In this paper, we propose a detailed energy survey of the physical, data link, and network layer by analytical techniques. We also show the impact of regular sleep periods on node energy consumption and present a comparison analysis of single-hop vs. multi-hop communications in the energy realm. A detailed energy expenditure analysis of not only the physical layer but also the link and network layer provides a basis for developing new energy efficient wireless sensor networks. Regular, coordinated sleeping extends the lifetime of sensor nodes, but systems can only benefit from sleeping in terms of transmitted packets if the data arrival rate to the system is low. Energy efficiency is the driving motivation for it can be considered the most important factor for wireless sensor networks because of the power constraints set by battery operation. Radio solutions in the lower ISM bands are attractive because of their relatively easy implementation and low power consumption. However, the data rates of these commercial radios are also relatively low, limiting transmittable frame sizes to a few tens of octets along with strict duty cycle requirements. From the analysis we extract key parameters of selected MAC protocols and show that some traditional mechanisms, such as binary exponential backoff, have some inherent problems. We also argue that single-hop communications has up todo% lower energy consumption than multi-hop forwarding within the feasible transmission distances of an ISM radio. Index Terms-Energy efficiency, Wireless sensor net- works, Medium access control (MAC) protocols, multi-hop communications a duty cycIe (Z), (3), which is normally 10% for the 434MHz band and 1% for the 868MHz band. The duty cycle is defined as the ratio, expressed as a percentage, of the maximum transmitter on-time, relative to a one hour period. When a sensor network is expected to work continuously, this duty cycle has to be taken into account and it can affect the energy efficiency of a network. In this paper we perform cross-layer analysis by pre- senting topology, medium access control (MAC) and ra- dio transceiver energy consumption models that work in unison. The hear topology model represents a common network after network layer route discovery has been accomplished. We use an energy consumption model for the transmission and reception of MAC frames originally presented in (4), develop a coordinated sleep group energy consumption model, and analytically investigate the effect of sleep on sensor networks using three MAC protocols. From the analysis we show that although in an ideal scenario multi-hop communications perform better than single-hop communications, realistic energy models and especially the MAC protocol design have a significant impact. We propose a multi-group sleep model for our nanoMAC protocol, and show that reg- ular sleep periods have a significant, energy reducing impact on node energy consumption with low traf!fic rates. The radio transceiver energy model takes into account several important radio parameters and we use the RFM TRlOOO and RFM radio designers guide (5) for realistic transceiver parameters. The main metric used is absolute energy, consumption per useful transmitted bit. This means only the MAC or thc network protocol data unit (PDU) will be considered and all the other communicated bits, headers, control frames, preambles, etc. are considered as overhead. The rest of the paper is organized as follows. Some related work is discussed in Section IT and in Section 111 we look at the radio propagation energy model. Section TV presents the network topology and energy
Read more
34
