Fundamental studies on ultra-high-speed optical LAN using optical circuit switching

Dynamic optical interconnects using fast Optical Circuit Switches (OCS) are emerging as a scalable and energy efficient alternative to increasing network demands. Initial concerns regarding slow switching speeds of OCSs were recently overcome, with prototypes enabling circuit setup in a few microseconds. This can potentially broaden the classes of traffic patterns that can be carried efficiently by an alloptical interconnect. However, application performance on such newer interconnects has not been fully understood yet. In this paper, we explore the the gap between advances in faster OCS hardware and the potential success of such newer technologies in terms of application performance and cluster energy efficiency. We evaluate the performance of latencysensitive distributed applications running on a fast OCS environment, analyzing its impact to overall server and network energy efficiency. We also discuss scheduling inefficiencies of current fast OCSs and evaluate ideas to solve them. We find that while some distributed applications suffer minimal performance penalty when running on fast OCSs, more flexible schedulers, like the ones outlined in this paper, improve application performance and OCS efficiency by up to 2.44 times compared to the strategies in the literature. Dynamic optical interconnects using fast Optical Circuit Switches (OCS) are emerging as a scalable and energy efficient alternative to increasing network demands. Initial concerns regarding slow switching speeds of OCSs were recently overcome, with prototypes enabling circuit setup in a few microseconds. This can potentially broaden the classes of traffic patterns that can be carried efficiently by an all-optical interconnect. However, application performance on such newer interconnects has not been fully understood yet. In this paper, we explore the the gap between advances in faster OCS hardware and the potential success of such newer technologies in terms of application performance and cluster energy efficiency. We evaluate the performance of latency-sensitive distributed applications running on a fast OCS environment, analyzing its impact to overall server and network energy efficiency. We also discuss scheduling inefficiencies of current fast OCSs and evaluate ideas to solve them. We find that while some distributed applications suffer minimal performance penalty when running on fast OCSs, more exible schedulers, like the ones outlined in this paper, improve application performance and OCS efficiency by up to 2.44 times compared to the strategies in the literature.

Optical Circuit Switching (OCS) provides a good support for the services requiring high bandwidth and Quality of Service (QoS). When the character of network traffic changes from voice-oriented to data-oriented, OCS must cooperate with new switching mechanisms such as Optical Burst Switching (OBS) to improve performance. So a Hybrid Optical Switching (HOS) system is proposed. In HOS, different traffics are classified and both OBS and OCS can be processed. At the same time, delay buffer mechanisms, which are Fiber Delay Line (FDL) and electronic buffering, are introduced in HOS to solve the contention of OBS bursts. And a wavelengths classification mechanism, which assigns some wavelengths dedicated to OCS traffics, is provided to guarantee the QoS of OCS. To analyze the performance in theory, models based on Markovian theory and iterative method are provided. The results got by theory are accurate compared with simulations. The use of delay buffer can decrease the blocking probability of OBS and increase resource utilization. Wavelength classification mechanism benefits to improve OCS's performance.

A hybrid optical/electrical datacenter network (HOE-DCN) integrates the benefits of electrical packet switching (EPS) and optical circuit switching (OCS) for better architectural scalability. Meanwhile, as each network service usually involves multiple virtual machines (VMs) that form a virtual network (VNT), how to reconfigure the VNTs in an HOE-DCN to adapt to the dynamic network environment becomes an interesting and important problem to tackle. In this work, we optimize the procedure of VNT reconfigurations that remap VNTs to given virtual network embedding (VNE) schemes, <italic xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">i.e.</i> , scheduling the required VM migrations and optical cross-connect (OXC) reconfiguration properly such that the overall VNT reconfiguration latency can be minimized. We first assume that all the VM migrations should be scheduled before the OXC reconfiguration to minimize service interruptions, and formulate a mixed integer linear programming (MILP) model to solve the scheduling problem exactly. Then, with the same assumption, we propose a time-efficient heuristic to schedule parallel VM migrations in batches such that the bandwidth competition can be significantly relieved. Finally, we divide the OXC reconfiguration into several progressive steps, and design a joint scheduling algorithm to arrange VM migrations together with the OXC reconfiguration steps.

