• Home
  • Search
  • Numerical Study of Slope Stabilization Using Recycled Plastic Pin
  • Cite Icon12
  • https://doi.org/10.1061/9780784413272.301Copy DOI Icon

Numerical Study of Slope Stabilization Using Recycled Plastic Pin

  • Feb 24, 2014
  • Mohammad Sadik Khan +2 more
Show More
  • Abstract
  • Literature Map
  • Citations
  • Similar Papers
Abstract

Moderate (3H : 1V) to steep (2.5H : 1V) slopes and embankments underlain by expansive clayey soils are susceptible to shallow land sliding during intense and prolonged rainfall events. These failures are predominant in the North Texas area and cause significant maintenance problems for the Texas Department of Transportation (TxDOT). The recycled plastic pin (RPP) has potential to be utilized in slope stabilization as a remedial measure of shallow slope failure. A parametric study was conducted to evaluate the effect of different spacings of RPP on the factor of safety and deformation of the slope. The objective of the current study was to investigate the effect of spacing and length of RPP over the factor of safety using the finite element method (FEM). The analysis was conducted using 2D FEM software package PLAXIS 2D, and factor of safety of the slope was determined using the strength reduction technique. A highway slope constructed using high plastic clayey soil, located over US 287 near St. Paul overpass in Midlothian, Texas, was selected as the reference slope. The strength of the slope was back analyzed using PLAXIS 2D at factor of safety equals to unity. As a remediation technique, RPP was selected for slope stabilization, and the slope was analyzed with different lengths (2.44 m to 3.65 m, 8 ft to 12 ft) and spacings (0.61 m c/c to 2.44 m c/c, 3 ft c/c to 8 ft c/c) of RPP. The FEM results indicated that RPP provided resistance against the shallow failure and resulted increment in factor of safety by shifting the failure plane to a deeper depth toward deep-seated failure. In addition, the factor of safety increased with the increment in RPP length as higher resistance was observed from the foundation soil. The factor of safety of the reinforced slope remained almost constant up to RPP spacing of 1.5 m (5 ft) c/c and then decreased with further increments in spacing. The horizontal deformation of the slope was greater with the increments in spacing of RPP.

Similar Papers
  • Conference Article
  • Citations10

Comparative Analysis of Slope Stability using Finite Element Method (FEM) and Limit Equilibrium Method (LEM)

  • Aug 05, 2023
  • Noraida Mohd Saim +1
  • PDF
  • Research Article
  • Citations12

Slope Stability Evaluation Due to Reservoir Draw-Down Using LEM and Stress-Based FEM along with Mohr–Coulomb Criteria

  • Nov 20, 2023
  • Water
  • Binaya Raj Pandey +2
  • Research Article
  • Citations17

Stability analysis of an unsaturated expansive soil slope subjected to rainfall infiltration

  • Jan 01, 2019
  • Geomechanics and Engineering
  • Suitao Qi +4
  • Research Article

Coupling of the finite element limit equilibrium method with the stochastic search algorithm and its application for an embankment dam.

  • May 09, 2026
  • Scientific reports
  • Juraj Ŝtetiar +1
  • Research Article
  • Citations1

Two-dimensional dynamic analysis of seismic slope stability using DEM coupling with strength reduction technique

  • Sep 01, 2019
  • IOP Conference Series: Earth and Environmental Science
  • Weidong Wu +4
  • PDF
  • Research Article
  • Citations53

Study on the influence of slope height and angle on the factor of safety and shape of failure of slopes based on strength reduction method of analysis

  • May 07, 2021
  • Beni-Suef University Journal of Basic and Applied Sciences
  • Henok Marie Shiferaw
  • PDF
  • Research Article
  • Citations11

Analysis of conventional and helical soil nails using finite element method and limit equilibrium method

  • Nov 01, 2022
  • Heliyon
  • Archita Goyal +1
  • Dissertation

Evaluating slope stability using regional water balance analysis

  • Jan 01, 2024
  • Saranya Rangarajan
  • Dissertation
  • Citations7

Soil and Slope Stability Study of Geomorphic Landform Profiles versus Approximate Original Contour for Valley Fill Designs

  • Jan 01, 2012
  • Harold Russell
  • Research Article

Seismic Stability Analysis of Slopes using Limit Equilibrium and Finite Element Method

  • Dec 30, 2025
  • Knowledge-Based Engineering and Sciences
  • Izzeldeen Alhashlamoun +3
  • PDF
  • Research Article
  • Citations6

Slip Line Theory Based Stability Analysis on the Influence of Deep Excavation on Adjacent Slope

  • Jun 24, 2018
  • Mathematical Problems in Engineering
  • Aizhao Zhou +5
  • Research Article
  • Citations3

Optimizing design and stability of open pit slopes in Tolay coal mine, Ethiopia

  • Jan 10, 2025
  • Scientific Reports
  • Eyerusalem Alemayehu +4
  • Research Article
  • Citations45

Comparison study between traditional and finite element methods for slopes under heavy rainfall

  • Feb 20, 2014
  • HBRC Journal
  • M Rabie
  • Research Article
  • Citations22

Application of Limit Equilibrium Analysis and Numerical Modeling in a Case of Slope Instability

  • Oct 26, 2020
  • Sustainability
  • Fhatuwani Sengani +1
  • Research Article
  • Citations132

Slope stability and vegetation: Conceptual and numerical investigation of mechanical effects

  • Nov 22, 2015
  • Ecological Engineering
  • Nomessi Kuma Kokutse +2
Cactus Communications logo

Copyright 2026 Cactus Communications. All rights reserved.