Joint source channel coding with MC-CDMA in capacity approach

this paper reviews the state of the technique of field programmable gate array (FPGA) for partial Reconfiguration (PR), design methodologies of Wireless Communication System, such as Multi Carrier Code Division Multiple Access (MC-CDMA) technique has been to be suited for future wireless systems that are expected to provide higher data rates and greater flexibility for the services of voice, data, video and Internet to the users due to its property in using the bandwidth in efficient manner. The Software Defined Radio is considered as a wireless system applied by routines so as software. Consequently, the use of SDR allows vehicle manufacturers to familiarize communication applications sustained through cars to appropriate to the standards of the respected country presented in the object oriented programming. FPGAs are playing a very significant role in SDR. However, in modern wireless communication system programs, SDR and CR need to design a wide range of waveforms complex, which it is complicated in design and performance and implementation needs more time. The design of the modulation and demodulation and other signal processing application of PR technique that have the ability to modify blocks of logic dynamically by downloading partial bit files, while the remaining logic is still working without interruption; thus, power consumption and configuration time can be saved for a larger extent. The PR using was allowed to move for fewer or smaller devices as, decrease power and increase system upgradability.

Multi-carrier code division multiple access (MC-CDMA) technique is a combination of two radio access techniques: CDMA and orthogonal frequency division multiplexing and has the advantages of both techniques. The paper presents the design of transmitter and receiver for MC-CDMA radio interface. It also presents encoders and decoders of turbo codes which were used in simulation of the MC-CDMA technique. Two turbo codes with 8-state recursive systematic convolutional were used in the simulation. The simulation results of the transmission quality in additive white Gaussian noise (AWGN) channel presented in the paper show bit error rate and frame error rate performance of MC-CDMA technique with the turbo codes and allow for comparison the performance of both turbo codes.

For future mobile communications, an appropriately chosen multiple access scheme is a critical issue. To support robust frequency planning, multi-operator scenarios, system coexistence and hierarchical cell structures, frequency division multiple access (FDMA) and multicarrier techniques are viable choices. Further multiple access schemes presently under discussion are code division multiple access (CDMA) and time division multiple access (TDMA). A mobile radio system concept deploying a hybrid frequency and time divided code division multiple access (F/T/CDMA) scheme with a multicarrier CDMA (MC-CDMA) component, called MC/JD-CDMA, is proposed and performance results for the uplink are presented. Attractive features of the proposed system concept are the possibility to flexibly offer voice and data services with different bit rates, soft capacity, as well as inherent frequency and interferer diversity.

Multi-Carrier CDMA (MC-CDMA) has been considered as a combination of the techniques of Code Division Multiple Access (CDMA) and Orthogonal Frequency Division Multiplex (OFDM). However, even until now, the efficient MC-CDMA scheme is still under study because of the inherent bugs in OFDM, such as the troubles caused by Multiple Access Interference (MAI) and Peak to Average Power Ratio (PAPR). In this paper, we present a novel two-dimensional spreading sequence named Two Dimensional Combined Complementary Sequence (TDC). If we take this kind of sequences as spreading codes, several prominent advantages can be achieved compared with traditional MC-CDMA. First, it can achieve MAI free in the multi-path transmission both in uplink and downlink. Second, it offers low PAPR value within 3 dB with a quite simple architecture. The last but not the least, the proposed MC-CDMA scheme turns out to be an efficient approach with high bandwidth efficiency, high spreading efficiency and flexible transmission rate enriched by a special shift-and-add modulation. Meanwhile, an algorithm that constructs TDC sequences is discussed in details. Based on above results, we can get the conclusion that the novel TDC sequences and corresponding MC-CDMA architecture have great potential for applications in next generation wireless mobile communications, which require high transmission rate in hostile and complicated channels.

Multi-carrier code division multiple access (MC-CDMA) technique is one of the strong candidates for next generation wireless mobile communication systems. Multi-carrier systems are very much sensitive to carrier frequency offset (CFO) results in intercarrier interference (ICI). To mitigate ICI without any spectral loss, a second order duobinary coded phase rotated conjugate cancellation algorithm is proposed in this paper. In the conventional phase rotated conjugate cancellation (PRCC) technique, one path carries the MC-CDMA signal with a phase spin of ϕ and the other path carries the conjugate of the first path signal with -ϕ phase spin. This artificial phase rotation allows the transmitter to tune the transmitted signals so that the ICI effects could be mutually cancelled at the receiver. Although the PRCC technique reduces the spectral efficiency, the limitation can be overcome by the joint second order duobinary coding scheme with PRCC technique. In the proposed method, the correlative coding between the binary symbols modulated on adjacent subcarriers is used to reduce the ICI without any spectral loss. Simulation results show that the proposed PRCC method provides better carrier to interference ratio (CIR) and bit error rate (BER) performances compared to the conventional conjugate cancellation (CC) technique.

