Improving Signal Coverage in Millimeter‐Wave Massive MIMO via Efficient Predefined‐Time Adaptive Neural Network–Based Beam Training

As a combination of spatial modulation (SM) system and massive multiple-input multiple-output (MIMO) system, massive SM aided MIMO (SM-MIMO) system is recently proposed. In broadband scenarios, single-carrier (SC) modulation is introduced to massive SM-MIMO system, thus massive SC-SM MIMO system is proposed for uplink multi-user transmission over frequency-selective fading channels. In this study, the uplink spectral efficiency (SE) of multi-cell massive SC-SM MIMO system is analysed, meanwhile the pilot contamination effect is taken into consideration. A tight SE lower bound of multi-cell massive SC-SM MIMO system is proposed with maximum ratio (MR) combining, which also takes into account the imperfect channel estimation, transmit antenna correlation and path loss. The tightness of the authors' proposed closed-form SE lower bound is shown via simulation results. The optimal pilot reuse factor can be determined with different system configurations by simulations, and the pilot reuse factor that is larger than one is more suitable for less TAs and user equipments.

Massive multiple-input multiple-output (MIMO) systems have attracted much attention lately due to the many advantages they provide over single- antenna systems. Owing to the many antennas, low- cost implementation and low power consumption per antenna are desired. To that end, massive MIMO structures with one-bit analog-to-digital converters (ADC) have been investigated in many studies. However, the effect of a strong interferer in the adjacent band on one-bit quantized massive MIMO systems have not been examined yet. In this study, we analyze the performance of uplink massive MIMO with one-bit ADCs under frequency selective fading with orthogonal frequency division multiplexing (OFDM) in the perfect and imperfect receiver channel state information cases. We derive analytical expressions for the bit error rate and ergodic rate. We show that the interfering band can be suppressed by increasing the number of antennas or the oversampling rate when a zero-forcing receiver is employed.

In this paper, we investigate the suitability of single carrier frequency domain processing (SC-FDP) as the downlink transmission scheme in a massive multiple-input multiple-output (MIMO) system. By deriving the sum-rate of the SC-FDP massive MIMO system theoretically, we show that this method obtains a sum-rate similar to that of orthogonal frequency division multiplexing (OFDM) massive MIMO. We also derive the theoretical sum-rate of both SC-FDP and OFDM in a non-synchronized massive MIMO scenario and show that the rate of the former is significantly larger than that of the latter. Moreover, we theoretically analyze the sum-rate of both systems in the presence of power amplifier non-linearity. All the sum-rates are derived for both zero forcing and matched filter precoding schemes. The results show that the effect of power amplifier non-linearity on the sum-rate of both systems is similar when the number of users is large. We also compare SC-FDP with OFDM from the peak to average power ratio (PAPR) and complexity viewpoints. Although the PAPR of SC-FDP signals is lower than that of OFDM signals, for MIMO systems, the difference between their PAPR decreases as we increase the number of users. Thus, both techniques can have similar PAPR in massive MIMO systems. The overall complexity of SC-FDP and OFDM is similar. Due to the mentioned facts, SC-FDP can be considered as a promising transmission scheme for the downlink of the massive MIMO systems in the presence of carrier frequency offset and power amplifier non-linearities.

This chapter, the techniques of massive multiple-input-multiple-output (MIMO) and network MIMO are studied. First, massive MIMO is compared with the conventional point-to-point MIMO used in current cellular systems in terms of capacity and energy efficiency. The comparison shows that massive MIMO has huge gains even under the modest conditions using simple linear processing. Then, the implementation of massive MIMO is discussed by focusing on the channel estimation method, the signal detection method and the precoding method. Following this, several main issues in massive MIMO are examined and relevant measures are discussed. Finally, network MIMO is studied by introducing cooperation between base stations to completely remove the inter-cell interference, at the cost of even higher complexity that places limits on the backhaul and fronthaul links.

Recently, massive multiple input multiple output (MIMO) is considered as a promising technology to significantly improve the spectral and energy efficiency of fifth generation (5G) networks. Massive MIMO increases the energy efficiency (EE) by three orders of magnitude as compared to single antenna systems. In this paper, we review and analyze energy efficient resource allocation techniques for massive MIMO system. To this end, the energy efficiency of massive massive MIMO with linear processing is formulated. Analytical formulation is provided for the spectral efficiency (SE) and total system power consumption model. The tradeoff on the spectral and energy efficiency is analyzed. The impacts of propagation and system parameters on the SE-EE tradeoff are investigated. Then, large scale fading based analytical approximation for the energy efficiency is formulated. Finally, numerical simulation is done to validate the theoretical analysis.

