Machine Learning-Based Routing and Wavelength Assignment in Software-Defined Optical Networks

Adaptive FEC-based lightpath routing and wavelength assignment in WDM optical networks

This paper proposes the optimal design of lightpath Routing and Wavelength Assignment (RWA) problem in Wavelength Division Multiplexing (WDM) networks without wavelength conversion. We formulate RWA as a mixed Integer Linear Programming (ILP) problem where the objective is to minimize the cost of wavelength assignment to the fiber links in the network. The Lagrangean relaxation technique and the optimization-based heuristics are used to solve this problem. Two sets of computational experiments are performed to test the algorithms for the maximum carried traffic and minimum wavelength requirements in three different network topologies (GTE, ARPA, OCT network). Based on solution quality to the computational experiments, the error gaps between the upper bound and the lower bound are close enough that the near optimal solutions could be obtained. On the other hand, we also show that the solution quality degrade gracefully under more and more heavy traffic network environment. By assessing solution quality and the computational time, we propose the efficient and effective optimization-based algorithms based on the Lagrangean relaxation method for the RWA problem in the WDM networks without wavelength conversion.

In this paper, we propose a new ant-based algorithm for the dynamic routing and wavelength assignment (RWA) problem in optical WDM networks under the wavelength continuity constraint. Unlike conventional approaches, which usually require centralized global network information, our new RWA algorithm constructs the routing solution in a distributed manner by means of cooperative ants. To facilitate the ants’ foraging task, we adopt in our algorithm a probabilistic routing table structure for route selection. The new algorithm is highly adaptive in that it always keeps a suitable number of ants in the network to cooperatively explore the network states and continuously update the routing tables, so that the route for a connection request can be determined promptly by the current states of routing tables with only a small setup delay. Some new schemes for path scoring and path searching are also proposed to enhance the performance of our ant-based algorithm. Extensive simulation results upon three typical network topologies indicate that the proposed algorithm has a very good adaptability to traffic variations and it outperforms both the fixed routing algorithm and the promising fixed–alternate routing algorithm in terms of blocking probability. The ability to guarantee both a low blocking probability and a small setup delay makes the new ant-based routing algorithm very attractive for both the optical circuit switching networks and future optical burst switching networks

The method in which Routing and Wavelength Assignment (RWA) of connection requests is performed in optical WDM networks, can appreciably affect resource consumption. The blocking probability for lightpath requests increases significantly with increase in resource consumption. Thus the method of performing RWA should be such that it minimizes consumption of network resources. RWA in all-optical networks is an NP-Complete problem. This paper proposes six new heuristic algorithms for static RWA in all-optical mesh networks that are not only efficient in terms of resource conservation but can also solve the RWA problem effectively in polynomial time. Comparisons show that the proposed algorithms perform better than some earlier well-known strategies.

In optical WDM networks, transmission of information along optical lines is advantageous since it has high transmission capacity, scalability, feasibility and also high reliability. But large amount of information is being carried; any problem during transmission can lead to severe damage to the data being carried. Hence it is essential to consider the routing as well as the wavelength assignment problems and then develop a combined solution for both the problems. In this paper, we propose to develop a routing and wavelength assignment algorithm for selecting the suitable alternate path for the data packets transmission. Two stages are based on the available bandwidth and the number of wavelength used in the link as construction of alternate paths, route and wavelength selection. In proposed work, Adaptive Routing and First-Fit Wavelength Assignment (AR-FFWA) algorithm to be used. For each pair of source and destination, the path with the minimum granularity values are selected as the primary path for data transmission, allocating the sufficient wavelength and the performances will be evaluated by using ns-2 simulation models. When we compared to existing system the overall blocking probability will be reduced to too low.

The widespread deployment of wireless telecommunication networks and growing Internet traffic globally leads to a substantial increase in signal traffic demands in fiber optic networks. This demand surge places significant pressure on the survivability of optical networks, specifically when faced with fiber cable failures that prevent failed optical fibers from satisfying connection requests. To address this challenge, in this paper, we consider integrated planning of regenerator installation, optical connection routing, and wavelength assignment (RWA) for wavelength division multiplexing (WDM) optical networks under link failures. To the best of our knowledge, we are the first to consider such an integrated problem. We minimize the number of backup regenerators required to fulfill all connection requests under all potential link failures while accounting for the wavelength and routing constraints. We formulate the problem as an integer program, while its size exponentially increases with the network size by nature. To solve large-scale instances for practical uses in the industry, we propose efficient algorithms to generate near-optimal solutions that are practically implementable. We perform extensive numerical experiments to demonstrate the effectiveness of our approach in solving real-world instances provided by our industry partners. The results show that our approach can efficiently obtain high-quality solutions while ensuring a minimal increase in backup regenerators as the network grows. Our solutions also offer valuable insights into planning a cost-effective and reliable fiber optic network for network operators.