The multicarrier code division multiple access (MC-CDMA) technique has received considerable attention due to its high data rate for future wireless communication systems. A common problem to multiuser MC-CDMA detectors under Rayleigh fading channels is that the performance is very sensitive to the signature waveform mismatch (SWM) induced by channel estimation distortion. Besides, the disturbance of colored noise could make the performance of the system worse. In this paper, the proposed multiuser detector which utilizes the modified independent component analysis (ICA) algorithm based on approximate negentropy maximization under the second-order cone programming (SOCP) constraint can provide robustness against small-to-medium SWM over colored noise environment for a synchronous MC-CDMA system.

Multi carrier code division multiple access (MC-CDMA), a strong contender for future mobile communication is a combination of orthogonal frequency division multiplexing (OFDM) and code division multiple access (CDMA). Turbo coding technique can be used for improving the performance of MC-CDMA system in terms of bit error rate (BER). The objective of this work is to form a coding scheme that reduces BER of MC-CDMA system. In this paper a time domain turbo block code (TBC) designed using powerful low density parity check (LDPC) code is used in MC-CDMA system for improving the BER performance and the same is proved through simulation. This code also has error correction capability along with high performance efficiency in terms of BER.

In the present time, there is a rapid increase in demand for faster and reliable transmission of multimedia data through wireless channels. When multimedia data specially an image is to be transferred through the wireless channel, image is highly degraded due to wireless channel errors such as fading, interference and bursty errors. Multi-Carrier Code Division Multiple Access (MC-CDMA) technique is considered as the most promising technique for efficient wireless data transmission. This paper presents the performance comparison of image transmission over MC-CDMA system with two interleaving techniques; Helical interleaving and chaotic interleaving. At the receiver, Linear Minimum Mean Square Error (LMMSE) equalization is employed. System performance is measured through Peak Signal-to-Noise Ratio (PSNR) and Root Mean square Error (RMSE) values. From results, it has been evaluated that MC-CDMA system having chaotic interleaving and LMMSE performs better instead of having helical interleaving for image transmission over wireless channels.

The multicarrier code division multiple access (MC-CDMA) technique has received considerable interest for its potential application to future wireless communication systems due to its high data rate. A common problem regarding the blind multiuser detectors used in MC-CDMA systems is that they are extremely sensitive to the complex channel environment. Besides, the perturbation of colored noise may negatively affect the performance of the system. In this paper, a new coherent detection method will be proposed, which utilizes the modified fast independent component analysis (FastICA) algorithm, based on approximate negentropy maximization that is subject to the second-order cone programming (SOCP) constraint. The aim of the proposed coherent detection is to provide robustness against small-to-medium channel estimation mismatch (CEM) that may arise from channel frequency response estimation error in the MC-CDMA system, which is modulated by downlink binary phase-shift keying (BPSK) under colored noise. Noncoherent demodulation schemes are preferable to coherent demodulation schemes, as the latter are difficult to implement over time-varying fading channels. Differential phase-shift keying (DPSK) is therefore the natural choice for an alternative modulation scheme. Furthermore, the new blind differential SOCP-based ICA (SOCP-ICA) detection without channel estimation and compensation will be proposed to combat Doppler spread caused by time-varying fading channels in the DPSK-modulated MC-CDMA system under colored noise. In this paper, numerical simulations are used to illustrate the robustness of the proposed blind coherent SOCP-ICA detector against small-to-medium CEM and to emphasize the advantage of the blind differential SOCP-ICA detector in overcoming Doppler spread.

