- Book Chapter
136
- 10.1190/1.9781560802785.ch5
5. The Self-Potential Method for Environmental and Engineering Applications
- Jan 01, 1990
- Robert F Corwin
The major environmental and engineering applications of the self-potential method have been investigations of subsurface water movement. Specific uses have included mapping of seepage flow associated with dams, dikes, reservoir floors, and other containment structures; studies of general groundwater movement; and delineation of flow patterns in the vicinity of landslides, wells, faults, drainage structures, shafts, tunnels, and sinkholes. The method also has been used to a lesser extent for subsurface thermal investigations such as mapping of steam flood fronts and coal mine fires, and preliminary studies indicate that it could be used to help delineate chemical concentration gradients associated with subsurface contaminants. Self-potential anomaly amplitudes generated by such environmental and engineering sources tend to be lower than those seen in mineral and geothermal exploration, and spurious anomalies associated with the presence of man-made structures at most field sites often create very high noise levels. Therefore extreme care in the acquisition and reduction of field data, and recognition of characteristic fields associated with artificial and natural noise sources, are critical to the success of environmental self-potential investigations. Interpretation of self-potential data often is qualitative, using visual correlation between observed profile or contour patterns and known or suspected seepage flow paths or other sources. The use of available geometric source models, including charged points, lines, spheres, cylinders, and sheets, can provide useful first estimates of source depth and configuration. Computer programs based on analytical modeling techniques can be used to calculate self-potentials generated by subsurface gradients of pressure, temperature, or chemical concentration. If in-situ physical property parameters such as cross-coupling coefficients and hydraulic, thermal, and electrical conductivity are known or can be reasonably estimated, these techniques can provide useful information about the nature, location, and strength of self-potential sources.
Read more