Hospital Environment Scenarios using WLAN over OPNET Simulation Tool

The Study of WLAN Cell Radius for Outdoor Coverage in Wireless Digital City Deployment

A very-low-profile, tri-band, planar inverted-F antenna (PIFA) with a height of 3.7 mm only for wireless local area network (WlAN) applications in the 2.4 GHz (2400~2484 MHz), 5.2 GHz (5150~5350 MHz), and 5.8 GHz (5725~5825 MHz) bands for tablet-laptop computer with a metal back cover is presented. The antenna was made of a flat plate of size 18.7 mm × 32.5 mm and bent into a compact structure with the dimensions 3.7 mm × 7 mm × 32.5 mm. The PIFA comprised a radiating top patch, a feeding/shorting portion, and an antenna ground plane. The top patch was placed horizontally above the ground with the feeding/shorting portion connecting perpendicularly therebetween. The antenna was designed in a way that the radiating patch consisted of three branches, in which each branch controlled the corresponding resonant mode in the 2.4/5.2/5.8 GHz bands.

A novel, tri-band, planar plate-type antenna made of a compact metal plate for wireless local area network (WLAN) applications in the 2.4 GHz (2400–2484 MHz), 5.2 GHz (5150–5350 MHz), and 5.8 GHz (5725–5825 MHz) bands is presented. The antenna was designed in a way that the operating principle included the dipole and the loop resonant modes to cover the 2.4/5.2 and 5.8 GHz bands respectively. The antenna comprised a larger radiating arm and a smaller loop radiating arm, which were connected to each other at the signal ground point. The antenna can easily be fed by using a 50 Q mini-coaxial cable and shows good radiation performance.

With the rapid development of wireless local area network (WLAN) and the proliferation of intelligent terminals, the current WLAN protocol is no longer able to meet the needs of users. Therefore, the next generation WLAN: IEEE 802.11ax has emerged to meet the growing demand for user traffic. Orthogonal Frequency Division Multiple Access (OFDMA), which enables simultaneous transmission of data by different User Equipment (UEs), is considered to be one of the key technologies of IEEE 802.11ax. In order to achieve high throughput rates and low access latency to ensure quality of service (QoS), IEEE 802.11ax supports two uplink access modes: scheduling access and random access. However, how to adaptively and efficiently switch these two access mechanisms in the process of real-time operation of the system, and effectively reduce the drawbacks caused by these two mechanisms is a thorny problem. This paper proposes an evaluation mechanism of network traffic load based on OFDMA-MAC protocol, and its performance is verified by simulation. The simulation results show that the traffic load assessment mechanism effectively improves the network throughput and quality of service (QoS), and also adapts to the dynamic changes in network traffic.

Wireless networks are being deployed widely to provide network connectivity without requiring the web of physical wires. A collection of a small number of workstations connected using a wireless network forms a wireless local area network (WLAN) that follows the IEEE 802.11 standard. In a WLAN, the communication takes place using packets whose sizes may vary and have a significant impact on the delay incurred during transmission. In this regard, fragmentation may play a vital role in reducing the delay for efficient transmission across the network. This paper analyzes the performance of WLANs with respect to the packet fragmentation. We simulate three network scenarios having 4, 8 and 12 wireless workstations respectively. The scenarios are simulated using OPNET IT Guru Academic Edition v 9.1 while incorporating a peer-to-peer (P2P) based communication model for each scenario. We compare the performance of non-fragmented and fragmented communication in terms of network delay and throughput. Our results show that the fragmentation minimizes the delay and increases the throughput, however its impact is highly dependent on the size of the underlying network.

With the rapid proliferation of broadband wireless services, it is of paramount importance to understand how fast data can be sent through a wireless local area network (WLAN). Thanks to a large body of research following the seminal work of Bianchi, WLAN throughput under saturated traffic condition has been well understood. By contrast, prior investigations on throughput performance under unsaturated traffic condition was largely based on phenomenological observations, which lead to a common misconception that WLAN can support a traffic load as high as saturation throughput, if not higher, under nonsaturation condition. In this paper, we show through rigorous analysis that this misconception may result in unacceptable quality of service: mean packet delay and delay jitter may approach infinity even when the traffic load is far below the saturation throughput. Hence, saturation throughput is not a sound measure of WLAN capacity under nonsaturation condition. To bridge the gap, we define safe-bounded-mean-delay (SBMD) throughput and safe-bounded-delay-jitter (SBDJ) throughput that reflect the actual network capacity users can enjoy when they require finite mean delay and delay jitter, respectively. Our earlier work proved that in a WLAN with multi-packet reception (MPR) capability, saturation throughput scales superlinearly with the MPR capability of the network. This paper extends the investigation to the nonsaturation case and shows that superlinear scaling also holds for SBMD and SBDJ throughputs. Our results here complete the demonstration of MPR as a powerful capacity-enhancement technique for WLAN under both saturation and nonsaturation conditions.

