Intensification of protein extraction from soybean processing materials using hydrodynamic cavitation

Determination of powder flow properties of skim milk powder produced from high-pressure homogenization treated milk concentrates during storage

Application of multi pass high pressure homogenization to improve stability, physical and bioactive properties of rosehip (Rosa canina L.) nectar

The impact of animal-based food production on climate change drives the development of plant-based alternatives. We demonstrate the use of colloidal thermogelation on a real nanoemulsion system to create structured gels that could be of interest for thermo-mechanical processing of next-generation plant-based food applications. We use a commercial pea protein isolate (PPI) without further purification to stabilize a 20 vol% peanut oil-in-water nanoemulsion at pH = 7 by high-pressure homogenization (HPH) and demonstrate the temperature induced gelation behavior of the nanoemulsion as a function of the HPH processing parameters. Bright-field and laser scanning confocal fluorescence microscopy reveals a diverse microstructure of the aqueous PPI dispersions, with a large amount of insoluble protein particles, cell-wall debris particles, and lipid inclusions. Sedimentation of particulates is prevented by HPH treatment and leads to a loss of the dispersion's thermogelation properties. The non-gelling PPI dispersion stabilizes nanoemulsions and the insoluble components of the PPI dispersions persist throughout the HPH processing. We perform a systematic rheological investigation of the effect of HPH processing on thermogelation and demonstrate that the number of HPH passes n and HPH pressure P control the average nanoemulsion droplet size measured by DLS at a 90° scattering angle. We show that the droplet size defines the final gel strength with a strong inverse dependence of the elastic modulus on droplet size. Furthermore, processing can lead to heterogeneously structured gels that yield over a large strain amplitude range.

Effect of high pressure homogenization (HPH) on microstructure and rheological properties of hazelnut milk

Hydrodynamic cavitation results in flow restriction in a flow system causing rapid pressure fluctuations and significant fluid forces. These can be harnessed to mediate microbial cell damage. Hydrodynamic cavitation was studied for the partial disruption of E. coli and selective release of specific proteins relative to the total soluble protein. The effects of the cavitation number, the number of passes, and the specific growth rate of E. coli on the release of periplasmic and cytoplasmic proteins were studied. At the optimum cavitation number of 0.17 for this experimental configuration, 48% of the total soluble protein, 88% of acid phosphatase, and 67% of beta-galactosidase were released by hydrodynamic cavitation in comparison with the maximum release attained using multiple passes through the French Press. The higher release of the acid phosphatase over the total soluble protein suggested preferred release of periplasmic compounds. This was supported by SDS-PAGE analysis. The absence of micronization of cell material resulting in the potential for ease of solid-liquid separation downstream of the cell disruption operation was confirmed by TEM microscopy. E. coli cells cultivated at a higher specific growth rate (0.36 h(-1)) were more easily disrupted than slower grown cells (0.11 h(-1)). The specific activity of the enzyme of interest released by hydrodynamic cavitation, defined as the units of enzyme in solution per milligram of total soluble protein, was greater than that obtained on release by the French Press, high-pressure homogenization, osmotic shock, and EDTA treatment. The selectivity offered indicates the potential of enzyme release by hydrodynamic cavitation to ease the purification in the subsequent downstream processing.

The effects of superfine grinding on the properties of chrysanthemum powder (CP) and high pressure homogenization (HPH) on the rheological properties of CP suspensions were investigated. Superfine grinding reduced particle size to a D50 of 28.45 μm. Instantaneous flow function and wall friction tests demonstrated that superfine ground CP had poor flowability and was more cohesive than more coarsely ground samples. Superfine grinding increased thermal stability and reduced the crystallinity of CP. After HPH treatment, the apparent viscosity and consistency coefficient (k, from 0.027 ± 0.005 to 1.847 ± 0.472) of CP suspension was significantly improved (p <.05), indicating that HPH treatment increased the consistency and reduced the fluidity of CP suspensions. As the HPH pressure increased from 40 to 120 MPa, the storage modulus (G') and loss modulus (G") of the CP suspensions increased, which fitted well with the Power Law model (R2 >.961). The CP suspension is a non‐Newtonian fluid with shear thinning behavior. Flow and rheological characteristics are measured under different consolidation pressures and HPH pressures, respectively. These findings reveal the potential application of superfine grinding and high pressure homogenization in the development of CP.Practical applicationThe use of superfine grinding and high pressure homogenization to process CP has broad application prospects, such as the preparation of micronized Chinese medicinal powders in the pharmaceutical industry and functional foods and beverages in the food industry.

High-pressure homogenization influences the functional properties of protein from oyster (Crassostrea gigas)

Ultrasound treatment and high-pressure homogenization were used to prepare soybean protein (SP)-phosphatidylcholine (PC) nanoemulsions in this study. Nanoemulsions prepared by high-pressure homogenization were more stable. The structural changes of SP and PC under ultrasound treatment and high-pressure homogenization treatment were investigated by Raman spectroscopy. It could be concluded that ultrasound and high-pressure homogenization treatments increased both the content of α-helix and unordered structure but decreased that of β-structures of SP, while the interaction between SP and PC decreased α-helix content and also reduced unordered structure and β-sheet structure. Ultrasound treatment and high-pressure homogenization exposed more tryptophan and tyrosine residues to promote hydrophobic interaction between SP and PC, which was beneficial for stabilizing the nanoemulsion. The SP-PC interaction exerted a more significant effect on side chain structure than those observed under ultrasound treatment and high-pressure homogenization. The dominant g-g-t vibrational mode of the disulfide bond of soybean protein was not appreciably changed by the two preparations. High-pressure homogenization increased the disorder of lipid chains of PC, promoting SP-PC interaction and thereby increasing the stability of the nanoemulsion. The structural change provided a theoretical basis for preparation of two nanoemulsions.

