Energy efficient flexible-bandwidth OFDM-based data center network

We are conducting research on the next generation of digital terrestrial broadcasting to enable large-volume content services such as 8K Super Hi-Vision. We have installed an experimental station for 8K transmissions in Hitoyoshi city, Kumamoto prefecture, Japan that uses dual-polarized multiple-input multiple-output (MIMO) technology and ultra-multilevel orthogonal frequency division multiplexing (OFDM) technology and conducted two 8K field experiments: a transmission test, and field measurements at 52 points in the Hitoyoshi area. In these experiments, we succeeded in carrying out the world's first terrestrial 8K transmission (91 Mbps) at a distance of over 27 km using only a single UHF (ultra-high frequency) channel (BW:6 MHz). We also measured the required field strength for the 256QAM, 1024QAM, and 4096QAM carrier modulation schemes as well as the responses of dual-polarized MIMO transmission channels.

Physical layer security is a crucial issue in wireless networks to prevent legitimate communication from eavesdropping. This paper investigates the physical layer security of a wireless multiple-input multiple-output (MIMO) orthogonal frequency division multiplexing (OFDM) communication system in the presence of a multiple-antenna eavesdropper. We first propose a minimum mean square error (MMSE)-based-filter secure MIMO–OFDM system which can destroy the orthogonality of eavesdropper’s signals. The MMSE-based-filter is used at the receiver to suppress the inter-subcarrier interference and disturb the reception of eavesdropper while maintaining the quality of legitimate transmission. Next, we propose another artificial noise (AN)-assisted secure MIMO–OFDM system to further improve the security of the legitimate transmission. The time-domain AN signal is designed to be canceled out at the legitimate receiver. Therefore, AN will disturb the reception of eavesdropper while the legitimate transmission will not be affected. Finally, power allocation for AN signals and subcarriers will be discussed since AN is generated utilizing the residual power of the MIMO–OFDM system. Simulation results are presented to demonstrate the security performance of the proposed transmit filter design and AN-assisted scheme in the MIMO–OFDM system.

The electrical wireless network build 4G TD-LTE network in 1.8GHz band, orthogonal frequency division multiplexing (OFDM) and multiple input multiple output (MIMO) are the key technologies. The OFDM system is sensitive to carrier frequency offset (CFO) and hence accurate CFO estimates for the OFDM system are essential. In this paper, we study the problem of carrier frequency offset (CFO) in multiple-input multiple-output (MIMO) orthogonal frequency division multiplexing (OFDM) systems, and then a multi-invariance PM algorithm is proposed to estimate CFO in MIMO-OFDM system. The proposed algorithm employs the property of multi-invariance. Simulations show that the proposed algorithm has a better CFO estimation performance than PM.

A survey on architectures and energy efficiency in Data Center Networks

Wireless network is one of the most important things in the development of telecommunication. However, the existing wireless technology has not been able to efficiently create a very high data rate because it was very sensitive to fading. Therefore, Orthogonal Frequency Division Multiplexing (OFDM) technology combined with MIMO (Multiple Input Multiple Output) transceiver system was used to gain more diversity and bandwidth efficiency. The propagation performed on the OFDM MIMO system was multipath propagation. To reduce Intersymbol Interference (ISI) was used Zero Forcing (ZF) equalizer which works by combining channel response and equalizer response itself to eliminate ISI. This study aims to determine the effect of Zero Forcing Equalizer on OFDM MIMO system using rayleigh fading channel and compared the result with OFDM MIMO STBC system. The research method used was simulation using MatLab R2015a. The simulation results showed that the performance of OFDM MIMO ZF system was worse than OFDM MIMO STBC system i.e BER vs EbNo simulation, eye diagram simulation, and constellation diagram simulation. The OFDM MIMO ZF system was required an Eb / No value more than 25 dB to achieve BER 10-4 while the OFDM MIMO STBC system only required an Eb / No value of 10.5 dB to achieve BER 10-4. The eye pattern generated by the OFDM MIMO ZF system was more closed and the dispersion of constellation signals away from the ideal point while OFDM MIMO STBC system displayed a more open eye pattern and the dispersion of its constellation signal closer to the ideal point. It indicated more ISI occurs in the OFDM MIMO ZF system than that in OFDM MIMO STBC system.

