Exploiting Spatial Correlation for Improving Coverage in Sensor Networks

Node placement for connected target coverage in wireless sensor networks with dynamic sinks

Aiming at the uneven random coverage distribution of wireless sensor networks sensor nodes, the sparrow search algorithm (SSA) is used to optimize the node coverage of wireless sensor networks. To improve the global search capability of SSA, the algorithm is improved and applied to the wireless sensor networks of bridge monitoring. For enhancing the coverage of the wireless sensor networks, this article uses two improved methods. One is to use the good point set theory to make the initial population evenly distributed; another is to introduce a weight factor to speed up its convergence. The experiments have proved the reliability and rationality of the algorithm. The improved algorithm is superior to other meta-heuristic algorithms and provides a new idea for optimizing bridge monitoring wireless sensor networks coverage.

Existing work on placing additional relay nodes in wireless sensor networks to improve network connectivity typically assumes homogeneous wireless sensor nodes with an identical transmission radius. In contrast, this paper addresses the problem of deploying relay nodes to provide fault-tolerance with higher network connectivity in heterogeneous wireless sensor networks, where sensor nodes possess different transmission radii. Depending on the level of desired fault-tolerance, such problems can be categorized as: (1) full fault-tolerance relay node placement, which aims to deploy a minimum number of relay nodes to establish k (k ges 1) vertex-disjoint paths between every pair of sensor and/or relay nodes; (2) partial fault-tolerance relay node placement, which aims to deploy a minimum number of relay nodes to establish k (k ges 1) vertex-disjoint paths only between every pair of sensor nodes. Due to the different transmission radii of sensor nodes, these problems are further complicated by the existence of two different kinds of communication paths in heterogeneous wireless sensor networks, namely two-way paths, along which wireless communications exist in both directions; and one-way paths, along which wireless communications exist in only one direction. Assuming that sensor nodes have different transmission radii, while relay nodes use the same transmission radius, this paper comprehensively analyzes the range of problems introduced by the different levels of fault-tolerance (full or partial) coupled with the different types of path (one-way or two-way). Since each of these problems is NP-hard, we develop O(sigmak <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">2</sup> )-approximation algorithms for both one-way and two-way partial fault-tolerance relay node placement, as well as O(sigmak <sup xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">3</sup> )-approximation algorithms for both one-way and two-way full fault-tolerance relay node placement (sigma is the best performance ratio of existing approximation algorithms for finding a minimum k-vertex connected spanning graph). To facilitate the applications in higher dimensions, we also extend these algorithms and derive their performance ratios in d-dimensional heterogeneous wireless sensor networks (d ges 3). Finally, heuristic implementations of these algorithms are evaluated via simulations.

Although most of the studies on coverage and connectivity in wireless sensor networks (WSNs) considered two-dimensional (2D) settings, such networks can in reality be accurately modeled in a three-dimensional (3D) space. The concepts of continuum percolation theory best fit the problem of connectivity in WSNs to find out whether the network provides long-distance multihop communication. In this paper, we focus on percolation in coverage and connectivity in 3D WSNs. We say that the network exhibits a coverage percolation (respectively, connectivity percolation) when a giant covered region (respectively, giant connected component) almost surely spans the entire network for the first time. Because of the dependency between coverage and connectivity, the problem is not only a continuum percolation problem but also an integrated continuum percolation problem. Thus, we propose an integrated-concentric-sphere model to address coverage and connectivity in 3D WSNs in an integrated way. First, we compute the critical density lambdaC con above which coverage percolation in 3D WSNs will almost surely occur. Second, we compute the critical density lambdac con above which connectivity percolation in 3D WSNs will almost surely occur. Third, we compute the critical density lambdac cov-con above which both coverage and connectivity percolation in 3D WSNs will almost surely occur. For each of these three problems, we also compute their corresponding critical network degree. Our results can be helpful in the design of energy-efficient topology control protocols for 3D WSNs in terms of coverage and connectivity.

Wireless sensor networks are a collection of specially designed nodes to provide support to sensor information propagation. Sensor nodes are basically designed to sense data as sensor and distribute to servers for further analysis. Based on the specific requirements, the numbers of sensor nodes can range from hundreds to thousands. All the communication will take place through predefined network characteristics. WSNs generally face energy issues. LEACH is designed for efficient cluster formation. It provides an efficient energy solution for data transmission from node to base station. Various enhanced version of LEACH has been proposed by Assuming LEACH as base protocol. The energy constraints are a critical aspect in developing the routing protocols for WSNs. Designers and researchers have contributed their effort through enhancement in energy saving procedure into WSNs. In this work, the LEACH based protocols and their performance in WSN has been analysed. This research paper evaluates recent advancement in LEACH based approaches for Wireless Wide Area Sensor Network with comparison table.

