• Home
  • Search
  • Modeling and Performance Analysis of Variable Cycle Engine with Ceramic Matrix Composite Turbine Blades
  • Cite Icon4
  • https://doi.org/10.3390/aerospace11110886Copy DOI Icon

Modeling and Performance Analysis of Variable Cycle Engine with Ceramic Matrix Composite Turbine Blades

Show More
  • Abstract
  • Literature Map
  • References
  • Citations
  • Similar Papers
Abstract

To meet the requirements of future aircraft for power systems, the turbine inlet temperatures of aero engines are gradually increasing. Ceramic matrix composite (CMC), with its higher thermal limit, has become the preferred material for the turbine blades of variable cycle engines (VCEs). However, the impact of CMC turbine blades on the performance of a VCE is still unknown. In this research project, the comprehensive cooling-efficiency characteristics of CMC are determined through a fluid–solid coupling calculation; a cooling calculation model for turbine blades is established, and cooling airflow solution and control technology (CSCT) for an air system is developed. Additionally, a VCE simulation model is established to analyze the influence of CMC turbine blades on the cooling airflow of the air system and the overall performance of the engine. The results show that, for the design condition, the CMC turbine blade can reduce the cooling airflow of the air system by approximately 10%, and the net thrust is increased by 6.07–7.98%. For the off-design conditions, with the CSCT, the specific fuel consumption can be reduced by 3.06–5.73% while ensuring that the engine net thrust remains unchanged. A comprehensive analysis of the performance for both the design point and off-design points indicates that the use of CMC for high-pressure turbine (HPT) guide vanes and rotor blades yields significant performance benefits, while the performance improvement from the use of CMC for low-pressure turbine (LPT) rotor blades is minimal.

Similar Papers
  • Research Article
  • Citations24

Aerodynamic design of the high pressure and low pressure axial turbines for the improved coal-fired recompression SCO2 reheated Brayton cycle

  • May 08, 2019
  • Energy
  • Wanlong Han +7
  • Research Article
  • Citations20

Material Selection for High Pressure (HP) Turbine Blade of Conventional Turbojet Engines

  • Jun 23, 2016
  • American Journal of Mechanical and Industrial Engineering
  • Ikpe Aniekan Essienubong +3
  • Research Article

Numerical and Experimental Analysis of the Tip Leakage Flow in a Squealer Low-Pressure Turbine Blade for Different Operating Conditions

  • Sep 12, 2025
  • Journal of Turbomachinery
  • Daniele Petronio +8
  • Single Report

Enabling Technologies for Ceramic Hot Section Components

  • Apr 30, 2009
  • Venkat Vedula +1
  • Research Article

Computational performance of a-100 kW low pressure turbine to recover gas turbine exhaust energy

  • Jun 28, 2019
  • Journal of Mechanical Engineering and Sciences
  • A A Ahmad Zahidin +2
  • Conference Article
  • Citations3

Unsteady and Calming Effects Investigation on a Very High Lift LP Turbine Blade: Part I — Experimental Analysis

  • Jan 01, 2002
  • Thomas Coton +3
  • Research Article
  • Citations9

Detection of Blade Mistuning in a Low Pressure Turbine Rotor Resulting from Manufacturing Tolerances and Differences in Blade Mounting

  • May 28, 2015
  • Journal of Mechanics Engineering and Automation
  • Florian Schönleitner +3
  • Research Article
  • Citations7

The Interaction of Main Stream Flow and Cavity Flows in Turbine Center Frames and Turbine Vane Frames

  • Dec 05, 2022
  • Journal of Engineering for Gas Turbines and Power
  • Filippo Merli +6
  • Book Chapter
  • Citations2

CMC Combustor Liner Design for a Model Ram Jet Engine

  • Mar 26, 2008
  • Tetsuya Morimoto +6
  • Research Article
  • Citations1

The Influence of Upstream Flow Angle Variation on Intermediate Turbine Duct

  • Oct 01, 2014
  • Applied Mechanics and Materials
  • Yang Wang
  • Research Article
  • Citations127

Analysis of DNS and LES of Flow in a Low Pressure Turbine Cascade with Incoming Wakes and Comparison with Experiments

  • Dec 01, 2002
  • Flow, Turbulence and Combustion
  • Vittorio Michelassi +2
  • Conference Article
  • Citations6

Unsteady Flow Interactions Between a High- and Low-Pressure Turbine: Part 2 — Rotor-Synchronic Averaging and Proper Orthogonal Decomposition of the Unsteady Flow Fields

  • Jun 17, 2019
  • M Dellacasagrande +8
  • Conference Article
  • Citations1

The Influence of Mach Number on the Boundary Layer Development of High-Lift Low Pressure Turbine in Low Reynolds Number

  • Sep 21, 2020
  • Wenhua Duan +2
  • Research Article
  • Citations11

Condition assessment of gas turbine blades and coatings

  • Jun 24, 2011
  • Engineering Failure Analysis
  • R Rajendran +3
  • Conference Article
  • Citations3

Experimental Investigation of Two Competitive High Pressure Turbine Blade Cooling Systems

  • Jun 26, 2017
  • Sergiy Risnyk +3
Cactus Communications logo

Copyright 2026 Cactus Communications. All rights reserved.