This paper gives the effectiveness measures of the comparison of the MIMO MC CDMA and MCCDMA modulation technique for wireless radio applications. MIMO is checked as a modulation technique for telephony communication system. A comparative study of MIMO MC CDMA and MC CDMA a variant of MC is done with the CDMA technology for the same application. The study will provide bird eye view of MIMO and CDMA for communication engineering. It was found by study that MIMO performs extremely well, providing a very high tolerance to multipath delay spread and channel noise. This paper attempts to assess wireless communications channels and propose techniques to improve the performance of modern wireless communications. Hence from a strategic perspective, an analytical study into the comparison of performance of MIMO Multi Carrier Code Division Multiple Access (MIMO-MC-CDMA) and multicarrier code division multiple access signal in frequency selective fading channel, the channel bandwidth is the main theme of this paper; from which the problems that may affect the communications link are highlighted and measures to counterbalance and alleviate multi path fading are proposed and investigated.

This paper introduces new blind time domain equalization (TEQ) techniques for downlink multicarrier code division multiple access (MC-CDMA) systems. This equalization exploits the guard interval (GI) redundancy together with the excess codes (EC) to restore the structural properties of MC-CDMA signal destroyed by multipath fading channels. Indeed, since in CDMA based wireless systems, the number of users per cell is significantly less than the spreading factor, a base station can set apart a subset of the codes, the excess codes that will not be used for spreading. It is shown that the joint use of the EC and GI redundancy improves significantly the equalization performance compared to the GI only or EC only cases. A second contribution consists in exploiting the previous information together with the one given by a pilot sequence in a semi blind scheme to further improve the performance. Finally, we propose a new adaptive algorithm for the estimation and tracking of the equalizer that has a faster convergence rate compared to existing algorithms of similar complexity order. Simulation based performance evaluations are given at the end of this paper to assess the effectiveness of the proposed methods in MC-CDMA.

Multicarrier code division multiple access (MC-CDMA) is a promising technique for high data rate and high capacity (large number of users) transmission. However, rapidly time varying channels degrade the performance due to loosing the orthogonality among the subcarriers as well as code patterns. Channel estimation is very important to design adaptive system for improvement in all round performance. This paper proposes an efficient channel estimation for Rayleigh fading channel in high capacity carrier interferometry /multi-carrier code division multiple access (CI/MC-CDMA) system with variable data rate using Genetic algorithms (GAs). The system implementation is done by allocating all sub-carriers to the users who transmit high data rate and alternate odd and even subcarriers are assigned to the other sets of users transmitting at low data rate. GAs is used to estimate a near optimal solution of the set of parameter values on frequency selective Rayleigh fading channel. Objective function is formed from the weighted average of channel capacity and bit error rate. Simulation results show that both channel capacity and bit error probability are improved with the increase of number of iterations/generations.

For the next generation wireless communication system, Multi carrier Code Division Multiple Access (MC-CDMA) has become very appealing scheme due to due to high data rates and interference limiting factors. In this research work we analyzes the capacity of MC-CDMA system using adaptive power and sub-channel allocation under perfect, imperfect and predicted channel state information (CSI). The transmitter and receiver both have been targeted in this paper. The proposed scheme is a novel idea that divides the sub-channels into small groups. Each group is assigned power according to the Eigen values and gain of the each sub-channel in that specific group. The receiver calculates optimal feedback vector for the transmitter by calculating the bit error rates using the above strategy and selects the optimal feedback vector. The simulations show that the usage of joint power and sub-channel allocation outperforms the capacity of the system. The capacity of the system is highly improved using adaptive power and sub-carriers allocation along with CSI prediction. The simulation results have been carried out for other power allocation schemes available in literature and results have been compared with perfect, imperfect and predicted CSI.

Multi Carrier Code Division Multiple Access (MC-CDMA) is a suitable modulation method for high data rates. In this modulation system, using of combining methods are inevitable for restoring orthogonality between diverse user signals. In this paper, the combining techniques of a MC-CDMA based on lifting discrete wavelet transform strategy (LDWT) are studied. Is presented to keep up the symmetry against the multipath Flat Fading Channels (FFC). Show of MC-CDMA under many channels similar the AWGN channel and FFC, is examined and BER versus SNR graphs are plotted and their presentation is deliberate.

In this paper, we derive the end-to-end (e2e) Bit Error Probability (BEP) of cooperative Multi Carrier Code Division Multiple Access (MC-CDMA) systems using selective threshold digital relaying (STDR). In STDR, a set of potential relays whose received Signal-to-Noise Ratio (SNR) exceeds a threshold value γ t , called reliable relays, is formed. Then, only the best relay among reliable relays is allowed to retransmit the received signal. We activate the relay with the largest SNR in relay-destination link. The derived BEP results are valid for any multipath intensity profile of the channel.