The 6 GHz band (5925-7125 MHz) has recently been proposed by the FCC to be shared with unlicensed devices This band is allocated to fixed, mobile (temporary fixed) and fixed satellite service links. The 13 GHz band (12700-13250 MHz) could also be subject to more flexible use, considering that it is allocated to the same type of incumbents. The purpose of this paper is to analyze coexistence between Wireless Local Area Networks (WLANs) and current terrestrial fixed links in these bands based on a case study approach, which can be replicated to other parts of the country. The coexistence analysis uses information from real links and accounts for the terrain morphology and actual land use to calculate the potential interference. We have conducted interference simulations from low-power indoor (LPI) WLANs to terrestrial fixed links and vice versa, from terrestrial fixed links to LPI WLANs, in the Denver metro area. The simulations have been performed in the upper part of the 6 GHz band, from 6875 to 7125 MHz, designated as the U-NII-8 band by the FCC, and in the 13 GHz band. To validate the simulations, we measured the incumbent signal power detected on the ground in a few locations in this area. We found that terrestrial fixed links operating in these bands can coexist with LPI WLANs without significant interference between each other, which will benefit consumers and encourage technology and innovation.

A signal-to-interference-noise ratio (SINR) constrained power control for code division multiple access (CDMA) and minimum mean square error (MMSE) multiuser detection is investigated. Two scenarios of a CDMA wireless local area network (WLAN) with MMSE multiuser detection are considered, i.e., the centralized power control for the uplink of a cellular WLAN, and the decentralized power control for an ad- hoc WLAN. It is proved that in both scenarios the interference between terminals is standard, so that the convergence of the proposed iterative power control (IPC) algorithm is guaranteed. Assuming asymptotically large number of communicating terminals and asymptotically large processing gain, it is shown that the power control becomes independent of particular spreading sequences, and thus, the random spreading sequences can be assumed. Furthermore, the transmitting powers can be readily adapted while the terminals join or leave the network. Numerical examples confirm that the simple IPC algorithm presented in this paper is very effective for cellular as well as ad-hoc CDMA WLAN's with MMSE multiuser detection for small to medium traffic loads and various SINR's requirements.

IEEE 802.11 wireless local area network (WLAN) physical layer (PHY) offers multiple data rates. In multi-rate WLANs, 802.11 distributed coordination function (DCF) presents the phenomenon so called ldquoperformance anomalyrdquo: when some hosts transmit at lower data rates, throughput of others at high rates will be restricted within the lowest rate, leading to the degradation of overall performance. Therefore, the link adaptation scheme for 802.11 WLAN should consider not only throughput of the observed host but also system throughput in order to optimize the overall performance. In this paper we propose a cross-layer link adaptation algorithm which improves system throughput by regarding the situation of PHY rate degradation more thoughtfully and critically, and meanwhile compensates the throughput of hosts with bad link qualities by applying differentiated channel access parameters. Simulation results demonstrate the effectiveness of the propose algorithm.

Call Admission Control (CAC) between heterogeneous networks, such as an integrated 3rd Generation Partnership Project (3GPP) Long Term Evolution (LTE) network and a Wireless Local Area Network (WLAN), plays an important role to utilize the system resources in a more efficient way. In this paper, we propose that the preference to the WLAN is determined based on the traffic load in the WLAN and the location of the cellular users. Our analysis relies on a previous study that divides the 3G cellular coverage area into zones based on the amount of resources that are required to support a connection to a mobile user. Using this model, we derive new call blocking and handoff failure probabilities as well as new call and handoff attempt failure probabilities. Through simulations, we investigate proper preference settings by changing the WLAN load in a 3 ring-based sector with a WLAN hotspot.

