration of the two systems can provide a higher accuracy of orbit determination, and SR_UKF performs better than EKF and UKF in filtering precision and stability.

In this paper, a scale-corrected minimal skew simplex sampling unscented Kalman filter (UKF) algorithm for the permanent magnet (PM) brushless DC motors (BLDCM) sensorless control has been studied to cancel the position sensor by the use of a systematical and analytical approach. Compared with the general UKF, the sampling method with the least Sigma points called minimal skew simplex sampling is adopted to reduce amount of computation and increase the estimation precision. Moreover, the scale-corrected strategy is introduced into the minimal skew simplex sampling UKF to overcome the nonlocal effects. On the other hand, for more easily calculating the value of back-EMF, the shape function of counter electromotive force is approximated by a series of sine and cosine functions based on the law of Fourier series. The purpose of the problem addressed is, by the method of scale-corrected minimal skew simplex sampling UKF, to properly estimate the rotor speed and position without installing encoders. Finally, the effectiveness of the proposed sensorless control technique is verified by simulation in MATLAB/Simulink.

In this paper, a state estimation method of distributed electric drive articulated vehicle dynamics parameters based on the forgetting factor unscented Kalman filter with singular value decomposition (SVD-UKF) is proposed. The 7DOF nonlinear dynamics model of a distributed electric drive articulated vehicle is established. The unscented Kalman filter algorithm is the foundation, with singular value decomposition replacing the Cholesky decomposition. A forgetting factor is introduced to dynamically adapt the observation noise covariance matrix in real time, resulting in a centralized parameter state estimator for the articulated vehicle. The proposed parameter state estimation method based on the forgetting factor SVD-UKF is simulated and compared with the unscented Kalman filter (UKF) estimation method. Key dynamic parameters are estimated, such as the lateral and longitudinal velocities and accelerations, angular velocity, articulated angle, wheel speeds, and longitudinal and lateral tire forces of both the front and rear vehicle bodies. The results show that the proposed forgetting factor SVD-UKF method outperforms the traditional UKF method. Furthermore, a prototype vehicle test is conducted to compare the estimated values of various dynamic parameters with the actual values, demonstrating minimal errors. This verifies the effectiveness of the proposed dynamic parameter estimation method for articulated vehicles.