Optimum power control and ordering in SIC receivers for uplink CDMA systems

It is well-known that multiuser detection techniques such as successive interference cancellation (SIC) can obtain significant performance improvement over traditional matched filter receivers in code division multiple access (CDMA) systems. Due to its simplicity and usefulness, the SIC structure has received significant attention for several years. In this letter, we make three contributions to the understanding of this receiver structure. First, we derive a closed form expression for received power profile of linear SIC with arbitrary spreading gain and SINR requirements. Second, using this expression we examine the performance of SIC under various ordering criteria based on spreading gain, path loss, and SINR/BER requirement. Third, we show that using a very simple and well-known sorting algorithm, we can obtain a cancellation order and set of power control levels which are very near the optimum in terms of minimizing total transmit power.

The use of multiple antennas at the transmitter or receiver provides a powerful means, of increasing the capacity of wireless systems. The goal of this paper is to illustrate ways in which analogies with multiuser code division multiple access (CDMA) systems may be used to provide design insights for space-time communication systems, for both single and multiple users. Three examples are considered: (a) noncoherent space-time codes for transmit antenna diversity against Rayleigh fading, constructed using an analogy with a CDMA downlink; (b) optimal multiuser transmit beamforming on a cellular downlink, where the algorithm for computing beamforming weights is obtained by transforming the problem into a CDMA uplink with MMSE interference suppression and power control; (c) design of high bandwidth efficiency systems exploiting both transmit and receive antenna arrays, using analogies with CDMA systems with random and slowly time-varying spreading waveforms.

This paper considers the application of low-density parity check (LDPC) error correcting codes to code division multiple access (CDMA) systems over satellite links. The adapted LDPC codes are selected from a special class of semi-random (SR) constructions characterized by low encoder complexity, and their performance is optimized by removing short cycles from the code bipartite graphs. Relative performance comparisons with turbo product codes (TPC) for rate 1/2 and short-to-moderate block sizes show some advantage for SR-LDPC, both in terms of bit error rate and complexity requirements. CDMA systems using these SR-LDPC codes and operating over non-linear, band-limited satellite links are analysed and their performance is investigated for a number of signal models and codes parameters. The numerical results show that SR-LDPC codes can offer good capacity improvements in terms of supportable number of users at a given bit error performance.

This paper deals with fading and/or near-far effects with or without power control on the evaluation of the sum capacity of finite dimensional Code Division Multiple Access (CDMA) systems. CDMA systems under consideration have binary or finite non-binary inputs and signature matrices. Important results of this paper are that the knowledge of the received power variations due to input power differences, fading and/or near-far effects can significantly improve the sum capacity.

In this treatise, the performance of Code division multiple access (CDMA) system is investigated using multi-user transmitter pre-processing (MUTP). The MUTP is promising signal processing technique which is carried out at the transmitter side to reduce the burden of detector and hence low complexity receiver is made feasible at mobile station (MS) in the context of downlink (DL) communication. Further, the unique signature sequence is considered to support more user population. In particular, the performance of MMSE-MUTP assisted CDMA system is investigated for realistic channel specifications based on Stanford University Interim (SUI) channel model. It has been demonstrated that the MMSE-MUTP assisted CDMA system provides achievable bit error rate with low complexity of receiver for DL transmission.

The capacity of CDMA (code-division multiple access) systems is limited by its other-user interference because all users in a cell share the same frequency band. To achieve maximum capacity, the 'near-far' problem needs to be dealt with. In practice, this is done through appropriate power control. Due to the interaction between the power control process, CDMA systems may become unstable if the desired SNR is not set appropriately. When CDMA systems are stable, the received power at the base station converges to the optimal power with a desired SNR (signal-to-noise ratio) setting. We analyze the associated power and the interference estimation in the discrete time domain and find the stability SNR upper bounds that can guarantee the system stability.

Successive interference cancellation (SIC) has been used in multi-rate code division multiple access (CDMA) systems to eliminate the co-channel interference. In SIC, the required transmission power of a certain user can be reduced if it is detected late in the cancellation order as the interferences caused by the users that are detected before have been cancelled. In this work, we study the power control strategy based on different orderings for the SIC given the knowledge of the battery capacity of the mobiles. In particular we propose different ordering schemes for SIC for different optimization objectives such as minimizing the total power, maximizing the minimum transmission/connection time for a group of users within the same cell and maximizing the total amount of data transmitted for a group of users. Experimental results show that significant improvement can be achieved by using the proposed ordering methods.

This paper studies detecting matrices in random dense and sparse Code Division Multiple Access (CDMA) systems. Detecting matrices were originally introduced in the coin weighing problem. Such matrices can be used in CDMA systems in over-loaded scheme where the number of users is greater than the number of chips. We drive some conditions in the large system limit for binary and bipolar random CDMA systems to ensure that any random matrix is a detecting matrix. Furthermore, we extend our results to sparse random ternary matrices that have been using in the sparse CDMA literature. Finally, a construction method for the sparse detecting matrices is introduced.

For high-speed code division multiple access (CDMA) systems, interchip interference that is caused by multipath propagation becomes severe and cannot be ignored. Together with the multiple access interference due to nonideal conditions in CDMA, they become major obstacles to overall system performance. In this paper, both batch and adaptive algorithms based on linear prediction are proposed for joint blind equalization and multiuser detection for asynchronous CDMA systems. It is shown that the new methods are insensitive to estimation error of propagation delay or chip timing. In addition, the adaptive algorithm is computationally efficient. Simulation results show that the proposed methods are also near-far resistant and compare favorably to many existing methods.