It is our great pleasure to welcome you to the 3rd ACM Workshop on Security of Ad Hoc and Sensor Networks (SASN'05), held in conjunction with the 12th ACM Conference on Computer and Communications Security (CCS'05), November 7, 2005, in Alexandria, Virginia.This year we received a total of 39 submissions on various aspects of ad-hoc and sensor network security. The program committee selected 6 as regular papers that cover a variety of topics, including trust establishment in Mobile Ad-Hoc Networks (MANETs), security of vehicular ad-hoc networks, secure group communication, key pre-distribution for sensor networks, jamming attacks against sensor network MAC protocols, and defense against Denial-of-Service (DoS) attacks. This year we continue the tradition of SASN'03 and SASN'04 to encourage the presentation and discussion of work-in-progress on ad-hoc and sensor network security. Among the 39 submissions, the program committee selected 7 papers to present in work-in-progress sessions, covering topics on anonymous routing for MANETs, key distribution for inter-group multicast in ad-hoc networks, improved topology assumptions for threshold cryptography in MANETs, RFID security, tracing in mobile wireless sensor networks, time synchronization attacks in sensor networks, and coordinated deployment for improving secure communications and sensing coverage in wireless sensor networks. In addition, the program includes a panel on Advances in Sensor and Ad-hoc Network Security and an invited keynote talk by Radha Poovandran (University of Washington) on Information Assurance in MANETs and Wireless Sensor Networks. We hope that these proceedings will serve as a valuable reference for security researchers and developers.

Many wireless sensor network applications must resolve the inherent conflict between energy efficient and nodes of coverage in wireless sensor networks to achieve desired quality of service (QoS). The wireless sensor networks (WSNs) have been the main focus in the past few years, and it is becoming a special issue. We study the problem of controlling the node locations and energy within ad-hoc sensor networks. Network survivability is a very important measure for deciding the efficiency of network protocols. It includes a measure of the network lifetime as well as the quality of service. In fact, these dynamics are very important in evaluating networks. The wireless network applications can be found in battlefield communication, homeland security, pollution sensing and traffic monitoring. As such, there has been an increasing need for defining and developing simulation frameworks for carrying out high-fidelity WSN simulation. In this cause, we present a simulation by including factors such as energy-consumption, Bandwidth, nodes, and coverage and provides an object-oriented definition of target, sensor and sink nodes, sensor and wireless communication nodes, and physical radio such as relating of nodes, mobility model and power model both energy-producing and energy-consuming components, the simulation was developed using C#.

Notice of Violation of IEEE Publication Principles Critical Density for Coverage and Connectivity in Two-Dimensional Aligned-Orientation Directional Sensor Networks Using Continuum Percolation, by Mohammad Khanjary, Masoud Sabaei, and Mohammad Reza Meybodi in IEEE Sensors Journal, vol. 14, no. 8, pp. 2856-2863, Aug. 2014 After careful and considered review of the content and authorship of this paper by a duly constituted expert committee, this paper has been found to be in violation of IEEE's Publication Principles. This paper contains significant portions of original text from the paper cited below. The original text was copied without attribution (including appropriate references to the original author(s) and/or paper title) and without permission. Integrated Coverage and Connectivity in Wireless Sensor Networks: A Two-Dimensional Percolation Problem, by H. M. Ammari and S. K. Das, in IEEE Transactions on Computers, vol. 57, no. 10, pp. 1423-1434, Oct. 2008 Sensing coverage is one of the fundamental design issues in wireless sensor networks, which reflects the surveillance quality provided by them. Moreover, network connectivity enables the gathered data by sensors to reach to the sink node. Given an initially uncovered field, and as more and more directional sensors are continuously added to the sensor network, the size of partial covered areas increases. At some point, the situation abruptly changes from small fragmented covered areas to a single large covered area. We call this abrupt change the sensing-coverage phase transition (SCPT). Likewise, given an originally disconnected sensor network, as more and more sensors are added, the number of connected components changes such that the sensor network suddenly becomes connected at some point. We call this sudden change the network connectivity phase transition (NCPT). The nature of such phase transitions is a central topic in the percolation theory. In this paper, we introduce aligned-orientation directional sensor networks in which nodes are deployed based on Poisson point process and the orientation of all sensor nodes is the same. Then, we propose an approach to compute density of nodes at critical percolation for both of the SCPT and NCPT problems in such networks, for all angles of field-of-view between 0 and π by using continuum percolation. Due to percolation theory, the critical density is infimum density that for densities above it SCPT and NCPT almost surely occur. In addition, we propose a model for percolation in directional sensor networks, which provides a basis for solving the SCPT and NCPT problems together.

