Efficient multicast association to improve the throughput in IEEE 802.11 WLAN

Fair and efficient resource allocation in IEEE 802.11ah WLAN with heterogeneous data rates

To Our Readers

In an infrastructure wireless LAN, the access point (AP) is responsible for connecting mobile stations (STA) and wired stations. Each access point is assigned on one channel. Traditionally, one station selects AP to connect is based on the received signal strength indicator (RSSI). This approach may cause all active mobile stations to connect to few APs and lots of contentions/collisions will occur by the Carrier Sense Multiple Access/Collision Avoidance (CSMA/CA) protocol. Consequently, the total network throughput will be degraded. Contrarily, if all STAs can be equally distributed to all APs and the signal strength of any pair of STA and connected AP is still kept in an acceptable range, the spare bandwidth in wireless LAN (WLAN) will be utilized in a more efficient way. In this paper, a novel dynamic load balance algorithm is proposed for WLAN. Simulation results show the proposed algorithm has the ability to fairly distribute all STAs among APs. Moreover, it also maximizes the average RSSI between AP and connected STAs.

Large Wi-Fi installations may make use of Wi-Fi controllers managing client mobility and different Virtual Local Area Networks (VLANs). However, as they might form a bottleneck, controller-less solutions are on the rise, e.g., cloud-managed solutions or mesh networks. IEEE 802.11 defines a framework for providing roaming assistance through neighbor reports and transition requests (IEEE 802.11k and IEEE 802.11v), but leaves generating meaningful candidates included in these frames open to the implementor. Without central controllers, deriving these candidates for Stations (STAs) is much more difficult. Access Points (APs) with more autonomy need to know other APs located in their proximity to provide roaming assistance for STAs. In this paper, we design and evaluate a network-assisted roaming architecture for controller-less Wi-Fi networks. APs learn roaming events in their vicinity and steer STAs by means of refined, yet standard-compliant neighbor reports and transition requests to better suited APs. Our results using a real-system prototype indicate a noticeable decrease of roaming times when comparing various reference approaches to our proposal.

This paper describes an experimental implementation of a variation of the Reverse Direction (RD) Medium Access Control (MAC) Protocol (RDP) defined in the IEEE 802.11n using the Wireless Open-Access Research Platform (WARP). The proposed approach, named Bidirectional MAC (BidMAC), allows the receiver of a valid data sequence to perform an RD transmission to the transmitter without contending for the channel. Whereas in RDP the RD transmission must be initiated by the transmitter, in BidMAC it can be dynamically initiated by the receiver according to its traffic requirements. Previous results based on mathematical analyses and computer-based simulations have shown that BidMAC can better balance downlink and uplink transmission opportunities in a Wireless Local Area Network (WLAN) where the Access Point (AP) handles bidirectional data flows for some of its wireless stations (STAs). This paper aims at going one step further and demonstrating that such superior performance can be attained in real environments. Towards this end, an implementation of BidMAC has been carried out in a reference design of WARP compatible with the IEEE 802.11a/g and tested in a proof-of-concept network formed by an AP and two STAs. Experimental results confirm the superior performance of BidMAC when compared to the legacy Distributed Coordination Function (DCF) of the IEEE 802.11 versus the traffic load, packet length, and data rate, yielding gains of up to 60%.*

We propose a Cooperative Opportunistic Automatic Repeat ReQuest (CoARQ) scheme to solve the HOL-blocking problem in infrastructure IEEE 802.11 WLANs. HOL blocking occurs when the head-of-the-line packet at the Access Point (AP) queue blocks the transmission of packets to other destinations resulting in severe throughput degradation. When the AP transmits a packet to a mobile station (STA), some of the nodes in the vicinity can overhear this packet transmission successfully. If the original transmission by the AP is unsuccessful, our CoARQ scheme chooses the station (STA or AP) with the best channel to the intended receiver as a relay and the chosen relay forwards the AP's packet to the receiver. This way, our scheme removes the bottleneck at the AP, thereby providing significant improvements in the throughput of the AP. We analyse the performance of our scheme in an infrastructure WLAN under a TCP controlled file download scenario and our analytical results are further validated by extensive simulations.