The exponential increase of Internet traffic due to cloud computing and other emerging web applications has created the need for more powerful data centres. These warehouse-scale data centres consist of thousands of racks interconnected with commodity switches and consume vast amount of energy. To face the requirements of the future data centres, new interconnection schemes have to be adopted to provide high throughput and reduced power consumption. Several optical interconnects for future data centre networks have recently appeared that provide high throughput, low latency and reduced power consumption. This paper discusses the need for a shift of the data centres networks to the optical domain to reduce the power consumption and meet the bandwidth requirements. Additionally, this paper presents some indicative optical interconnects for high performance data centres that have appeared recently in the research literature. Finally, it presents a qualitative categorization and comparison of these schemes based on their main features such as performance, connectivity and scalability.

Publication in the conference proceedings of EUSIPCO, Glasgow, Scotland, 2009

Multiuser channel estimation and prediction in two dimensions for MIMO–OFDM uplinks

Data centers (DCs), owing to the exponential growth of Internet services, have emerged as an irreplaceable and crucial infrastructure to power this ever-growing trend. A DC typically houses a large number of computing and storage nodes, interconnected by a specially designed network, namely, DC network (DCN). The DCN serves as a communication backbone and plays a pivotal role in optimizing DC operations. However, compared to the traditional network, the unique requirements in the DCN, for example, large scale, vast application diversity, high power density, and high reliability, pose significant challenges to its infrastructure and operations. We have observed from the premium publication venues (e.g., journals and system conferences) that increasing research efforts are being devoted to optimize the design and operations of the DCN. In this paper, we aim to present a systematic taxonomy and survey of recent research efforts on the DCN. Specifically, we propose to classify these research efforts into two areas: 1) DCN infrastructure and 2) DCN operations. For the former aspect, we review and compare the list of transmission technologies and network topologies used or proposed in the DCN infrastructure. For the latter aspect, we summarize the existing traffic control techniques in the DCN operations, and survey optimization methods to achieve diverse operational objectives, including high network utilization, fair bandwidth sharing, low service latency, low energy consumption, high resiliency, and etc., for efficient DC operations. We finally conclude this survey by envisioning a few open research opportunities in DCN infrastructure and operations.

In the era of cloud computing, data center network (DCN) can consume a significant amount of power (e.g., 10 to 20 percent) in large-scale data centers. To reduce the power consumption of DCN, traffic consolidation has been recently proposed as an effective approach to reduce the number of DCN devices in use. However, existing consolidation approaches do not sufficiently consider the flow completion time (FCT) requirement. On one hand, missing the FCT deadlines can cause serious violation of service-level agreement, especially for delay-sensitive networking services, such as web search and E-commerce. On the other hand, keeping all the devices on to make FCTs much shorter than the desired requirements is unnecessary because 1) users may not be able to perceive the difference, and 2) such a greedy strategy can lead to unnecessarily high DCN power consumption and thus more electricity costs. In this paper, we propose FCTcon, a dynamic FCT control strategy for DCN power optimization. FCTcon is designed rigorously based on control theory to dynamically control the FCT of delay-sensitive traffic flows exactly to the requirements, such that the desired FCT performance is guaranteed while the maximum amount of DCN power savings can be achieved. Results from both hardware experiments and simulation evaluation demonstrate that, compared to the state-of-the-art DCN power optimization schemes, FCTcon can improve the DCN FCT performance, while achieving nearly the same or even more power savings. Consequently, FCTcon can result in more than 22.0 to 62.2 percent extra net profits for a data center with 50K servers. In addition, we further propose two extended designs of FCTcon to handle the coflow abstraction recently proposed for DCN, which successfully reduce the coflow deadline miss ratio by 12 to 15 percent.

For a multiple-input multiple-output (MIMO) orthogonal frequency division multiplexing (OFDM) system, time-varying multipath fading of channel destroys the orthogonality among subcarriers and leads to serious intercarrier interference (ICI). The system performance degrades more severely as normalized Doppler frequency increases. In order to mitigate the effect of time-varying fading, a low-complexity iterative receiver with joint ICI cancellation and pilot-assisted channel estimation is proposed. The initial channel state information (CSI) is estimated by performing time-domain interpolation and least-square (LS) method on the received pilot symbols. The soft outputs are obtained from the decoders after low-complexity linear minimum mean-square error (LC-LMMSE) detection. In the following stages, the soft outputs are feedback to update the CSI estimation. Furthermore, a ¿linear statistics combining¿ (LSC) technique is used to improve the performance of the proposed equalizer by combining the outputs of LC-LMMSE and parallel interference canceler (PIC) with weighting coefficients estimated by maximizing the signal to interference-plus-noise ratio (SINR) at the output of LSC. The complexity of system is significantly reduced by restricting the interference to neighboring subcarriers and employing the LC-LMMSE by limiting the frequency-domain CSI into diagonal region. The simulation results show that the proposed iterative receiver with estimated CSI approaches the ICI-free bound even at very high mobility scenarios.

