PAPR Reduction in Coded SC-FDMA Systems via Introducing Few Bit Errors

Long Term Evolution (LTE) chose Single Carrier Frequency Division Multiple Access (SC-FDMA) for uplink communications due to lower signal envelope changes in SC-FDMA signal. This enables low peak to average power ratio (PAPR) in SC-FDMA in contrast to Orthogonal Frequency Division Multiple Access (OFDMA). High PAPR cannot be ignored as it reduces energy efficiency due to the requirement of large range linear power amplifiers. As the mobile devices are power restricted, there is a requirement to mitigate PAPR in the uplink SC-FDMA systems, especially for higher order modulations. Companding is an attractive technique to mitigate PAPR without any bandwidth extension. This paper suggests a companding transform using exponential function to mitigate PAPR in SC-FDMA systems. The suggested transform maintains the average signal power contrary to $\mu$ law companding. Simulation results demonstrate that exponential companding technique without any decompanding operation reduces PAPR by a significant value by maintaining the average signal power and BER performance.

Single carrier frequency division multiple access (SC-FDMA) which utilizes single carrier modulation at the transmitter and frequency domain equalization at the receiver is a technique that has similar performance and essentially the same overall structure as those of an OFDMA system. One prominent advantage over OFDMA is that the SC-FDMA signal has lower peak-to-average power ratio (PAPR). SC-FDMA has drawn great attention as an attractive alternative to OFDMA, especially in the uplink communications where lower PAPR greatly benefits the mobile terminal in terms of the transmit power efficiency. SC-FDMA is currently a working assumption for the uplink multiple access scheme in 3GPP Long Term Evolution (LTE). To achieve low PAPR, a novel scheme, SC-OFDMA with super frame using intermediate mapping (SF-IFDMA), is proposed in this paper. In our proposed scheme, B frames with N subcarriers will be combined into one super frame, then SC-OFDM technique is applied to reduce the PAPR of the super frame, the super frame with lowered PAPR will finally be divided into B OFDM frames for the transmission. The combining and dividing process is equivalent to the concatenation process. The proposed scheme requires no side information and can significantly reduce PAPR while maintaining small number of subcarriers.

The UMTS Long Term Evolution (LTE) is an emerging technology in the evolution of 3G networks. LTE runs on an advancement of the obtainable UMTS infrastructure already used by over 80 percent of mobile subscribers worldwide. We have very inadequate resources in cellular technologies and it is important to utilize them with high efficiency. Single Carrier Frequency Division Multiple Access (SC-FDMA) & Orthogonal Division Multiple Access (OFDMA) are most important division of LTE. OFDMA was well utilized for achieving high spectral efficiency in communication method. SC-FDMA is introduced in recent times and it became handy candidate for uplink multiple access scheme in LTE system that is a project of Third Generation Partnership Project (3GPP). The Multiple Access Scheme in Advanced Mobile radio system has to meet the challenging requirements for example high throughput, fine robustness, capable Bit Error Rate (BER), high spectral efficiency, small delays, low computational difficulty, less Peak to Average Power Ratio (PAPR), low error probability etc. In our paper, we investigate the performance of SC-FDMA in LTE physical layer by considering different modulation schemes (QPSK, 16QAM and 64QAM) on the basis of BER vs Eb/No. Additive White Gaussian Noise (AWGN) and fading channel are used to evaluate the performance in presence of noise and fading.

Non-Gaussian noise is one of the most common noise models observed in wireless channels. This type of noise has severe impact on wireless systems detection devices. In this paper, the issue of OFDM and SCFDMA PAPR in non-Gaussian noise channel is addressed. Single carrier frequency division multiple access (SCFDMA) is developed form the Orthogonal Frequency Division Multiple access, (OFDM), and is a promising technique for high data rate uplink communications in the cellular systems. SCFDMA has similar throughput performance and essentially the same overall complexity as OFDM. One of the most important advantages of SCFDMA is the peak-to-average power ratio (PAPR), which is lower than that of OFDM. SCFDMA is employed in the uplink multiple access scheme in the Long Term Evolution (LTE) of cellular systems, and identified by the Third Generation Partnership Project (3GPP). In this paper, we show the performance differences of the OFDM and SCFDA system under different noise scenarios. The performance measure is the PAPR.

The 3rd generation partnership project (3GPP) long term evolution (LTE) standard has adopted orthogonal frequency division multiplexing access (OFDMA) in downlink and single carrier-frequency division multiple access (SC-FDMA) scheme for the uplink transmissions, which utilizes single carrier modulation and frequency domain equalization. In this paper, we proposed a power-function companding scheme to reduce the peak-to-average power ratio (PAPR) of SC-FDMA signals. The proposed companding scheme can transform the original SC-FDMA signals into power-function-distributed. Moreover, the scheme can compress the large signals, while maintaining the average power constant. Computer simulation results show that the proposed companding scheme can offer better PAPR reduction by properly choosing the control parameters.

