Link-Level Traffic Scheduling for Providing Predictive QoS in Wireless Multimedia Networks

International audience

This work introduces a Medium Access Control (MAC) protocol designed to allow a group of underwater robots that share a wireless communication channel to effectively communicate with each other. The goal of the Underwater Multirobot Cooperative Intervention MAC (UMCI-MAC) protocol presented in this work is to minimize the end to end delay and the jitter. The access to the medium in UMCI-MAC follows a Time Division Multiple Access (TDMA) strategy which is arbitrated by a master, which also has the capability to prioritize the transmission of some nodes over the rest of the network. Two experiments have been carried out with a team of four Autonomous Underwater Vehicles (AUV) in order to compare this protocol with Aloha-CS and S-FAMA MAC protocols used in Underwater Wireless Sensor Networks (UWSN). In the first experiment, the communications and the AUVs have been simulated using UWSim-NET. The objective of this experiment was to evaluate all three protocols in terms of delay, jitter, efficiency, collisions and throughput depending on the size of the data packet and the rate of packet delivery in the application layer for each robot. The results of this experiment proved that UMCI-MAC successfully avoids packet collisions and outperforms the other two protocols in terms of delay, jitter and efficiency. The second experiment consisted of a Hardware In The Loop (HIL) teleoperation of a team of four robots. One of the AUVs was a real BlueROV in a water tank, while the remaining AUVs and the communications were simulated with UWSim-NET. It demonstrates the impact of the MAC protocols in underwater acoustic links. Of the three MAC protocols evaluated in this work, UMCI-MAC was the only one which succeeded in the proposed teleoperation experiment. Thus demonstrating its suitability as a communications protocol in underwater cooperative robotics.

A common broadband PON applicable to many operators increases the world-wide market for the product. Multiplexing of data from the customer into the network is done passively on the PON. PONs offer a flexible future proof service delivery platform for the access network. The MAC (medium access control) protocol controls ONU (optical network unit) access to the shared capacity on the PON, this protocol is very important if TDMA (time division multiple access) multiplexing is used on the upstream. The MAC protocol must be efficient because the PON capacity is shared. Dynamic allocation of bandwidth to active ONUs enables higher efficiency than if the capacity is fixed at call set-up. Many MAC protocols operating as collison-free and collison-based protocols have been proposed and are now proposed. Therefore there are many kinds of protocol and data frame that are transmitted between OLT (optical line termination) and ONUs. If the network operator which manages OLT supports many types of protocol at ONUs, the network operator can support these. In this paper, the MAC frame structure offers the flexibility to cope with different physical layer specifications. At the same time it offers the possibility of implementing a variety of media access protocols so that a variety of services can be supported. This frame guarantees the operation of various protocols at ONUs using a key-set that has variable fields.

Power efficient ultra-wideband based wireless communication for wireless body area network applications

In this paper we propose a simple relay enabled medium access (SRMAC) protocol that enables cooperative relay transmissions. Due to the wireless signal power attenuation with distance, using a relay in a wireless network can make wireless networking more bandwidth efficient at the expense of requiring multiple transmissions for a single packet. Standard MAC protocols such as the IEEE 802.11 MAC protocol, while useable with relaying, however are not designed explicitly for relay communication. When IEEE 802.11 MAC protocol is used for cooperative communication such a relaying, each packet transmission would need to separately contend for the channel via a channel access procedure which can use significant resources (both energy and bandwidth). Because using a single relay requires two transmissions, an efficient medium access control (MAC) protocol that supports two hop transmission is needed. We introduce a protocol, SRMAC, which is a simple cooperative MAC protocol that utilizes information from the physical layer for the MAC operation of relay networks. We consider the bandwidth efficiency of SRMAC protocol considering both the physical layer and MAC layer. The SRMAC protocol includes the possibility of both cooperative transmission and direct transmission. With SRMAC, cooperative transmission (relaying) can be dynamically chosen when it is more beneficial than direct transmission. The SRMAC protocol can improve the throughput by up to 20% compared to conventional MAC protocols.

Since cognitive wireless network (CRN) has the characteristic of secondary use, it can enable the device to dynamically access available spectrum without interference to primary users (PUs), which can effectively alleviate contradiction between the lack of spectrum resources and the growing demand for wireless access. However, Medium Access Control (MAC) protocol as CRN core components, can achieve competition access of the licensed spectrum and coordination control, which will maximize spectrum utilization efficiency and network throughput. The contribution of this survey is threefold. First, we analyze the characteristics of the existed multi- channel MAC protocol in CRN; Second, according to the different ways of spectrum access in CRNs, the multi-channel MAC protocols are classified into time-slotted based MAC protocol, control channel based MAC protocol and hybrid MAC protocol, and the paper emphatically analyzed the advantages and disadvantages of these multi-channel MAC protocols; Finally, the paper explores the difficulties and the challenges of multi-channel MAC protocols design in cognitive wireless network.

