H2 performance via static output feedback for a class Of nonlinear systems

This study employs the free-weighting matrix approach to investigate the output feedback control of a linear discrete-time system with an interval time-varying delay. First, the delay-dependent stability is analyzed using a new method of estimating the upper bound on the difference of a Lyapunov function without ignoring any terms; and based on the results, a design criterion for a static output feedback (SOF) controller is derived. Since the conditions thus obtained for the existence of admissible controllers are not expressed strictly in terms of linear matrix inequalities, a modified cone complementarity linearization algorithm is employed to solve the nonconvex feasibility SOF control problem. Furthermore, the problem of designing a dynamic output feedback controller is formulated as one of designing an SOF controller. Numerical examples demonstrate the effectiveness of the method and its advantage over existing methods.

This paper presents a method to design a static output feedback active suspension controller for ride comfort improvement and motion sickness reduction in a real vehicle system. Full-state feedback controller has shown good performance for active suspension control. However, it requires a lot of states to be measured, which is very difficult in real vehicles. To avoid this problem, a static output feedback (SOF) controller is adopted in this paper. This controller requires only three sensor outputs, vertical velocity, roll and pitch rates, which are relatively easy to measure in real vehicles. Three types of SOF controller are proposed and optimized with linear quadratic optimal control and the simulation optimization method. Two of these controllers have only three gains to be tuned, which are much smaller than those of full-state feedback. To validate the performance of the proposed SOF controllers, a simulation is carried out on a vehicle simulation package. From the results, the proposed SOF controllers are quite good at improving ride comfort and reducing motion sickness.

This thesis is concerned with the dissipative control and filtering problems of singular systems. Four classes of singular systems are considered: delay-free singular systems, singular systems with constant time-delay, uncertain singular systems with time-varying delay and sensor failures, and singular Markovian jump systems with actuator failures.
\nFor delay-free singular systems, the system augmentation approach is employed to study the dissipative control and filtering problems. First, the approach is used to solve the dissipative control problem by static output-feedback for standard state-space systems which are the special cases of singular systems. For a continuous-time standard state-space system, the closed-loop system is represented in an augmented system form. Based on the augmented system, a necessary and sufficient dissipativity condition is proposed, which decouples the Lyapunov matrix and controller matrix. To further separate the Lyapunov matrix and the system matrices, an equivalent condition is obtained by introducing some slack matrices. Then, a necessary and sufficient condition for the existence of a static output-feedback controller is proposed, and an iterative algorithm is given to solve the condition. For discrete-time singular systems, by giving an equivalent representation of the solution set, a necessary and sufficient dissipativity condition is proposed in terms of strict linear matrix inequality (LMI) which can be easily solved by standard commercial software. Then a state-feedback controller design method is given based on the augmentation system approach. The method is extended to the static output-feedback control problem and the reduced-order dissipative filtering problem.
\nFor continuous-time singular time-delay systems, the problem of state-feedback dissipative control is considered. An improved delay-dependent dissipativity condition in terms of LMIs is established by employing the delay-partitioning technique, which guarantees a singular system to be admissible and dissipative. Based on this, a delay-dependent sufficient condition for the existence of a state-feedback controller is proposed to guarantee the admissibility and dissipativity of the closed-loop system. In addition to delay-dependence, the obtained results are also dependent on the level of dissipativity. Moreover, the results obtained unify existing results on H∞ performance analysis and passivity analysis for singular systems.
\nFor discrete-time singular systems with polytopic uncertainties, time-varying delay and sensor failures, the problem of robust reliable dissipative filtering is considered. The filter is designed by the reciprocally convex approach such that the filtering error singular system is admissible and strictly (Q, S, R)-dissipative. For singular systems with time-varying delay and sensor failures, a sufficient condition of reliable dissipative analysis is obtained in terms of LMIs. Then the result is extended to the uncertain case by introducing some variables to decouple the Lyapunov matrices and the filtering error system matrices. Moreover, a desired filter for uncertain singular systems with time-varying delay and sensor failures is obtained by solving a set of LMIs.
\nFor continuous-time singular Markovian jump systems with actuator failures, the problem of reliable dissipative control is addressed. Attention is focused on the state-feedback controller design method such that the closed-loop system is admissible and strictly (Q, S, R)-dissipative. A sufficient condition is obtained in terms of strict LMIs. Moreover, the results obtained unify existing results on H∞control and passive control on singular Markovian jump systems.

This paper presents a method for designing a static output feedback integrated path tracking controller for autonomous vehicles. For path tracking, state–space model-based control methods, such as linear quadratic regulator, H∞ control, sliding mode control, and model predictive control, have been selected as controller design methodologies. However, these methods adopt full-state feedback. Among the state variables, the lateral velocity, or the side-slip angle, is hard to measure in real vehicles. To cope with this problem, it is desirable to use a state estimator or static output feedback (SOF) control. In this paper, an SOF control is selected as the controller structure. To design the SOF controller, a linear quadratic optimal control and sliding mode control are adopted as controller design methodologies. Front wheel steering (FWS), rear wheel steering (RWS), four-wheel steering (4WS), four-wheel independent braking (4WIB), and driving (4WID) are adopted as actuators for path tracking and integrated as several actuator configurations. For better performance, a lookahead or preview function is introduced into the state–space model built for path tracking. To verify the performance of the SOF path tracking controller, simulations are conducted on vehicle simulation software. From the simulation results, it is shown that the SOF path tracking controller presented in this paper is effective for path tracking with limited sensor outputs.