Many wireless local area network (WLAN) performance estimations are done with the assumption of uniformly distributed stations (STAs). In practice, on the contrary STAs are distributed unevenly among access points (APs), causing hot-spots and under utilized APs in a wireless network. Considering a WLAN is made up of multiple APs, having some APs carrying excessive loads (i.e. hot-spots) degrades both the considered APs as well as the overall network performance. The system performance can be improved by associating incoming STAs effectively throughout the network, in a sense to balance the network load evenly between APs and relieve the hot-spot congestion. Currently employed user association method in IEEE 802.11 WLANs considers only the received signal strength of APs at STAs, and associates STAs to the closest (in signal strength sense) AP, ignoring its load and interference value.Novel user association algorithms are required for congestion relief and network performance improvement. In this work, a new distributed association algorithm taking into consideration not only the received signal strength of the APs at STAs but also AP loadings and interference is proposed. A new AP load calculation method acknowledging the interference between STAs and APs is presented. Our simulations demonstrate that the proposed algorithm can improve the overall system throughput performance more than 50% and offers a better load distribution across the network compared to conventional association algorithm.

The next generation wireless local area network (WLAN) needs to significantly improve the area throughput in high-dense deployment scenario. Orthogonal frequency division multiple access (OFDMA), considered as the key technology of the next generation WLAN, has been adopted by IEEE 802.11ax. However, most existing studies have one tricky problem: interference extension problem, i.e., the stations (STAs) placed at dispersive locations from one basic service set (BSS) access channel and transmit data simultaneously through OFDMA, thereby interfering a large area and suppressing the potential transmissions around this BSS. Unfortunately, high-dense deployment scenario exacerbates interference extension problem. This article proposes a spatial clustering group division-based OFDMA (SCGD-OFDMA) protocol, which enables the geographically close STAs to form spatial clustering groups, named SCGs. Each SCG has a leader STA and several member STAs. Each SCG’s leader STA contends for channel resources. After that, the leader STAs that successfully contending channel are scheduled by the access point one by one to trigger its member STAs to transmit uplink data by using OFDMA. Therefore, the geographical interference area is reduced and the area throughput is improved since the concurrent STAs in one SCG are located in limited area. This article theoretically analyzes the optimal SCG establishment, and throughput and area throughput of SCGD-OFDMA. Theoretical analysis is consistent with simulation results. The simulation results also show that when the number of STAs is 200 and all resource units are used for random access, SCGD-OFDMA outperforms IEEE 802.11ax and OMAX in area throughput by 56.13% and 190.97%, respectively.

IEEE 802.11ax introduces Uplink Orthogonal Frequency Division Multiple Access (OFDMA)-based Random Access (UORA), a novel feature for facilitating random channel access in Wireless Local Area Networks (WLANs). Similar to the conventional random access scheme in WLANs, UORA employs the OFDMA backoff (OBO) procedure to access the channel’s Resource Units (RUs) and selects a random OBO counter within the OFDMA contention window (OCW) range. The Access Point (AP) can determine and communicate this OCW range to each station (STA). Multiple STAs accessing RUs result in transmission failure due to RU collisions, which occur when specific RUs remain unassessed by any STA, leading to wastage. Efforts to optimize channel efficiency require minimizing both collisions and idle RU despite the challenges arising from UORA’s distributed and random nature. The Fisher-Yates shuffle algorithm introduces a random uniform distribution strategy for managing RU allocations among STAs. The results demonstrate that this approach enables STAs to access RUs in a distributed manner, effectively reducing idle and wasted RUs, especially in scenarios involving a limited number of STAs. Furthermore, this approach effectively mitigates collisions among STAs, even in scenarios with a more significant number of STAs.

Automated interference detection is required for operation and management services in wireless networks as Wireless Local Area Networks (WLANs) based on IEEE 802.11 Standard since co-channel interference from other wireless transmitters occurs irregularly. We propose a new approach for detecting the presence of interference on 802.11 links. Our solution focuses on the Access Point (AP)-initiated monitoring approach without Wireless Station (STA)-initiated additional function and sniffer devices. Our approach uses the geographical distribution of the response delay of the Acknowledgment packet (ACK) to the downlink packet that AP transmitted to STAs. The proposed method consists of a continuous monitoring step and a periodical diagnosis step to measure network statistics by ACK response delay between an AP and STAs and to detect whether and where interference occurs respectively. Comprehensive simulation results show that the proposed approach has a good accuracy and low misdetection ratio for diagnosing the interference existence and location in IEEE 802.11 WLANs.