In wireless communications, massive multiple-input multiple-output (MIMO) systems in which the base station (BS) is equipped with a large number of antennas can provide significant spectral and energy efficiency by means of simple signal processing. Therefore, massive MIMO is an attractive technology for next generation wireless communication systems and for green communications. There are two operation modes: time-division duplex (TDD) and frequency-division duplex (FDD) for massive MIMO systems, and the debate on the two modes is still discussed in the literature. The originator of massive MIMO systems, Marzetta, has presented the basic frame structures for both the TDD and the FDD modes. However, the basic frame structures do not carefully take the hardware impairments such as phase noise (PN) into account. In this paper, by taking the PN as the key hardware impairment into account, we recommend new and efficient frame structures for both the TDD and the FDD modes. The corresponding performance comparison between the two modes is also provided by using the data transmission efficiency (DTE) as the performance measurement. The comparison may help determine which mode should be used for massive MIMO systems.

Massive multiple-input multiple-output (MIMO) systems are a main enabler of the excessive throughput requirements in 5G and future generation wireless networks as they can serve many users simultaneously with high spectral and energy efficiency. To achieve this massive MIMO systems require accurate and timely channel state information (CSI), which is acquired by a training process that involves pilot transmission, CSI estimation, and feedback. This training process incurs a training overhead, which scales with the number of antennas, users, and subcarriers. Reducing the training overhead in massive MIMO systems has been a major topic of research since the emergence of the concept. Recently, deep learning (DL)-based approaches have been proposed and shown to provide significant reduction in the CSI acquisition and feedback overhead in massive MIMO systems compared to traditional techniques. In this paper, we present an overview of the state-of-the-art DL architectures and algorithms used for CSI acquisition and feedback, and provide further research directions.

Massive multiple-input multiple-output (MIMO) systems have been drawing considerable interest. In the uplink, massive MIMO systems are commonly studied assuming that each base station (BS) decodes the signals of its user terminals separately and linearly while treating all interference as noise. Although this approach provides improved spectral efficiency (SE) in favorable channel conditions, it is generally sub-optimal from an information-theoretic perspective. In this work we characterize the SE of massive MIMO when the BSs are allowed to jointly decode the received signals. We consider two schemes for handling the interference, and derive their SEs for both finite and asymptotic number of antennas. Simulation tests of the proposed methods illustrate their gains in SE compared to standard separate linear decoding, and show that the standard approach fails to capture the actual achievable rates of massive MIMO systems, particularly when the interference is dominant.

Massive multiple input multiple output (MIMO), also known as a very large-scale MIMO, is an emerging technology in wireless communications that increases capacity compared to MIMO systems. The massive MIMO communication technique is currently forming a major part of ongoing research. The main issue for massive MIMO improvements depends on the number of transmitting antennas to increase the data rate and minimize bit error rate (BER). To enhance the data rate and BER, new coding and modulation techniques are required. In this paper, a generalized spatial modulation (GSM) with antenna grouping space time coding technique (STC) is proposed. The proposed GSM-STC technique is based on space time coding of two successive GSM-modulated data symbols on two subgroups of antennas to improve data rate and to minimize BER. Moreover, the proposed GSM-STC system can offer spatial diversity gains and can also increase the reliability of the wireless channel by providing replicas of the received signal. The simulation results show that GSM-STC achieves better performance compared to conventional GSM techniques in terms of data rate and BER, leading to good potential for massive MIMO by using subgroups of antennas.

The performance of the hybrid beamforming system based on the full-connected structure is close to that of the full-digital one in millimeter-wave (mmWave) massive multiple-input multiple-output (MIMO) systems. However, due to the high complexity of circuit wiring in practical applications, it has been greatly restricted. This paper investigates the hybrid (analog/digital) beamforming design of a multiuser mmWave massive MIMO system with sub-connected structure. For this system, we focus on a sum-rate maximization probelm. Considering the joint design of the receiver, and transmitter, a two-stage design method is adopted. In the analog stage, the analog beamformer, and combiner are designed by the proposed piecewise dual joint iterative approximation (PDJIA) method, which not only can obtain closed-form solutions but also has linear property. Based on the criterion of avoiding the loss of information, the problem of digital beamforming is solved by exploiting the baseband piecewise successive approximation (BPSA) method, which can effectively increase the number of users served. Simulation results show that the proposed scheme outperforms the state-of-the art MIMO hybrid beamforming design schemes, and more accurately approximates to that of the full-digital system.

