LTE-A系統之場域內多使用者協調式多點傳送：一個基於天線選擇的方法

Imperfect channel state information degrades the performance of multiple-input multiple-output (MIMO) communications; its effect on single-user (SU) and multi-user (MU) MIMO transmissions are quite different. In particular, MU-MIMO suffers from residual inter-user interference due to imperfect channel state information while SU-MIMO only suffers from a power loss. This paper compares the throughput loss of both SU and MU MIMO on the downlink due to delay and channel quantization. Accurate closed-form approximations are derived for the achievable rates for both SU and MU MIMO. It is shown that SU-MIMO is relatively robust to delayed and quantized channel information, while MU MIMO with zero-forcing precoding loses spatial multiplexing gain with a fixed delay or fixed codebook size. Based on derived achievable rates, a mode switching algorithm is proposed that switches between SU and MU MIMO modes to improve the spectral efficiency, based on the average signal-to-noise ratio (SNR), the normalized Doppler frequency, and the channel quantization codebook size. The operating regions for SU and MU modes with different delays and codebook sizes are determined, which can be used to select the preferred mode. It is shown that the MU mode is active only when the normalized Doppler frequency is very small and the codebook size is large.

We propose a cross-layer switching method of orthogonal frequency division multiple access (OFDMA) and multiuser multiple input multiple output (MU-MIMO) for the future wireless local area network systems. The proposed method, employed on the medium access control layer, switches between OFDMA and MU-MIMO as the transmission method after processing by using physical layer information such as an overhead of channel state information feedback, station number, and data length in order to improve the transmission efficiency. Simulation results show that the proposed method achieves higher total throughput than conventional OFDMA or MU-MIMO where switching is not performed.

In multi-user millimeter wave (mmWave) multiple input multiple output (MIMO) systems, obtaining accurate information/knowledge regarding the channel state is crucial to achieving multi-user interference cancellation and reliable beamforming (BF)–to compensate for severe path loss. This knowledge is nonetheless very challenging to acquire in practice since large antenna arrays experience a low signal-to-noise ratio (SNR) before BF. In this paper, a multi-user channel estimation (CE) scheme namely generalized-block compressed sampling matching pursuit (G-BCoSaMP), is proposed for multi-user mmWave MIMO systems over frequency selective fading channels. This scheme exploits the cluster-structured sparsity in the angular and delay domain of mmWave channels determined by the actual spatial frequencies of each path. As the corresponding spatial frequencies of multi-user mmWave MIMO systems with Hybrid BF often fall between the discrete Fourier transform (DFT) bins due to the continuous Angle of Arrival (AoA)/Angle of Departure (AoD), the proposed G-BCoSaMP algorithm can address the resulting power leakage problem. Simulation results show that the proposed algorithm is effective and offer a better CE performance in terms of MSE when compared to the generalized block orthogonal matching pursuit (G-BOMP) algorithm that does not possess a pruning step.

Preceding with block diagonalization is an attractive approach for approaching sum capacity in multiuser MIMO (multiple input multiple output) broadcast channels. This method though requires either global channel state information at every receiver or an additional training phase, which requires additional system planning. This paper proposes a lattice based multi-user precoder that uses block diagonalization combined with pre-equalization and perturbation for the multiuser MIMO broadcast channel. Achievable rates are computed and used to show that the proposed technique approaches the capacity with block diagonalization and water-filling but does not require the additional channel state information at the receiver. Monte Carlo simulations under the case of equal power allocation show that the proposed method provides better diversity and BER (bit error rate) performance than block diagonalization with a zero-forcing receiver.

Multi-user Massive MIMO, OFDM and other related techniques like Spatial diversity, Spatial decoupling, Ray tracing model, Beam forming, OFDM, and CDMA are discussed in this chapter.

Multiuser multiple-input multiple-output (MU-MIMO) cognitive radio (CR) systems can achieve higher spectral efficiency by multiplexing multiple users on the same time-frequency resources and allowing concurrent spectrum sharing instead of opportunistic sharing. MU-MIMO techniques have been successfully deployed in 4G cellular systems based on traditional static spectrum access approach, and a vast number of multiuser detection algorithms, such as maximum ratio combining (MRC), minimum mean-squared error (MMSE), and capacity-aware (CA) are presently being tailored toward solving the MIMO processing in cognitive networks, where additional constraints are imposed to protect licensed users’ QoS. The focus in this chapter is on concurrent CR networks based on CA MU-MIMO that maximizes the uplink MIMO channel capacity for each cognitive user while controlling the interference levels to licensed users. Two applications of CA MU-MIMO will be explored: cognitive radio-based wireless sensor networks (CR-WSNs) and cognitive small cells in heterogeneous networks (HetNets).