A routing and wavelength assignment (RWA) algorithm against high-power jamming based on software-defined optical networks (SDONs) is proposed. The SDON architecture is designed with power monitors at each node, which can collect the abnormal power information from each port and wavelength. Based on the abnormal power information, a metric, the weighted attack probability (WAP), can be calculated. A WAP-based RWA algorithm (WAP-RWA) is proposed considering the WAP values of each link and node along the selected lightpath. Numerical results show that the WAP-RWA algorithm can achieve a better performance in terms of blocking probability and resource utilization compared with the attack-aware dedicated path protection (AA-DPP) RWA (AA-DPP-RWA) algorithm, while providing a protection comparable with the AA-DPP-RWA algorithm.

In this paper we consider the routing and wavelength assignment problem in a wavelength routed all optical network. Inspired by techniques from artificial intelligence, in particular the Blocking Island (BI) abstraction, we propose a simple and intelligent routing and wavelength assignment (RWA) algorithm: BI_RWA. This algorithm can be used in arbitrarily connected optical networks. In addition, it is general enough such that with some simple modifications, it can be applied to different optical networking scenarios: static or dynamic traffic, single or multiple fiber links between node pairs, with or without wavelength converters. We have conducted simulation experiments to evaluate the performance of our algorithm. The simulation is carried out in two parts: static traffic and dynamic traffic. The results will demonstrate that our RWA algorithm outperforms state-of-the-art related algorithms.

While a session request is assigned to a wavelength-routed optical WDM networks, which are circuit-switched in nature, the challenge of routing and wavelength assignment (RWA) is to calculate the optimal path between two nodes, and further is to assign an available set of wavelengths along this path. An algorithm called Total wavelengths and Expected available wavelengths (TEW) proposed by Pavarangkoon et. al. in order to achieve effective routing and wavelength assignment formulates a link weight function and considers this as the main factor for route selection. This function is calculated by using a determination factor of the number of wavelengths that are being used currently and are supposed to be available after a certain time. However, this algorithm tends to overload paths with smaller weights and higher utilization while lightly loaded paths with slightly lower capacities may remain unused. In this paper, propose an improvement to the TEW algorithm by incorporating the frequency of usage of the paths in the weight function and running Dijkstra’s shortest path algorithm to choose paths that have more total and expected available wavelengths and less frequency of usage. The proposed algorithm is called as Countered Total wavelengths and Expected available wavelengths (CTEW) algorithm. The impact of the proposed algorithm on blocking probability is investigated by means of computer simulation and by comparing it with TEW algorithm. The results show that the proposed algorithm can achieve better performance in terms of blocking probability.

This paper aims to study the lightpaths provisioning problem in optical WDM networks with scarce available wavelengths under the static (off-line) traffic demands such that network operator’s (NO’s) revenue is maximized. To achieve this goal, a NO has to be addressed with the issue how to solve the call admission control jointly with the lightpaths routing and wavelength assignment (RWA) problem in efficient manner. The improved bee colony optimization (BCOi) metaheuristic is applied to solve the considered revenue maximization (Max-Rev) problem. We evaluated the performances of the proposed BCOi Max-Rev framework by performing numerous simulation experiments in different realistic WDM optical network topologies. We observed that our BCOi Max-Rev algorithm is an efficient tool to produce high quality solutions within reasonable amount of CPU time. It has been proved that BCOi Max-Rev solutions just slightly deviate from optimal solutions (at most 1%) and considerably outperform some heuristic algorithms, such as the Max-Profit and FCFS. In addition, our Max-Rev BCOi algorithm is able to produce better solution quality compared to the constructive BCO approach (up to 3.5% in the case of NSFNet and 5% in the case of EON). Finally, we compared the BCOi to differential evolution (DE) approach in the case of more complex networks, such as the USA optical network topology. The results show that our BCOi always outperforms DE metaheuristic, whereby the profit improvement could reach up to 20 % in some instances.