Fault tolerance, performance, and throughput have been major areas of research and development since the evolution of large-scale networks. Internet-based applications are rapidly growing, including large-scale computations, search engines, high-definition video streaming, e-commerce, and video on demand. In recent years, energy efficiency and fault tolerance have gained significant importance in data center networks and various studies directed the attention towards green computing. Data centers consume a huge amount of energy and various architectures and techniques have been proposed to improve the energy efficiency of data centers. However, there is a tradeoff between energy efficiency and fault tolerance. The objective of this study is to highlight a better tradeoff between the two extremes: (a) high energy efficiency and (b) ensuring high availability through fault tolerance and redundancy. The main objective of the proposed Energy-Aware Fault-Tolerant (EAFT) approach is to keep one level of redundancy for fault tolerance while scheduling resources for energy efficiency. The resultant energy-efficient data center network provides availability as well as fault tolerance at reduced operating cost. The main contributions of this article are: (a) we propose an Energy-Aware Fault-Tolerant (EAFT) data center network scheduler; (b) we compare EAFT with energy efficient resource scheduling techniques to provide analysis of parameters such as, workload distribution, average task per servers, and energy consumption; and (c) we highlight effects of energy efficiency techniques on the network performance of the data center.

Free Space Optical (FSO) communication is an emerging technology to provide high bandwidth, secure and high quality communication. In this work we have determined the capacity of the Free Space Optical communication system with Multiple Input Multiple Output (MIMO) Orthogonal Frequency Division Multiplexing (OFDM) technique under weak atmospheric turbulence conditions. To model the weak turbulence condition of the atmosphere lognormal channel model is used throughout the work. The capacity of MIMO-OFDM FSO is evaluated in the presence of Inter Symbol Interference (ISI) and is compared with MIMO FSO with ISI. The capacity of MIMO-OFDM FSO system increases in comparison to MIMO in the presence of ISI. It is found that the effect of ISI is mitigated by using OFDM and the capacity is enhanced. Since MIMO uses spatial divervity to mitigate the fading caused by turbulence hence the capacity of both MIMO-OFDM FSO and MIMO FSO also increases as the number of receiving antennas is increased.

Data center network (DCN) can consume a significant amount of power (e.g., 10% to 20%) in large-scale data centers. To reduce the power consumption of DCN, traffic consolidation has been recently proposed as an effective approach to reduce the number of DCN devices in use. However, existing consolidation approaches do not sufficiently consider the flow completion time (FCT) requirement. On one hand, missing the FCT deadlines can cause serious violation of service-level agreement, especially for delay-sensitive networking services, such as web search and E-commerce. On the other hand, keeping all the devices on to make FCTs much shorter than the desired requirements is unnecessary because 1) users may not be able to perceive the difference, and 2) such a greedy strategy can lead to unnecessarily high DCN power consumption and thus more electricity costs. In this paper, we propose FCTcon, a dynamic FCT control strategy for DCN power optimization. FCTcon is designed rigorously based on control theory to dynamically control the FCT of delay-sensitive traffic flows exactly to requirements, such that the desired FCT performance is guaranteed while the maximum amount of DCN power savings can be achieved. Results from both hardware experiments and simulation evaluations demonstrate that, compared to the state-of-the-art DCN power optimization schemes, FCTcon can improve the DCN FCT performance, while achieving nearly the same or even more power savings. Consequently, FCTcon can result in more than 22.0% to 62.2% extra net profits for a data center with 50K servers.

As the infrastructure of cloud computing and big data, data centers have been deployed widely. Then, how to make full use of the computing and storage resources in data centers will be the focus. Data center networks are considered important solution for the problem above, which include intra-data center and inter-data center networks. Both of them will depend on the optical networking due to its advantages, such as high bandwidth, low latency, and low energy consumption. Data center interconnected by flexi-grid optical networks is a promising scenario to allocate spectral resources for applications in a dynamic, tunable and efficient control manner. Compared with inter-data center, optical interconnect in intra-data center networks is a more pressing need and promising scenario to accommodate these applications in a dynamic, flexible and efficient manner. OpenFlow based Software Defined Networking (SDN) is considered as a good technology, which is very suitable for data center networks. This paper mainly focuses on the data center optical networks based on software defined networking (SDN), which can control the heterogeneous networks with unified resource interface. Architecture and experimental demonstration of OpenFlow-based optical interconnects in intra-data center Networks and OpenFlow-based flexi-grid optical networks for inter-data center are presented in the paper respectively. Some future works are listed finally.