Joint pairing and power allocation optimization in multichannel MABC-based two-way relaying

In this paper, we propose a cooperative spectrum sharing protocol based on OFDM two-way relaying with joint optimal subcarrier and power allocation. Specifically, the secondary system helps the primary system achieve their target rates through OFDM two-way relaying, where the secondary system forwards the primary signal by using a fraction of subcarriers and power. In return, the secondary system can gain spectrum access by using the remaining subcarriers and power to transmit its own signal. Joint optimal subcarrier and power allocation is derived aiming to maximize secondary transmission rate with primary transmission rate constraint. Simulation results demonstrate a significant enhancement in spectrum efficiency compared with several benchmark schemes.

In this paper, we consider an amplify-and-forward wireless relay system where multiple source nodes communicate with their corresponding destination nodes with the help of relay nodes. Conventionally, each relay equally distributes the available resources to its relayed sources. This approach is clearly sub-optimal since each user experiences dissimilar channel conditions, and thus, demands different amount of allocated resources to meet its quality-of-service (QoS) request. Therefore, this paper presents novel power allocation schemes to i) maximize the minimum signal-to-noise ratio among all users; ii) minimize the maximum transmit power over all sources; iii) maximize the network throughput. Moreover, due to limited power, it may be impossible to satisfy the QoS requirement for every user. Consequently, an admission control algorithm should first be carried out to maximize the number of users possibly served. Then, optimal power allocation is performed. Although the joint optimal admission control and power allocation problem is combinatorially hard, we develop an effective heuristic algorithm with significantly reduced complexity. Even though theoretically sub-optimal, it performs remarkably well. The proposed power allocation problems are formulated using geometric programming (GP), a well-studied class of nonlinear and nonconvex optimization. Since a GP problem is readily transformed into an equivalent convex optimization problem, optimal solution can be obtained efficiently. Numerical results demonstrate the effectiveness of our proposed approach.

A stochastic model for joint optimal congestion control and power allocation in multi-channel multi-radio wireless mesh networks is proposed. The design problem characterizes the stochastic traffic of the network data flows and the capacity of radio channels in multi-channel multi-radio wireless mesh networks as some random variables. The corresponding design problem is formulated as the stochastic network utility maximization problem subject to some stochastic constrains, which is a chance constrained programming. The genetic algorithm is used to solve this stochastic maximization problem. The simulation is conducted in the Hyacinth network, and the result shows the quantitative relationship between the network performance and the confidence level.

SummaryWe investigate the problem of joint downlink wireless backhaul bandwidth (WBB) and power allocation in heterogeneous cellular networks (HCNs). A WBB partitioning scheme is considered, which allocates the whole bandwidth between the macrocell and small cells for data transmission and backhauling. We formulate an optimization problem to maximize the weighted sum logarithmic utility function by jointly optimizing WBB portion and fronthaul power allocation of each base station with consideration of the backhaul capacity limitation on each small cell. In order to solve this joint optimization problem, we propose a hierarchical two‐level approach and decompose the original problem into two independent subproblems: the WBB allocation at the macrocell base station (MBS) and the power allocation at both the MBS and small cell base stations (SBSs). Accordingly, the optimal WBB portion and power allocation solutions are obtained, respectively. Furthermore, we develop a distributed algorithm to implement the joint WBB and power allocation. Numerical results verify the effectiveness of the proposed approach and analyze the impact of the weighted coefficient and backhaul capacity limitation on the network performance. In addition, significant performance gains can be achieved by the proposed approach over the benchmark.

A novel cross-layer joint relay selection and power allocation (CL-JRSPA) scheme over physical layer and data-link layer is proposed for cooperative relaying system in this paper. Our goal is finding the optimal relay selection and power allocation scheme to maximize system achievable rate when satisfying total transmit power constraint in physical layer and statistical delay quality-of-service (QoS) demand in data-link layer. Using the concept of effective capacity (EC), our goal can be formulated into an optimal joint relay selection and power allocation (JRSPA) problem to maximize the EC when satisfying total transmit power limitation. We first solving optimal power allocation (PA) problem with Lagrange multiplier approach, and then solving optimal relay selection (RS) problem. Simulation results demonstrate that CL-JRSPA scheme gets larger EC than other schemes when satisfying delay QoS demand. In addition, the proposed CL-JRSPA scheme achieves the maximal EC when relay located approximately halfway between source and destination, and EC becomes smaller when the QoS exponent becomes larger.