Multiple access interference (MAI) appears in Code Division Multiple Access (CDMA) systems when the communication channel is a multi-path channel and the spreading codes are not orthogonal. Orthogonality between spreading codes cannot be maintained at the CDMA receiver because the codes may be asynchronous due to channel delay and multi-path spread. The receiver cannot perfectly separate the different signals of the multiple access users, and the resultant MAI limits the capacity of CDMA systems. MAI is a function of the cross correlation property between used spreading codes. In this paper we focus on the cross correlation of the spreading codes, we propose a method to find spreading codes with minimum magnitude of cross correlation. Employing these codes will reduce the resultant MAI in the CDMA system; hence it will increase the system capacity. A great enhancement is shown by comparing found minimum cross correlation spreading codes (MCCSC) with Hadamard and Gold codes.

This paper carries comprehensive comparison of Interleave Division Multiple Access (IDMA) and Code Division Multiple Access (CDMA) systems in terms of performance (BER) and behavior to different number of users. Performance analysis of two systems whose transmitter and receiver structures are almost same are studied under Additive White Gaussian Noise (AWGN) and performance differences are illustrated by simulation results. Although Multiple Access Interference (MAI) and Intersymbol Interference (ISI) can affect the performance of the CDMA system, simulation results illustrates that IDMA system model achieves this type of problem using their interleavers. Results also show that large number of users can easily be adapted by the IDMA scheme much easier than CDMA scheme.

The W-CDMA system plays an important role in the 3G cellular systems because of its compatible networking architecture to the present popular Global System for Mobile Communications (GSM) systems as well as the salient features of a Code Division Multiple Access (CDMA) system, including multi-path fading tolerance, high system capacity, low power consumption, good performance and coverage. In CDMA system, a procedure used by a Mobile Station (MS) to search for the best cell site and achieve code, time, and frequency synchronization with it is referred as cell search. Fast cell search is essential to reduce switch on delay (initial cell search), increase stand by time (idle mode search) and maintain good link quality (active-mode search). This is particularly true for the Wideband Code Division Multiple Access-Frequency Division Duplex (W-CDMA-FDD) system since it employs nonsynchronous base stations instead of synchronous ones of other CDMA systems to extend coverage from outdoor to indoor. Cell search is critical for achieving code and time synchronization. The main process of achieving cell search is divided into three stages followed by code verification, tracking and carrier frequency adjustment: 1) slot synchronization, 2) frame synchronization and code group identification, 3) primary scrambling code identification. This paper addresses slot synchronization in downlink as cell search algorithm in W-CDMA. In the three step search, the receiver searches for the slot timing by correlating the received signal with the Primary Synchronization (PSCH) code using Matched Filter (MF). This paper propose a design for a hierarchical matched filter for Primary Synchronization Code (PSC). The aim is to reduce the hardware complexity using Field Programmable Gate Array (FPGA) logic resources required to realize the filter.

A dispersive finite impulse response (FIR) channel model is often considered for indoor wireless channels. For the FIR channel model in this paper, we consider the joint estimation of channel parameters and data symbols in indoor code division multiple access (CDMA) systems. The least squares formulation is constructed for the joint estimation incorporating the decision feedback technique. This formulation is suitable for indoor CDMA systems that usually have a small processing gain. The formulation is further modified to provide a recursive approach to estimate the channel vector.

In the underwater passive positioning systems (UPPS), it involves a key technology of multi-user communication that the beacons synchronously send positioning messages to the targets. Interferences from other users, referred to multi-access interferences (MAIs), can induce significant bit errors for the desired user. In this paper, we designed an underwater acoustic Code Division Multiple Access (CDMA) system using the coded cyclic shift key (CCSK) modulation, and proposed a hybrid MAI cancellation scheme based on cyclic shift inverse matrix transform (CSIMT) and recursive least square (RLS) in the CDMA system. The hybrid scheme can suppress MAI better than RLS or CSIMT, and meets the requirements of strong stability to support reliable transmission for UPPS. The CSIMT interference cancellation performs well under the far-near effects, which doesn’t depend on the accuracy of the estimation of transmitted data, and the strong MAI can be reduced by transformation of the zero-forcing correlation values using m sequence cyclic shift inverse matrix. The RLS interference cancellation is used to mitigate MAI form the detected users with comparable power, by using the estimated the channel impulse response between the receiver and the detected users, and the regenerated signal of detected users form decoder output, which allows of strong error-correcting codes, and it’s robust in an asynchronous environment. The theoretical analysis and experimental result show that the hybrid MAI cancellation scheme can effectively suppress MAI better. The shallow water sea trial was carried out near Dalian Tiger Beach Ocean Park in China, at a distance of about 5 km, the data rates of 100bps, where three users could communicate asynchronously with low failure ratio and can match the UPPS application.

Multicarrier code division multiple access (MC-CDMA) can be applied in underwater acoustic communication networks to combat the narrow bandwidth of the underwater acoustic channel and multipath fading. Power control is one of the key technologies for the MC-CDMA communication networks. In this paper, we propose a multi-objective power control scheme based on improved particle swarm optimization (PSO) algorithm for underwater acoustic MC-CDMA communication networks. The distance of different nodes to base station (BS) is not same, which can cause near-far effect. So we propose a fitness function which is consisted of power consumption and SINR (the signal to interference plus noise ratio) on the receiver. The method effective reduces the power consumption of nodes and decreases the near-far effect. Comparing with the scheme without power control, our results show that the proposed power control algorithm can be used in underwater acoustic channel. Not only the power consumption is lower, but also the bit error rate (BER) performances are better.