Low Power Consumption DQPSK Demodulator Using Silica-Based Planar Lightwave Circuit

In this paper, the authors derive the moment generating function (MGF) of the decision variable for a practical optical differential quadrature phase shift keying (DQPSK) receiver affected by phase noise and the amplifier spontaneous emission noise. The effect of the different optical filters, Gaussian, Fabry-Peacuterot (FP), and optical integrator, on the phase noise is examined. Using the saddle point approximation, the authors obtain numerically the bit error rate (BER) for the above system, as a function of the optical-signal-to-noise ratio (OSNR) and the source linewidth. The model is found to agree with previous published simulation results and the Monte Carlo simulations presented in this paper. The authors also calculate the BER floors for DQPSK inflicted by the phase noise and compare its performance with differential phase shift keying (DPSK). Finally, the authors examine the effect of interferometric demodulation on the relative intensity noise (RIN) spectra and the impact on the DQPSK system performance. In particular, the authors examine the influence of system dispersion on the receiver sensitivity

A transmission-type refractive index sensor, based on planar lightwave circuit (PLC) technology is proposed. In the proposed structure, we introduce a combination of coarse measurements, using the dependence of the angle of refraction and fine measurement, and the dependence of the phase on the refractive index to measure the absolute refractive index precisely, without expensive optical measurement equipment. The theoretical model of the proposed refractive index sensor is derived based on Fourier optics and transfer function to simulate its performance. The simulation results for the use of the 2.5%-Δ silica-based PLC technology indicate that the proposed structure has the potential to achieve a refractive index error of approximately 1 × 10−6 RIU or less when a monitored power deviation of ±0.05 dB is accepted.

Abstract. In this paper an FPGA-based test system for high-speed transmission experiments with integrated photonic receivers is presented. Pseudorandom binary sequences are generated inside the FPGA and encoded as either differential quadrature phase shift keying (DQPSK) or quadrature phase shift keying (QPSK) signals. The DQPSK encoder uses a 64-fold parallel-prefix-layers architecture for real-time operation which allows for a maximum internal encoder data rate of 64 Gbit/s. Two-fold parallel data streams of I and Q signals suitable for driving an optical IQ-modulator can be transmitted and received by four 12.5 Gbit/s transceivers. Integrated bit error testers are used to determine bit error rates in real-time.

In digital communications, 90 or 180 degree phase ambiguity between the receiver and transmitter carrier is a serious problem for the coherent demodulation. To remove their phase ambiguity, differential quadrature phase shift keying (DQPSK) was proposed with the cost of a remarkable 2.4 dB performance degradation. Based on the iterative decoding (ID) scheme, an efficient joint convolutional code (CC)-coded DQPSK method is proposed to close the gap between quadrature phase shift keying (QPSK) and DQPSK. Using the extrinsic information transfer (EXIT) chart technique, we unveil that the low-complexity convolutional codes outperform the high-complexity Turbo codes for the ID scheme. Simulation results turn out that the proposed scheme can overcome the error-floor effect, and achieve almost 3.54 dB and 0.9 dB signal-to-noise ratio (SNR) gain compared with the non-iterative CC at 10−5 Bit Error Rate (BER)and iterative Turbo schemes at 10−7 BER, respectively.

This paper presents recent progress toward the realization of ultrahigh-speed coherent optical transmission with a single-channel bit rate of more than 1 Tbit/s using ultrashort pulse technology and an advanced modulation format. We first describe Tbit/s optical time-division multiplexing (OTDM) transmission employing differential binary or quadrature phase shift keying. We present our recent demonstrations of single-polarization 640-Gb/s differential phase-shift keying and 1.28-Tb/s differential quadrature phase-shift keying transmissions over 525 km, which employ an ultrafast optical Fourier transformation technique. We then focus on coherent optical transmission using quadrature amplitude modulation (QAM) with a multiplicity of 512 that enables us to achieve an ultrahigh spectral efficiency of more than 10 b/s/Hz. Finally, we demonstrate a novel ultrahigh-speed, spectrally efficient coherent pulse transmission combining OTDM and QAM. A 400 Gb/s, 32 RZ/QAM signal was successfully transmitted over 225 km on a single carrier at 10 Gsymbol/s × 4-OTDM.