In the overlay medium access control (MAC) of cognitive radio networks, secondary user (SU) uses the spectrum portion which is assigned to primary user (PU), when PU is not using this spectrum at that time. In this article, a multiuser overlay MAC protocol is considered in which PUs and SUs are using time division multiple access and carrier sense multiple access (CSMA) MAC schemes, respectively. Firstly, new frame format and algorithm for the proposed MAC protocol are described, then the analytical modelling of this protocol is explained. In the SU network, Markov chain model along with the CSMA protocol is used for better utilization of the opportunity from the PU network (PUN). Channel utilization and probability of success are also derived and analyzed for this protocol with respect to idle time, collision (failure) time, various spectrum opportunities from PUN, number of SUs, and their fairness. This MAC scheme provides the optimal solution for channel utilization under a constraint on the probability of collisions. Numerical results are also provided to validate analysis of proposed MAC protocol and to investigate the performance behaviour of the optimal solution.

A schedule based MAC in wireless Ad-hoc Network by utilizing Fuzzy TOPSIS

Cognitive Radio (CR) exploits underutilized licensed spectrums to improve its bandwidth availability. Using CR technology, a node is able to adapt its transmission and reception radio parameters including channel frequency dynamically according to local spectrum availability. For channel access between wireless nodes, a cognitive Medium Access Control (MAC) protocol is necessary to coordinate the CRs. Multi-channel MAC protocol extensions have been proposed in IEEE802.11 to enable a node to operate in multiple channels in order to improve network-wide throughput. These multi-channel MAC protocols have several functions that can be leveraged by cognitive MAC protocols due to their similarities in certain aspects, though the CR has an additional requirement to cope with the existence of licensed users that have higher authority over the channels. Current research in cognitive MAC protocols assumes the availability of a common control channel at all times, which is an approach in the multi-channel MAC protocols. This approach has certain hardware requirements that may not be readily available at CR nodes. Hence, other approached may be necessary. In this paper, various types of multi-channel MAC protocols are reviewed, followed by discussion of their merits and demerits in multi-channel environments. The purpose is to show the additional functionalities and challenges that each multi-channel MAC protocol has to offer and address in order to operate in multihop CR networks. By providing discussion on possible technology leverage from multi-channel to cognitive MAC protocols, we aim to establish a foundation for further research and discussion.

Two important criteria of wireless body area networks (WBANs) are low power consumption and delay. These criteria can be met by designing efficient medium access control (MAC) protocols. In this paper, two TDMA-based MAC protocols are proposed. The first protocol, TM–MAC makes use of only a main radio. The second proposed protocol, TWM–MAC makes use of a WUR alongside the main radio. The two proposed protocols are compared with different categories of standard MAC protocols and it is shown that they outperform the standard ones by improving the power consumption and delay. The TWM–MAC consumes 55% less power consumption than the Scheduled Channel Polling MAC (SCP–MAC) protocol for a high traffic scenario on the high-rate platform while the TM-MAC consumes 85% less power consumption than the SCP–MAC. For a low traffic scenario, the TWM–MAC performs 53.5% better than the SCP–MAC protocol and 77.5% better than the very low power MAC (VLPM) protocol on the high and low-rate platforms respectively. An improvement in delay was observed with the TWM–MAC protocol for high traffic situations. The TWM–MAC protocol surpasses the VLPM protocol by 81.1% in terms of latency for a high traffic scenario and 3.2% for a low traffic scenario.

The key contributions of this paper are the proposed Pure Collective Aloha (PCA) medium access control (MAC) protocol with multilevel powers and its closed-form theoretical analysis. The PCA MAC protocol collects a batch of packets before transmitting these packets sequentially in the channel. The key idea in the design of this PCA MAC protocol with multilevel powers is to spread out the arrivals of each batch of packets in a channel and the multilevel powers of the packets received at the receiver allow capture for the case of the strongest signal power packet among the overlapping lower signal power packets to be successfully received at the receiver. If it is the only received packet, it is successfully received, regardless of its received power level. The PCA MAC protocol with multilevel powers is analyzed theoretically. The explicit closed-form expressions for the optimal offered loads and the maximum throughputs of the Pure Aloha, the Slotted Aloha and the PCA MAC protocols with multilevel powers are presented. The numerical results show that the throughput of the asynchronous PCA MAC protocol with multilevel powers is about 90.5% better than that of the asynchronous Pure Aloha MAC protocol with multilevel powers and can approach the maximum throughput bound of the synchronous Slotted Aloha MAC protocol with multilevel powers, without the need of any synchronization mechanism to slot boundaries.