Carrier frequency offset (CFO) and phase noise are challenging problems in single carrier frequency division multiple access (SC-FDMA) system. In this study, the authors have studied single-carrier space frequency block coding (SC-SFBC) to reduce the peak to average power ratio (PAPR) of the multiple-input multiple-output (MIMO) SC-FDMA signal, in which Alamouti SFBC will change the signal spectrum structure, break the single-carrier property and increase PAPR. Also, the authors propose a joint algorithm to suppress the inter-carrier interference (ICI) caused by phase noise and CFO. Conventional methods are to estimate phase noise and CFO in other algorithms, which are pretty difficult and complicated to obtain accurate estimation results. Unlike the conventional works, the novelty of the authors proposed algorithm is that it directly calculates the interference components and then reconstructs the ICI matrix. Thus, it avoids the degrading interactions between phase noise and CFO estimations. The proposed algorithm exploits block-type pilot, which is a common pilot pattern in SC-FDMA communications and is used in other wireless communication standards. Simulation results show that the suppression performance keeps smooth while phase noise and CFO varies, and BER performance degradation can be significantly reduced in 3 dB.

Blind selective mapping for single-carrier frequency division multiple access system

Single Carrier Frequency Division Multiple Access (SC-FDMA) has been selected for use in the Long Term Evolution (LTE) uplink due to its lower Peak-to-Average Power Ratio (PAPR) relative to OFDMA The resultant lower PAPR results in fewer excursions into the amplifier's nonlinear region, where signal distortion can occur and results in degraded bit error rate (BER). The SC-FDMA scheme normally applies 16-ary Quadrature Amplitude Modulation (16-QAM), but amplitude phase shift keying (APSK) modulation has a lower PAPR than does 16-QAM, resulting in improved BER This paper investigates the constellation ring ratio of the 16-APSK modulation scheme and its effects on BER through its effects on the PAPR. Simulation results are used to conclude that a ring ratio that ranges from 2.5 to 3.5 delivers the best results and provides BER and PAPR improvement.

Long Term Evolution (LTE) has adopted Single Carrier Frequency Division Multiple Access (SCFDMA) technique for uplink and Orthogonal Frequency Division Multiple Access (OFDMA) for downlink. SCFDMA is often called as Discrete Fourier Transform (DFT) spread OFDMA. In this paper, Wavelet based SCFDMA is proposed for analyzing Bit Error Rate (BER) performance. Analysis is carried out using different wavelets and different modulation schemes under AWGN channel. This analysis will show that the reduction in BER takes place by using wavelet transform in SCFDMA. Thus wavelet based SCFDMA provides better BER performance than that of DFT based SCFDMA.

The Long Term Evolution (LTE) standards are generated by the Third Generation Partnership Project (3GPP) for the Fourth Generation (4G) wireless communication systems. The Fourth Generation (4G) wireless communication standards use new physical layer signaling techniques in their physical layer. Single Carrier Frequency Division Multiple Access (SC-FDMA) and Orthogonal Frequency Division Multiple Access (OFDMA) are the two major signaling techniques used in LTE. OFDMA is used in the downlink of the Fourth Generation (4G) wireless communication systems for its high spectral efficiency and SC-FDMA is used in the uplink of the Fourth Generation (4G) wireless communication systems for its high power efficiency. The main objective of this paper is to design and implement the reliable and energy efficient architecture for LTE uplink system using FPGA. IFDMA is the most energy efficient subcarrier mapping scheme of SC-FDMA multiple access scheme. In IFDMA, the data symbols subcarrier mapping is not one to one instead each subcarrier carries a part from each data symbol transmitted at that time instant. The reason for the selection of IFDMA subcarrier mapping along with SC-FDMA multiple access scheme for LTE uplink comes mainly from its advantage to provide a low peak to average power ratio (PAPR) for the transmitted waveform. This results in less power consumption in the mobile station during uplink transmission. The reliability of the system is improved using interleaving process by avoiding packet loss. Convolution codes are less complex and are used to provide error free transmission. The enhancement of energy efficiency is done using the convolution coded IFDMA. The chosen energy efficient architecture must be more power efficient and support high data rates, which is the main requirement for the mobile user. The proposed reliable and energy efficient architecture for LTE uplink system is implemented using Xilinx system generator tool.

