Ontogeny of plants under various gravity condition.

T-Consciousness Fields (TCFs) are introduced as non-physical entities, with their effects initiated through the human mind. It is hypothesized that information transmitted via TCFs may influence the behavior of studied subjects. The present experiment aimed to investigate the effects of TCFs on cell cycle progression and ATP production in the HEK-293 cell line under both microgravity (MG) and Earth gravity (1G) conditions. To achieve this, cultured cells were exposed to TCFs for 24 hours following an initial 24-hour incubation period, under either microgravity (MG) conditions, simulated by clinostat rotation, or a standard Earth gravity (1G) environment. Untreated cells served as the control group. Flow cytometry was used to assess the distribution of cells across different phases of the cell cycle, and ATP concentration was measured by evaluating luciferase enzyme activity. The results showed a significant increase in the sub-G1 phase under microgravity (MG) conditions (p < 0.05), indicating elevated apoptosis. In contrast, TCFs-treated samples maintained sub-G1 levels comparable to those under Earth gravity (1G). Additionally, TCFs treatment significantly increased the S phase under MG (p < 0.05) and the G2 phase under 1G (p < 0.05). ATP concentrations were markedly reduced under MG in both treated and untreated samples compared to 1G (p < 0.05). However, in the clinostat environment, ATP levels in TCFs-treated samples were approximately twice as high as those in untreated controls (p < 0.05), whereas no significant difference was observed under 1G conditions. These findings suggest that the reduced sub-G1 phase in TCFs-treated samples under MG reflects apoptosis inhibition, while increased ATP levels and prolonged S phase indicate enhanced cellular efficiency under stress. The distinct outcomes under MG and 1G imply that the information transmitted by TCFs may vary depending on environmental conditions. Further studies are needed to elucidate the underlying mechanisms of TCF action.

Numerical estimation of droplet motion on linear wettability gradient surface in microgravity environment

BackgroundThe availability of potassium is one of the main environmental factors for modifying the plasticity of root architecture. Many potassium channels and transporters are involved in regulating primary root growth in response to low potassium stress. NRT1.5/NPF7.3 transporter is a NO3−/H+ and K+/H+ cotransporter, and participates in NO3− and K+ translocation from the roots to the shoots. However, the underlying mechanism of NRT1.5-regulated primary root growth under low potassium stress is unclear.ResultsWe show that NRT1.5/NPF7.3 inhibited primary root growth under low potassium conditions by regulating the accumulation of PIN2 protein and auxin levels. Under low potassium conditions, the mutants nrt1.5 and lks2 exhibited longer primary roots, longer meristem regions and elongation zones of primary roots, and more cell activity in the meristem region compared to WT plants, revealing the involvement of NRT1.5 in LK (low potassium)-inhibition primary root growth. In addition, exogenous auxin (IAA), auxin analogue (NAA, 2.4-D) or auxin precursor (IBA) promoted the primary root growth of WT and the complementation line NRT1.5 COM plants. In addition, the application of NPA inhibited the primary root growth of the nrt1.5 and lks2 mutants. Auxin accumulation was higher in the root tip of nrt1.5 plants than in WT plants, indicating that NRT1.5 regulates root growth inhibition by regulating auxin distribution. Furthermore, PIN2 was degraded more quickly in nrt1.5 plants under LK stress.ConclusionsOur findings reveal that NRT1.5 inhibits primary root growth by modulating the auxin level in the root tip via the degradation of PIN2.

BackgroundArabidopsis thaliana primary root growth has become a model for evo-devo studies due to its simplicity and facility to record cell proliferation and differentiation. To identify new genetic components relevant to primary root growth, we used a Genome-Wide Association Studies (GWAS) meta-analysis approach using data published in the last decade. In this work, we performed intra and inter-studies analyses to discover new genetic components that could participate in primary root growth.Methods and resultsWe used 639 accessions from nine different studies under control conditions and performed different GWAS tests. We found that primary root growth changes were associated with 41 genes, of which six (14.6%) have been previously described as inhibitors or promoters of primary root growth. The knockdown lines of two genes, Suppressor of Gene Silencing (SGS3), involved in tasiRNA processing, and a gene with a Sterile Alpha Motif (SAM) motif named NOJOCH MOOTS (NOJO), confirmed their role as repressors of primary root growth, none has been shown to participate in this developmental process before.ConclusionsIn summary, our GWAS analysis of different available studies identified new genes that participate in primary root growth; two of them were identified as repressors of primary root growth.

