Optimal resource management for multi-access edge computing without using cross-layer communication

Optimizing the energy consumption of an MEC (Multi-Access Edge Computing) system is a crucial challenge for operation cost reduction and environmental conservation. In this paper, we address an MECS (MEC Server) sleep control problem that aims to reduce the energy consumption of the system while providing users with a reasonable service delay by adjusting the number of active MECSs according to the load imposed on the system. To tackle the problem, we identify two crucial issues that influence the design of an effective sleep control technique and propose methods to address each of these issues. The first issue is accurately predicting the system load. Changes in system load are spatio-temporally correlated among MECSs. By leveraging such correlation information with STGCN (Spatio-Temporal Graph Convolutional Network), we enhance the prediction accuracy of task arrival rates for each MECS. The second issue is rapidly selecting MECSs to sleep when the load distribution over an MEC system is given. The problem of choosing sleep MECS is a combinatorial optimization problem with high time complexity. To address the issue, we employ a genetic algorithm and quickly determine the optimal sleep MECS with the predicted load information for each MECS. Through simulation studies, we verify that compared to the LSTM (Long Short-Term Memory)-based method, our method increases the energy efficiency of an MEC system while providing a compatible service delay.

Multi-access edge computing (MEC) has emerged as a promising technology to facilitate efficient vehicular applications, such as autonomous driving, path planning and navigation. By offloading tasks from vehicles to MEC servers (MECSs), the MEC system can facilitate computation-intensive applications with hard latency constraints in vehicles with limited computing resources. However, owing to the mobility of vehicles, the vehicles are not evenly distributed across the MEC system. Therefore, some MECSs are heavily congested, whereas others are lightly loaded. If a task is offloaded to a congested MECS, it can be blocked or have high latency. Moreover, service interruption would occur because of the high mobility and limited coverage of the MECS. In this paper, we assume that the task can be divided into a set of subtasks and computed by multiple MECSs in parallel. Therefore, we propose a method of task migration with partitioning. To balance loads, the MEC system migrates the set of subtasks of tasks in an overloaded MECS to one or more underloaded MECSs according to the load difference. Simulations have indicated that, compared with conventional methods, the proposed method can increase the satisfaction of quality-of-service requirements, such as low latency, service reliability, and MEC system throughput by optimizing load balancing and task partitioning.

Accelerating the development of the 5G network and Internet of Things (IoT) application, multi-access edge computing (MEC) in a small-cell network (SCN) is designed to provide computation-intensive and latency-sensitive applications through task offloading. However, without collaboration, the resources of a single MEC server are wasted or sometimes overloaded for different service requests and applications; therefore, it increases the user’s task failure rate and task duration. Meanwhile, the distinct MEC server has faced some challenges to determine where the offloaded task will be processed because the system can hardly predict the demand of end-users in advance. As a result, the quality-of-service (QoS) will be deteriorated because of service interruptions, long execution, and waiting time. To improve the QoS, we propose a novel Fuzzy logic-based collaborative task offloading (FCTO) scheme in MEC-enabled densely deployed small-cell networks. In FCTO, the delay sensitivity of the QoS is considered as the Fuzzy input parameter to make a decision where to offload the task is beneficial. The key is to share computation resources with each other and among MEC servers by using fuzzy-logic approach to select a target MEC server for task offloading. As a result, it can accommodate more computation workload in the MEC system and reduce reliance on the remote cloud. The simulation result of the proposed scheme show that our proposed system provides the best performances in all scenarios with different criteria compared with other baseline algorithms in terms of the average task failure rate, task completion time, and server utilization.

In multi-access edge computing (MEC) systems, there are several local cache servers caching contents to satisfy the users’ requests, instead of letting the users download via the remote cloud server. In this paper, a content scheduling problem (CSP) in MEC systems is considered. Taking into account jointly the freshness of the cached contents and the traffic data costs, we study how to schedule content updates along time in a multi-cell setting. Different from single-cell scenarios, a user may have multiple candidate cache servers, and thus all cells and their caching decisions must be jointly taken. We first prove that CSP is $\mathcal{N}\mathcal{P}$-hard, then we formulate CSP using integer linear programming. For problem solving, via a mathematical reformulation, we derive a column generation algorithm embedded into a rounding scheme. Our performance evaluation demonstrates that the solutions obtained are within 0.8% from global optimality.