In this paper, a new miniaturized compact dual-band microstrip slot antenna is presented. To achieve the dual-band characteristics, two adjunct partial arc-shaped small slots are joined to two main circular slots embedded in the ground of the antenna structure. With a reduced size of 30 × 28.5 × 0.8 mm3, the proposed antenna presents a dual-band characteristic. The design is optimized using a High Frequency Structure Simulator (HFSS) followed by experimental verifications. An impedance bandwidth, for S11≤10 dB, that covers the 1.8 GHz and 2.4 GHz bands is accomplished, which makes the proposed antenna basically suitable for hand-held devices and medical applications. More applications such as digital communication system (DCS) 1.71–1.88 GHz, personal communication services (PCS) 1.85–1.99 GHz, Universal and mobile telecommunications system UMTS 1.92–2.17 GHz, Bluetooth 2.4–2.5 GHz, and Wi-Fi 2.4–2.454 GHz, Industrial Scientific and Medical radio frequency (RF) band ISM-2.4 GHz, Wireless Local Area Network (WLAN-2.4)are possible by simply changing one of the geometrical antenna dimensions. The antenna is characterized by stable radiation patterns as well.

The purpose of this paper is to demonstrate a reliable construction of wireless local area network (WLAN) and universal mobile telecommunications systems (UMTS) interoperating system. The proposed system shall provide high data rates alongside a significant coverage area. It is known that WLAN makes available high data rates within a very restricted coverage. On the other hand UMTS provides comparatively extended coverage with low data rates. Prior papers planned to integrate WLAN with UMTS to get the best of both systems. Accordingly several types of integration solutions have been evaluated upon success of integration between the 3G and the IEEE 802.11a systems. This approach is especially pragmatic in shadow of the fact that the evolved UMTS system fielding had been delayed due to economic factors. To accomplish an inclusive handover between both technologies this work made use of session initiation protocol (SIP) as signaling protocol and the mobile IP which is the standard communications protocol to allow mobile device users to move from one network to another as a handover protocol. This approach is shown to be useful given that no major alterations in the node Bs are required. Conceptual and practical comparisons showed that the use of mobile stream control transmission protocol (mSCTP) as transport layer protocol is considered the best approach for achieving interoperability between UMTS and WLAN. On the physical layer MPLS has been used to achieve load balancing and protection from congestions. We deployed different integration solutions for ensuring service continuity across different radio technologies that provide high-quality of service. Performance tests for different application traffic types and distributions have been conducted for both HTTP and multimedia streaming.

Unmanned aerial vehicles (UAVs)-based applications, such as surveillance systems and wireless relays, are attracting increasing attention from academia and industrial fields. The high-performance aerial communication system is one of the key enablers for them. However, due to the low attenuation of radio waves in the air-to-ground channels, the interference between aerial and terrestrial communication systems would significantly deteriorate their communication performance and greatly limit the potential UAV applications. To address the problem, in this paper, the spectrum sharing strategy between a multiple UAV communication system, in which both UAVs and ground station (GS) are equipped with directional antennas, and terrestrial systems is proposed. The GS position is selected and the flyable areas of the UAVs using certain spectrum resources are defined in advance using prior knowledge from spectrum monitoring on terrestrial communication systems to minimize interference and maximize the flyable areas of the UAVs instead of the low-efficient dynamic channel sensing and allocation for interference elimination. The simulations are conducted through a case study of the spectrum sharing between a multi-UAV video transmission system and the terrestrial wireless local area network (WLAN) system in the 5.7GHz band. The simulation results show that thanks to the proposed system the entire area can be enabled for UAV flight.

Wireless local area network (WLAN) communication is one of the fast and secure wireless technologies, which is vastly used in nowadays portable and handheld devices. This paper is oriented on designing of a planar WLAN antenna to serve in WLAN network devices. The designed antennas are single and dual-band planar monopole antennas to be working at IEEE 802.11 WLAN frequencies; 2.45 GHz and 5.2/5.8 GHz bands. Different configurations have been used in the design process, especially for the dual-band antenna, where dual-resonant is required. The antennas have been designed analytically then simulated using the CST software package. Simulation results for the input reflection coefficient, realized gain, and radiation pattern have been considered to evaluate their features. The antennas have also been fabricated practically and practical measurements for the input reflection coefficient and radiation pattern have been taken which shown a good agreement with those of simulation.

Currently, the IEEE 802.11n wireless local-area network (WLAN) has been broadly deployed world-wide for flexible and high-speed Internet access communications. Since it uses the limited number of partially overlapping channels (POCs) at 2.4 GHz band, the throughput performance is often degraded by interferences from signals of other WLANs. Thus, we have studied throughput drop estimation models for concurrently communicating multiple links under interferences, where the 40 MHz channel bonding (CB) and 20 MHz non-CB are considered separately. We have observed that the simultaneous use of CB and non-CB can improve the performance by enhancing the channel capacity while reducing the interference. In this paper, we study the throughput drop estimation model for concurrently communicating links under coexistence of CB and non-CB in IEEE 802.11n WLAN. The model accuracy is verified by comparing the estimated throughput with the measured one under various network topologies.