Nitrogen is an essential soil nutrient for plants, and lack of nitrogen commonly limits plant growth. Soil nitrogen is typically available to plants in two inorganic forms: nitrate and ammonium. To better understand how nitrate and ammonium differentially affect plant metabolism and development, we performed transcriptional profiling of the shoots of ammonium-supplied and nitrate-supplied Arabidopsis (Arabidopsis thaliana) plants. Seven genes encoding class III glutaredoxins were found to be strongly and specifically induced by nitrate. RNA silencing of four of these glutaredoxin genes (AtGRXS3/4/5/8) resulted in plants with increased primary root length (approximately 25% longer than the wild type) and decreased sensitivity to nitrate-mediated inhibition of primary root growth. Increased primary root growth is also a well-characterized phenotype of many cytokinin-deficient plant lines. We determined that nitrate induction of glutaredoxin gene expression was dependent upon cytokinin signaling and that cytokinins could activate glutaredoxin gene expression independent of plant nitrate status. In addition, crosses between "long-root" cytokinin-deficient plants and "long-root" glutaredoxin-silenced plants generated hybrids that displayed no further increase in primary root length (i.e. epistasis). Collectively, these findings suggest that AtGRXS3/4/5/8 operate downstream of cytokinins in a signal transduction pathway that negatively regulates plant primary root growth in response to nitrate. This pathway could allow Arabidopsis to actively discriminate between different nitrogen sources in the soil, with the preferred nitrogen source, nitrate, acting to suppress primary root growth (vertical dimension) in concert with its well-characterized stimulatory effect on lateral root growth (horizontal dimension).

Flammability limit of thin flame retardant materials in microgravity environments

Sucrose mediates moderate salinity-promoted primary root growth in rapeseed.

Experimental testing of mini heat pipes under microgravity conditions aboard a suborbital rocket

Microgravity (MG) during space flight has been known to cause adverse effect on bone quality. Data collected from studies done on spaceflights show loss of 1–1.6% bone mineral density (BMD) per space-flight-month[1]. Most BMD has been recorded in load-bearing bones [2]. Some studies has considered using drugs and different growth factors to maintain bone mass in microgravity conditions but it can be too expensive to maintain over longer periods of time besides the systematic effects of such treatments [3]. Considering the effects of microgravity are partially attributed to lack of mechanical force on bone tissue, which alters gene expression, reduction in transcription factors and growth factors. Furthermore, lack of gravity effects cell growth, proliferation, differentiation, cytoskeleton polymerization and cellular morphology [4, 5]. Thus to reverse these adverse effects on bone physiology, it is important to provide cells with mechanical stimulus which can provide essential mechanical signal for cells to counter the effects of microgravity. Ultrasound acoustic vibrations can be readily applied in, in vivo and human studies and has shown anabolic effects on osteopenic bone tissue [6]. Furthermore, ultrasound is a non-invasive and more target specific treatment relative to cyclic strain and vibration. The objective of this study is to see effects of low intensity pulsed ultrasound (LIPUS) on disused bone model and osteogenic activity of osteoblast cells cultures in simulated microgravity. This will help us understand that effects of ultrasound on microgravity and mechanotransduction pathway responsible for anabolic effect on bone cells.

Boiling heat transfer and bubble dynamics in microgravity

Morphological root plasticity optimizes nutrient and water uptake by plants and is a promising target to improve tolerance to metal toxicity. Exposure to sublethal chromate [Cr(VI)] concentrations inhibits root growth, decreases photosynthesis and compromises plant development and productivity. Despite the increasing environmental problem that Cr(VI) represents, to date, the Cr tolerance mechanisms of plants are not well understood, and it remains to be investigated whether root architecture remodelling is important for plant adaptation to Cr(VI) stress. In this report, we analysed the growth response of Arabidopsis thaliana seedlings to concentrations of Cr(VI) that strongly repress primary and lateral root growth. Interestingly, adventitious roots started developing, branched and allowed seedlings to grow under highly growth-repressing Cr(VI) concentrations. Cr(VI) negatively regulates auxin transport and response gene expression in the primary root tip, as evidenced by decreased expression of auxin-related reporters DR5::GFP, DR5::uidA and PIN1::PIN1::GFP, and then, another auxin maximum is established at the site of adventitious root initiation that drives adventitious root organogenesis. Both primary root growth inhibition and adventitious root formation induced by high Cr(VI) levels are blocked by a gain-of-function mutation in the SOLITARY-ROOT/IAA14 gene of Arabidopsis. These data provide evidence that suggests a critical role for auxin transport and signalling via IAA14/SLR1 in the developmental program linking Cr(VI) to root architecture remodelling.