Optical splitters are essential for the construction of optical networks such as fiber-to-the home systems. These devices should exhibit not only good optical characteristics such as low loss and polarization insensitivity but also long-term reliability. Silica-based planar lightwave circuits (PLCs) on Si can form one of the most suitable Y-branching splitters because they have the advantages of low loss, low coupling loss to optical fibers and high reproducibility[l]. When PLC splitters are used in practice, the input and output fibers must be connected to waveguides. Therefore, it is necessary to establish a precise connection technique and confirm its long-term stability. However, neither the connection performance of splitters with up to 32 ports nor the long-term reliability of fiber-connected splitters have yet been evaluated in detail. Here, we describe the connection performance and reliability of 1×8 and 1×32 splitter modules. We have chosen strict Bellcore requirements [2] as the first step in evaluation of the PLC splitter reliability. The requirements are recognized as a standard for reliability tests on optical devices, and define the optical criteria as well as the test conditions.

We present a summary of our recent work on using lattice-form Mach-Zehnder interferometers implemented using silica-based planar lightwave circuit technology for optical signal processing. In particular, we demonstrate that the same device structure (either based on 6 taps or 12 taps) can be used to perform various signal processing functions ranging from pulse repetition rate multiplication to arbitrary waveform generation.

A hybrid-integrated coherent receiver module has been achieved using flip-chip bonding technology, consisting of a silica-based 90°-hybrid planar lightwave circuit (PLC) platform, a spot-size converter integrated waveguide photodiode (SSC-WG-PD), and a dual-channel transimpedance amplifier (TIA). The receiver module shows error-free operation up to 40Gb/s and OSNR sensitivity of 11.5 dB for BER = 10−3 at 25 Gb/s.

이 논문에서는 계층변조를 적용하는 AT-DMB (advanced terrestrial digital multimedia broadcasting) 시스템에 적용할 수 있는 블라인드등화 기법을 제시하고 그 성능을 살펴본다. AT-DMB 시스템은 기존 T-DMB의 DQPSK (differential quadrature phase-shift keying) 신호와 역방향 호환성을 보장하고 더 높은 데이터 전송률을 지원하기 위해 16-QAM (quadrature amplitude modulation) 계층변조 방식을 적용한다. 이 결과 SNR (signal to noise ratio)에 따라 기존 T-DMB 심볼과 추가된 심볼은 서로 다른 판정오율 (decision error rate)을 가진다. 따라서 판정한 신호로부터 채널을 추정할 때 판정오율이 낮은 선순위 심볼과 판정오율이 높은 후순위 심볼의 신뢰도에 따라 다른 가중치를 줌으로써 판정치의 전체적인 신뢰도를 향상시킬 수 있다. 이 논문에서는 계층변조에 따른 비트 오율(bit error rate) 성능의 악화정도를 분석하고, 모의실험을 통해 판정신호의 신뢰도에 따라 가중치를 주는 제안방식이 가중치를 주지 않은 경우에 비해 비트 오율 성능이 향상됨을 확인하였다. In this paper, we propose a blind equalization method for advanced terrestrial digital multimedia broadcasting (AT-DMB) systems which use hierarchical modulation. The AT-DMB system adopts hierarchical 16-ary quadrature amplitude modulation (16-QAM) to ensure backward-compatibly with the differential quadrature phase shift keying (DQPSK) signal of the legacy terrestrial digital multimedia broadcasting (T-DMB) systems and to support higher transmission rate. Due to the hierarchical modulation, the conventional T-DMB signal and the additional signal have different error rate at same signal to noise ratio (SNR). By weighting the decided symbols differently according to the reliability of the symbols, i.e., high priority symbol with low error rate and low priority symbol with high error rate, we can improve the channel estimation accuracy. In this paper, we analyze SNR loss by hierarchical modulation and confirm it through simulations. Moreover, through simulations, we verify that the proposed weighting method improve BER compared to the no-weighting method.