The optimum transmission strategy for maximizing energy efficiency (EE) of a multi-user massive multiple-input multiple-output (MIMO) system in radio frequency energy harvesting networks is investigated. We focus on dynamic time-switching (TS) antennas, to avoid the practical problems of power-splitting antennas, such as complex architectures, power loss and signal distortion when splitting the power of the received signal into power for information decoding (ID) and energy harvesting (EH). However, since a single TS antenna cannot serve ID and EH simultaneously, the MIMO system is considered in this paper. We thus formulate an EE optimization problem and propose an iterative algorithm as a tractable solution, including an antenna selection strategy to optimally switch each TS antenna between ID mode and EH mode using nonlinear fractional programming and the Lagrange dual method. Further, the problem is solved under practical constraints of maximum transmission power and outage probabilities for a minimum amount of harvested power and rate capacity for each user. Simulation results show that the proposed algorithm is more energy-efficient than that of baseline schemes, and demonstrates the trade-off between the required amount of harvested power and energy efficiency.

In this paper, a hybrid multi-user massive MIMO system operating on the mmWave frequency is considered. To reduce the heavy beam training overhead for such a massive MIMO system, we propose a 3D beam training algorithm, which estimates the azimuth and elevation of the angle of arrival (AoA) and departure (AoD) between the base station (BS) and the mobile stations (MSs). The proposed algorithm first executes a hierarchical search to acquire the range of azimuth and elevation, then applies an exhaustive search within this range for a more precise matching. Through this two-stage approach, the beam training overhead can be substantially reduced.

With a large number of antennas at the transmitter and receiver, massive multiple-input multiple-output (MIMO) systems can achieve substantially high spectral efficiency as well as high stability and reliability. Nevertheless, one of the major challenges for its practical use is its computational complexity for symbol detection that grows exponentially with the number of antennas. In this work, we focus on a low complexity implementation of massive MIMO detector based on matched filter (MF) detection with parallel interference cancellation (PIC). In general, MF-based detector performs poorly in the high SNR region. Nevertheless, with the help of powerful channel coding such as low-density parity-check (LDPC) codes and the well-designed PIC, the resulting error performance of the proposed MF-PIC can approach or even outperform the conventional minimum mean square error (MMSE)-based detector with much less complexity. Furthermore, due to its parallel structure, low latency implementation based on parallel architecture is possible and thus is suitable for practical massive MIMO systems.

In this paper, we develop the channel estimation algorithm for a massive multiple input multiple output (MIMO) system using one-bit analog-to-digital converters (ADCs). Although, one-bit quantization significantly reduces the deployment cost and power consumption of the massive MIMO, the great distortion induced by one-bit quantization makes channel estimation more difficult. Therefore, a channel estimation method by executing a deep neural network (DNN) over multiple signal segments is proposed for the uplink of one-bit massive MIMO. The average of the DNN’s outputs throughout all the segments is the final channel estimate for a transmission block. In order to improve the estimation accuracy without increasing the length of pilot, the data symbols got based on the initial channel estimates are used as the other part of pilots to refine the estimation result. Moreover, a sliding window based pilot segment method is adopted to increase the number of signal segments with a same pilot length. The simulation results show that the proposed scheme outperforms least squares (LS) and Bussgang linear minimum mean squared error (BLMMSE) channel estimators in the whole signal-to-noise-ratio (SNR) region.

Massive multiple-input multiple-output (MIMO) is a key technology for emerging next-generation wireless systems. Utilizing large antenna arrays at base-stations, massive MIMO enables substantial spatial multiplexing gains by simultaneously serving a large number of users. However, the complexity in massive MIMO signal processing (e.g., data detection) increases rapidly with the number of users, making conventional hand-engineered algorithms less computationally efficient. Lowcomplexity massive MIMO detection algorithms, especially those inspired or aided by deep learning, have emerged as a promising solution. While there exist many MIMO detection algorithms, the aim of this magazine paper is to provide insight into how to leverage deep neural networks (DNN) for massive MIMO detection. We review recent developments in DNN-based MIMO detection that incorporate the domain knowledge of established MIMO detection algorithms with the learning capability of DNNs. We then present a comparison of the key numerical performance metrics of these works. We conclude by describing future research areas and applications of DNNs in massive MIMO receivers.