Multiple input multiple output (MIMO) systems have high potential to achieve maximum channel capacity in wireless communication systems. Multi-user (MU) MIMO network with transmit antennas $$T_x$$ at base station can schedule as many single antenna users in one time slot. This necessitates incorporation of a user scheduling strategy. Maximizing sumrate performance without under utilization of channel resources is a primary objective of such scheduling algorithms. Another key design factor for such techniques is to optimize fairness i.e. allowing equal opportunity to all communicating entities. In this paper, we present a simple approach to solve the scheduling problem in MU-MIMO systems while addressing the conflicting objectives of sumrate and fairness. Two variants of the proposed method are also discussed that provide options for maximizing the cumulative sumrate and improving the fairness. Simulations validate the proposed algorithm as a better choice over other conventional methods as it achieves optimal performance with relatively less computational complexity and without compromising fairness. Fairness results are verified by average sumrate method and Jain’s Fariness Index.

Multiple input multiple output (MIMO) processing techniques are of interest for the next generation wireless communication systems due to their potential ability to dramatically improve the system capacity. There have been existed several multi-user MIMO (MU-MIMO) transmit schemes such as zero-forcing dirty paper coding (ZF-DPC), and zero-forcing beamforming (ZFBF). In this paper, we analysis and compare the dynamic transmission schemes based on TDMA and SDMA under perfect and imperfect channel state information (CSI). The system throughput (sum data rate), the optimal user number that can be supported are evaluated under perfect CSI by computer simulations. The effect of imperfect CSI on the throughput of TDMA and SDMA is also investigated. The results show that under perfect channel state information at both transmitter and receiver, the SDMA schemes can achieve a larger throughput than the TDMA scheme because SDMA can fully explore the multiuser diversity by transmitting to the optimal set of users. In contrast, the results show that the system performance of SDMA scheme is sensitive to the channel error.

We consider the problem of joint space-time decoding and multiaccess interference (MAI) rejection in multiuser multiple-input multiple-output (MIMO) wireless communication systems. We address the case when both the receiver and multiple transmitters are equipped with multiple antennas and when space-time block codes (STBCs) are used to send the data simultaneously from each transmitter to the receiver. A new linear receiver structure is developed to decode the data sent from the transmitter-of-interest while rejecting MAI, self-interference, and noise. The proposed receivers are designed by minimizing the output power subject to constraints that zero-force self-interference and/or preserve a unity gain for all symbols of the transmitter-of-interest. Simulation results show that in multiaccess scenarios, the proposed techniques have substantially lower symbol error rates as compared with the matched filter (MF) receiver, which is equivalent to the maximum likelihood (ML) space-time decoder in the point-to-point MIMO communication case.

Wireless communication paradigm has evolved from single-user single-input single-output (SISO) and multiple-input multiple-output (MIMO) systems to multi-user (MU) MIMO counterparts, which are shown greatly improving the rate performance by transmitting to multiple users simultaneously. The sum-capacity and the capacity region of a single-cell MU MIMO downlink system or the so-called MIMO broadcast channel (MIMO-BC) can be attained by the nonlinear “Dirty Paper Coding (DPC)” scheme [1] [2] [3]. However, DPC requires a high implementation complexity due to the non-linear successive encoding/decoding at the transmitter/receiver, and is thus not suitable for real-time applications. Other studies have proposed to use alternative linear precoding schemes for the MIMO-BC, e.g., the block-diagonalization scheme [4], to reduce the complexity. More information on the key developments of single-cell MIMO communication can be found in, for example, [5] [6] [7].

The explosive demand for high data rates and the need ubiquitous wireless connectivity has led to the phenomenon of network densification, the deployment of large number of base station within a geographic area. Since the radio spectrum is limited, wireless transmissions need to share a common resource which results in interference. Interference in turn creates a bottleneck on the communication rate. Recently three breakthroughs have been made to increase the capacity of wireless networks while mitigating interference : multiple input multiple output (MIMO) beamforming, interference alignment (IA) and pattern reconfigurable antennas (PRA). While a great deal of progress has been made on understanding each individually, relatively little is known about how to use these techniques in combination to increase system performance. In this dissertation, we analyze and experimentally evaluate how these new technologies can be leveraged to enhance the rate performance of communication networks. Specifically, we address three problems: i) enhancing multi-user MIMO performance with PRA, ii) improving IA performance with PRA-based antenna selection, and iii) enabling practical blind IA with PRA. To understand the impact PRAs on MU-MIMO and IA, it is necessary to evaluate their performance through measurements. Simulation-based studies often reiterate over set of simplistic channel models and unrealistic assumptions. This dissertation focuses on a measurement-based evaluation approach. For each of these problems, a hardware testbed implementation and measurement methodology is developed for evaluating the performance of the aforementioned technologies through efficient and repeatable experiments. The first two major contributions of this dissertation focus on multi-user MIMO (MU-MIMO) and IA. While the theoretical rate gains of MU-MIMO and IA are substantial, the performance gains in practical systems and measured channels have been limited. One of the key limiting factors are spatially correlated user channels. In this work, we propose MU-MIMO and IA transmission schemes that leverage the pattern diversity provided by PRAs to mitigate the effects of spatial correlation in wireless channels. PRAs are capable of dynamically adjusting their radiation pattern, providing an additional degree of freedom that can be exploited to improve MU-MIMO and IA performance by treating the array configuration and radiation characteristics as additional components in the joint optimization of adaptive system parameters. We quantify the benefits of pattern diversity on the rate performance of MU-MIMO and IA systems through extensive measurements. Furthermore, we develop efficient antenna mode selection algorithms to realize those benefits without increasing the system complexity or overhead, making these techniques suitable for practical implementation. The third contribution of this dissertation focuses on a transmission technique known as blind IA. In contrast to MU-MIMO and conventional IA, blind IA is signaling scheme that suppresses interference in multi-user systems, without the knowledge of channel state information at the transmitter (CSIT). The key to performing IA without CSIT is the use of PRAs that are capable of dynamically switching among a fixed number of radiation patterns to introduce artificial fluctuations in the channel. In this dissertation, we develop a novel implementation of a blind IA system on a software defined radio platform where each of the receivers is equipped with a PRA. Our work provides the first experimental evaluation of PRA-based blind IA schemes and demonstrates significant gains in rate and reliability over traditional orthogonal transmission schemes such as TDMA.