This paper studies the case of an overlay cognitive radio network where the primary user leases spectral resources to the secondary user in exchange for cooperation, considering that both type of users have specific quality of service requirements. We investigate the problem of joint power and time allocation for the secondary access during the cooperative phase, with a view to optimizing the effective capacity of the primary user given an average energy constraint for the secondary user. Afterwards, the optimal power allocation of the secondary user for its own transmission phase is investigated in order to maximize the effective capacity of the secondary link. The proposed joint power and time allocation mechanism is compared with an optimal time/constant power allocation scheme and a less sophisticated baseline allocation scheme, i.e. power allocation under constant time and its superiority is proven for various network parameters. The reference model of one primary---one secondary user is extended to a general multi user cognitive radio network through the proposed pairing mechanism based on matching theory. Particularly, considering the remarks of the reference scenario, we propose two different matching schemes (with/without consideration of primary users' quality of service requirements) and we confirm their superiority compared to other matching mechanisms.

Given a multihop wireless network and a source-destination pair of nodes, this paper addresses the problem of jointly selecting a communication route and allocating transmit power levels, so that the end-to-end spectral efficiency of the route exceeds a desired threshold and the maximum power used by any link is minimized. Spectral-efficient routing has been subject to interest in the recent literature. The transmit power level, however, has been assumed to be known, and route selection was considered in isolation. This paper presents the first polynomial-time algorithm for joint spectral-efficient routing and power allocation that provides solutions arbitrarily close to the optimal one. Our computational results further illustrate the efficiency of the proposed approach.

This paper investigates the optimal resource allocation of a downlink non-orthogonal multiple access (NOMA) system consisting of one base station and multiple users. Unlike existing short-term NOMA designs that focused on the resource allocation for only the current transmission timeslot, we aim to maximize a long-term network utility by jointly optimizing the data rate control at the network layer and the power allocation among multiple users at the physical layer, subject to practical constraints on both the short-term and long-term power consumptions. To solve this problem, we leverage the recently-developed Lyapunov optimization framework to convert the original long-term optimization problem into a series of online rate control and power allocation problems in each timeslot. The power allocation problem, however, is shown to be non-convex in nature and thus cannot be solved with a standard method. However, we explore two structures of the optimal solution and develop a dynamic programming based power allocation algorithm, which can derive a globally optimal solution, with a polynomial computational complexity. Extensive simulation results are provided to evaluate the performance of the proposed joint rate control and power allocation framework for NOMA systems, which demonstrate that the proposed NOMA design can significantly outperform multiple benchmark schemes, including orthogonal multiple access (OMA) schemes with optimal power allocation and NOMA schemes with non-optimal power allocation, in terms of average throughput and data delay.

We consider power allocation and relay positioning with the objective to minimize system error probability in a dual-hop regenerative relaying system operating under co-channel interference. First, assuming fixed relay location, adaptive power allocation at the source and the relay nodes under joint power constraint is presented. Then considering fixed power allocation scheme, the optimal relay position is obtained. Results show that optimum power allocation, optimum relay location and joint optimization of the power allocation and relay positioning significantly improve the system performance in terms of error probability compared to uniform power allocation and mid-point distance location for the relay node.

The explosive demands for mobile broadband service bring a major challenge to 5G wireless networks. Device-to-device communication, adopting side links for user-direct communication, is regarded as a main technical source for offloading large volume of mobile traffic from cellular base station. This article investigates the joint power and subcarrier allocation scheme for device-to-device communication in 5G time division duplex systems. In time division duplex system, instead of utilizing an exclusive portion of the precious cellular spectrum, device-to-device pairs reuse the subcarriers occupied by cellular users, thus producing harmful interference to cellular users in both uplink and downlink communication, and strongly limiting the spectrum efficiency of the system. To this end, we focus on the maximization of device-to-device throughput while guaranteeing both uplink and downlink channel quality of service of cellular users as well as device-to-device pairs. The problem is formulated as a mixed integer non-linear programming (MINLP) problem. To make it tractable, we separate the original MINLP problem into two sub problems: power allocation and sub-carrier reusing. The former is to develop optimal power allocation for each device-to-device pair and each cellular user, with the constraints of maximum power and quality of service. It is solved by geometric programming technique in convex optimization method. The latter is derived as a one-to-many matching problem for scheduling multiple subcarriers occupied by cellulars to device-to-device pairs. It is solved by Hungarian method. Simulation results show that the proposed scheme significantly improves system capacity of the device-to-device underlay network, with quality of service of both device-to-device users and cellular users guaranteed.