The power consumption is an essential issue for designers of mobile devices. Orthogonal Frequency Division Multiplexing (OFDM) suffers from its Peak – to – Average Power Ratio (PAPR) problem. The Discrete Fourier Transmission Spread OFDM (DFTS-OFDM) based on Single Carrier Frequency Division Multiple Access (SC-FDMA) has been widely adopted due to its lower peak-to-average power ratio (PAPR) of transmits signals compared with OFDM. There are three types of mapping in SCFDMA. These namely Localized FDMA (LFDMA), Distributed FDMA (DFDMA), and Interleaved FDMA (IFDMA). In this paper, we propose a modified SCFDMA. This is based on using Hadamard transform instead of Fast Fourier Transform (FFT). Utilizing LFDMA Mapping techniques this is proposed for uplink scenario of LTE. Simulation results show that the proposed scheme reduces PAPR compared to the conventional SCFDMA while the BER does not degraded.

The Third Generation Partnership Project (3GPP) Long Term Evolution (LTE) standard is becoming the appropriate choice to pave the way for the next generation wireless and cellular standards. While the popular OFDM technique has been adopted and implemented in previous standards and also in the LTE downlink, it suffers from high peak-to-average-power ratio (PAPR). High PAPR requires more sophisticated power amplifiers (PAs) in the handsets and would result in lower efficiency PAs. In order to combat such effects, the LTE uplink choice of transmission is the novel Single Carrier Frequency Division Multiple Access (SC-FDMA) scheme which has lower PAPR due to its inherent signal structure. While reducing the PAPR, the SC-FDMA requires a more complicated detector structure in the base station for multi-antenna and multi-user scenarios. Since the multi-antenna and multi-user scenarios are critical parts of the LTE standard to deliver high performance and data rate, it is important to design novel architectures to ensure high reliability and data rate in the receiver. In this paper, we propose a flexible architecture of a high data rate LTE uplink receiver with multiple receive antennas and implemented a single FPGA prototype of this architecture. The architecture is verified on the WARPLab (a software defined radio platform based on Rice Wireless Open-access Research Platform) and tested in the real over-the-air indoor channel.

In this paper, we propose a low-complexity peak-to-average power ratio (PAPR) reduction scheme that combines both multi-band (MB)-Hadamard precoding and clipping for the optical orthogonal frequency division multiplexing (OFDM) systems. Approximations of PAPR distribution for baseband OFDM signals are analyzed and the effective signal-to-noise ratio (SNR) of the whole transmission link considering both the clipping and quantization noise are presented. After that, the MB-Hadamard precoding is adopted to compresses the peak signals, minimizing the contaminating influence of signal distortions in subsequent clipping operations. In addition, the received SNRs and bit error rate (BER) are calculated theoretically for each split sub-band. The 50-m step-index polymer optical fiber (POF) transmission is adopted as a special case to both evaluate the system performance and then compare the proposed scheme with other well-known PAPR reduction techniques. With this scheme, the PAPR is reduced effectively and the system’s BER performance is improved significantly. The results show that the proposed scheme with appropriate number of sub-bands precoding provides favorable trade-offs among PAPR reduction, power spectral density, transmission rate, BER, and computational complexity, which demonstrates its feasibility and validity.

Orthogonal frequency division multiple access (OFDMA) and Single Carrier Frequency Division Multiple Access (SC-FDMA) are the two major multiple access schemes for 4G wireless communications. In long term evolution (LTE) the downlink multiple access scheme is based on OFDMA and the uplink multiple access scheme is based on SC-FDMA. In this letter, we derive the fundamental performance difference between OFDMA and SC-FDMA, and present the general performance comparison between them. Analytical results show that OFDMA performance upper bounds SC-FDMA in the sense of capacity. The conclusion is further confirmed by numerical results.

SC-FDMA (Single-Carrier Frequency Division Multiple Access) is employed in the 3GPP LTE (Long-Term Evolution) standard as the uplink transmission scheme. The SC-FDMA signal has a low PAPR. This makes it well-suited to power efficient transmission at the mobile terminal. Although it is a common assumption to use frequency-domain linear equalization in SC-FDMA, a decision feedback equalizer (DFE) composed of a frequency-domain feedforward filter and a time-domain feedback filter can provide enhanced performance. Even when error propagation is taken into account, results show that a DFE still offers a significant performance gain over the conventional LE for uncoded SC-FDMA. This paper demonstrates that SC-FDMA with DFE is capable of increasing the throughput in a power limited channel by up to 41% compared to LE. Alternatively, for a given peak transmit power, the use of a DFE can achieve a 14% coverage extension in NLOS and 19% in LOS.