Differential phase-shift keying (DPSK) has been widely implemented and developed in high-speed optical communication systems. The low error rate detection at high access rate is one of the considerable issues in practical engineering application. Balanced detection based on fiber Mach-Zehnder delay interferometer (MZDI) is the typical optical DPSK signal detecting method. It requires that the free spectrum range (FSR) of the MZDI equals the reciprocal of symbol period of the DPSK signal. For the reasons of ambient temperature variation and nonlinear phase noise, a dynamic frequency offset always exists between the FSR and the reciprocal of symbol period. That may introduce some optical signal-to-noise ratio (OSNR) costs and fault detections. Therefore, it is significant to inhibit the frequency offset on DPSK detection. In this paper, firstly, we discuss the effects of frequency offset on DPSK detection, and realize the conclusion that frequency offset is virtually equivalent to an additional phase difference between adjacent symbols. Secondly, through simulation, we analyze the feasibility of DPSK detection in the presence of a definite range of frequency offset, and present the quantitative computation of effective coverage, duty cycle, and optimal sampling time of symbol interference. Some issues which should be considered in practical implementation are also discussed. Finally, according to the relationship among phase difference, temperature and voltage, we propose a phase difference compensation scheme which can automatically adjust the voltage for optimal detections, and dynamically track the changing of ambient temperature and nonlinear phase noise. Furthermore, we ascertain the performance of the voltage requested for implementing the scheme. The scheme can be also developed to quadrature phase-shift keying (QPSK) and differential QPSK (DQPSK) modulation situations.

A multi-tone code division multiple access (MT-CDMA) system with post-detection diversity combining is analyzed. The analysis is presented in terms of average bit error rate (BER). The modulator uses differential quadrature phase shift keying (DQPSK) signaling over a slowly Rician fading and frequency selective channel in the indoor environment. Here, the influence of the order of diversity and number of tones is studied for given bandwidth (BW), bit rate and transmitter power. The paper also compares the BER performance between differential binary phase shift keying (DBPSK) and DQPSK based MT-CDMA systems.

While silica waveguide PLC products have been deployed in various systems and applications, hybrid integration of semiconductor opto-electronic devices on silica-based planar lightwave circuit (PLC) has become the mainstream platform for small form factor, low-cost and high volume integrated transceiver modules. One of the main benefits of hybrid integration is the wafer-scale process, which greatly reduces chip/module size and assembly cost. This paper reviews the development of this technology, and as an example, presents a hybrid integrated transmitter with four wavelengths on silica PLC chip for LX4 and 10GbE applications.

We propose a novel passive alignment method for multiple silica-based planar lightwave circuit (PLC) interconnections. The method employs grooves for fitting formed on a silica-based PLC with optical fibers. We achieved low-loss PLC interconnections with the method. The method is a promising way of realizing cost-effective and pluggable multi-PLC integration.

Bit error rate (BER) results are presented for pi /4 differential quadrature phase-shift keying (DQPSK) with Nyquist pulse shaping in flat and frequency-selective fading channels. BER results are shown for a wide range of multipath delays, receiver speeds and power ratios (C/D) between the main ray and the delayed ray in a two ray channel model. Co-channel interference effects are also considered. In addition, the instantaneous BER for pi /4 DQPSK in various fading channels is simulated. The simulation is first performed off line, and then bit error patterns are replayed in real time to allow subjective evaluation of link quality between a source and sink. This method is being used to provide real time bit error simulation of US Digital Cellular data channels using simple computer hardware. >

Higher spectral efficiency and greater data rate per channel are the most cost-effective strategies to meet the exponential demand of data traffic in the optical core network. Multilevel modulation formats being spectrally efficient enhance the transmission capacity by coding information in the amplitude, phase, polarization or a combination of all. This paper presents the design architecture of a 32-channel dense wavelength division multiplexed (DWDM) system, where each channel operates with multi-level phase modulation formats at 40 Gbps. The proposed design has been simulated for 50 GHz channel spacing to numerically compute the performance of both differential phase-shift keying (DPSK) and differential quadrature phase-shift keying (DQPSK) modulation formats in such high-speed DWDM system. The transmission link is analyzed with perfect dispersion compensation and also with under-compensation scheme. The link performance in terms of quality factor (