A game incentive mechanism for energy efficient federated learning in computing power networks

Various real-time, latency-sensitive, and high-speed mobile applications are evolving as 5G applications. These applications are realized using Multi-access Edge Computing (MEC) and Network Function Virtualization (NFV) technologies in the 5G system. MEC platform, MEC service, and MEC application are the main components of an MEC Framework. NFV Orchestrator, Virtualized Infrastructure Manager (VIM), and virtualization technologies such as Virtual Machines (VM) and Containers are the main pillars of the NFV technology. In this paper, we study the impact of the virtualization technologies in the deployment of the MEC framework and its components while. We also study the impact of virtualization technologies on NFV and MEC KPIs such as onboarding time, instantiation time, MEC service and application response times. The experiments and its analysis show that containers perform better than VM to instantiate/terminate MEC components in the NFV framework. The observed MEC service KPIs show that the edge application’s performance will be improved to meet the QoE of the applications irrespective of the virtualization technology used. These results can be used as a reference while deploying the MEC components based on their granular functionalities.

With modern Electric Connected Vehicles (ECVs) becoming more intelligent and entertaining, the Multi-access Edge Computing (MEC) servers deployed near the Road Side Units (RSUs) have been expected to not only improve the computing performance, but also alleviate the ECVs' battery burden. However, the uneven spatial and temporal distribution of vehicle arrivals cause that the MEC servers in busy areas are overloaded, which results in degraded computation performance and limited energy alleviation for ECVs. In this paper, we consider the task distribution among nearby MEC servers and propose a novel partial offloading strategy where multiple blocks of the tasks are cooperatively processed by MEC servers in the vehicles' moving directions. After formulating the mathematical model to jointly optimize the computing latency and energy consumption of ECVs, a Deep Reinforcement Learning (DRL) based task partial offloading strategy is proposed and a Deep Q-Network (DQN) is adopted to make the offloading decision. Simulation results illustrate the significant alleviation of energy consumption and improvement of computation performance compared with conventional methods.

Multi-access edge computing (MEC) promises to deliver localized computing power and storage. Coupled with low-latency 5G radio access, this enables the creation of high added-value services for mobile users, such as in-vehicle infotainment or remote driving. The performance of these services as well as their scalability will however depend on how MEC will be deployed in 5G systems. This paper evaluates different MEC deployment options, coherent with the respective 5G migration phases, using an accurate and comprehensive end-to-end (E2E) system simulation model (exploiting Simu5G for radio access and Intel CoFluent for core network and MEC), taking into account user-related metrics, such as response time or MEC latency. Our results show that 4G radio access is going to be a bottleneck, preventing MEC services from scaling up. On the other hand, the introduction of 5G will allow a considerable higher penetration of MEC services.

The extensive growth in Industrial Internet of Things (IIoT) applications has tremendously increased the demands for low latency and resource-sensitive computing to accomplish critical industrial automations. This has leveraged the use of some proficient computing paradigms such as multiaccess edge computing (MEC), which facilitates a low latency and scalable solution for the execution of industrial workloads. However, continual generation of industrial data has imposed a substantial amount of stress on the resource-constrained MEC systems. In this perspective, our study proposes a consolidated stochastic computation offloading (CSCO) framework to address the increasing computational demands of MEC-based IIoT systems. The proposed framework efficiently handles industrial workloads by modeling them as stochastic processes to observe the number of data packets denied service due to the finite number of busy MEC servers. We provide an analytical solution corresponding to the loss probability of data packets denied service at the MEC servers. This leads to the development of a computation offloading mechanism for time-critical tasks. Furthermore, we provide the expression for conditional waiting time (CWT) and unconditional waiting time (UWT) of the data packets waiting to be offloaded to the remote cloud servers. Through extensive numerical simulations, it is inferred that the proposed CSCO framework provides promising results in characterizing the stochastic behavior of MEC-based IIoT systems, thereby providing a low latency, and resource sensitive solution for the considered system.

This paper designs a novel energy-efficient hybrid federated and centralized learning (HFCL) framework for training wireless traffic prediction models in aerial networks over distributed multi-access edge computing (MEC) servers where multiple network data analytics functions (NWDAFs) are embedded in the unmanned aerial vehicle (UAV)-aided MEC servers according to the framework standardized by the 3rd Generation Partnership Project (3GPP) specification. Here, UAVs can use federated learning (FL) with their part of local datasets, while the remaining local datasets can be offloaded to the centralized server for centralized learning (CL). To achieve such HFCL energy-efficiently for battery-constrained UAVs, we propose an energy-efficient computation offloading (ECO) scheme for the HFCL. We rigorously formulate analytical models for the overall energy consumption at MEC servers on UAVs and total latency for HFCL process based on the amount of offloaded datasets at each UAV. Here the energy consumption includes i) the transmission energy consumption for offloading the local dataset and ii) the energy consumption for FL processing, which includes local training and local model uploading. To balance between the overall energy consumption and total latency during HFCL process while preventing overload at UAVs, we propose a theoretical framework for the ECO problem that optimizes the amount of offloaded local datasets over multiple UAVs on aerial networks. Here, the ECO problem is formulated as the convex optimization problem under the continuous domain of the amount of offloaded datasets. Our numerical and simulation results show that our proposed framework can construct wireless traffic prediction models with an acceptable training accuracy in an energy-efficient manner over various benchmarks by striking a balance between energy consumption and overall training latency.