With the advanced physical layer techniques such as multiple-input and multiple-output (MIMO) and orthogonal frequency-division multiplexing (OFDM), transmission real-time 2D/3D contents and applications becomes more and more necessary in wireless networks for the amazing growing in demand of customers. However, the low efficiency of medium access control (MAC) protocol degrades the performance of real-time traffic greatly in multihop, wireless and mobile environment. Focusing on supporting real-time multimedia traffic in cognitive wireless mesh networks (WMNs), an enhanced MAC protocol is proposed. And the contribution of this paper is twofold: (1) An efficient carrier sense multiple access with collision avoidance (CSMA/CA) compatible time division multiple access (TDMA)-like MAC protocol called T-MAC is proposed, which aims to improve the system performance by allocating more channel access time in centralized manner and decreasing overhead. (2) An optimal adaptive scheduling scheme is proposed to support real-time multimedia applications and guarantee QoS for different priority traffic, which aims to find the optimized schedule among all possible sequences of concurrent transmissions by minimizing the occupied resources. Detailed simulation results and comparison with IEEE 802.11e MAC scheme show that the proposed T-MAC can effectively improve quality of service (QoS) for multimedia traffic in terms of throughput, end-to-end delay and packet loss rate, which also manifests that T-MAC is an efficient multimedia applications transmission scheme for mobile terminals and MAPs in cognitive WMNs.

High throughput and fair resource sharing are two of the most important objectives in designing a medium access control (MAC) protocol. Currently, most MAC protocols including IEEE 802.11 DCF adopt a random access based approach in a distributed manner in order to coordinate the wireless channel accesses among competing stations. In this paper, we first identify that a random access–based MAC protocol may suffer from MAC protocol overhead such as a random backoff for data transmission and a collision among simultaneously transmitting stations. Then, we propose a new MAC protocol, called sequential coordination function (SCF), which coordinates every station to send a data frame sequentially one after another in a distributed manner. By defining a service period and a joining period, the SCF eliminates unnecessary contentions during the service period, and by explicitly determining the sequence of frame transmission for each stations, it reduces collision occurrences and ensures fairness among stations in the service period. The performance of SCF is investigated through intensive simulations, which show that the SCF achieves higher throughput and fairness performances than other existing MAC protocols in a wide range of the traffic load and the number of stations.

Over the past few years, mobile networks have emerged as a promising approach for future mobile IP applications. With limited frequency resources, designing an effective MAC (Medium Access Control) protocol is a hot challenge. IEEE 802.11b/g/a/n networks are currently the most popular wireless LAN products on the market [1]. The conventional IEEE 802.11b and 802.11g/a specification provide up to 11 and 54 Mbps data rates, respectively. However, the MAC protocol that they are based upon is the same and employs a CSMA/CA (Carrier Sense Multiple Access/Collision Avoidance) protocol with binary exponential back-off. IEEE 802.11 DCF (Distributed Coordination Function) is the de facto MAC protocol for wireless LAN because of its simplicity and robustness [2,3]. Therefore, considerable research efforts have been put on the investigation of the DCF performance over wireless LAN [2]. With the successful deployment of IEEE 802.11a/b/g wireless LAN and the increasing demand for real-time applications over wireless, the IEEE 802.11n Working Group standardized a new MAC and PHY (Physical) layer specification to increase the bit rate to be up to 600 Mbps [3]. The throughput performance at the MAC layer can be improved by aggregating several frames before transmission [3]. Frame aggregation not only reduces the transmission time for preamble and frame headers, but also reduces the waiting time during CSMA/CA random backoff period for successive frame transmissions. The frame aggregation can be performed within different sub-layers. In 802.11n, frame aggregation can be performed either by A-MPDU (MAC Protocol Data Unit Aggregation) or A-MSDU (MAC Service Data Unit Aggregation). Although frame aggregation can increase the throughput at the MAC layer under ideal channel conditions, a larger aggregated frame will cause each station to wait longer before its next chance for channel access. Under errorprone channels, corrupting a large aggregated frame may waste a long period of channel time and lead to a lower MAC efficiency [4]. On the other hand, wireless LAN mobile stations that are defined as the stations that access the LAN while in motion are considered in this chapter. The previous paper analyzed the IEEE 802.11b/g/n MAC performance for wireless LAN with fixed stations, not for wireless LAN with mobile stations [5, 6, 7, 8, 9, 10]. On the contrary, Xi Yong [11] and Ha Cheol Lee [12] analyzed the MAC performance for IEEE 802.11 wireless LAN with mobile stations, but considered only IEEE 802.11 and 802.11g/a wireless LAN specification. So, this chapter summarizes all the reference papers and analyzes the IEEE 802.11b/g/a/n MAC performance for wireless LAN with fixed and mobile stations. In other words, we will present the analytical evaluation of saturation

This paper describes a new approach for the performance evaluation of wireless ATM protocols where the channel quality is also taken into consideration. One of many aspects which decide the performance of wireless ATM is the medium access control (MAC) protocol which should satisfy the needs of different services. MAC protocols must also cope with the complex radio environment where fading, multipath propagation and interference cause additional limitations of the system performance. We illustrate the use of this new approach for the evaluation of a MAC protocol used in an indoor wireless ATM network.