• Home
  • Search
  • MODULAR CAUSTIC SIDE SOLVENT EXTRACTION UNIT (MCU) GAMMA MONITORS SYSTEM FINAL REPORT
  • Open Access IconOpen Access
  • https://doi.org/10.2172/890139Copy DOI Icon

MODULAR CAUSTIC SIDE SOLVENT EXTRACTION UNIT (MCU) GAMMA MONITORS SYSTEM FINAL REPORT

  • Dec 15, 2005
  • V Casella
Show More
  • Abstract
  • Literature Map
  • References
  • Similar Papers
Abstract

The Department of Energy (DOE) selected Caustic-Side Solvent Extraction (CSSX) as the preferred technology for the removal of radioactive cesium from High-Level Waste (HLW) at the Savannah River Site (SRS). Before the full-scale Salt Waste Processing Facility (SWPF) becomes operational, the Closure Business Unit (CBU) plans to process a portion of dissolved saltcake waste through a Modular CSSX Unit (MCU). This work was derived from Technical Task Request SP-TTR-2004-00013, ''Gamma Monitor for MCU''. The deliverables for this task are the hardware and software for the gamma monitors and a report summarizing the testing and acceptance of this equipment for use in the MCU. Gamma-ray monitors are required to: (1) Measure the Cs-137 concentration in the decontaminated salt solution before entering the DSS (Decontaminated Salt Solution) Hold Tank, (2) Measure the Cs-137 concentration in the strip effluent before entering the Strip Effluent Hold Tank, (3) Verify proper operation of the solvent extraction system by verifying material balance within the process (The DSS Hold Tank Cs-137 concentration will be very low and the Cs-137 concentration in the Strip Effluent Hold Tank will be fifteen times higher than the Cs-137 concentration in the Feed Tank.) Sodium iodide monitors are used to measure the Cs-137 concentration in the piping before the DSS Hold tank, while GM monitors are used for Cs-137 measurements before the Strip Effluent Hold Tank. Tungsten shields were designed using Monte Carlo calculations and fabricated to reduce the process background radiation at the detector positions. These monitors were calibrated with NIST traceable standards that were specially made to be the same as the piping being monitored. Since this gamma ray monitoring system is unique, specially designed software was written and acceptance tested by Savannah River National Laboratory personnel. The software is a LabView-based application that serves as a unified interface for controlling the monitor hardware and communicating with the host Distributed Control System (DCS). In order to provide user friendly software for the process personnel, the software was broken down into just a few software modules. These software modules are the Application Window, Detector Selection, Detector Configuration Settings, Background Counting, and Routine Data Acquisition. Instructions for using the software have been included in a user's manual that is appended to this report. The work presented in this report meets all of the requirements set forth in the project task plan to design and implement gamma ray monitors for the MCU. Additional setup and testing of the system will be required when it implemented in the process.

Similar Papers
  • Single Report
  • Citations2

DETERMINATION OF LIQUID FILM THICKNESS FOLLOWING DRAINING OF CONTACTORS, VESSELS, AND PIPES IN THE MCU PROCESS

  • Jun 06, 2006
  • M Poirier +2
  • Single Report
  • Citations4

RESULTS OF ROUTINE STRIP EFFLUENT HOLD TANK AND DECONTAMINATED SALT SOLUTION HOLD TANK SAMPLES FROM MODULAR CAUSTIC-SIDE SOLVENT EXTRACTION UNIT DURING MACROBATCH 3 OPERATIONS

  • Jun 10, 2011
  • T Peters +1
  • Single Report
  • Citations1

RESULTS OF ROUTINE STRIP EFFLUENT HOLD TANK AND DECONTAMINATED SALT SOLUTION HOLD TANK SAMPLES FROM MODULAR CAUSTIC-SIDE SOLVENT EXTRACTION UNIT DURING MACROBATCH 3 OPERATIONS

  • Jul 15, 2011
  • T Peters +1
  • Single Report

Analytical Results from Salt Batch 10 Routine DSSHT and SEHT Monthly Samples

  • Oct 01, 2019
  • Thomas Peters
  • Single Report

Extraction, Scrub, and Strip Test Results from The Interim Salt Disposition Program Macrobatch 11 Tank 21H Qualification Samples

  • Feb 11, 2019
  • T Peters
  • Single Report
  • Citations1

Results from the Second MCU Flush DSSHT Sample

  • Jul 07, 2021
  • Thomas Peters
  • Single Report
  • Citations20

HEAT OF HYDRATION OF SALTSTONE MIXES-MEASUREMENT BY ISOTHERMAL CALORIMETRY

  • Jul 02, 2007
  • J Harbour +2
  • Single Report
  • Citations8

Next Generation Solvent (NGS): Development for Caustic-Side Solvent Extraction of Cesium

  • Mar 01, 2014
  • Bruce A Moyer +14
  • Single Report
  • Citations22

SALTSTONE VARIABILITY STUDY - MEASUREMENT OF POROSITY

  • Aug 23, 2007
  • J Harbour +4
  • Single Report
  • Citations3

MEASUREMENT OF SPECIFIC HEAT CAPACITY OF SALTSTONE

  • Sep 29, 2008
  • J Harbour +1
  • Single Report
  • Citations1

NEXT GENERATION SOLVENT MATERIALS COMPATIBILITY WITH POLYMER COMPONENTS WITHIN MODULAR CAUSTIC-SIDE SOLVENT EXTRACTION UNIT

  • Sep 29, 2011
  • F Fondeur +2
  • Single Report
  • Citations1

Analytical Results from final Salt Batch 9 Routine DSSHT and SEHT Monthly Samples

  • Mar 28, 2018
  • T Peters
  • Single Report

SALTSTONE 2QCY10 TCLP RESULTS

  • Oct 05, 2010
  • M Reigel
  • Single Report

SALTSTONE 2QCY08 TCLP RESULTS

  • Mar 23, 2009
  • A Cozzi
  • Single Report
  • Citations4

SALTSTONE 3QCY09 TCLP RESULTS

  • Jan 13, 2010
  • M Reigel
Cactus Communications logo

Copyright 2026 Cactus Communications. All rights reserved.