Finding an optimal node deployment strategy in wireless sensor networks (WSNs) that would reduce cost, be robust to node failures, reduce computation, and communication overhead, and guarantee a high level of coverage along with network connectivity is a difficult problem. In fact, sensing coverage and network connectivity are two of the most fundamental problems in WSNs as they can directly impact the network lifetime and operation. In this paper, we consider deriving optimal conditions for connectivity with coverage in WSNs. Most versions of this problem are (NP-complete), while approximation algorithms cannot be developed for some versions of polynomial time, unless P = NP. Hence, we also develop a heuristic for some versions of the problem and the efficacy of the heuristic will be evaluated through extensive simulations. We are also interested in determining the probability of finding a path between a given pair of nodes over a given topology of WSNs. This will serve as a measure of connectivity with coverage of the network. Hence, we derive necessary and sufficient conditions for connectivity with coverage over a clustered structure in WSNs. Then, employing queuing networks modeling techniques, we present a dynamic programming study of the connectivity with coverage of clustered structure and its effect on routing in generalized WSNs. The performance evaluation of the proposed schemes shows that availability of nodes, sensor node coverage, and the connectivity were sufficiently enhanced to maximize network lifetime.

Forest fire detection system using barrier coverage in wireless sensor networks

Target Coverage and Network Connectivity in Wireless Sensor Networks (WSNs) plays a momentous role in the field of monitoring environment, habitant observing, disaster recovery, surveillance, etc. Coverage and Network Connectivity collectively can be considered as a proportion of Quality of Service (QoS) in a sensor network. It implies the coverage of each point in the detecting field while in the meantime fulfilling the measure that each node is surrounded by the equivalent neighbourhood of at least one other node. Many primary issues influence the outline and performance of WSN. A Comprehensive survey is made based on the scheduling algorithm and set cover approach, in which we analyze various approaches and their algorithm complexity. Firstly, the scheduling algorithm intermittently provides the required data service with guaranteed efficiency. This methodology can efficiently reduce the entire number of active nodes in the network, resulting in maximizing the network lifetime. Secondly, the set cover approach plays a major role in solving target coverage problem which group sensors into each cover set thereby, target coverage was achieved. Typical issues and open research challenges are addressed by classifying the approaches available in literature into three broad categories namely, adaptable coverage radius, coverage deployment strategy, and sleep scheduling. This survey aims to provide a better perceptive of the existing open challenges and possible futuristic approaches for target coverage and network connectivity in wireless sensor networks.

Coverage in wireless sensor networks is a critical issue since it reflects the cost and detection capability of the network. Sensor coverage model is closely to the sensing functions of different types of sensors while network coverage is a collaborative measure from geographically distributed sensors. The coverage problems in wireless sensor networks have been formulated in various ways with different assumptions, constraints and objectives. In this work, a collaborative coverage model is proposed in the target surveillance application, while sensor sensing probabilistic model is introduced. Furthermore, a collaborative target coverage optimization algorithm (CTCOMSN) is presented to prolong the network lifetime in energy constraint mobile sensor networks. Simulation results show that CTCOMSN can prolong the lifetime greatly while improving the sensing quality.

Efficient coverage and connectivity are two important factors that ensures better service quality especially during tracking targets or monitoring events in wireless sensor network. Although massive amount of studies has been carried out in the past to enhance coverage and connectivity issues, till date very few studies have witnessed a significant and standard outcomes that can opt further. Hence, this paper introduces a computationally efficient technique for jointly addressing both coverage and connectivity problems in large-scale wireless sensor network that ensures optimal network lifetime too. The proposed system has been empirically designed, and algorithms formulated to ensure energy efficient monitoring of event. The outcomes of the study are compared with standard energy efficient hierarchical protocol to benchmark the results.

Energy efficiency and sensing accuracy have both been attractive research fields in sensor networks. Achieving both objectives is possible in a compromise model. In this paper we formulate one such problem and use a game theoretic approach for its solution. The interaction between sensor nodes is modeled as a cooperative bargaining game, where individual sensors cooperate for achieving the application sensing requirements while minimizing and balancing the energy consumption. We use Kalai-Smordinsky Bargaining Solution to find a distribution rule that optimizes the trade-off in the compromise problem. Based on the distribution rule, we propose a lightweight distributed algorithm in order to schedule nodes for performing the sensing task. Simulation shows a superiority in terms of scalability over a similar earlier work, while a comparable achievement in network lifetime improvement is obtained at the same time.

Wireless Sensor Networks (WSNs) can be used effectively to form barriers that monitor strips of land for applicaions such as homeland security and critical infrastructure protection. Sensors are highly constrained in their energy usage, so when they harvest energy, it is neccessary that this energy be used effectively. When WSNs are used as barriers, they are typically deployed for extended period of time, so it is of great importance that the network has a long lifetime. The lifetime problem for WSNs has been studied extensively. In this paper we give an exact solution to the problem of achieving maximum lifetime for the application of k-barrier coverage in energy harvesting wireless sensor networks.