The morphometry of the root system, the meristematic activity and the level of indole-3-acetic acid (IAA), abscisic acid (ABA) and zeatin in the primary root tips of rapeseed seedlings were analyzed as functions of time on a slowly rotating clinostat (1 rpm) or in the vertical controls (1 rpm). The fresh weight of the root system was 30% higher throughout the growth period (25 days) in clinorotated seedlings. Morphometric analysis showed that the increase in biomass on the clinostat was due to greater primary root growth, earlier initiation and greater elongation of the secondary roots, which could be observed even in 5-day-old seedlings. However, after 15 days, the growth of the primary root slowed on the clinostat, whereas secondary roots still grew faster in clinorotated plants than in the controls. At this time, the secondary roots began to be initiated closer to the root tip on the clinostat than in the control. Analysis of the meristematic activity and determination of the levels in IAA, ABA and zeatin in the primary root tips demonstrated that after 5 days on the clinostat, the increased length of the primary root could be the consequence of higher meristematic activity and coincided with an increase in both IAA and ABA concentrations. After 15 days on the clinostat, a marked increase in IAA, ABA and zeatin, which probably reached supraoptimal levels, seems to cause a progressive disturbance of the meristematic cells, during a decrease of primary root growth between 15 and 25 days. These modifications in the hormonal balance and the perturbation of the meristematic activity on the clinostat were followed by a loss of apical dominance, which was responsible for the early initiation of secondary roots, the greater elongation of the root system and the emergence of the lateral roots near the tip of the primary root.

The primary root is the basic component of root systems, initiates during embryogenesis and develops shortly after germination, and plays a key role in early seedling growth and survival. The phytohormone ethylene shows significant inhibition of the growth of primary roots. Recent findings have revealed that the inhibition of ethylene in primary root elongation is mediated via interactions with phytohormones, such as auxin, abscisic acid, gibberellin, cytokinins, jasmonic acid, and brassinosteroids. Considering that Arabidopsis and rice are the model plants of dicots and monocots, as well as the fact that hormonal crosstalk in primary root growth has been extensively investigated in Arabidopsis and rice, a better understanding of the mechanisms in Arabidopsis and rice will increase potential applications in other species. Therefore, we focus our interest on the emerging studies in the research of ethylene and hormone crosstalk in primary root development in Arabidopsis and rice.

Arabidopsis 14-3-3 proteins are a family of conserved proteins that interact with numerous partner proteins in a phospho-specific manner, and can affect the target proteins in a number of ways; e.g. modification of enzymatic activity. We isolated T-DNA insertion lines in six 14-3-3 genes within the non-epsilon group that phylogenetically group in three closely related gene pairs. In total, 6 single, 3 double, 12 triple, and 3 quadruple mutants were generated. The mutants were phenotyped for primary root growth on control plates: single and double mutants were indistinguishable from WT, whereas six triples and all quadruples showed a shorter primary root. In addition, length of the first epidermal cell with a visible root hair bulge (LEH) was used to determine primary root elongation on medium containing mannitol and 1-aminocyclopropane-1-carboxylic acid (ACC). This analysis showed clear differences depending on the stress and 14-3-3 gene combinations. Next to the phenotypic growth analyses, a 14-3-3 pull-down assay on roots treated with and without mannitol showed that mannitol stress strongly affects the 14-3-3 interactome. In conclusion, we show gene specificity and functional redundancy among 14-3-3 proteins in primary root elongation under control and under abiotic stress conditions and changes in the 14-3-3 interactome during the onset of stress adaptation.

3D printing is one of the key technologies in space exploration. The disparity in gravitational forces between Earth and space presents both challenges and opportunities with regard to material handling. This article examines the potential of employing ultrasonic levitation as a handling tool for substrate-free additive manufacturing processes in microgravity environments. Through preliminary experiments, we demonstrate the feasibility of manipulating polymer powders using acoustic fields while concurrently melting the levitated material. Subsequent experiments conducted in our drop tower facility confirm our ability to manipulate particles with acoustic traps under microgravity conditions. Building upon these findings, we outline plans to further advance our research using an expanded acoustic levitation system capable of three-dimensional object manipulation. Our objectives include moving and orienting large components beyond the wavelength limit in microgravity, manipulating granular raw material while melting it in proximity to the print part, and achieving a semi-continuous fusion of print material with the print part. Therefore, we present an intelligent control strategy based on the results of a digital twin simulation. Furthermore, we utilize a stereo camera combined with computer vision as feedback for the control system to ensure precise handling of the manipulated objects and particles. This study represents a significant advance toward the realization of efficient substrate-free additive manufacturing processes in microgravity environments, with potential applications for in-space manufacturing. Ultimately, this could result in long-term space missions becoming less reliant on supply deliveries, thus reducing cost and additionally enabling faster response to unforeseen issues.