In recent years, AIoT (Artificial Intelligence of Things) applications have received lots of attention since it exploits widely deployed IoT devices to collect data and perform an action while leveraging AI to obtain knowledge and insights. When deploying AIoT in 5G networks, Multi-access Edge Computing (MEC) is appropriate for enabling local management of IoT devices and computation of machine learning (ML) algorithms. Facing the multitude of threats in the ML data layer, IoT service layer, and 5G communications layer, MEC should enable corresponding detection and mitigation schemes to protect AIoT applications. In this article, we examine the existing security solutions located in each layer and discuss the interrelated challenges. For example, a network-traffic-based IDS solution in MEC might capture IoT malware but fail to identify a growing file-less attack. We suggest that firmware emulation in IoT endpoint should be included to provide system-level behaviors to network-based detectors in MEC so that file-less attacks can be distinguished. The potential of a backdoor attack aiming to poison data or corrupt ML models cannot be ignored in AIoT applications, and a corresponding detector should be implemented in MEC. Due to the rise of low-cost Software-Defined Radio (SDR), malicious attacks using rogue base stations (BSs) have become more popular. It implies that security protection at MEC in the communications layer is necessary. This article, therefore, proposes a novel platform, M3Inspector, where inspectors located in mobiles and AIoT machines collect information from surrounding BSs and provide them to MEC. MEC determines the rogue BS and makes a notification to users subscribing to the local service. A realistic 5G experimental platform with rogue BSs is developed. The results demonstrate that attack detection and mitigation can be implemented in the MEC paradigm to significantly improve the security protection of AIoT from the perspectives of rogue BS attacks and file-less attacks.

In industrial production, mass data transmission and processing are required with an increase in production data, which causes large-scale and complicated wiring in the manufacturing industry. However, it is difficult to achieve improved performance through traditional wireless communication technologies. 5G, a leading communication technology, with its Ultra-Reliable Low Latency Communication (uRLLC) combined with Multi-access Edge Computing (MEC), provides huge potential for the service with requirements for higher bandwidth, lower latency, and more computation. The Local Area Network type (LAN-type) Service supported by the 5G system reduces the net distance, which further decreases latency and provides data security. Based on this, in this paper, a 5G MEC gateway system is proposed to realize local wireless communication in a factory. The gateway system includes an intranet Address Resolution Mechanism, which is designed to resolve User Equipment IP addresses, a MEC server, which acts as a switch for packets broadcasting, and network tunnels, which are established between gateways to transmit data in the 5G LAN. In addition, the implemented testbed includes Raspberry Pi, which acts as the gateway, and the OpenVPN server, which runs in the MEC. Finally, two cases are shown to transfer Profinet and OPC UA data with this system.

Application-aware resource allocation and data management for MEC-assisted IoT service providers

Mobility-aware task offloading in MEC with task migration and result caching

Sparse code multiple access (SCMA) is a kind of code-domain non-orthogonal multiple access (NOMA) scheme, which can support the increasing requirements for high spectral efficiency and massive connections. Meanwhile, multi-access edge computing (MEC) is a promising technology for providing resource-constrained users with computing resources. The integration of these two technologies can efficiently improve the computation service. In this paper, we propose a novel optimization scheme in the SCMA-based MEC network from the perspective of energy and latency for the Internet of Things (IoT) devices. To minimize the total overhead of devices, the communication and computation resources allocation, as well as computation offloading are jointly considered. Primarily, a joint SCMA codebook assignment based on the bidirectional matching principle and optimal power allocation algorithm is proposed to maximize the uplink transmit rate. Moreover, we put forward CPU frequency scheduling strategies utilizing convex optimization to optimize the computing resources allocation of local devices and the MEC server. Finally, a low-complexity task offloading policy based on simulated annealing is presented. Numerical results show that our proposed joint optimization algorithm for resource allocation and computation offloading can achieve a good compromise between time delay and energy consumption for IoT devices.