To achieve a long run-time for battery-operated portable electronic devices that incorporate wireless transceivers, efficient power management of the radio is a critical requirement. The power management function of IEEE 802.11 wireless local area networks (WLANs) allows stations (STAs) to operate in the doze mode so that their power consumption is significantly reduced. Hence, efficient algorithms to manage when and how often a STA enters and exits doze mode are crucial to battery-operated STAs. We address this problem by developing a novel model for stochastic analysis of timer-based power management in infrastructure IEEE 802.11 WLANs. Based on this model, the probabilities that a STA is active, idle, or dozing are derived, and the power consumption of the STA, number of frames buffered, and average delay per frame are obtained. These results enable an efficient power management algorithm that optimizes the idle timer and doze duration at the STA and the frame buffer at the access point. Moreover, similar statistics for the basic power management method in the IEEE 802.11 standard are derived as a special case of the proposed timer-based power management scheme. Numerical results are presented to demonstrate the effectiveness of the proposed algorithms.

There has been widespread deployment of IEEE 802.11 wireless local area networks (LANs) because of high demand from mobile terminals, such as iPod and Android terminals. With the increasing energy consumption of the wireless LANs, the development of power saving technologies incorporated into the wireless LANs have become important. In wireless LANs, access points (APs) continuously consume the power regardless of the communication. Therefore, we have proposed the Radio-On-Demand (ROD) wireless LAN, which provides power saving schemes on the basis of the utilization of wireless LANs. In this study, we particularly focus on the power saving scheme of the APs, and propose the decentralized association management of ROD wireless LANs. In our scheme, an AP assigns associated stations (STAs) to new APs before switching to sleep mode. Simulation results show that the proposed scheme can realize sufficient power saving.

In dense wireless local area network (WLAN) environments, the haphazard deployment of WLAN devices causes them to overlap. In such situations, a coverage adaptation through transmission power control (TPC) is required. At the same time, coverage holes should be taken into consideration for connectivity maintenance among devices. In this paper, a TPC scheme is proposed that reduces overlaps in an autonomous manner, without generating target coverage holes. The problem is formulated as a target coverage problem, in which wireless stations (STAs) are treated as target points, and the transmission power is appropriately controlled by the proposed scheme. In addition, we prove that the target coverage game is a potential game, and the proposed method is guaranteed to converge to a Nash equilibrium after a finite number of iterations. In order to prevent the occurrence of coverage holes that cannot be detected by the available STA information, we propose the exclusion of coverage boundary access points (APs) from reducing transmission power, with the idea that each boundary AP always contains the region covered by it alone. The coverage boundary APs are determined through Delaunay triangulation of all APs. The proposed scheme is evaluated by performing some simulations. The simulation results indicate that the proposed TPC scheme is effective in reducing coverage overlaps without generating coverage holes.

In the case of a 3G-WLAN interworking architecture, handoff latency is mainly caused by the delays incurred when a mobile station (STA) transfers a current security context to the target access network or establishes connectivity to a new access point (AP). Existing handoff optimization schemes have mostly focused on reducing the scanning time which is to discover nearby access points. Even though the time taken by a mobile STA to authenticate the target APs contributes to the total handoff delay, the schemes to optimize the authentication time have not yet been fully investigated for providing seamless connectivity to mobile users performing handoff in WLANs. As a solution, pre-authentication, a technique performing the authentication of target APs before the completion of the handoff procedure, has attracted considerable attention to reduce the overall delay related with a handoff, which is performed within inter-subnet and/or inter-administrative domain levels. Therefore, in this article, we propose a novel pre-authentication scheme to minimize the handoff delay in 3G-WLAN interworking architecture. The proposed scheme pre-authenticates a new AP directly through a switched channel in a short period of time. Our evaluation shows that the proposed scheme outperforms the existing authentication schemes defined in the IEEE 802.11 standards in terms of authentication delay, signaling cost, and mobility rate. The proposed mechanism offers an additional advantage in that it is easy to implement and deploy by simply modifying the device driver modules of clients' WLAN interfaces.

With the rapid growth in Internet network infrastructure, there is an urgent need to deploy energy-efficient networking technology. In particular, there is a need for energy-efficient wireless local area networks (WLANs), which are widely used due to their ease of deployment and low installation costs. To realize this, radio-on-demand (ROD) have been proposed. Access points (APs) in ROD are equipped with wake-up receivers that change their status to sleep or active mode based on the network traffic distribution. This study proposes a station aggregation scheme targeting multiple stations (STAs) in ROD. In this scheme, APs cooperate with each other and aggregate their STAs based on their utilization. Simulation results demonstrate the effectiveness of the scheme in terms of power saving and load balancing in ROD networks.