• Home
  • Search
  • Insights on the Buffer Effect in Blended Positive Electrodes for Lithium Ion Batteries
  • https://doi.org/10.1149/ma2023-022223mtgabsCopy DOI Icon

Insights on the Buffer Effect in Blended Positive Electrodes for Lithium Ion Batteries

Show More
  • Abstract
  • Literature Map
  • Similar Papers
Abstract

An approach to improve the performance of positive electrodes for Li-ion batteries that is commonly used by companies is fabricating them using mixtures of different materials (usually 2) with complementary features1. This coexistence, when properly formulated, provides an extra design degree of freedom and gives rise to synergetic effects, allowing blends to perform better than what the rule of mixture predicts. Unfortunately, the internal dynamics of the electrodes are still poorly understood at fundamental level and the optimization of formulations for such blends still mainly depends on empirical studies. One of the important characteristics identified in blends is termed the buffer effect. This occurs when the material exhibiting fastest kinetics can receive an excess of the incoming lithium under high power discharge and subsequently, when the current stops, transfer this excess to the higher capacity material.In this study, the role and extent of this effect is explored for a set of representative materials and the resulting blends resulting from their mixtures. For the measurements we are using a special experimental model-like blended electrode setup reported by Heubner et al.2 slightly adapted to our needs. In this setup, two positive electrodes with different active material, but same active mass, are facing each other, separated by 2 separators with a disk of perforated lithium in the middle. During measurement, current is applied between an electrode and lithium while a potentiostat actively keeps the two positive electrodes at the same potential. Such setup gives us access to the current exchanged between the positive electrodes while keeping them in equal potential at all times, as would happen in a blended electrode with 50% of each material.For the study, 4 cathode active materials were used, LiNi0.5Mn0.3Co0.2O2 (NMC), LiMn2O4 (LMO), LiFePO4 (LFP) and LiFe0.4Mn0.6PO4 (LFMP), and every binary combination of them was measured. The cells after 3 C/10 formation cycles were subjected to a pulsed electrochemical test (1 minute 3C pulses followed by 10 minutes of relaxation). Top figure shows the voltage response of the cell vs. time while the bottom one shows the charge that was transferred between the materials during their relaxations (buffering charge) and while the cell current is equal to zero , for the NMC-LMO blend. We applied the same protocol for all the combinations under study and found out large variations of this buffering ability depending on the blends constituents and their individual electrochemical properties. It is clearly evident that both the magnitude and the direction (sign) of the buffering current varies in the voltage range meaning each material can act as donor or acceptor of the buffering lithium. We believe that this provides a new insight in the internal processes in blended electrodes and brings us one step closer to their rational design. References : Casas‐Cabanas et al. Isr J Chem 61, 26–37 (2021).Heubner et al. J Power Sources 363, 311–316 (2017). Figure 1

Similar Papers
  • Research Article
  • Citations155

Rock-Salt Growth-Induced (003) Cracking in a Layered Positive Electrode for Li-Ion Batteries

  • Oct 24, 2017
  • ACS Energy Letters
  • Hanlei Zhang +6
  • Research Article
  • Citations12

Utilization of V 6O 13 as the positive electrode in lithium batteries

  • Jul 01, 1989
  • Materials Science & Engineering B
  • M Menetrier +2
  • Research Article
  • Citations16

Strategies for formulation optimization of composite positive electrodes for lithium ion batteries based on layered oxide, spinel, and olivine-type active materials

  • Oct 02, 2022
  • Journal of Power Sources
  • Anna Weichert +5
  • Research Article

(Invited) Highly Concentrated LiBF4-Based Electrolyte Solutions for LiNi0.5Mn1.5O4 Positive Electrodes in Lithium Ion Batteries

  • Sep 01, 2016
  • Electrochemical Society Meeting Abstracts
  • Takayuki Doi +7
  • PDF
  • Research Article
  • Citations82

Solid-electrolyte interphase nucleation and growth on carbonaceous negative electrodes for Li-ion batteries visualized with in situ atomic force microscopy

  • May 22, 2020
  • Scientific Reports
  • Sergey Yu Luchkin +5
  • Research Article

Experimental Analysis of the Current Distribution between Graphite and SiOx in Blend Electrodes for Lithium-Ion Cells

  • Dec 22, 2023
  • Electrochemical Society Meeting Abstracts
  • Julian Knorr +3
  • Research Article
  • Citations6

Study on Prediction of Binder Distribution in the Drying Process of the Coated Web of Positive Electrode for Lithium ion Battery

  • Mar 01, 2020
  • IOP Conference Series: Materials Science and Engineering
  • Yongjian Su +4
  • Research Article
  • Citations13

The Role of Diphenyl Carbonate Additive on the Interfacial Reactivity of Positive Electrodes in Li-ion Batteries

  • Jan 03, 2020
  • Journal of The Electrochemical Society
  • Pinar Karayaylali +8
  • Research Article
  • Citations58

The influence of cycling temperature and cycling rate on the phase specific degradation of a positive electrode in lithium ion batteries: A post mortem analysis

  • Aug 08, 2016
  • Journal of Power Sources
  • Mariyam Susana Dewi Darma +7
  • Research Article
  • Citations2

Two Electrolyte Decomposition Pathways at NMC Electrodes in Lithium-Ion Batteries

  • Jul 07, 2022
  • ECS Meeting Abstracts
  • Bernardine L D Rinkel +3
  • Research Article

Studies on LiMn1.5Ni0.4Cr0.1O4 Cathode Spinel Combined with Graphene for Lithium Ion Batteries

  • Apr 29, 2015
  • Electrochemical Society Meeting Abstracts
  • Rajesh K Katiyar +6
  • Research Article
  • Citations29

Electrochemical properties and microstructures of LiMn2O4 cathodes coated with aluminum zirconium coupling agents

  • Feb 10, 2020
  • Ceramics International
  • Sunfa Wang +6
  • Research Article

Influence of Acetylation and Polymerization Degree of Chitosan As Green Binder Material for LiMn2O4 Positive Electrodes in Lithium Ion Batteries

  • Jul 07, 2022
  • Electrochemical Society Meeting Abstracts
  • Sven Kuenne +1
  • Research Article

Prussian Blue As Negative and Positive Electrode in Lithium and Sodium-Ion Batteries

  • Apr 29, 2015
  • Electrochemical Society Meeting Abstracts
  • María José Piernas-Muñoz +3
  • Research Article
  • Citations1

Study of (dis)-Sodiation Mechanisms within Individual Na3V2(PO4)2F3 Cathode Crystals By 4D-STEM Phase and Orientation Mapping Using ASTAR System

  • May 01, 2020
  • Electrochemical Society Meeting Abstracts
  • Kirill Cherednichenko +8
Cactus Communications logo

Copyright 2026 Cactus Communications. All rights reserved.