This paper modifies the prototype model-free adaptive control (PMFAC) approach in which system output fluctuation and overshoot (SOFO) is easy to occur. Targeting a class of nonlinear discrete-time single-input single-output systems, historical input/output sensor data are utilized to online construct equivalent explicit data model for control design, making the controller model-free. Then, a novel compensation input term including a compensation gain and a signum function parameterized by incremental output is proposed to soften system inputs, which can in turn restrain the SOFO. Numerical simulations and a speed control experiment for a direct current motor verify that the modified approach can restrain the SOFO successfully and reduce response time compared with the PMFAC.

Improved stability criterion and output feedback control for discrete time-delay systems

In this paper, an optimal control scheme for a class of nonlinear systems with time delays in both state and control variables with respect to a quadratic performance index function is proposed using a new iterative adaptive dynamic programming(ADP) algorithm.By introducing a delay matrix function, the explicit expression of the optimal control is obtained using the dynamic programming theory and the optimal control can iteratively be obtained using the adaptive critic technique.Convergence analysis is presented to prove that the performance index function can reach the optimum by the proposed method.Neural networks are used to approximate the performance index function, compute the optimal control policy, solve delay matrix function, and model the nonlinear system, respectively, for facilitating the implementation of the iterative ADP algorithm.Two examples are given to demonstrate the validity of the proposed optimal control scheme.

Robust analysis and control for a class of uncertain nonlinear discrete-time systems

A linear control system defined by a stationary differential equation of nth order with several commensurate lumped and distributed delays in state is considered. In the system, the input is a linear combination of m variables and their derivatives of order not more than n−p and the output is a k-dimensional vector of linear combinations of the state and its derivatives of order not more than p−1. For this system, a spectrum assignment problem by linear static output feedback with commensurate lumped and distributed delays is studied. Necessary and sufficient conditions are obtained for solvability of the arbitrary spectrum assignment problem by static output feedback controller. Corollaries on stabilization of the system are obtained.

This paper is focused on the static output feedback (SOF) control problem for a class of switched nonlinear systems with actuator faults. By means of the Takagi-Sugeno fuzzy model, the switched nonlinear plant is described by a family of switched fuzzy systems. Considering transmission failures may occur between controller and actuator, a reliable SOF controller against actuator faults is designed. Sufficient conditions are developed to guarantee the existence of the reliable SOF controller. Furthermore, an iterative algorithm is designed to determine the controller gains, which avoids the conservatism brought by the traditional singular value decomposition method. To validate the effectiveness of the proposed approach, a numerical example is exploited and simulation results are also presented.

Static output-feedback robust gain-scheduling control with guaranteed [formula omitted] performance

This article presents a new approach to design static output-feedback (SOF) controllers for constrained Takagi-Sugeno fuzzy systems with nonlinear consequents. The proposed SOF fuzzy control framework is established via the absolute stability theory with appropriate sector-bounded properties of the local state and input nonlinearities. Moreover, both state and input constraints are explicitly taken into account in the control design using set-invariance arguments. Especially, we include the local sector-bounded nonlinearities of the fuzzy systems in the construction of both the nonlinear controller and the nonquadratic Lyapunov function. Within the considered local control context, the new class of nonquadratic Lyapunov functions provides an effective solution to estimate the closed-loop domain of attraction, which can be nonconvex and even disconnected. The convexification procedure is performed using specific congruence transformations in accordance with the special structures of the proposed SOF controllers and nonquadratic Lyapunov functions. Consequently, the fuzzy SOF control design can be reformulated as an optimization problem under strict linear matrix inequality constraints with a linear search parameter. Compared to existing fuzzy SOF control schemes, the new structures of the control law and the Lyapunov function are more general and offer additional degrees of freedom for the control design. Both theoretical arguments and numerical illustrations are provided to demonstrate the effectiveness of the proposed approach in reducing the design conservatism.

Combined input–output finite-time stability condition with static output-feedback H ∞ control is proposed in this work to effectively attenuate the short-duration road disturbance. The control problem is formulated based on the pre-defined condition of input–output finite-time stability with H ∞ bound along with pre-established quarter-car active suspension model. Then, a feasible static output-feedback controller is designed via variable substitution approach and linear matrix inequalities. Output-feedback control’s initial infeasibility issue is solved by state-feedback technique. The controller is specifically designed for the system which exposed with short-duration exogenous disturbances hence, this work prefers finite-time approach instead Lyapunov asymptotic stability condition. To enumerate the significance of the proposed controller numerical examples are presented and its response is effectively analyzed in distinct domains (time and frequency). The theoretical results denote that the combined input–output finite-time stability condition with static output-feedback H ∞ control can enhance the vehicle performance better when compared with passive and conventional static output-feedback control scheme. Additionally, the controller robustness is verified.

Discrete sliding mode control for nonlinear systems using feedback linearization

NN-adaptive predictive control for a class of discrete-time nonlinear systems with input-delay