In the past few decades, the architecture of optical networks has undergone significant evolution, from the earliest wavelength-division multiplexing (WDM) optical networks to elastic optical networks (EONs) and later to space-division multiplexing (SDM) EONs, to address the continuous growth of Internet traffic. By 2024, Pbps-level optical networks are expected, far exceeding the capacity limit of single-mode fibers. The massive SDM era is on the horizon. In this context, a newly designed architecture for optical networks called the spatial channel network (SCN) architecture, which achieves high cost efficiency by means of practical hierarchical optical cross-connects, has recently been proposed. However, the evolution of optical network architectures will simultaneously present challenges related to network optimization. For instance, with the evolution from WDM optical networks to EONs, the kernel network optimization problem was transformed from the routing and wavelength assignment (RWA) problem into the routing and spectrum assignment (RSA) problem due to the additionally introduced constraint of spectrum contiguity. Similarly, specially designed algorithms are also expected to be essential for addressing the network optimization problem in SCNs. In this paper, we define this new problem as the routing, spatial channel, and spectrum assignment (RSCSA) problem. We propose an integer linear programming (ILP) model and a heuristic algorithm to solve the RSCSA problem. We examine the performance of the proposed approaches via simulation experiments. The results show that both proposed approaches are effective in finding the optimal solutions or solutions close to the lower bounds. To the best of our knowledge, this is the first work to focus on the network optimization problem in SCNs.

The Static RWA (Routing and Wavelength Assignment) problem in Optical Networks is a combinatorial optimization problem fit to iterative search methods. In this article we further investigate the static manycast RWA problem in optical networks and solve it using an evolutionary programming (EP) strategy such that the number of the manycast requests established for a given number of wavelengths is maximized. The proposed algorithm solves, approximately, the wavelength assignment problem while a backtracking approach is used to solve the routing issue. We present the details of our proposed algorithm and compare it to another metaheuristic named genetic algorithm (GA). EP shows a 24 % improvement over GA.

Translucent optical networks use sparsely located regenerator nodes to increase the optical reach, otherwise limited by the physical layer impairments. Routing in translucent networks often causes the lightpath to traverse a fiber more than once, requiring the use of multiple wavelengths on a fiber for the same lightpath. Most of the routing and wavelength assignment (RWA) algorithms for static demand in translucent networks (termed static RWA) require loop-free routes for shortest path routing and also are agnostic to traffic load. In this paper, we address the problem of static RWA in translucent networks without using physical layer information and show how to route lightpaths on paths with a loop (i.e., not a simple path). We propose integer linear programming formulation to get the exact solutions to the static RWA problem. This work is the first one to optimally solve the static RWA problem for non-simple paths, providing the lower bound on the number of wavelengths and regeneration needed for static lightpath establishment when regeneration facilities are limited. We propose a heuristic algorithm based on the concept of Wardrop equilibrium, to adaptively equalize the mean delay along all the lightpath routes from source to destination. The proposed heuristic can not only accommodate the correlation between feasible lightpath routes but also account for the fact that alternate routes correspond to different levels of choice randomness. Wavelength assignment is done using graph coloring with branch-and-price method. Numerical results demonstrate that the proposed heuristic reduces the number of regenerators and wavelengths required to satisfy a given demand.

In an all-optical WDM network; optical fibers are used to transmit data followed by WDM technology. An optical fiber carries light along its length path at high rates and with little loss. Several wavelengths on a single fiber can be used to transfer data, when using wavelength-division multiplexing. In this way, several data transmissions at very high speed can take place on a single fiber. The routing and wavelength assignment (RWA) problem consists of finding a path and a wavelength for a set of data connections. The objective is typically to maximize the profit of established data by achieving as much as possible lightpath for transmitting optical signal (max-RWA). The RWA is NP-hard, thus much research has been conducted to finding a good way of approaching the RWA. This work mainly focuses on the analyzes work RWA problem based on integer linear programming (ILP) and reliable heuristics for variant topology of WDM networks. For performance analysis heuristics method as well as others variants of solution for RWA problem also had been implemented which results give some interesting observation about resources as well as optimal solution.

Routing and wavelength assignment vs. EDFA reliability performance in optical backbone networks: An operational cost perspective