In this letter, we investigate the joint optimization of sensing time and power allocation for amplify-and-forward cognitive relay networks. By jointly considering the sensing slot and the data transmission slot, the optimization problems are respectively formulated to maximize the average network throughput and minimize the approximate outage probability of secondary transmission under the average transmit power constraint of secondary users and the average interference power constraint of primary user. The optimal algorithms are developed to acquire the optimal sensing time and power allocation. Simulation results demonstrate that significant improvements in the average throughput and outage behavior are achieved through the joint optimization.

In this paper, we explore a joint subcarrier assignment and power allocation with statistical delay QoS guarantees for full-duplex OFDMA systems. Effective capacity theory which evaluates wireless channel capacity from a novel view of link layer provides a theory basis for modeling the system capacity under the conditions of delay QoS constrains. After modeling the aggregate effective capacity of the system, we formulate joint subcarrier assignment and power allocation problem as a mixed integer programming problem, whose target is to maximize the aggregate effective capacity. To solve this integer programming problem, we allocate initial power on each subcarrier and decompose it into two subproblems, which are subcarrier allocation problem and power allocation problem respectively. Further, we propose an alternative algorithm to achieve joint subcarrier assignment and power allocation, which can meet the “subcarrier continuity” constraint of uplink resource allocation. Simulations have shown that the performance of our proposed scheme is favorite. Additionally, we investigate the effect of the residual selfinterference, inter-node interference (INI) and statistical delay QoS exponent on the performance of systems.

In this article, we address the problem of optimal joint power and resource allocation when Non-Orthogonal Multiple Access (NOMA) and Orthogonal Frequency Multiple Access (OFDMA) are combined for a hybrid downlink multiple access. First, an optimal solution of joint power and resource allocation minimizing the transmit power consumption, is obtained by rewriting the original optimization problem into an equivalent convex one and then by solving it by means of the well-known interior-point method. Second, we analyze the properties of the optimum, which are twofold; we show that at the optimum, the order of the users is preserved from one channel to another. Then, we derive a closed-form expression for the optimal power allocation in the particular case where all users have positive non-zero transmit powers in all channels.

Machine-to-Machine (M2M) communications have received considerable attentions in recent years. By allowing machine type communications devices (MTCDs) to communicate with each other or with infrastructures under reduced human intervention, M2M communications are expected to offer a large variety of MTCD-related applications. While the vision of M2M communications is quite promising, the diverse quality of service (QoS) requirements and the complicated network architecture pose challenges and difficulties to resource allocation, cell selection and random access schemes, etc. In this paper, we take into account the impacts of random access on the transmission performance of the MTCDs and examine the energy efficiency of each MTCD. Applying the concept of utility function, we define network utility function and formulate the problem of joint cell selection and power allocation as a network utility function maximization problem. By applying iterative method and Lagrange dual method, the formulated optimization problem is solved and the optimal joint cell selection and power allocation strategy can be obtained. Simulation results demonstrate the effectiveness of the proposed algorithm.

In this letter, we propose an optimal joint power allocation and beamforming for MIMO-NOMA in mmWave communications. In this method, to reduce the system overhead, we consider a random near random far (RNRF) pairing scheme in our NOMA data transmission. We formulate an optimization problem to find the optimal power allocation and random beamforming (RBF) coefficients to improve the system performance. We prove the convexity of the underlying optimization problem and propose an iterative algorithm to jointly update the power allocation and RBF coefficients to maximize the communication reliability. Our proposed technique significantly reduces the outage probability (OP) of the system.