Although widely adopted by the chemical and pharmaceutical industries in recent years, little published data is available regarding possible applications of high pressure homogenisation for dairy products. The objective of this work was to compare the effects of conventional (18 MPa, two-stage) and single or two-stage high pressure homogenisation (HPH) at 50-200 MPa on some properties of raw whole bovine milk (approximately 4% fat). Fat globule size decreased as HPH pressure increased and, under certain conditions of temperature and pressure, HPH yielded significantly smaller fat globules than conventional homogenisation. Fat globule size was also affected by milk inlet temperature. The pH of all homogenised milk samples decreased during 24 h refrigerated storage. Total bacterial counts of milk were decreased significantly (P < 0.05) for milk samples HPH-treated at 150 or 200 MPa. Whiteness and rennet coagulation properties of milk were unaffected or enhanced, respectively, as homogenisation pressure was increased. Average casein micelle size decreased slightly when skim milk was homogenised at 200 MPa. Thus, HPH treatment has several, potentially significant, effects on milk properties.

Effect of high pressure homogenization on the structure and the interfacial and emulsifying properties of β-lactoglobulin

SummaryTraditional solvent‐based approaches for the separation of protein from plant sources are widely used, although they can lead to low protein yield and protein degradation. In this study, protein isolation was conducted by alkaline extraction (AE) and isoelectric precipitation, and the effect of high‐pressure homogenisation (HPH) (0 MPa [control], 50, 100, and 150 MPa) at two different stages during extraction was assessed, namely high pressure homogenisation followed by alkaline extraction (HPH + AE) or alkaline extraction followed by high pressure homogenisation (AE + HPH). Although the control procedure resulted in a protein yield of 45.99 ± 0.72%, the highest protein yield was determined by AE + 100 MPa HPH (61.92 ± 1.06%). Solubility, foaming capacity, emulsification index, hue angle, and denaturation enthalpy of the isolated protein increased after HPH treatments compared to control. Generally, the high‐pressure treatment during protein isolation increased pumpkin seed press cake's protein yield and enhanced the isolates' techno‐functional properties.

The objective of this study was to evaluate the effect of cryoconcentration assisted by centrifugation-filtration on the bioactive compounds and the microbiological quality of aqueous maqui (Aristotelia chilensis (Mol.) Stuntz) and calafate (Berberis microphylla G. Forst) extracts pretreated with high-pressure homogenization (HPH). Aqueous extracts were prepared from fresh fruits which were treated with HPH (predefined pressure and number of passes). The best pretreatment was determined by aerobic mesophilic, fungal, and yeast counts. Treated extracts were frozen at −30 °C in special tubes and centrifuged at 4000 rpm for 10 min to obtain the cryoconcentrated product. The optimal pretreatment conditions for HPH were 200 MPa and one pass in which the extracts exhibited no microorganism counts. Cryoconcentration by freezing and subsequent centrifugation-filtration in a single cycle showed high process efficiency (&gt;95%) in both soluble solids and bioactive compounds (total polyphenols and anthocyanins) and antioxidant capacity of the fresh fruits and extracts. The HPH treatment and subsequent cryoconcentration assisted by centrifugation-filtration is an efficient technology to obtain concentrates with good microbiological quality and a high content of bioactive compounds.

Beneficial effects of high-pressure homogenization on the dispersion stability of aqueous hydrolysate from Mytilus edulis

This study primarily aimed to enhance the extraction of cutin from industrial tomato peel residues. Initially, the conventional extraction process was optimized using response surface methodology (RSM). Subsequently, high-pressure homogenization (HPH) was introduced to improve extraction efficiency and sustainability. The optimization process focused on determining the optimal conditions for conventional extraction via chemical hydrolysis, including temperature (100-130 °C), time (15-120 min), and NaOH concentration (1-3%). The optimized conditions, determined as 130 °C, 120 min, and 3% NaOH solution, yielded a maximum cutin extraction of 32.5%. Furthermore, the results indicated that applying HPH pre-treatment to tomato peels before alkaline hydrolysis significantly increased the cutin extraction yield, reaching 46.1%. This represents an approximately 42% increase compared to the conventional process. Importantly, HPH pre-treatment enabled cutin extraction under milder conditions using a 2% NaOH solution, reducing NaOH usage by 33%, while still achieving a substantial cutin yield of 45.6%. FT-IR analysis confirmed that cutin obtained via both conventional and HPH-assisted extraction exhibited similar chemical structures, indicating that the main chemical groups and structure of cutin remained unaltered by HPH treatment. Furthermore, cutin extracts from both conventional and HPH-assisted extraction demonstrated thermal stability up to approximately 200 °C, with less than 5% weight loss according to TGA analysis. These findings underscore the potential of HPH technology to significantly enhance cutin extraction yield from tomato peel residues while utilizing milder chemical hydrolysis conditions, thereby promoting a more sustainable and efficient cutin extraction process.

Combined effects of high pressure homogenization treatment and citral on microbiological quality of apricot juice