Modeling and performance analysis of a data center network (DCN) combining optical packet switching (OPS) and agile optical circuit switching (OCS) in a unified platform are presented. Hybrid optoelectronic packet routers which combine optical switching fabric and electronic buffers are used, supporting 100 Gbit/s (25 Gbit/s × 4 wavelengths) optical packets. OCS transmission is implemented by a novel “express path,” (ExP) an instant wavelength path on demand, which enables certain flows following the ExP with no packet contention, whereas ordinary OPS packets are switched with a deflection routing algorithm and buffering for contention resolution. This architecture can support OCS for large and reliability-sensitive data transferring and OPS for latency-sensitive applications. The performance of the network is investigated via numerical simulations of top-of-rack switch (ToR)-to-ToR traffic in an N-dimensional (up to 4096 node) torus topology. We have made the following observations: 1) torus topology results in high throughput and can be scaled out by increasing the dimension; 2) contention resolution between OPS and agile OCS is needed and our proposed strategies enhance the overall performance; and 3) in a lightly to moderately loaded case of OPS traffic, more than 100 ExPs can be supported simultaneously with acceptable affect on OPS.

In optical switching paradigm, there are three approaches; optical circuit switching, optical packet switching, and optical burst switching (OBS). OBS is a technology that takes the best features of packet switching and circuit switching by providing a flexible infrastructure for carrying IP traffic and at the same time ensuring efficient utilization of the fiber link. In this paper we propose an effective contention resolution scheme to achieve minimum burst loss at core nodes. Algorithm of zero burst loss for bimodal burst switching is extended from single node star network topology to two node star topology. Scheduling at the core node, typically an optical cross connect (OXC), is performed in two modes i.e., Mode 0 & Mode 1. Mode 0 is for burst transmission between all directly connected edge nodes whereas Mode 1 is for burst transmission through remote core node to a particular destination edge node. Synchronization of the reservation request between the core nodes is a critical task in such a topology. In order to achieve minimum burst loss, using a small length of fiber delay line in recirculation mode results in an effective strategy.

Optical burst switching (OBS) is a switching technology that can efficiently operate in the optical core network using WDM technology and can also develop the future optical internet. The OBS switching technology presents a trade-off between the two switching technologies: optical circuit switching (OCS) and optical packet switching (OPS). This switching approach increases resource utilization compared with OCS technology and avoids the technological barriers of OPS networks. In OBS networks, many packets are assembled into one data burst at the edge node and a burst header packet (BHP) is sent before the burst transmission by an offset time in order to reserve the required resources in core nodes. This can cause security issues in the network and more specifically denial of service attacks that can occur if a source node is compromised. In this paper, we study a specific denial of service attack which we refer to as "BHP flooding attack", which prevents legitimate traffics from reserving the required resources at intermediate core nodes. We also propose the design of a reconfigurable BHP flooding countermeasure module that allows to counter against this type of attacks in an OBS network.

In optical packet switching (OPS)-based data center networks (DCNs), it is preferred to set up temporal optical circuit switching (OCS) paths for large-data transmission that requires high reliability. However, inappropriate OCS path selection could severely affect the original OPS traffic. This is because an OCS path may break the network topology and cause OPS packet circulations. We propose to maintain bypassing routes for every link of the OCS path when it is established. Then, the OPS packets can bypass the OCS links by being deflected to the bypassing routes. Therefore, this method facilitates the coexistence of OCS in OPS-based DCNs. Numerical simulations demonstrate the benefit achieved by our proposal compared with non-bypassing-route scenarios.

We develop an integrated optical packet and circuit switching node in which signaling via optical packet switching is implemented. We demonstrate 80 (8λ × 10) Gbit/s optical packet switching with <;1E-4 packet-loss-rate, 8-lightpaths establishment, and dynamic wavelength-resources control.

DWDM multi-mode switching network provides a unified approach to DWDM-based communications by allowing electronic packet switching (EPS), optical burst switching (OBS) and optical circuit switching (OCS) to be carried in the same network, and on the same router platform. In this paper, we present a sub-millisecond dynamic optical path setup scheme for the multi-mode switching router. More specifically, we devised a reconfigurable asymmetric optical burst switching (RA-OBS) scheduling scheme which integrates burst scheduling in the OBS mode, connection setup/teardown in the OCS mode, and channel reconfiguration in the EPS mode in a seamless fashion. The proposed scheme allows wavelengths to be dynamically shared among three different switching modes in real-time. The performance of the proposed integrated scheduler has been verified using OBS-ns2 simulator as well as in a hardware testbed. In particular, we have implemented the proposed integrated multi-mode scheduler in FPGA hardware in an optical switching testbed, and have demonstrated application triggered real-time sub-millisecond optical path setup. Another key contribution is that the proposed approach brings out the practical value of optical burst switching, which has stayed mostly in the theoretical regime in the past decade. We show that a truly dynamic optical network can be built with off-the-shelf optical components.