Massive MIMO is a multi-user MIMO (multiple-input multiple output) technology that has the ability to provide uniformly better service to wireless terminals in high-mobility environs. The major concept behind this is to equip base stations with arrays of more antennas that are utilized to serve various terminals simultaneously. The term "massive" refers to the count of antennas and not the physical size. However, deployment of multiple antennas at each node obviously maximizes the hardware cost, system complexity, and transmitter power. Particularly, in MIMO systems, each antenna needs a specific radio frequency chain that rapidly increases the system complexity and is unpleasant since the antenna count increases. Therefore, it is disincentive to employ multiple antennas at all the nodes. As a solution to this, transmit antenna strategy (T AS) is evolved that minimizes system complexity, hardware cost and so on. Still, the problem rises in the selection criteria of transmit antenna. Recently, more research works have been focusing on this issue by offering advanced algorithms or models. Such a way that, this research work concentrates on optimal transmit antenna selection to solve the problems like system complexity, cost, etc. In this paper an improved optimization model is introduced for the optimal selection of antenna. The proposed algorithm is named as Modified Velocity vector-based GSA (MV -GSA), which is the enhanced version of Gravitational Search Algorithm (GSA) that defines the count of antenna. This work goes on with the determination of solving multi-objective problem that increases the capacity and relative Energy Efficiency (EE) as well. At last, this model proved as better performer compared over conventional models, like Artificial Bee Colony (ABC), Genetic Algorithm (GA), Firefly (FF) Particle Swarm Optimization (PSO), and conventional GSA, respectively.

Multiple-input multiple-output (MIMO) transmis- sion techniques improve spectral efficiency and/or error rate of wireless communications link. If the transmitter obtains complete channel knowledge using feedback information, the reduced computational complexity at the receiver can be realized without affecting the desired target performance. However, in practical systems only partial channel state information is available due to limited feedback channel capacity. Especially in a multiuser MIMO system, the finite rate transmission of each user in the uplink is necessary. Thus, in this paper a limited feedback multiuser MIMO scheme is proposed where the receiver sends back a fixed amount of information to the transmitter. Various feedback methods are investigated to minimize performance degradation with low feedback rate. Simulation results show that our proposed scheme outperforms other MIMO candidate solutions in 3GPP HSDPA.

In this paper, we investigate the coexistence of two technologies that have been put forward for the fifth generation (5G) of cellular networks, namely, network-assisted device-to-device (D2D) communications and massive MIMO (multiple-input multiple-output). Potential benefits of both technologies are known individually, but the tradeoffs resulting from their coexistence have not been adequately addressed. To this end, we assume that D2D users reuse the downlink resources of cellular networks in an underlay fashion. In addition, multiple antennas at the BS are used in order to obtain precoding gains and simultaneously support multiple cellular users using multiuser or massive MIMO technique. Two metrics are considered, namely the average sum rate (ASR) and energy efficiency (EE). We derive tractable and directly computable expressions and study the tradeoffs between the ASR and EE as functions of the number of BS antennas, the number of cellular users and the density of D2D users within a given coverage area. Our results show that both the ASR and EE behave differently in scenarios with low and high density of D2D users, and that coexistence of underlay D2D communications and massive MIMO is mainly beneficial in low densities of D2D users.

An adaptive rate optimization solution is presented to utilize the benefits of multiuser multiple-input multiple-output (MU-MIMO) communications in a wireless network with distributed and decentralized control that adapts to dynamic channel, interference, and traffic conditions. First, the ergodic sum rates of MIMO multiple access channel (MAC) and interference channel (IC) configurations are determined by jointly integrating the error and overhead effects due to channel estimation (training) and feedback into the rate optimization. Then, a distributed channel access protocol that leverages local information without any centralized scheduler is developed to select and activate MU-MIMO configurations with the maximum achievable sum rates depending on channel, interference, and traffic conditions. In a mobile ad hoc network (MANET), MU-MIMO is shown to provide major gains in network throughput (after accounting for the control message overhead) compared with single antenna and point-to-point (P2P) MIMO communications.