Scheduling traffic for maximum switch lifetime in optical data center fabrics

We propose and implement an enhanced moving average (MA) based dynamic resource allocation method for optical packet and circuit integrated (OPCI) networks. In the OPCI networks, optical packet switching (OPS) and optical circuit switching (OCS) share the total bandwidth in a fiber by allocating separate wavelength resources to them. In this work, we leverage an exponential moving average (EMA) as an enhanced MA. Every time a signaling process for path establishment or release occurs at a node, the proposed method employs the EMA of number of in-use paths to reallocate wavelengths to OCS and OPS while the conventional method employs the absolute number of in-use paths. When the EMA reaches or becomes less than a threshold value, the dynamic resource allocation is executed. As results of simulations and a verification experiment, we show that the proposed method can reduce the amount of routing processes without suffering from blocking of path establishments in comparison to the conventional method. In addition, it is expected that the proposed method can effectively allocate vaster amount of bandwidth to OPS without suffering from the blocking and achieve better system performances for OPS.

An optical packet and circuit integrated network (OPCInet) will allow diverse services, enhanced functional flexibility, and efficient energy consumption, as optical packet switching (OPS) and optical circuit switching (OCS) links are provided on the same infrastructure. In this paper, we design and develop a control system consisting of header processing for optical packets, signaling and routing for optical path setup, and wavelength resource control and link switching between OPS and OCS for the efficient use of resources. Our onboard optical packet header processor is capable of 16-bit longest prefix matching by embedding a 0.6W (5% of TCAM technology on the same condition), 200 million search-per-second (equivalent to 100 Gbps) forwarding engine LSI, and a statistical memory LSI for retaining the statistical information of processed headers. Reactive control automatically selects a packet or circuit link according to the statistical traffic information from the header processor and works with signaling for optical paths. We present an experimental demonstration of a new control system using a previously developed OPCInet testbed.

Hybrid optical networks (HONs) are the combination of different switching mechanisms such as Optical Circuit Switching (OCS), Optical Burst Switching (OBS) and Optical Packet Switching (OPS). The basic idea behind HONs is to integrate the advantages of different switching mechanisms. HONs are classified into three classes as: (1) parallel hybrid optical networks, (2) integrated hybrid optical networks, (3) client-server hybrid optical networks. In this article, we describe these classes in detail and a new integrated hybrid optical network called EISM (Efficient Integration of Switching Mechanisms in all-optical networks) is introduced. The proposed EISM method could perform optimally while considering some implementation criteria; such criteria include network bandwidth utilization, implementation complexity and also the domain of network performance by combining four switching mechanisms-OCS, long-OBS, short-OBS and OPS.

Contrary to Optical Circuit Switching (OCS), Optical Burst Switching (OBS) is efficient for bursty traffic but also weak in guaranteeing the delivery of real-time traffic. We have proposed an OBS enhancement approach, called Labeled OBS with Home Circuits or LOBS-HC, which provides each source-destination pair with a wavelength sharable home circuit for the real-time traffic, so it can guarantee lossless transmission with a short delay. In previous works, we have shown that LOBS-HC requires less resources and provides a better QoS to the real-time traffic than OCS, since it does statistical multiplexing. Here, we extend the study of LOBS-HC. First, we study a few possible design choices in LOBS-HC. Then we evaluate its performance under not only real-time traffic, but also best-effort traffic. Finally, we analyze the effects of the switching speed and the burst size on the performance.

As the performance requirements and scale of high-performance computing (HPC) systems grow rapidly, systems with such a large number of computing nodes present significant challenges in network architecture design because their peak performance is increasingly limited by communication rather than computation. Moreover, certain HPC application always shows some specific communication patterns, and different topologies have various performances with these patterns. To implement a traffic pattern adaptive HPC system, we propose a topology reconfigurable hybrid network architecture based on optical circuit switching (OCS), which could be adjusted into different classical topologies. And an algorithm of topology calculating and a permutation matrix-based optical switch configuration mechanism are proposed to construct network. We discuss network performances with limited OCS switches occupation, and results show that traffic pattern adaptive network improves the performance of latency and throughput to a large extent.